The impact of agroforestry combined with water harvesting on soil carbon and nitrogen stocks in central Chile evaluated using the ICBM/N model

Soil organic carbon (SOC) and total nitrogen (N) stocks in an agroforestry system with water harvesting were analysed in a field experiment and the results compared with those of other crop management systems in the Mediterranean zone of central Chile. Agroforestry with water harvesting showed higher positive effects on N stocks, mainly in the upper soil layer, than the other crop management systems. However, soil analysis revealed a lack of differences between treatments, a fact that might be related mainly to the short study time (12 years) and the high spatial variability in these soil properties at the experimental site. In addition, the Introductory Carbon Balance Model that simulates N processes (ICBM/N) was evaluated for simulating trends in SOC and N stocks in the field experiment. Soil data collected between 1996 and 2008 in the field experiment and primarily literature data sets were used to test ICBM/N and its performance was evaluated by considering uncertainty in model inputs using Generalised Likelihood Uncertainty Estimation (GLUE) methodology. The GLUE estimates (5% and 95%) and measured SOC and N stocks were in satisfactory agreement. The observed SOC and N stocks were bracketed by the uncertainty bands in 70% and 80% of the simulations, respectively. Sensitivity analysis showed the model to be most sensitive to C parameters, such as the humification coefficient (h). The results of this study show that ICBM/N can be an effective tool for estimating SOC and N stocks from agroforestry combined with water harvesting systems in the Mediterranean zone of central Chile over the medium term. However, they also indicate that additional data sets are needed to redefine the parameter distributions in the model and thus to predict trends in SOC and N stocks in the future.     

Anatomical localization and stereoisomeric composition of <Emphasis Type="Italic">Tribolium castaneum</Emphasis> aggregation pheromones

We report that the abdominal epidermis and associated tissues are the predominant sources of male-produced pheromones in the red flour beetle, Tribolium castaneum and, for the first time, describe the stereoisomeric composition of the natural blend of isomers of the aggregation pheromone 4,8-dimethyldecanal (DMD) in this important pest species. Quantitative analyses via gas chromatography–mass spectrometry showed that the average amount of DMD released daily by single feeding males of T. castaneum was 878 ± 72 ng (SE). Analysis of different body parts identified the abdominal epidermis as the major source of aggregation pheromone; the thorax was a minor source, while no DMD was detectable in the head. No internal organs or obvious male-specific glands were associated with pheromone deposition. Complete separation of all four stereoisomers of DMD was achieved following oxidation to the corresponding acid, derivatization with (1R, 2R)- and (1S, 2S)-2-(anthracene-2,3-dicarboximido)cyclohexanol to diastereomeric esters, and their separation on reversed-phase high-performance liquid chromatography at −54°C. Analysis of the hexane eluate from Porapak-Q-collected volatiles from feeding males revealed the presence of all four isomers (4R,8R)/(4R,8S)/(4S,8R)/(4S,8S) at a ratio of approximately 4:4:1:1. A walking orientation bioassay in a wind tunnel with various blends of the four synthetic isomers further indicated that the attractive potency of the reconstituted natural blend of 4:4:1:1 was equivalent to that of the natural pheromone and greater than that of the 1:1 blend of (4R,8R)/(4R,8S) used in commercial lures.     

Giant rhinoceros Paraceratherium and other vertebrates from Oligocene and middle Miocene deposits of the Kağızman-Tuzluca Basin, Eastern Turkey

A recent fieldwork in the Ka??zman-Tuzluca Basin in northeastern Turkey led us to the discovery of three vertebrate localities which yielded some limb bones of the giant rhino Paraceratherium, a crocodile tooth, and some small mammals, respectively. These discoveries allowed, for the first time to date some parts of the sedimentary units of this basin. This study also shows that the dispersal area of Paraceratherium is wider than it was known before. Eastern Turkey has several Cenozoic sedimentary basins formed during the collision of the Arabian and Eurasian plates. They are poorly documented for vertebrate paleontology. Consequently, the timing of tectonic activities, which led to the formation of the East Anatolian accretionary complex, is not constrained enough with a solid chronological framework. This study provides the first biostratigraphic evidences for the infill under the control of the compressive tectonic regime, which built the East Anatolian Plateau.     

