Response to lead pollution: mycorrhizal Pinus sylvestris forms the biomineral pyromorphite in roots and needles

Environmental Science and Pollution Research - The development of mycorrhized pine seedlings grown in the presence of lead was assessed in order to investigate how higher plants can tolerate lead...     

The Role of Disaggregation of Asset Values in Flood Loss Estimation: A Comparison of Different Modeling Approaches at the Mulde River,Germany

In loss estimation there is a spatial mismatch of hazard data that are commonly modeled on an explicit raster level and exposure data that are often available only for aggregated administrative units. Usually disaggregation methods that use ancillary information to distribute lumped exposure data in a finer spatial resolution help to bridge this gap. However, the actual influence of different mapping techniques and ancillary data on the final loss estimation has not been analyzed yet. In this paper three methods are applied to disaggregate residential building assets using two kinds of land use/land cover (LULC) data. The resulting disaggregated assets are validated and compared using census data of the residential building number on the community and constituency level. In addition, the disaggregated assets are taken to estimate residential building losses due to the flood in August 2002 in 21 municipalities on the River Mulde in Saxony, Germany. Losses are calculated with the help of four loss models. In general, disaggregation helps to decrease the error variance within the loss estimation. It must, however, be stated that the application of sophisticated disaggregation methods does not lead to significant improvements compared to the straightforward binary method. Therefore more effort should instead be put into the provision of high-resolution LULC data. Finally, the remaining uncertainties in loss estimation are high and demand further improvements in all modeling aspects.     

Erprobung und Erfolgskontrolle eines Phytoremediationsverfahrens zur Sanierung Sprengstoff-kontaminierter Böden

On the area of a former ordnance plant (‘Werk Tanne’, Clausthal-Zellerfeld, Germany), a field experiment for phytoremediation of TNT-contaminated soils has been carried out since May 1999. The concept is based on a stepwise degradation of TNT by white-rot fungi and mycorrhiza within the rhizosphere of site-specific seedlings. An appropiate site with contaminants in the surface-soil was prepared with a large-scale soil grader and subsequently divided into different experimental plots, including an uncontaminated control as well as a contaminated plot without treatment. Planting of the selected trees and shrubs (infected with mycorrhiza during nursery) and inoculation with wood chips (inoculated with white-rot fungi) is followed by a detailed monitoring of the experimental plots (chemical analyses, biotest-battery, ecological field indicators). For the evaluation of the results, multivariate methods are applied.     

Handling the phosphorus paradox in agriculture and natural ecosystems: Scarcity,necessity, and burden of P

This special issue of Ambio compiles a series of contributions made at the 8th International Phosphorus Workshop (IPW8), held in September 2016 in Rostock, Germany. The introducing overview article summarizes major published scientific findings in the time period from IPW7 (2015) until recently, including presentations from IPW8. The P issue was subdivided into four themes along the logical sequence of P utilization in production, environmental, and societal systems: (1) Sufficiency and efficiency of P utilization, especially in animal husbandry and crop production; (2) P recycling: technologies and product applications; (3) P fluxes and cycling in the environment; and (4) P governance. The latter two themes had separate sessions for the first time in the International Phosphorus Workshops series; thus, this overview presents a scene-setting rather than an overview of the latest research for these themes. In summary, this paper details new findings in agricultural and environmental P research, which indicate reduced P inputs, improved management options, and provide translations into governance options for a more sustainable P use.     

