Characterization of hard- and softwood biochars pyrolyzed at high temperature

A wide range of waste biomass/waste wood feedstocks abundantly available at mine sites provide the opportunity to produce biochars for cost-effective improvement of mine tailings and contaminated land at metal mines. In the present study, soft- and hardwood biochars derived from pine and jarrah woods at high temperature (700 °C) were characterized for their physiochemical properties including chemical components, electrical conductivity, pH, zeta potential, cation-exchange capacity (CEC), alkalinity, BET surface area and surface morphology. Evaluating and comparing these characteristics with available data from the literature have affirmed the strong dictation of precursor type on the physiochemical properties of the biochars. The pine and jarrah wood feedstocks are mainly different in their proportions of cellulose, hemicellulose and lignin, resulting in biochars with heterogeneous physiochemical properties. The hardwood jarrah biochar exhibits much higher microporosity, alkalinity and electrostatic capacity than the softwood pine. Correlation analysis and principal component analysis also show a good correlation between CEC–BET–alkalinity, and alkalinity–ash content. These comprehensive characterization and analysis results on biochars’ properties from feedstocks of hardwood (from forest land clearance at mine construction) and waste pine wood (from mining operations) will provide a good guide for tailoring biochar functionalities for remediating metal mine tailings. The relatively inert high-temperature biochars can be stored for a long term at mine closure after decades of operations.     

A full-scale sequencing batch reactor system for swine wastewater treatment

A full-scale sequencing batch reactor (SBR) system was evaluated for its ability to remove carbon and nitrogen from swine wastewater. The SBR was operated on four, six-hour cycles each day, with each cycle consisting of 4.5 hours of “React,” 0.75 hours of “Settling”, 0.75 hours for “Draw” and “Fill.” Within each cycle, an amount of wastewater equivalent to about 5% of the reactor volume (5,500 litres) was removed and added. The SBR system was able to remove 82% of biochemical oxygen demand (BOD) and more than 75% of nitrogen. Even though the SBR effluent, with an average effluent BOD₅ of about 588 mg L^{? 1}, did not meet the discharge criteria, it enabled a reduction of the land base required for land application of swine wastewater by about 75%. Results indicated that the SBR system was a viable method for the treatment of swine wastewater.     

Occurrence of alternative flame retardants in indoor dust from New Zealand: indoor sources and human exposure assessment

Due to worldwide restrictions on polybrominated diphenyl ethers (PBDEs), the demand for alternative flame retardants (AFRs), such as organophosphate flame retardants (OPFRs), novel brominated FRs (NBFRs) and hexabromocyclododecanes (HBCDs), has recently increased. Little is known about human exposure to NBFRs and OPFRs and that their levels in dust have been scarcely evaluated worldwide. To increase the knowledge regarding these chemicals, we measured concentrations of five major NBFRs, ten OPFRs and three HBCD isomers in indoor dust from New Zealand homes. Dust samples were taken from living room floors (n=34) and from mattresses of the same houses (n=16). Concentrations (ngg(-1)) of NBFRs were: 1,2-bis(2,4,6-tribromophenoxy)ethane (BTBPE) (<2-175), decabromodiphenyl ethane (DBDPE) (<5-1430), 2-ethylhexyl-2,3,4,5-tetrabromobenzoate (TBB) (<2-2285) and bis(2-ethylhexyl)-3,4,5,6-tetrabromophthalate (TBPH) (<2-640). For OPFRs, concentrations (ngg(-1)) ranged between: tri-ethyl-phosphate (TEP) (<10-235), tri-n-butyl-phosphate (TnBP) (<20-7545), tris-(2-chloroethyl)-phosphate (TCEP) (<20-7605), tris-(1-chloro-2-propyl) phosphate (TCPP) (20-7615), tri-(2-butoxyethyl)-phosphate (TBEP) (50-27325), tris-(2,3-dichloropropyl)-phosphate (TDCPP) (20-16560), tri-phenyl-phosphate (TPhP) (20-35190), and tri-cresyl-phosphate (TCP) (<50-3760). HBCD concentrations fell in the range <2-4100ngg(-1). BTBPE, DBDPE, TBPH, TBEP, and TnBP showed significant positive correlation (p<0.05) between their concentrations in mattresses and the corresponding floor dust (n=16). These data were used to derive a range of plausible exposure scenarios. Although the estimated exposure is well below the corresponding reference doses (RfDs), caution is needed given the likely future increase in use of these FRs and the currently unknown contribution to human exposure by other pathways such as inhalation and diet.     