An environmental impact assessment of quantum dot photovoltaics (QDPV) from raw material acquisition through use

Some emerging technologies are expected to be pivotal for solving many of the environmental challenges faced today, especially those related to energy. However, many of these technologies may incur significant environmental impacts over their life cycle, while having environmental benefits during their use. This paper presents results of a Life Cycle Assessment (LCA) of a proposed type of nanophotovoltaic, quantum dot photovoltaic (QDPV) module. The LCA is confined to the stages of raw materials acquisition, manufacturing, and use. The impacts of QDPV are compared with other types of PV modules and energy sources - both renewable and nonrenewable. To provide a comprehensive comparative assessment, QDPV modules were compared with mature as well as emerging PV types for which data are available. Comparative assessment with other types of energy sources includes coal, oil, lignite, natural gas, diesel, nuclear, wind, and hydropower.QDPV modules may have the potential to overcome two current barriers of solar technology: low efficiencies and high manufacturing costs. If higher efficiencies are realized, QDPV modules could pave the way to large scale implementation of solar energy, helping nations move toward greater energy independence. On the other hand, candidate materials as quantum dots for solar cell applications are mostly compound semiconductors such as cadmium selenide, cadmium telluride, and lead sulfide which may be toxic and for which renewable options are limited. Toxic effects of these materials may be exacerbated by their nanoscale features.The LCA was carried out using the software SimaPro, and the Ecoinvent Life Cycle Inventory (LCI) database supplemented with available literature and patent information. Our results indicate that while QDPV modules have shorter Energy PayBack Time (EPBT), lower Global Warming Potential (GWP), SO_x and NO_x emissions than other types of PV modules, they have higher heavy metal emissions, underscoring the need for investigation of emerging technologies, especially nano-based ones, from a life cycle perspective. QDPV modules are better in all impact categories assessed than carbon-based energy sources but they have longer EPBT than wind and hydropower and higher GWP.     

Health implications of radon distribution in living rooms and bedrooms in U.K. dwellings--a case study in Northamptonshire

Environmental radon exposure of residents of domestic premises in the United Kingdom (UK) and elsewhere in Europe is estimated on the basis of the measured radon concentrations in, and the relative occupancies of, the principal living room and bedroom. While studies on radon concentration variability in the individual units in apartment blocks in various countries have been described, little data has been reported on variability in two-storey single-family dwellings, and the majority of extant studies consolidate living room and bedroom data early in the analysis. To investigate this further, detailed analysis was made of radon concentration data from a set of thirty-four homes situated in areas of Northamptonshire known to exhibit high radon levels. All homes were of typical UK construction of brick/block/stone walls under a pitched tile/slate roof. Approximately 50% of the sample were detached houses, the remainder being semi-detached (duplex) or terraced (row-house). Around 25% of the sample possessed cellars, while 12% were single-storey dwellings (bungalows), reflecting the typical incidence of this type of dwelling in England. In the two-storey homes, all monitored bedrooms were on the upper floor. Distribution of the ratios of bedroom/living room radon concentrations (BR/LR ratio) in individual properties was left-skewed (mean 0.67, median 0.73, range 0.05-1.05) with a tail extending to just above 1.0. The mean is consistent with the outcome of earlier extensive studies in England, while the variability depends principally on the characteristics of the property, and not on seasonal factors. In a small set of homes, the BR/LR ratio was anomalously low, (mean 0.3). BR/LR ratios in single-storey homes clustered around a value of 1.0, indicating that house design, rather than lifestyle, is the dominant factor in determining bedroom radon concentrations. Homes with higher mean annual radon concentrations showed lower BR/LR ratios, supporting our proposal that, in some homes, radon emanation from building materials may comprise a significant component of the overall radon level.     

Trends in the spatial and temporal distribution of 129I and 99Tc in coastal waters surrounding Ireland using Fucus vesiculosus as a bio-indicator

Spatial and temporal trends in (129)I and (99)Tc concentrations around the Irish coastline have been evaluated using Fucus vesiculosus as a bio-indicator. (129)I concentrations in a recent set of seawater samples have also been recorded and reveal an identical spatial pattern. Concentrations of (129)I in Fucus from the northeast coast of Ireland proved to be at least two orders of magnitude higher than concentrations in Fucus from the west coast. The (129)I content of Fucus increased significantly between 1985 and 2003, in line with increases in discharges of (129)I from the Sellafield nuclear reprocessing plant. Similar trends were observed in the case of (99)Tc. (129)I/(99)Tc ratios in Irish seawater were deduced from the Fucus data, and compared to ratios in discharges from Sellafield and from the French reprocessing plant at Cap de la Hague. Levels of (129)I and (99)Tc in Fucus from the west coast were found to be enhanced with respect to levels in seaweeds from other regions in the Northern Hemisphere unaffected by discharges from nuclear installations such as those referred to.     

