Scandium,yttrium, and lanthanide contents in soil from Serbia and their accumulation in the mushroom Macrolepiota procera (Scop.) Singer

The mobility (fractionation) of rare earth elements (REEs) and their possible impacts on ecosystems are still relatively unknown. Soil samples were collected from two sites in central Serbia, an unpolluted mountain region (site 1) and a forest near a city (site 2). In order to investigate REE fractions (acid-soluble/exchangeable, reducible, oxidizable, and residual) in soils, BCR sequential extraction was performed. Additionally, the content of REEs was also determined in stipes and caps of the mushroom Macrolepiota procera, growing in the observed sites. Sc, Y, and lanthanide contents were determined by inductively coupled plasma mass spectrometry (ICP-MS), and results were subjected to multivariate data analysis. Application of pattern recognition technique revealed the existence of two distinguished clusters belonging to different geographical sites and determined by greater levels of Sc, Y, and lanthanides in Go? soil compared to Trstenik soil. Additionally, PCA analysis showed that REEs in soil were concentrated in two groups: the first consisted of elements belonging to light REEs and the second contained heavy REEs. These results suggest that the distribution of REEs in soils could indicate the geographical origin and type of soil. The bioconcentration factors and translocation factors for each REE were also calculated. This study provides baseline data on the rare earth element levels in the wild edible mushroom M. procera, growing in Serbia. In terms of bioconcentration and bioexclusion concept, Sc, Y, and REEs were bioexcluded in M. procera for both studied sites.

     

Levels and source apportionment of volatile organic compounds in southwestern area of Mexico City

Thirteen volatile organic compounds (VOCs) were quantified at three sites in southwestern Mexico City from July 2000 to February 2001. High concentrations of different VOCs were found at a Gasoline refueling station (GS), a Condominium area (CA), and at the University Center for Atmospheric Sciences (CAS). The most abundant VOCs at CA and CAS were propane, n-butane, toluene, acetylene and pentane. In comparison, at GS the most abundant were toluene, pentane, propane, n-butane, and acetylene. Benzene, a known carcinogenic compound had average levels of 28, 35 and 250 ppbC at CAS, CA, and GS respectively. The main contributing sources of the measured VOCs at CA and CAS were the handling and management of LP (Liquid Propane) gas, vehicle exhaust, asphalt works, and use of solvents. At GS almost all of the VOCs came from vehicle exhaust and fuel evaporation, although components of LP gas were also present. Based on the overall results possible abatement strategies are discussed.     

Biodegradable Polymer Composites as Coating Materials for Granular Fertilizers

The composites consisting of poly(vinyl alcohol), horn meal, rapeseed cake, glycerol and phosphogypsum were proposed for the encapsulation of mineral fertilizers. Poly(vinyl alcohol) was used as a binder. The other components making ca. 70% of the mass of the composites were waste materials or by-products. They contain phosphorus, nitrogen, calcium, potassium and sulphur, which are useful nutrients for plants. The effect of the amount of glycerol and of the composition of the mixture of the fillers on the mechanical, sorption properties, water vapour permeability, solubility in water, dimensional stability of the composite films was studied. The addition of phosphogypsum and increase of the concentration of glycerol in the composites lead to the decrease of the tensile strength, water vapour permeability and to the increase of elongation at break and of the solubility of the composite films in water. The composites prepared were used for encapsulation of fertilizers. It was established that encapsulation resulted in the increase of the time of release of the fertilizers. In addition, encapsulation improved mechanical properties of the fertilizers. The fertilizer granules were coated with composite films and tested in the cultivation of tomato sprouts. They showed considerable positive effect on the development of the roots of the plants.     

Indoor and outdoor concentrations of fine particles, particle-bound PAHs and volatile organic compounds in Kaunas, Lithuania

This complex study presents indoor and outdoor levels of air-borne fine particles, particle-bound PAHs and VOCs at two urban locations in the city of Kaunas, Lithuania, and considers possible sources of pollution. Two sampling campaigns were performed in January-February and March-April 2009. The mean outdoor PM(2.5) concentration at Location 1 in winter was 34.5 ± 15.2 μg m(-3) while in spring it was 24.7 ± 12.2 μg m(-3); at Location 2 the corresponding values were 36.7 ± 21.7 and 22.4 ± 19.4 μg m(-3), respectively. In general there was little difference between the PM concentrations at Locations 1 and 2. PM(2.5) concentrations were lower during the spring sampling campaign. These PM concentrations were similar to those in many other European cities; however, the levels of most PAHs analysed were notably higher. The mean sum PAH concentrations at Locations 1 and 2 in the winter campaign were 75.1 ± 32.7 and 32.7 ± 11.8 ng m(-3), respectively. These differences are greater than expected from the difference in traffic intensity at the two sites, suggesting that there is another significant source of PAH emissions at Location 1 in addition to the traffic. The low observed indoor/outdoor (I/O) ratios indicate that PAH emissions at the locations studied arise primarily from outdoor sources. The buildings at both locations have old windows with wooden frames that are fairly permissive in terms of air circulation. VOC concentrations were mostly low and comparable to those reported from Sweden. The mean outdoor concentrations of VOC's were: 0.7 ± 0.2, 3.0 ± 0.8, 0.5 ± 0.2, 3.5 ± 0.3, and 0.2 ± 0.1 μg m(-3), for benzene, toluene, ethylbenzene, sum of m-, p-, o-xylenes, and naphthalene, respectively. Higher concentrations of VOCs were observed during the winter campaign, possibly due to slower dispersion, slower chemical transformations and/or the lengthy "cold start" period required by vehicles in the wintertime. A trajectory analysis showed that air masses coming from Eastern Europe carried significantly higher levels of PM(2.5) compared to masses from other regions, but the PAHs within the PM(2.5) are of local origin. It has been suggested that street dust, widely used for winter sanding activities in Eastern and Central European countries, may act not only as a source of PM, but also as source of particle-bound PAHs. Other potential sources include vehicle exhaust, domestic heating and long-range transport.     