A real-time,dynamic early-warning model based on uncertainty analysis and risk assessment for sudden water pollution accidents

A real-time, dynamic, early-warning model (EP-risk model) is proposed to cope with sudden water quality pollution accidents affecting downstream areas with raw-water intakes (denoted as EPs). The EP-risk model outputs the risk level of water pollution at the EP by calculating the likelihood of pollution and evaluating the impact of pollution. A generalized form of the EP-risk model for river pollution accidents based on Monte Carlo simulation, the analytic hierarchy process (AHP) method, and the risk matrix method is proposed. The likelihood of water pollution at the EP is calculated by the Monte Carlo method, which is used for uncertainty analysis of pollutants’ transport in rivers. The impact of water pollution at the EP is evaluated by expert knowledge and the results of Monte Carlo simulation based on the analytic hierarchy process. The final risk level of water pollution at the EP is determined by the risk matrix method. A case study of the proposed method is illustrated with a phenol spill accident in China.     

Identifying problems for choosing suitable areas for installation of a new landfill through GIS technology: A case study

Selecting a suitable place to install a new landfill is a hard work. Bauru is a Brazilian municipality where the local landfill currently in use has a life span that is almost over, and the selection of a new area for a future landfill is crucial and urgent. Here we use a geographic information system (GIS) approach to indicate possible suitable areas for installing the landfill. The considered criteria were: river network and the respective buffer zone, relief, urban areas and their respective buffer zone, existence of Areas for Environmental Protection (AEPs), occurrence of wells and their respective buffer zones, existence of airports and their buffer zones, wind direction, and the road network and its respective buffer zone. Due the facts that (1) Bauru has an urban area relatively large in relation to whole municipal area, (2) Bauru has two airports, and (3) this area encompasses parts of three AEPs, the model showed that there are few areas suitable and moderately suitable in Bauru, and the greater part of the municipality is unsuitable to install a new landfill. Due to this important finding reported here, the local policymakers should consider the suitable or even moderately suitable areas for analysis in situ or look for other creative solutions for destination of the solid waste. We highly encourage the use of GIS in studies that seek suitable areas for future landfills, having found that SIG was a tool that allowed fast and precise work and generated an outcome sufficiently clear of interpretation.

Implications:?Solid waste (SW) management is one of the main environmental concerns nowadays. Landfilling SW is still the main practice to disposal of such material. However, for many regions, suitable places for landfilling are getting scarce. This study proved this situation for a populous place in a southeastern Brazilian region. This study also showed how the decision makers should manage the problem in order to minimize the amount of SW generated and delivered for the landfill. Massive investment in education is a critical issue to reach the proposed aim.     

Immersion frying for the thermal drying of sewage sludge: an economic assessment

This paper presents an economic study of a novel thermal fry-drying technology which transforms sewage sludge and recycled cooking oil (RCO) into a solid fuel. The process is shown to have significant potential advantage in terms of capital costs (by factors of several times) and comparable operating costs. Three potential variants of the process have been simulated and costed in terms of both capital and operating requirements for a commercial scale of operation. The differences are in the energy recovery systems, which include a simple condensation of the evaporated water and two different heat pump configurations. Simple condensation provides the simplest process, but the energy efficiency gain of an open heat pump offset this, making it economically somewhat more attractive. In terms of operating costs, current sludge dryers are dominated by maintenance and energy requirements, while for fry-drying these are comparatively small. Fry-drying running costs are dominated by provision of makeup waste oil. Cost reduction could focus on cheaper waste oil, e.g. from grease trap waste.     

The Contribution of Marsh Zones to Water Quality in Dutch Shallow Lakes: A Modeling Study

Many lakes have experienced a transition from a clear into a turbid state without macrophyte growth due to eutrophication. There are several measures by which nitrogen (N) and phosphorus (P) concentrations in the surface water can be reduced. We used the shallow lake model PCLake to evaluate the effects of three measures (reducing external nutrient loading, increasing relative marsh area, and increasing exchange rate between open water and marsh) on water quality improvement. Furthermore, the contribution of different retention processes was calculated. Settling and burial contributed more to nutrient retention than denitrification. The model runs for a typical shallow lake in The Netherlands showed that after increasing relative marsh area to 50%, total phosphorous (TP) concentration in the surface water was lower than the Maximum Admissible Risk (MAR, a Dutch government water quality standard) level, in contrast to total nitrogen (TN) concentration. The MAR levels could also be achieved by reducing N and P load. However, reduction of nutrient concentrations to MAR levels did not result in a clear lake state with submerged vegetation. Only a combination of a more drastic reduction of the present nutrient loading, in combination with a relatively large marsh cover (approximately 50%) would lead to such a clear state. We therefore concluded that littoral marsh areas can make a small but significant contribution to lake recovery.     

