集输油环境氟橡胶O形圈老化行为实验研究*

为研究氟橡胶O形圈在集输油环境中的老化行为特征,以长庆油田使用的氟橡胶O形圈(位于非金属复合管连接接头处)为研究对象,采用宏观与微观相结合的方法,通过挂片实验分析氟橡胶O形圈在不同介质（采出油,采出水）、温度（25,50 ℃）、压力条件（0.1,4,6 MPa）下老化后的形貌、质量、拉伸性能及硬度。结果表明:采出油、采出水均能引起O形圈发生溶胀,从而降低O形圈的强度、韧性、硬度;采出水引起的溶胀显著高于采出油更易导致O形圈表面产生坑洞缺陷;渗透速率随温度升高而急剧增加,压力对渗透速率的影响不明显;硬度降低较小,最大降幅为4.17%。结合现场服役813 d的密封圈SEM形貌,证实集输介质渗透会引起氟橡胶圈溶胀、导致表面产生坑洞等缺陷。     

突发性环境污染事故应急监测的措施分析

突发性环境污染事故会对环境造成较大的伤害,如果不能及时采取措施,就会使污染进一步扩大,不仅带来经济的损失,而且会破坏到生态的平衡。因此,要建立起突发环境污染事故的应急监测,这样才能尽可能的减少突发性环境污染事件的影响。基于此,本文从突发性环境污染事故的特征入手,首先分析其应急监测的意义,然后探究具体的措施,希望可以借此给突发性环境污染应急监测的相关研究提供一定的参考意见。     

畜禽环境中抗生素的去除及其风险评估

抗生素作为饲料添加剂广泛应用于畜禽养殖业,造成养殖环境抗生素大量蓄积,尤其是在畜禽粪便中,长期的积累不仅污染养殖场内土壤环境,残留的抗生素还会随畜禽粪便进入周边水体及农田环境,威胁农作物及人体健康。目前,国内相关研究主要集中在抗生素的降解工艺及降解规律方面,而对其去除效率的影响因素及风险评价研究相对较少。笔者综述了国内外抗生素的降解转化及去除方式等的研究进展,并概述了抗生素在畜禽环境中的生态风险评估的研究现状,为抗生素的高效去除、风险预估及畜禽粪便资源化安全利用提供理论基础和技术支撑。     

Annual Nutritional Organ Mass Cycle of <Emphasis Type="Italic">Bufo gargarizans</Emphasis> (Cantor, 1842) in Response to Extreme High Temperature

The annual relative mass of storage organs cycle of Bufo gargarizans in southwestern China was studied from December 2005 to November 2006. We described how those organs changed in response to extreme temperatures. Energy reservation dropped to the lowest levels after dormancy for both sexes, and then increased for period of 4.25 month. However, the mass of these organs dropped again rapidly until August (liver) and September (fat bodies) due to the constraint from extreme high temperature occurred during the summer, and then non-significantly increased before hibernation. For ovaries, varied with a different profile to those of liver and fat bodies have a resting period of four months. In addition, the toads’ ovaries kept growing when the mass of liver and fat bodies declining accordingly during hibernation. Therefore, ovarian mass increased during the hibernation and non-hibernation period.     

Technological innovation paths toward green industry in China

With the environmental carrying capacity reaching its limits and the decreasing margin benefits of traditional production factors, the green transformation and green development through technological innovations has been a major direction for the future development of Chinese industries. However, the characteristics and heterogeneities of various types of industries call for different approaches regarding technological innovations. How to choose the most effective mode of technological innovation according to the characteristics of a certain industry has been a key issue. This paper measures the green total factor productivity of 32 industrial trades using the Slacks Based Measure(SBM)-DDF method. The effects of three innovation modes in the green transformation of industrial industry, including the independent innovation(Ⅱ), the technology introduction(TI), and the government support(GS), are empirically analyzed based on industry heterogeneity. Results indicate that the green total factor productivities of different industries show significant differences if taking into account the energy input and the undesirable output of pollutant emissions. The green total factor productivities of traditional high input,high pollution, and high energy consumption industrial trades were significantly lower than those with obvious green features. The year of 2009 is a leap year for the industrial green transformation in China. For resource-intensive industries, the II and the GS are the important ways to achieve green transformation. For labor-intensive industries, the TI is the best path to achieve green transformation, while for technology-intensive industries, the II is the primary driving force for the promotion of green developments. In addition, the innovation-compensating effect of the current Chinese environmental regulations to the resource-intensive industries has been revealed. Improving the overall scale and the industrial concentration of the industries is also beneficial for the green transformation of the industries.     