Volatile nanoparticle formation and growth within a diluting diesel car exhaust

A major source of particle number emissions is road traffic. However, scientific knowledge concerning secondary particle formation and growth of ultrafine particles within vehicle exhaust plumes is still very limited. Volatile nanoparticle formation and subsequent growth conditions were analyzed here to gain a better understanding of "real-world" dilution conditions. Coupled computational fluid dynamics and aerosol microphysics models together with measured size distributions within the exhaust plume of a diesel car were used. The impact of soot particles on nucleation, acting as a condensational sink, and the possible role of low-volatile organic components in growth were assessed. A prescribed reduction of soot particle emissions by 2 orders of magnitude (to capture the effect of a diesel particle filter) resulted in concentrations of nucleation-mode particles within the exhaust plume that were approximately 1 order of magnitude larger. Simulations for simplified sulfuric acid-water vapor gas-oil containing nucleation-mode particles show that the largest particle growth is located in a recirculation zone in the wake of the car. Growth of particles within the vehicle exhaust plume up to detectable size depends crucially on the relationship between the mass rate of gaseous precursor emissions and rapid dilution. Chassis dynamometer measurements indicate that emissions of possible hydrocarbon precursors are significantly enhanced under high engine load conditions and high engine speed. On the basis of results obtained for a diesel passenger car, the contributions from light diesel vehicles to the observed abundance of measured nucleation-mode particles near busy roads might be attributable to the impact of two different time scales: (1) a short one within the plume, marked by sufficient precursor emissions and rapid dilution; and (2) a second and comparatively long time scale resulting from the mix of different precursor sources and the impact of atmospheric chemistry.     

Partitioning and bioaccumulation of metals from oil sands process affected water in indigenous Parachlorella kessleri

This paper studies the partitioning and bioaccumulation of ten target metals (⁵³Cr, Mn, Co, ⁶⁰Ni, ⁶⁵Cu, ⁶⁶Zn, As, ⁸⁸Sr, ⁹⁵Mo and Ba) from oil sands tailings pond water (TPW) by indigenous Parachlorella kessleri. To determine the role of extracellular and intracellular bioaccumulation in metal removal by P. kessleri, TPW samples taken from two oil sands operators (Syncrude Canada Ltd. and Albian Sands Energy Inc.) were enriched with nutrient supplements.Results indicate that intracellular bioaccumulation played the main role in metal removal from TPW; whereas extracellular bioaccumulation was only observed to some extent for Mn, Co, ⁶⁰Ni, ⁶⁵Cu, ⁸⁸Sr, ⁹⁵Mo and Ba. The FTIR scan and titration of functional groups on the cell surface indicated low metal binding capacity by indigenous P. kessleri. However, it is believed that the dissolved cations and organic ligand content in TPW (such as naphthenic acids) may interfere with metal binding on the cell surface and lower extracellular bioaccumulation. In addition, the total bioaccumulation and bioconcentration factor (BCF) varied during the cultivation period in different growth regimes.     

Mercury levels and trends (1993-2009) in bream (Abramis brama L.) and zebra mussels (Dreissena polymorpha) from German surface waters

Mercury concentrations have been analysed in bream (Abramis brama L.) and zebra mussels (Dreissena polymorpha) collected at 17 freshwater sites in Germany from 1993-2009 and 1994-2009, respectively, within the German Environmental Specimen programme. Mercury concentrations in bream ranged from 21 to 881 ng g⁻¹ wet weight with lowest concentrations found at the reference site Lake Belau and highest in fish from the river Elbe and its tributaries. Statistical analysis revealed site-specific differences and significant decreasing temporal trends in mercury concentrations at most of the sampling sites. The decrease in mercury levels in bream was most pronounced in fish from the river Elbe and its tributary Mulde, while in fish from the river Saale mercury levels increased. Temporal trends seem to level off in recent years. Mercury concentrations in zebra mussels were much lower than those in bream according to their lower trophic position and varied by one order of magnitude from 4.1 to 42 ng g⁻¹ wet weight (33-336 ng g⁻¹ dry weight). For zebra mussels, trend analyses were performed for seven sampling sites at the rivers Saar and Elbe of which three showed significant downward trends. There was a significant correlation of the geometric mean concentrations in bream and zebra mussel over the entire study period at each sampling site (Pearson’s correlation coefficient = 0.892, p = 0.00002). A comparison of the concentrations in bream with the environmental quality standard (EQS) of 20 ng g⁻¹ wet weight set for mercury in biota by the EU showed that not a single result was in compliance with this limit value, not even those from the reference site. Current mercury levels in bream from German rivers exceed the EQS by a factor 4.5-20. Thus, piscivorous top predators are still at risk of secondary poisoning by mercury exposure via the food chain. It was suggested focusing monitoring of mercury in forage fish (trophic level 3 or 4) for compliance checking with the EQS for biota and considering the age dependency of mercury concentrations in fish in the monitoring strategy.