过硫酸钾去除水中的TCE

以地水中的氯代烃污染物三氯乙烯(TCE)为目标污染物,以过硫酸钾溶液为氧化剂,探讨了不同条件下过硫酸钾对TCE的去除效果。实验结果表明,在40℃,过硫酸钾初始浓度为2.43 g/L条件下,反应2 h后,TCE的去除率就可达到96.8%;过硫酸钾对TCE的去除符合一级反应动力学方程,速率常数(K)为1.3364 h-1,半衰期(t1/2)为0.51 h;过硫酸钾对TCE的去除速率在pH为中性附近时最大,其后无论pH升高或降低去除速率均减小;受温度和pH影响较明显,并且反应温度越高,受pH的影响越明显;随离子强度的增加而减小;反应活化能为119.6 kJ/mol;过硫酸钾溶于水生成过硫酸根离子(S2O28-),S2O28-会进一步生成硫酸根自由基(SO4-.),在碱性条件下,SO4-.与OH-反应会进一步生成羟基自由基(.OH)。过硫酸钾对于TCE的去除主要源自SO4-.和.OH的强氧化性。     

可旋转径向式微粒捕集器消声特性影响因素灰色关联分析

为降低可旋转径向式微粒捕集器中的排气噪声,采用有限元法建立可旋转径向式微粒捕集器声学特性模型,分析得到了其消声特性和传递损失曲线,并采用灰色关联分析方法研究可旋转径向式微粒捕集器结构参数对消声特性的影响程度。结果表明,可旋转径向式微粒捕集器具有降噪能力,且对高频噪声消声效果明显好于低频噪声,平均消声量为20 dB左右;直径比和扩张管锥角是影响可旋转径向式微粒捕集器消声特性的2个主要因素,适当选用小的直径比和扩张管锥角,有利于提高可旋转径向式微粒捕集器的消声性能。     

Fenton氧化-序批式膜生物反应器耦合处理干法腈纶废水

采用Fenton氧化-序批式膜生物反应器(SBMBR)组合工艺处理干法腈纶废水。结果表明,在废水初始pH值为3.0,H2O2投加量为90.0 mmol/L,Fe2+投加量为20.0 mmol/L,反应时间为2.0 h的条件下,Fenton氧化预处理对腈纶生产废水的COD去除率达到47.0%以上,COD由1 091 mg/L降至560 mg/L,废水的BOD5/COD由0.32升至0.69,废水的可生化性得到显著提高。Fenton处理出水与丙烯腈废水等比例混合后,采用SBMBR进行生化处理,在水力停留时间为24 h,90 min缺氧/150 min好氧交替运行的条件下,COD、NH4+-N和TN的平均去除率分别为71.7%、97.2%和47.4%,碳源不足是限制TN去除效果的主要影响因素。在无外加碳源的条件下,组合工艺处理后出水COD和NH4+-N浓度分别为117 mg/L和1.7 mg/L,出水水质可以稳定达到国家一级排放标准(GB8978-1996)。     

MFC-MBR耦合系统运行效果

膜生物反应器(MBR)是一种高效的污水处理工艺,而微生物燃料电池(MFC)能有效降解污泥中的胞外生物有机质(EBOM)并回收电能.将MFC与MBR联用,建立了一套能够有效抑制膜污染同时回收电能的新系统——MFC-MBR耦合系统,MBR的剩余污泥经MFC处理后回流.以传统MBR为对照,对耦合系统中污水处理效果、膜污染情况和污泥混合液的性质进行研究.研究表明,耦合系统的污水处理效果没有明显恶化,COD去除率为94％,NH4+-N的去除率为92％.耦合系统能够有效减缓膜污染的发生,清洗周期延长了28％.污泥混合液的MLVSS/MLSS稳定在80％ ～ 88％,系统内几乎没有无机颗粒积累.松散结合态胞外聚合物(LB-EPS)降低了48％,使污泥混合液性质得到改善.较低的污泥比阻(2.69×1012m/kg)和标准化毛细吸水时间(1.67 s·L/g MLSS),证明耦合系统污泥混合液脱水性能提高了.     

炼油污水回用处理RO系统的稳定运行及维护

文章介绍了兰州石化公司炼油污水深度处理反渗透(RO)系统的工艺流程及维护。通过进出水电导率、产水回收率等变化情况,分析了RO系统的运行状况。得知:运用此系统,反渗透系统产水回收率达到65%～70%,系统脱盐率在99%以上,产水可以满足一级除盐水要求,实现了装置稳定运行的目标。     

回收与降解聚驱采出水的工艺探讨

含聚污水的处理是困扰石油行业的难题之一。基于聚驱采出水的特点,围绕聚合物的回收利用和降解理论及技术,探讨国内外含聚污水处理技术的研究与应用现状,对比分析现有处理技术存在的问题及适应性,提出采用化学混凝、气浮和水质改性等技术来回收利用PAM(聚丙烯酰胺)的新思路,打破了降解PAM的传统思维,同时分析含聚污水处理与利用技术的可行性与应用前景,有望实现含聚污水的循环利用。     