生物难降解有机污染物的治理对策

针对废水中难降解化学合成有机污染物的种类和数量不断增加，生物处理出水达标困难的现状，总结了国内外的经验和研究成果，对现有处理装置改造提出了若干建议，并介绍了几种国外废水处理新技术。     

pH对煤泥水絮凝沉降的影响

选择聚合氯化铝(PAC)/阴离子型聚丙烯酰胺(PHP)、氯化钙(CaCl2)/非离子型聚丙烯酰胺(NPAM)组合与NPAM、PHP、两性离子型聚丙烯酰胺(ZPAM)作为絮凝剂,在对道清选煤厂水采筛下原生煤泥和浮选尾矿的煤泥水进行组合药剂絮凝实验的基础上,考察了pH对煤泥水絮凝沉降的影响。实验结果表明,在不同的pH下,煤泥水的絮凝效果不同:在酸性条件下,宜单独使用有机高分子絮凝剂;在中性至碱性条件下,无机凝聚剂和有机絮凝剂联合使用效果较好。     

垃圾炉一次风量对炉床燃烧影响的仿真研究

针对垃圾焚烧炉床层内垃圾燃烧过程复杂性及影响垃圾燃烧效率因素多的问题,运用数值仿真方法对某垃圾焚烧炉床层垃圾燃烧进行了模拟,获得了垃圾质量流失速率、水分蒸发速率、挥发分释放速率、焦炭燃烧速率和烟气的温度;并在50~1 000 Nm3/min范围内改变一次风流量,获得了床层质量流失比值、过剩空气系数和烟气中各组分的质量百分比含量。仿真结果显示,一次风流量取值517.47~6`32.09 Nm3/min时燃烧效率较高;炉排两端区域的一次风流量在50~75 Nm3/min时,可以使垃圾床表面平均温度明显提高,而且还可以提高燃烧效率,同时减少供风总量,节约能源与动力资源。本研究对优化设计垃圾焚烧炉,提高床层内垃圾的燃烧效率有一定参考价值。     

TiO_2光催化对微滤去除腐殖酸的膜污染控制研究

着重研究了不同紫外灯光源和照射时间条件下,TiO_2光催化(PCO)对微滤去除腐殖酸过程中的膜污染控制,并探讨了膜污染的控制机理。研究结果表明,TiO_2光催化能有效提高微滤对腐殖酸的去除,同时降低膜通量的下降,起到有效控制膜污染的作用。进一步的实验分析表明,TiO_2光催化控制膜污染的主要机理在于将腐殖酸降解为易于被TiO_2吸附的小分子量物质,吸附腐殖酸降解产物后的TiO_2聚合颗粒粒径增大,易于在膜表面形成更为松散的沉积层,并使膜污染从以膜孔堵塞和沉积层污染为主转化为以沉积层污染为主的可逆性污染。     

PVA降解菌的复配组合及其紫外诱变处理的研究

对已筛选出的4株PVA降解菌进行不同的组合后测定PVA降解率,发现Z5与Z8菌株混合后在1周内对PVA的去除率达到了所有组合中的最高值52.07%,比单菌株提高了约22%。采用紫外照射的方法对混合菌进行诱变并利用正交实验研究其特性,结果表明,诱变后的混合菌在1周内降解了91.46%的PVA,并且碳源浓度对酶活的影响最为显著。当pH为7,碳源、氮源含量分别为1.5 g/L、0.6 g/L,NaC l浓度为1.5 g/L时,诱变菌株处于最佳生长状态。