Indoor radon monitoring in Northern Iran using passive and active measurements

In this work we present the results of a 2-year survey of indoor radon variations in four cities of Lahijan, Ardabil, Sar-Ein and Namin in North and Northwest Iran. We used both passive and active measurements by solid state nuclear track detectors (SSNTDs) with CR-39 polycarbonate and PRASSI Portable radon Gas Surveyor. A total of 1124 samplers in Lahijan, Ardabil, Sar-Ein and Namin were installed. Sampling frequency was seasonal and sampling locations were randomly chosen based on dwelling structures, floors, geological formations, elevation and temperature variation parameters. For quality assurance, 281 active measurements and double sampling were carried out. Based on our results and the results of previous surveys, Ardabil and Lahijan have the second and third highest radon concentration in Iran, respectively (Ramsar is first). The average radon concentration during the year in Lahijan, Ardabil, Sar-Ein and Namin were 163, 240, 160 and 144 Bq/m(3) with medians of 160, 168, 124 and 133 Bq/m(3), respectively. These concentrations give rise to annual effective doses of 3.43 mSv/y for Lahijan and 5.00 mSv/y for Ardabil. The maximum recorded concentration was 2386 Bq/m(3) during winter in Ardabil and the minimum concentration was 55 Bq/m(3) during spring in Lahijan. Relationships between radon concentration and building materials and room ventilation were also studied. The dosimetry calculations showed that these four cities could be categorized as average natural radiation zones. The correlation coefficients relating warm and cold season radon variation data were obtained.     

Optimisation of systems to locate discrete gamma-ray sources within a large search area

Most systems used to locate discrete gamma-ray sources involve systematically passing a detector over the search area while seeking a significant increase in the observed count-rate. This paper discusses the ways in which such systems may be designed to maximise the probability of locating a source. It is shown that optimised systems use a collimated, energy-discriminating detector and overlapping counting intervals determined by the scanning geometry and speed.     

Intra-cultivar variability of the soil-to-grain transfer of fallout 137Cs and 90Sr for winter wheat

Differences between the root uptake of fallout radionuclides by different cultivars ('inter-cultivar' variability) growing on the same field may be influenced not only by genetic differences of the cultivars, but also by the spatial variability of the soil-to-grain transfer within the cultivation area of each cultivar. This 'intra-cultivar' variability was investigated in 2001 and 2002 for 137Cs and 90Sr using three winter wheat cultivars with four replicates for each cultivar at three different sites in Bavaria, Germany. The intra-cultivar variability proved to be in the same range as the inter-cultivar variability which was determined earlier at the same sites for both radionuclides. An ANOVA of the 137Cs data set revealed that the variability of the 137Cs soil-to-grain transfer was caused by the soil and climate (year) at the field sites and the interaction of cultivar and field. A significant contribution of the factor 'cultivar' alone to the variability could not be detected. This may be due to the complex environmental conditions to which plants are exposed in field experiments. To find wheat cultivars with minimal uptake of fallout radionuclides it may be better to examine the molecular mechanisms of their root uptake in order to identify targets for breeding "safer" plants.     

Distribution of nuclear bomb Pu in Nishiyama area, Nagasaki, estimated by accurate and precise determination of 240Pu/239Pu ratio in soils

Plutonium isotopes in forest soils collected in Nishiyama area, Nagasaki, were successfully determined by high resolution inductively coupled plasma mass spectrometry after the treatment with a microwave decomposition system. The (240)Pu/(239)Pu atom ratios observed in the samples in the Nishiyama area were obviously lower than the range of the global fallout. The low ratios (minimum 0.032) observed in Nishiyama area indicated the influence of detonation of the Pu nuclear weapon in 1945. Since the area is contaminated also by global fallout, the (240)Pu/(239)Pu atom ratio can be more sensitive indicator of bomb-derived Pu than Pu activity concentration.