A rapid and efficient determination of natural estrogens in soils by pressurised liquid extraction and gas chromatography-mass spectrometry

We present a new analytical procedure for the extraction and determination of natural estrogens in soils based on pressurised liquid extraction and GC-MS determination. After testing twelve solvents, acetone proved to be the most efficient extractant. The optimum extraction temperature is 60 degrees C. Soil extracts have to be purified and concentrated by C-18 solid phase extraction. The dried extracts are derivatised by N-methyl-N-(trimethylsilyl)trifluoro-acetamide before measurement by GC-MS. Recoveries of 79-103% with relative standard deviations 相似文献   

Effective rates of heavy metal release from alkaline wastes--quantified by column outflow experiments and inverse simulations

Column outflow experiments operated at steady state flow conditions do not allow the identification of rate limited release processes. This requires an alternative experimental methodology. In this study, the aim was to apply such a methodology in order to identify and quantify effective release rates of heavy metals from granular wastes. Column experiments were conducted with demolition waste and municipal waste incineration (MSWI) bottom ash using different flow velocities and multiple flow interruptions. The effluent was analyzed for heavy metals, DOC, electrical conductivity and pH. The breakthrough-curves were inversely modeled with a numerical code based on the advection–dispersion equation with first order mass-transfer and nonlinear interaction terms. Chromium, Copper, Nickel and Arsenic are usually released under non-equilibrium conditions. DOC might play a role as carrier for those trace metals. By inverse simulations, generally good model fits are derived. Although some parameters are correlated and some model deficiencies can be revealed, we are able to deduce physically reasonable release-mass-transfer time scales. Applying forward simulations, the parameter space with equifinal parameter sets was delineated. The results demonstrate that the presented experimental design is capable of identifying and quantifying non-equilibrium conditions. They show also that the possibility of rate limited release must not be neglected in release and transport studies involving inorganic contaminants.     

Effect of host and larval frass volatiles on behavioural response of the old house borer,Hylotrupes bajulus (L.) (Coleoptera: Cerambycidae), in a wind tunnel bioassay

Summary. In a wind tunnel bioassay the effect of three concentrations of natural extracts of (1) Scots pine wood, Pinus sylvestris, and (2) larval frass on the behavioural response of unmated females and males of the old house borer, Hylotrupes bajulus, was tested and compared to the behavioural effects of the male-produced sex pheromone (3R)-3-hydroxy-2-hexanone. The influence on the behaviour of both sexes was found to be equally significant for the two higher concentrated hexane extracts of wood and larval frass. Therefore several synthetic monoterpenes present in the extracts and ethanol were tested at the two higher concentrations (1:100, 1:1000 vol/vol). Among the higher concentrated monoterpenoid hydrocarbons [(+)-α-pinene, (+)-β-pinene, (+)-limonene], only α-pinene increased the activity, orientation towards scent source and interest towards conspecifics. The tests with higher concentrated ethanol and the oxygenated monoterpenes [(-)-verbenone, (-)-trans-pinocarveol, (+)-terpinen-4-ol, (+)-α-terpineol, (-)-myrtenol] revealed that verbenone is the most effective stimulant for the females, followed by trans-pinocarveol, terpinen-4-ol and α-terpineol. For males, terpinen-4-ol was the only mediator significantly inducing attraction and orientation towards the scent source combined with an interest in conspecifics apparent by fighting or courtship behaviour. Males did not respond to verbenone which is a main compound of larval frass. Myrtenol and ethanol were ineffective in both sexes. In fact behavioural observations suggest that the beetles were repelled by the high dose of myrtenol. Using the ten-fold lower dose of the synthetic monoterpenes (1:1000 vol/vol), all semiochemicals except myrtenol lost activity. Myrtenol, however, induced behavioural responses, like increased activity and orientation towards scent source, only at the low concentration. Based on the results, primary attraction of unmated old house borer is probably mediated by monoterpenes of coniferous wood, while secondary attraction to infested wood would occur in response to volatiles of larval frass. Received 5 May 1999; accepted 30 September 1999     

Frost drought in conifers at the alpine timberline: xylem dysfunction and adaptations

