An approach for domino effect reduction based on optimal layouts

An approach to reduce the probability of producing a domino effect in process industry is developed in this work. It is assumed that optimal layouts should include appropriate analysis to reduce risk during the process design stage. The model developed for this approach combines the estimation of probability of damage due to overpressure, proposed by Mingguang and Juncheng (2008), and escalation threshold values defined by Cozzani, Gubinelli, and Salzano (2006). These equations are combined with other typical layout constraints as well as bounding the probability constraint, which has resulted in a highly non-linear MINLP problem. Solving a case study used by other authors provides evidence for reliability of the developed approach. In this way, layouts are designed to reduce the escalation probability yielding safe distributions.     

Trace analysis of parabens preservatives in drinking water treatment sludge,treated, and mineral water samples

Parabens have been widely used as antimicrobial agents, mainly in food products, pharmaceuticals, and cosmetics. Although they are known as safe preservatives, they also cause some harm to human health, which has been discussed lately. Therefore, the aim of this study was to evaluate the occurrence of nine parabens (including isomers) in mineral and drinking waters, besides in drinking water treatment sludge (DWTS) samples with determination by liquid chromatography tandem mass spectrometry (LC-MS/MS). Both methods solid phase extraction (SPE) and QuEChERS were validated. Calibration curves showed a correlation coefficient of 0.99 for all compounds. LOQ values ranged from 0.04 to 4 μg L^?1 in aqueous matrices and from 5 to 500 ng g^?1 in DWTS. Recoveries between 70 and 115% were reached with RSD below 20% for all compounds in SPE whereas recoveries between 62 and 119% were found with RSD below 20% for almost all compounds in QuEChERS. Matrix effect had low values (<?20%); it was only above 20% for methylparaben in the SPE and for pentylparaben in the QuEChERS. Using a quick and simple extraction procedures with SPE, QuEChERS, and LC-MS/MS analyses, these methods proved to be selective and sensitive. They were successfully applied to real samples (treated water, mineral water, and sludge), and methylparaben was detected at concentration levels below 0.242 μg L^?1 in mineral and treated water samples and 10 ng g^?1 in DWTS samples.     

Factors affecting the quantitative uncertainty of the estimated short-term intake. Part I—Calculation methods

ABSTRACT

The calculation of the combined uncertainty of the international estimated short-term intake (IESTI) of ethephon residues in apples is shown as an example. The ethephon residues in apples were reported by the Joint FAO (Food and Agriculture Organization of the United Nations)/WHO (World Health Organization) Meeting on Pesticide Residues (JMPR). The apple consumption data were taken from the IESTI (international short-term intake) calculation template used by the JMPR. The IESTI was calculated with the currently used method (case 2a) and a proposed one recommended by the EFSA (European Food Safety Authority)/RIVM (Dutch National Institute for Public Health) Scientific Workshop co-sponsored by FAO and WHO. In this example, the ratio of IESTI_proposed/IESTI_current and their combined relative uncertainty are about 2.8, and 1.7, respectively. The larger IESTI and uncertainty obtained with the proposed equation are the consequence of calculation only with the large portion (LP) instead of its combination with unit mass, and the MRL instead of the highest residue (HR). The LP is the major contributor to the combined uncertainty. Both the calculated IESTI and its combined uncertainty depend on the actual food – pesticide residue combination, and should be calculated for each case.     

Cocaine and other illicit drugs in airborne particulates in urban environments: a reflection of social conduct and population size

Levels of cocaine and other psychoactive substances in atmospheric particulate matter (PM) were determined in urban environments representing distinct social behaviours with regard to drug abuse: night-life, university and residential areas. Three cities (with population >1 million and <0.3 million inhabitants) were selected. Mean daily levels of drugs in PM were 11-336 pg/m³ for cocaine, 23-34 pg/m³ for cannabinoids, and 5-90 pg/m³ for heroin. The highest levels were recorded on weekends, with factors with respect to weekdays of 1-3 for cocaine, 1-2 for cannabinoids and 1.1-1.7 for heroin. Higher levels were detected in the night-life areas, pointing towards consumption and trafficking as major emission sources, and possibly ruling out drug manufacture. The similarities in temporal trends at all sites suggested a city-scale transport of psychoactive substances. Correlations were detected between cocaine and amphetamine consumption (r² = 0.98), and between heroin and cannabinoids (r²>0.82).     

Occurrence and distribution of pharmaceuticals in surface water, suspended solids and sediments of the Ebro river basin, Spain

The occurrence of 43 pharmaceuticals belonging to predominant therapeutic classes and their distribution in surface water, suspended solids and sediments has been investigated in the Ebro river basin in the Northeast of Spain. WWTP effluents were found to be a main source of contamination and the spatial distribution was affected by the river flow at the sampling point and corresponding dilution factor, resulting in higher concentrations and higher loads in small tributary rivers than in the Ebro river. The study showed that some compounds are preferentially found bound to suspended solids and not detected in river water. Generally, compounds with basic characteristics (pKa > 7) showed higher tendency to bind to suspended solids. The sediment samples generally presented lower concentrations than suspended solids.     

