Variation of raw wastewater microbiological quality in dry and wet weather conditions

The microbiological quality of urban wastewaters presents important environmental, sanitary, and political challenges. However, the variability of untreated wastewater quality is seldom known when it comes to microbial parameters. This study aims to evaluate the variability of microbiological quality in wastewater influents from different wastewater treatment plants connected to combined and partially separate sewer networks in the Parisian area and to evaluate the impact of this variability on the treatment efficiency and on the accuracy of wastewater effluent monitoring. The densities of fecal indicator bacteria (FIB), Escherichia coli and intestinal enterococci, and their partitioning on settleable particles were analyzed at the inlet of two wastewater treatment plants during dry weather (130 composite samples and 7 days sampled every 2 hours) and storm events (39 composite samples, and 7 rain courses) from 2008 to 2012. The results showed that fecal indicator densities vary according to the network characteristics and according to the meteorological conditions. During storm events, a significant dilution of E. coli and enterococci was observed, as well as a decrease in the settleable fraction of E. coli during the maximal impact of the storm. However, storm events did not significantly impact the regular FIB monitoring. FIB removals by primary and secondary treatment were significantly correlated with FIB densities in influent wastewater; however, meteorological conditions also influenced the removal of FIB.     

Electrostatic Precipitator Performance from the Point of View of Gas Treatment Time

This paper describes a risk assessment methodology for preliminary assessment of municipal sludge incineration. The methodology is a valuable tool in that it can be used for determining the hazard indices of chemical contaminants that might be present in sewage sludge used in incineration. The paper examines source characteristics (i.e., facility design), atmospheric dispersion of emission, and resulting human exposure and risk from sludge incinerators. Seven of the ten organics were screened for furtherinvestigation. An example of the calculations are presented for cadmium.     

Airborne foliar transfer of particular metals in Lactuca sativa L.: translocation,phytotoxicity, and bioaccessibility

The uptake, translocation, and human bioaccessibility of metals originating from atmospheric fine particulate matters (PM) after foliar exposure is not well understood. Lettuce (Lactuca sativa L.) plants were exposed to micronic PbO, CuO, and CdO particulate matters (PMs) by the foliar pathway and mature plants (6 weeks old) were analyzed in terms of: (1) metal accumulation and localization on plant leaf surface, and metal translocation factor (TF) and global enrichment factor (GEF) in the plants; (2) shoot growth, plant dry weight (DW), net photosynthesis (Pn), stomatal conductance (Gs), and fatty acid ratio; (3) metal bioaccessibility in the plants and soil; and (4) the hazard quotient (HQ) associated with consumption of contaminated plants. Substantial levels of metals were observed in the directly exposed edible leaves and newly formed leaves of lettuce, highlighting both the possible metal transfers throughout the plant and the potential for human exposure after plant ingestion. No significant changes were observed in plant biomass after exposure to PbO, CuO, and CdO-PMs. The Gs and fatty acid ratio were increased in leaves after metal exposure. A dilution effect after foliar uptake was suggested which could alleviate metal phytotoxicity to some degree. However, plant shoot growth and Pn were inhibited when the plants are exposed to PbO, and necrosis enriched with Cd was observed on the leaf surface. Gastric bioaccessibility of plant leaves is ranked: Cd?>?Cu?>?Pb. Our results highlight a serious health risk of PbO, CuO, and CdO-PMs associated with consumption of vegetables exposed to these metals, even in newly formed leaves in the case of PbO and CdO exposure. Finally, the study highlights the fate and toxicity of metal rich-PMs, especially in the highly populated urban areas which are increasingly cultivated to promote local food.

     

The role of epicuticular waxes on foliar metal transfer and phytotoxicity in edible vegetables: case of Brassica oleracea species exposed to manufactured particles

Environmental Science and Pollution Research - The rapid industrialization and urbanization of intra- and peri-urban areas at the world scale are responsible for the degradation of the quality of...     

A decision framework for possible remediation of contaminated sediments in the River Kymijoki, Finland