Drought stress can cause xylem embolism in trees when the water potential (psi) in the xylem falls below specific vulnerability thresholds. At the alpine timberline, frost drought is known to cause excessive winter embolism unless xylem vulnerability or transpiration is sufficiently reduced to avoid critical psi. We compared annual courses of psi and embolism in Picea abies, Pinus cembra, Pinus mugo, Larix decidua, and Juniperus communis growing at the timberline vs. low altitude. In addition, vulnerability properties and related anatomical parameters as well as wood density (D(t)) and wall reinforcement (wall thickness related to conduit diameter) were studied. This allowed an estimate of stress intensities as well as a detection of adaptations that reduce embolism formation. At the alpine timberline, psi was lowest during winter with corresponding embolism rates of up to 100% in three of the conifers studied. Only Pinus cembra and Larix decidua avoided winter embolism due to moderate psi. Minor embolism was observed at low altitude where the water potentials of all species remained within a narrow range throughout the year. Within species, differences in psi50 (psi at 50% loss of conductivity) at high vs. low altitude were less than 1 MPa. In Picea abies and Pinus cembra, psi50 was more negative at the timberline while, in the other conifer species, psi50 was more negative at low altitude. Juniperus communis exhibited the lowest (-6.4 +/- 0.04 MPa; mean +/- SE) and Pinus mugo the highest psi50 (-3.34 +/- 0.03 MPa). In some cases, D(t) and tracheid wall reinforcement were higher than in previously established relationships of these parameters with psi50, possibly because of mechanical demands associated with the specific growing conditions. Conifers growing at the alpine timberline were exposed to higher drought stress intensities than individuals at low altitude. Frost drought during winter caused high embolism rates which were probably amplified by freeze-thaw stress. Although frost drought had a large effect on plant water transport, adaptations in hydraulic safety and related anatomical parameters were observed in only a few of the conifer species studied.     

Oxy-fuel coal combustion—A review of the current state-of-the-art

Carbon dioxide emissions will continue being a major environmental concern due to the fact that coal will remain a major fossil-fuel energy resource for the next few decades. To meet future targets for the reduction of greenhouse gas (GHG) emissions, capture and storage of CO₂ is required. Carbon capture and storage technologies that are currently the focus of research centres and industry include: pre-combustion capture, post-combustion capture, and oxy-fuel combustion. This review deals with the oxy-fuel coal combustion process, primarily focusing on pulverised coal (PC) combustion, and its related research and development topics. In addition, research results related to oxy-fuel combustion in a circulating fluidised bed (CFB) will be briefly dealt with.During oxy-fuel combustion, a combination of oxygen, with a purity of more than 95 vol.%, and recycled flue gas (RFG) referred to as oxidant is used for combusting the fuel producing a gas consisting of mainly CO₂ and water vapour, which after purification and compression, is ready for storage. The high oxygen demand is supplied by a cryogenic air separation process, which is the only commercially available mature technology. The separation of oxygen from air as well as the purification and liquefaction of the CO₂-enriched flue gas consumes significant auxiliary power. Therefore, the overall net efficiency is expected to be decreased by 8–12% points, corresponding to a 21–35% increase in fuel consumption. Alternatively, ion transport membranes (ITMs) are proposed for oxygen separation, which might be more energy efficient. However, since ITMs are far away from becoming a mature technology, it is widely expected that cryogenic air separation will be the selected technology in the near future. Oxygen combustion is associated with higher temperatures compared with conventional air combustion. Both fuel properties as well as limitations of steam and metal temperatures of the various heat exchanger sections of the boiler require a moderation of the temperatures in the combustion zone and in the heat-transfer sections. This moderation in temperature is accomplished by means of recycled flue gas. The interdependencies between the fuel properties, the amount and temperature of the recycled flue gas, and the resulting oxygen concentration in the combustion atmosphere are reviewed.The different gas atmosphere resulting from oxy-fuel combustion gives rise to various questions related to firing, in particular, with respect to the combustion mechanism, pollutant reduction, the risk of corrosion, and the properties of the fly ash or its resulting deposits. In this review, detailed nitrogen and sulphur chemistry was investigated in a laboratory-scale facility under oxy-fuel combustion conditions. Oxidant staging succeeded in reducing NO formation with effectiveness comparable to that typically observed in conventional air combustion. With regard to sulphur, a considerable increase in the SO₂ concentration was measured, as expected. However, the H₂S concentration in the combustion atmosphere in the near-flame zone increased as well. Further results were obtained in a pilot-scale test facility, whereby acid dew points were measured and deposition probes were exposed to the combustion environment. Slagging, fouling and corrosion issues have so far been addressed via short-term exposure and require further investigation.Modelling of PC combustion processes by computational fluid dynamics (CFD) has become state-of-the-art for conventional air combustion. Nevertheless, the application of these models for oxy-fuel combustion conditions needs adaptation since the combustion chemistry and radiative heat transfer is altered due to the different combustion gas atmosphere.CFB technology can be considered mature for conventional air combustion. In addition to its inherent advantages like good environmental performance and fuel flexibility, it offers the possibility of additional heat exchanger arrangements in the solid recirculation system, i.e. the ability to control combustion temperatures despite relatively low flue gas recycle ratios even when combusting in the presence of high oxygen concentrations.