A new THOR shoulder design: a comparison with volunteers, the Hybrid III, and THOR NT

OBJECTIVE: Since the shoulders are rarely seriously injured in frontal or oblique collisions, they have been given low priority in the development of frontal impact crash test dummies. The shoulder complex geometry and its kinematics are of vital importance for the overall dummy kinematics. The shoulder complex also influences the risk of the safety belt slipping off the shoulder in oblique forward collisions. The first aim of this study was to develop a new 50th percentile male THOR shoulder design, while the second was to compare the new shoulder, mounted on a THOR NT dummy, with volunteer, THOR NT, and Hybrid III range of motion and stiffness data. The third aim was to test the repeatability of the new shoulder during dynamic testing and to see how the design behaves with respect to belt slippage in a 45 degrees far-side collision. METHODS: The new 50th percentile THOR shoulder design was developed with the aid of a shell model of the seated University of Michigan Transportation Research Institute (UMTRI) 50th percentile male with coordinates for joints and bony landmarks (Schneider et al., 1983). The new shoulder design has human-like bony landmarks for the acromion and coracoid processes. The clavicle curvature and length are also made similar to that of a male human, as is the range of motion in the anterior-posterior, superior-inferior, and medial-lateral directions. The new shoulder design was manufactured and tested under the same conditions that T?rnvall et al. (2005b) used to compare the shoulder range of motion for the volunteers, Hybrid III, and THOR Alpha. The new design was also tested in two dynamic test configurations: the first was a 0 degrees full-frontal test and the second was a 45 degrees far-side test. The dummy tests were conducted with an R-16 seat with a three-point belt, the Delta V was 27.0+/-0.5 km/h and the maximum peak acceleration was approximately 14.6+/-0.5 g for each test. RESULTS: A new shoulder design with geometry close to that of humans was developed to be retrofitted to the THOR NT dummy. The results showed that the range of motion for the new shoulder complex during static loading was larger by at least a factor of three, for the maximum load (200 N/arm), than that of either the Hybrid III or the THOR NT; this means it was more similar to the volunteers' range of motion. It was observed that the THOR NT with the new shoulder did not slide out of the shoulder belt during a far-side collision. The performance of the new shoulder was reasonably repeatable and stable during both the static tests and the sled tests. CONCLUSION: A new shoulder for the THOR NT has been designed and developed, and data from static range of motion tests and sled tests indicate that the new shoulder complex has the potential to function in a more human-like manner on the THOR dummy.     

An abbreviated alternatives assessment process for product designers: a children’s furniture manufacturing case study

Alternatives assessment is becoming increasingly popular to evaluate the potential environmental and human health hazards of materials. A three step process was used to identify and evaluate alternative products for a children's furniture manufacturer. An alternatives assessment framework was developed to analyze alternative mattresses. The framework specifically addresses those environmental and safety attributes applicable to the product and the product components in accordance with the product’s intended use. The result of the assessment allowed the manufacturer to select the most environmentally friendly alternative and eliminate polyvinyl chloride from their product.     

Minimizing leakage from a smelter off-gas system by enhanced control

The off-gas handling system is a vital component of a smelter and it is essential that it operates in accordance with environmental regulations. A key feature of the off-gas management system is maintaining a slightly negative system pressure to prevent gas leakage, such as SO₂, out into the work and external environments. To enhance sustainable development, there is also growing interest in capturing and reusing the significant amount of heat and CO₂ contained within off-gas. The potential incorporation of heat and CO₂ recovery systems places importance on enhancing control to minimize the risk of both gas leakage and disturbance of the smelting process. With these requirements in mind, an easily implementable feedforward control enhancement to existing control schemes is proposed to help provide improved performance.     

Activity ratios of 137Cs, 90Sr and 239+240Pu in environmental samples

Both global and Chernobyl fallout have resulted in environmental contamination with radionuclides such as 137Cs, 90Sr and 239+240Pu. In environmental samples, 137Cs and 239+240Pu can be divided into the contributions of either source, if also the isotopes 134Cs and 238Pu are measurable, based on the known isotopic ratios in global and Chernobyl fallout. No analogous method is available for 90Sr. The activity ratios of Sr to Cs and Pu, respectively, are known for the actual fallout mainly from air filter measurements; but due to the high mobility of Sr in the environment, compared to Cs and Pu, these ratios generally do not hold for the inventory many years after deposition. In this paper we suggest a method to identify the mean contributions of global and Chernobyl fallout to total Sr in soil, sediment and cryoconite samples from Alpine and pre-Alpine regions of Austria, based on a statistical evaluation of Sr/Cs/Pu radionuclide activity ratios. Results are given for Sr:Cs, Sr:Pu and Cs:Pu ratios. Comparison with fallout data shows a strong depletion of Sr against Cs and Pu.     