Impact of municipal solid waste incineration bottom ash on the properties and frost resistance of clay bricks

Journal of Material Cycles and Waste Management - This paper presents an experimental study on the properties, structure and durability (frost resistance: one-side and all-sides freezing and...     

BVOC emissions, photosynthetic characteristics and changes in chloroplast ultrastructure of Platanus orientalis L. exposed to elevated CO2 and high temperature

To investigate the interactive effects of increasing [CO₂] and heat wave occurrence on isoprene (IE) and methanol (ME) emissions, Platanus orientalis was grown for one month in ambient (380 μmol mol⁻¹) or elevated (800 μmol mol⁻¹) [CO₂] and exposed to high temperature (HT) (38 °C/4 h). In pre-existing leaves, IE emissions were always higher but ME emissions lower as compared to newly-emerged leaves. They were both stimulated by HT. Elevated [CO₂] significantly reduced IE in both leaf types, whereas it increased ME in newly-emerged leaves only. In newly-emerged leaves, elevated [CO₂] decreased photosynthesis and altered the chloroplast ultrastructure and membrane integrity. These harmful effects were amplified by HT. HT did not cause any unfavorable effects in pre-existing leaves, which were characterized by inherently higher IE rates. We conclude that: (1) these results further prove the isoprene's putative thermo-protective role of membranes; (2) HT may likely outweigh the inhibitory effects of elevated [CO₂] on IE in the future.     

Application of heterogeneous catalysis to biodiesel synthesis using microalgae oil

• Microalgae oil application for biodiesel synthesis is discussed. • Catalytic effectiveness of ferment preparations and chemical catalyst is disputed. • Application of heterogeneous catalysts for biodiesel synthesis is reviewed. • Possibilities of catalyst regeneration is shown. Recently, there is a growing interest in the use of microalga in various fields. Microalgae have properties such as rapid reproduction and high biomass accumulation, and under certain conditions, some are able to accumulate a large amount of oil. However, microalgae oil often contains more free fatty acids than the vegetable oil and is therefore unsuitable for biodiesel synthesis using alkaline catalysts. For this reason, some authors suggest the application of heterogeneous catalysis. A particular interest in the use of immobilized enzymes has developed. Other solid substances can also be used as heterogeneous catalysts are usually metal oxides, carbonates or zeolites. The use of these catalysts results in simpler biodiesel synthesis, especially purification processes, a cleaner end product and a less polluted environment. The molar ratio of alcohol to oil is lower during enzymatic transesterification, and more than 90% ester yield is obtained using a molar ratio of alcohol to oil of 3:1 to 4.5:1. The alcohols do not have a negative effect on the effectiveness of chemical catalysts, so it is possible to use alcohols in molar ratio from 4:1 to 12:1. The optimal temperature of enzymatic process is 30℃‒50℃. An ester yield of more than 95% was obtained in 12‒48 h. Using chemical catalysts, greater than a 95% yield of esters was obtained at higher temperatures in a shorter time. Material costs of enzymatic catalysis can be reduced by reusing the catalysts directly or after regeneration.     

Toxic atmospheric pollutants from crematoria ovens: characterization,emission factors,and modeling

Environmental Science and Pollution Research - Human remains and corpses’ cremation is an increasing practice worldwide alternative to burials, which have increased their cost and reduced...     

Degradation of bisphenol A by the UV/H2O2 process: a kinetic study

A theoretical and experimental study of bisphenol A (BPA) degradation by the UV/H₂O₂ process in water is presented. The effects of the H₂O₂ concentration and the specific rate of photon emission (E_P,0) on BPA degradation were investigated. A kinetic model derived from a reaction sequence was employed to predict BPA and hydrogen peroxide concentrations over time using an annular photochemical reactor in batch recirculation mode. The local volumetric rate of photon absorption (LVRPA) inside the photoreactor was computed using a Line Source with Parallel Plane emission model (LSPP). From the proposed kinetic model and the experimental data, the second order rate constants of the reactions between hydroxyl radicals and the main reacting species (H₂O₂ and BPA) were estimated applying a nonlinear regression method. A good agreement between the kinetic model and experimental data, for a wide range of operating conditions, was obtained. For BPA, H₂O₂, and TOC concentrations, the calculated root means square errors (RMSE) were 2.3?×?10^??2, 9.8?×?10^??1, and 9.0?×?10^??2 mmol L^??1, respectively. The simplified kinetic model presented in this work can be directly applied to scaling-up and reactor design, since the estimated kinetic constants are independent of the reactor size, shape, and configuration. Further experiments were made by employing low BPA initial concentration (100 μg L^??1) in water and real wastewater. A lower degradation rate of BPA was observed in the real wastewater, although the UV/H₂O₂ process has also been able to completely degrade the target pollutant in less than 1 h.