Chitosan/albumin/CaCO3 as mimics for membrane bioreactor fouling: genesis of structural mineralized-EPS-building blocks and cake layer compressibility

Membrane bioreactor biofouling is usually described as an extracellular matrix in which biopolymers, inorganic salts and active microbes co-exist. For that reason, biomineralization (BM) models can be useful to describe the spatial organization and environmental constraints within the referred scenario. BM arguments were utilized as background in order to (1) evaluate CaCO₃ influence on flux decline; pore blocking and cake layer properties (resistance, permeability and compressibility) in a wide range of Chitosan/Bovine serum albumin (BSA) mixtures during step-pressure runs and, (2) perform membrane autopsies in order to explore the genesis of mineralized extracellular building blocks (MEBB) during cake layer build up. Using low molecular weight chitosan (LC) and BSA, 2 L of 5 LC/BSA mixtures (0.25-1.85 ratio) were pumped to an external ultra filtration (UF) membrane (23.5 cm², hydrophobic, piezoelectric, 100 kDa as molecular weight cut-off). Eight different pressure steps (40 ± 7 to 540 ± 21 kPa) were applied. Each pressure step was held for 900 s. CaCO₃ was added to LC/BSA mixtures at 0.5, 1.5 and 3 mM in order to create MEBB during the filtration tests. Membrane autopsies were performed after the filtration tests using thermo gravimetric, scanning microscopy and specific membrane mass (mg cm⁻²) analyses. Biopolymer-CaCO₃ step-pressure filtration created compressible cake layers (with inner voids). The formation of an internal skeleton of MEBB may contribute to irreversible fouling consolidation. A hypothesis for MEBB genesis and development was set forth.     

Phenol depletion by thermally activated peroxydisulfate at 70°C

The ability of thermal activated peroxydisulfate (PS) of mineralizing phenol at 70 °C from contaminated waters is investigated. Phenol in concentrations of 10⁻⁴ to 5 × 10⁻⁴ M is quantitatively depleted by 5 × 10⁻³ to 10⁻² M activated PS in 15 min of reaction. However, mineralization of the organic carbon is not observed. Instead, an insoluble phenol polymer-type product is formed. A reaction mechanism including the formation of phenoxyl radicals and validated by computer simulations is proposed. High molecular weight phenolic products are formed by phenoxyl radical H-abstraction reactions. This is not the case for the room temperature degradation of phenol by sulfate radicals where sulfate addition to the aromatic ring mainly leads to the generation of hydroxycyclohexadienyl radicals leading to hydroxybenzenes and oxidized open chain products. Therefore, a change in the reaction mechanism is observed with increasing temperature, and thermal activation of PS at 70 °C does not lead to the mineralization of phenol. Thus PS activation at 70 °C may be considered a potential method to reduce the load of phenol in polluted waters by polymerization.     

Assessment of oral bioaccessibility of arsenic in playground soil in Madrid (Spain): a three-method comparison and implications for risk assessment

Three methodologies to assess As bioaccessibility were evaluated using playground soil collected from 16 playgrounds in Madrid, Spain: two (Simplified Bioaccessibility Extraction Test: SBET, and hydrochloric acid-extraction: HCl) assess gastric-only bioaccessibility and the third (Physiologically Based Extraction Test: PBET) evaluates mouth-gastric-intestinal bioaccessibility. Aqua regia-extractable (pseudo total) As contents, which are routinely employed in risk assessments, were used as the reference to establish the following percentages of bioaccessibility: SBET - 63.1; HCl - 51.8; PBET - 41.6, the highest values associated with the gastric-only extractions. For Madrid playground soils - characterised by a very uniform, weakly alkaline pH, and low Fe oxide and organic matter contents - the statistical analysis of the results indicates that, in contrast with other studies, the highest percentage of As in the samples was bound to carbonates and/or present as calcium arsenate. As opposed to the As bound to Fe oxides, this As is readily released in the gastric environment as the carbonate matrix is decomposed and calcium arsenate is dissolved, but some of it is subsequently sequestered in unavailable forms as the pH is raised to 5.5 to mimic intestinal conditions. The HCl extraction can be used as a simple and reliable (i.e. low residual standard error) proxy for the more expensive, time consuming, and error-prone PBET methodology. The HCl method would essentially halve the estimate of carcinogenic risk for children playing in Madrid playground soils, providing a more representative value of associated risk than the pseudo-total concentrations used at present.     

An Observation Method for Analyzing Operators’ Routine Activity in Computerized Control Rooms

An activity analysis method was developed for studying the structure and dynamics of control room operators’ activity during normal operation based on directly observable elements of the operators’ behavior. The method assesses current activity along three dimensions in each 5-min period of the shift. Intensity characterizes arousal level, direction shows whether the activity is directed predominantly at the process control task, at something else, or miscellaneous. Motivation reflects if the activity is driven by intrinsic or extrinsic motivation. A case study is presented, in which 3 morning, 3 afternoon, and 3 night shifts of a Nuclear Power Plant operator crew are involved. The obtained results gave a deeper understanding of the operators’ activity and also revealed an “arousal compensation” tendency.     

Deposition and Retention of Ultrafine Aerosol Particles in the Human Respiratory System. Normal and Pathological Cases

The particle number concentration in ambient air is dominated by nanometersized particles. Recent epidemiological studies report an association between the presence of nanoparticles in inhaled air at the workplace and acute morbidity and even mortality in the elderly. A theoretical model of deposition of 20 nm particles in the human alveolus was formulated. Gas flow structure and deposition rate were calculated for alveoli with different elastic properties of lung tissue. Data obtained in the paper show increased convective effects and diffusional rate of deposition of nanoparticles for alveoli with higher stiffness of the alveolar wall. The retention of deposited particles is also higher in these pathological alveoli. Results of our calculations indicate a possibility of existence of a positive loop of coupling in deposition and retention of nanoparticles in the lung with pathological changes.