Organochlorine contaminants in hair of adolescents from Iassy, Romania

Human hair samples (n=42) from Iassy county (Eastern Romania) collected in 2002-2003 from adolescents were analyzed for hexachlorocyclohexane (HCH) isomers, p,p'-DDT and its metabolites, hexachlorobenzene (HCB), chlordane and metabolites and 5 polychlorinated biphenyl (PCB) congeners. Very low levels were found for HCB and oxychlordane (0.8 and 2.5 ng g(-1)) indicating a low usage of these pesticide formulations in the studied area. In case of HCHs, gamma-HCH isomer was measured at higher median concentrations (79 ng g(-1) hair) compared to the beta-HCH isomer (55 ng g(-1)), which generally is the most prevalent from HCHs. The DDTs profile consisted in p,p'-DDE and p,p'-DDT which levels correspond to 81% of sum DDTs. Very high median concentrations measured for p,p'-DDT (192 ng g(-1)) combined with lower values for p,p'-DDE/p,p'-DDT of 0.4 (from 0.20 to 2.0) in all hair samples suggest recent exposure to "fresh" DDT. When gender was considered, significantly higher concentrations for most of the investigated contaminants were found in girls hair compared to boys. Very high levels were found in the present study for HCHs and DDTs compared to samples from Greece, Western Europe and China. In case of PCBs, the levels found in Romanian samples were found to be in the same range compared to other previously published data.     

Effects of cement flue dusts from a Nigerian cement plant on air, water and planktonic quality

Effects of cement flue dust from Ewekoro cement Kilns were monitored at some aquatic receptor locations. High levels of total suspended particulates (TSPs) and atmospheric deposition rates (ADRs) were recorded within the factory compared to ancillary locations outside the factory. The TSP and ADR levels which were location dependent were significantly higher (P?<?0.05) during the dry periods than in the wet season. Irrespective of seasonal variations, the key elements in the emissions were Ca^2?+? and Fe^2?+?. The concentrations of Zn^2?+?, Mn^2?+? and Pb^?+? which were trace elements were significantly higher (P?<?0.05) in the deposited than in the airborne particulates. The planktonic flora and fauna of the river systems draining the area were poor with 16 phytoplanktonic and nine zooplanktonic species. Numerically, the phytoplanktons were dominated by diatoms (Bacillariophyta) with Synedra sp. being the most abundant species. The zooplanktonic fauna dominated by rotifers had Lecane curvicornis as a regular occurrence in all the three catchment rivers. The physicochemical parameters assayed were significantly higher (P?<?0.05) in the factory effluent discharges than in water samples from each of the catchment rivers. Seasonal variations inclusive, HCO $_{3}^{-}$ , CO $_{3}^{2-}$ , Ca^2?+? and Mg^2?+? constituted the major ionic component of water samples analysed irrespective of location. Alaguntan River which receives effluents directly from the factory had significantly higher levels (P?<?0.05) of the assayed ions than the other two rivers draining the cement factory catchment areas.     

Evaluation of concentration efficiency of the Pseudomonas aeruginosa phage PP7 in various water matrixes by different methods

Enteric viruses monitoring in surface waters requires the concentration of viruses before detection assays. The aim of this study was to evaluate different methods in terms of recovery efficiencies of bacteriophage PP7 of Pseudomonas aeruginosa, measured by real-time PCR, using it as a viral control process in water analysis. Different nucleic acid extraction methods (silica–guanidinium thiocyanate, a commercial kit (Qiagen Viral RNA Kit) and phenol–chloroform with alcohol precipitation) exhibited very low recovery efficiencies (0.08–4.18 %), being the most efficient the commercial kit used for subsequent experiments. To evaluate the efficiency of three concentration methods, PBS (as model for clean water) and water samples from rivers were seeded to reach high (HC, 10⁶ pfu ml^?1) and low concentrations (LC, 10⁴ pfu ml^?1) of PP7. Tangential ultrafiltration proved to be more efficient (50.36?±?12.91, 17.21?±?9.22 and 12.58?±?2.35 % for HC in PBS and two river samples, respectively) than adsorption–elution with negatively charged membranes (1.00?±?1.34, 2.79?±?2.62 and 0.05?±?0.08 % for HC in PBS and two river samples, respectively) and polyethylene glycol precipitation (15.95?±?7.43, 4.01?±?1.12 and 3.91?±?0.54 %, for HC in PBS and two river samples, respectively), being 3.2–50.4 times more efficient than the others for PBS and 2.7–252 times for river samples. Efficiencies also depended on the initial virus concentration and aqueous matrixes composition. In consequence, the incorporation of an internal standard like PP7 along the process is useful as a control of the water concentration procedure, the nucleic acid extraction, the presence of inhibitors and the variability of the recovery among replicas, and for the calculation of the sample limit of detection. Thus, the use of a process control, as presented here, is crucial for the accurate quantification of viral contamination.