基于RS和GIS的山东省17城市生态环境质量动态变化研究

运用遥感动态监测与地理信息系统技术相结合的方法,以2005年和2009年遥感解译数据、土地侵蚀数据及环境统计数据为数据源,依据《生态环境状况评价技术规范(试行)》(HJ/T192-2006),对山东省17个城市生态环境质量现状及动态变化趋势进行了评价。结果表明:2009年17个城市生态环境状况指数在59.81～78.08之间,生态环境质量状况总体良好;2005-2009年17城市生态环境状况指数变化值在0.06～3.5之间,生态环境质量状况基本稳定。     

Effect of humic acids on physicochemical property and Cd(II) sorption of multiwalled carbon nanotubes

Zinc pyrithione is used as an antifouling agent. However, the environmental impacts of zinc pyrithione have recently been of concern. Zinc induces diverse actions during oxidative stress; therefore, we examined the effect of zinc pyrithione on rat thymocytes suffering from oxidative stress using appropriate fluorescent probes. The cytotoxicity of zinc pyrithione was not observed when the cells were incubated with 3 μM zinc pyrithione for 3 h. However, zinc pyrithione at nanomolar concentrations (10 nM or more) significantly increased the lethality of cells suffering from oxidative stress induced by 3 mM H₂O₂. The application of zinc pyrithione alone at nanomolar concentrations increased intracellular Zn²⁺ level and the cellular content of superoxide anions, and decreased the cellular content of nonprotein thiols. The simultaneous application of nanomolar zinc pyrithione and micromolar H₂O₂ synergistically increased the intracellular Zn²⁺ level. Therefore, zinc pyrithione at nanomolar concentrations may exert severe cytotoxic action on cells simultaneously exposed to chemicals that induce oxidative stress. If so, zinc pyrithione leaked from antifouling materials into surrounding environments would be a risk factor for aquatic ecosystems. Alternatively, zinc pyrithione under conditions of oxidative stress may become more potent antifouling ingredient.     

Ozonation as an advanced oxidant in treatment of bamboo industry wastewater

The present study employed ozonation process to treat the bamboo industry wastewater (BIWW). The impact of ozone dosage and initial organic concentration on color, COD and TOC removal rates were studied along with characterization of the major organics in raw and treated wastewater. The results suggested the ozone dosage of 3.15 g h⁻¹ (concentration 52.5 mg L⁻¹) was suitable for the treatment. After 25 min ozonation of 1 L raw wastewater, the color, COD and TOC removal efficiencies were 95%, 56% and 40%, respectively, with an influent COD concentration of 835 mg L⁻¹. The ratio of kg O₃ kg⁻¹ COD at 3.15 g h⁻¹ was 2.8 (<3), revealing that ozonation was a cost effective process for tertiary treatment of BIWW. Longer oxidization time was required to achieve similar results for raw wastewater with higher COD concentration. The chromatogram from gel permeation chromatography revealed that ozonation resulted in the breakdown of high molecular weight compounds into lower molecular weight components but could not completely mineralize the organic matter. The majority of these compounds were identified in both raw and ozonated samples via GC-MS analysis. In addition to ester derivatives as the main intermediates of ozonation, 1-chloroctadecane, methyl stearate, benzophenone and α-cyperone were identified as the by-products of ozonation.     

Emission characterization of unintentionally produced persistent organic pollutants from iron ore sintering process in China

Emission of unintentionally produced persistent organic pollutants (Unintentional POPs), including polychlorinated dibenzo-p-dioxins (PCDDs), polychlorinated dibenzofurans (PCDFs), polychorinated biphenyls (PCBs), hexachlorobenzene (HxCBz) and pentachlorobenzene (PeCBz), were investigated in four typical iron ore sintering plants in China. The emission factors and annual mass releases of the Unintentional POPs were calculated. The results indicated that PCDFs contributed more than 60% to the overall toxic equivalent quantity (TEQ) values, while the contribution of the dl-PCBs is relatively low, and only in the range of 8-9%. The dominant congeners of PCDD/Fs and dl-PCBs contributing most to the total TEQ were 1,2,3,7,8-PeCDD, 2,3,4,7,8-PeCDF and PCB-126. With regard to the TEQ contributions, the most abundant homologues were PeCDFs and HxCDD/Fs, followed by PeCDDs and non-ortho dl-PCB, whereas HpCDD/Fs, OCDD/Fs and mono-ortho dl-PCBs almost made no contributions. Due to the massive use of recycled waste in the feeding materials, the average emission factor of PCDD/Fs and dl-PCBs of the four plants was 3.95 μg WHO-TEQ ton⁻¹. Based on the results, the annual release of PCDD/Fs and dl-PCBs in 2007-2009 were estimated to be 2070 g, 2212 g, and 2307 g WHO-TEQ, respectively.