Background, aim, and scope  The paper describes the spatial contamination of the River Kymijoki, South-Eastern Finland, and the coastal region of the Gulf of Finland with PCDD/Fs and mercury. The findings of ecotoxicologial and human health studies are also reported, including environmental and human risk assessments. Sediments from the River Kymijoki, draining into the Gulf of Finland, have been heavily polluted by the pulp and paper industry and by chemical industries. A wood preservative, known as Ky-5, was manufactured in the upper reaches of the river between 1940 and 1984 causing severe pollution of river sediments with polychlorinated dibenzo-p-dioxins (PCDD) and dibenzofurans (PCDF). Moreover, the sediments have been polluted with mercury (Hg) from chlor-alkali production and the use of Hg as a slimicide in pulp and paper manufacturing. Materials and methods  An extensive sediment survey was conducted as well as sediment transport modeling, toxicity screening of sediment invertebrates, and a survey of contaminant bioaccumulation in invertebrates and fish. Studies on human exposure to PCDD/Fs and the possible effects on hypermineralization of teeth as well as an epidemiological study to reveal increased cancer risk were also conducted. An assessment of the ecological and human health risks with a null hypothesis (no remediation) was undertaken. Results  The sediment survey revealed severe contamination of river and coastal sediments with PCDD/Fs and Hg. The total volume of contaminated sediments was estimated to reach 5 × 10⁶ m³ and hot spots with extremely high concentrations (max 292,000 ng g⁻¹ or 1,060 ng I-TEQ g⁻¹ d.w.) were located immediately downstream from the pollution source (approximately 90,000 m³). Sediment contamination was accompanied by changes in benthic assemblages, but direct effects were masked by many factors. The fish showed only slightly elevated PCDD/F levels in muscle, but orders of magnitude higher in the liver compared with reference freshwater sites and the Baltic Sea. The concentrations in human fat did not reveal high human exposure in the Kymijoki area in general and was lower than in sea fishermen. The relative risk for total cancer among farmers was marginally higher (RR = 1.13) among those living close to the river, compared with farmers living further away, and the possibility of increased cancer risk cannot be ruled out. A conservative risk assessment revealed that the present probability of exceeding the WHO upper exposure limit of 4 pg WHO-TEQ kg⁻¹ d⁻¹ for PCDD/Fs and DL-PCBs was 6%. The probability of exceeding the WHO limit value of 0.23 μg kg⁻¹ d⁻¹ for methyl mercury was estimated to be notably higher at 62%. Based on these studies and the estimated risks connected with different remediation techniques a general remediation plan with cost benefit analysis was generated for several sub-regions in the river. Dredging, on-site treatment, and a close disposal of the most contaminated sediments (90,000 m³) was suggested as the first phase of the remediation. The decision regarding the start of remediation will be made during autumn 2008. Conclusions  The sediments in the River Kymijoki are heavily polluted with PCDD/Fs and mercury from earlier chlorophenol, chlor-alkali, and pulp and paper manufacturing. A continuous transport of contaminants is taking place to the Gulf of Finland in the Baltic Sea. The highly increased PCDD/F and Hg levels in river sediments pose an ecotoxicological risk to benthic fauna, to fish-eating predators and probably to human health. The risks posed by mercury exceed those from PCDD/Fs and need to be evaluated for (former) chlor-alkali sites and other mercury releasing industries as one basis for remediation decision making. Recommendations and perspectives  The studies form the basis of a risk management strategy and a plan for possible remediation of contaminated sediments currently under consideration in the Southeast Finland Regional Environment Centre. It is recommended that a detailed restoration plan for the most seriously contaminated areas should be undertaken. Based on current knowledge, the restoration of the whole river is not feasible, considering the current risk caused by the contaminated sediment in the river and the costs of an extensive restoration project. The experiences gained in the present case should be utilized in the evaluation of PCDD/F- and mercury-contaminated sites in other countries. The case demonstrates that the historic reservoirs are of contemporary relevance and should be addressed, e.g., in the national implementation plans of the Stockholm Convention. Electronic supplementary material  The online version of this article (doi:) contains supplementary material, which is available to authorized users.     

Assessment Tools for Urban Catchments: Defining Observable Biological Potential1

Abstract: Urbanization represents a strong and increasingly more prevalent impact on stream quality worldwide. One of the characteristic effects of increased urbanization is a consistent decline in biological stream condition. The characterization of this biological degradation with increasing urbanization presents a number of advantages for the study and management of urban streams and catchments. In this paper, the limitation of biological condition with urbanization, called observed biological potential, is characterized. Using an urban intensity index and a biological index developed specifically for urban systems in the Baltimore, Maryland; Cleveland, Ohio; and San Jose, California regions, two principal techniques were compared (quantile regression and bin regression) to define observed biological potential along urban gradients. Quantile regression was selected as the preferable tool for describing observed biological potential given the consistency with which it can be applied and its statistical efficiency, however, bin quantile regression performed similarly. Having identified a numeric approximation of observed biological potential, two methods for identifying factors related to distance from potential as a way of identifying critical environmental factors affecting biological condition in urban areas were explored. The results of this work can be used for identifying benchmarks for urban stream biological condition, identifying limiting catchment characteristics, and prioritizing urban stream management efforts.     

Anticipatory capacity in response to global change across an extreme elevation gradient in the Ica Basin,Peru

Regional Environmental Change - Mountainous areas with extreme elevation gradients and corresponding ranges of biophysical and socioeconomic conditions are highly vulnerable to global change. We...     

The chemical exploitation of nickel phytoextraction: An environmental, ecologic and economic opportunity for New Caledonia

Herein, we explore the outlines of an innovative method based on the chemical recovery of metal-rich biomass produced in phytoextraction technologies. Taking advantage of the adaptive capacity of some New Caledonian plants to hyperaccumulate Ni²⁺ cations in their aerial parts, this technique is based on the direct use of metals derived from plants as “Lewis acid” catalysts in organic chemistry. Metallic cations contained in New Caledonian nickel hyperaccumulators are recovered through a simple cost-effective process and serve the preparation of heterogeneous catalysts used in synthetic transformations allowing access to molecules with high added-value. The design of all processes is in line with the principles of green chemistry; it is adapted to the new economic constraints; it offers a new relevant outlet for metal-rich biomass; and it represents an alternative to non-renewable mineral materials.