Probabilistic risk assessment for long-range atmospheric transport of radionuclides

A simplified means of probabilistic risk assessment (PRA) for long-range atmospheric transport based on a K-diffusion model is presented. In a case study, model parameters are estimated by comparing with the results of long-range atmospheric dispersion model calculations using one-year numerical weather prediction model data. It is found that the estimated ensemble mean provides a reasonable first approximation to the total dry and wet deposition from the one-year continuous release.     

Natural and man-made organobromine compounds in marine biota from Central Norway

Brominated organic pollutants were found in selected samples of mollusk tissue, fish liver, as well as in the eggs and livers of shag from three sites in Central Norway. More than 80 organobromines were identified owing to the defined isotope ratio acquired by GC/ECNI-MS. However, only a few peaks could be assigned to anthropogenic brominated flame retardants (polybrominated diphenyl ethers). Most of the organobromine compounds detected were unknown or halogenated natural products. The known halogenated natural products MHC-1 and TBA were abundant in all samples and usually between equally abundant, and up to 50 fold more concentrated than the major polybrominated diphenyl ether congener BDE 47. The halogenated natural products BC-2 (2-MeO-BDE 68) and BC-3 (6'-MeO-BDE 47), were on level with BDE 100 which was the second most abundant BDE congener in many samples. The previously identified natural polybrominated hexahydroxanthene derivatives (PBHDs) were detected for the first time in bird eggs. Being major contaminants in bird eggs, PBHDs were only present at low levels in bird liver from nestlings originating from the same clutch. Such differences were detected for several other major contaminants. One unknown tetrabromo compound particularly abundant in mussels from Munkholmen was studied by GC/MS and the molecular ion was detected at m/z 446. The abundance of the most important unknown compounds did not correlate with BDEs and they most likely represent halogenated natural products. This study supports that halogenated natural products have to be treated as serious contaminants of marine coastal waters. Our data suggest that their abundance is highest in habitats along the shoreline. Thorough examination of these compounds in environmental samples is an important task.     

Impact of climate change: an empirical investigation of Malaysian rice production

This paper examines the possible impact of climate change on Malaysian rice production. Using the Ricardian Method and farm household data, we have examined the effects on rice producers focusing on sharecropper adaptations and ecological causes. The principle goal of this research paper is to investigate the impact of climate variables such as temperature, rainfall and precipitation on rice production during main and off seasons, in Kedah, Malaysia. The main purpose of this paper is to examine how climate change affects the net income of paddy farmers in the study area. The statistically significant results show that temperature, rainfall, farm size, educational knowledge, land area and value of labour input have an impact on rice production per hectare revealing potential impacts of climate vulnerability on Malaysian agriculture. The results showed that net revenue increased by Ringgit Malaysia (RM 1= $0.3277) 4.78 per hectare throughout the main seasons as a result of minimal increase in the temperature while there is a decrease of RM 3.02 in the net revenue per hectare during off seasons. During the off season, rainfall increased revenue per hectare by RM 1.32 and during the main season it reduced revenue per hectare by RM 1.01. The evidence from this study may be useful for Malaysian policymakers to facilitate greater preventive measures during the main and off-seasons to counteract climate uncertainty and vulnerability.     

Qualitative and Quantitative Assessment of Hepatitis A Virus in Wastewaters in Tunisia

Hepatitis A causes substantial morbidity in both industrialized and non-industrialized countries and represents an important health problem in several southern Mediterranean countries. The objectives of the study were as follows: (a) to assess the occurrence of hepatitis A virus (HAV) in Tunisia through the monitoring of urban wastewaters collected at wastewater treatment plants (WTPs); (b) to characterize environmental strains; and (c) to estimate the viral load in raw and treated sewages, in order to evaluate the potential impact on superficial waters receiving discharges. A total of 150 raw and treated wastewaters were collected from three WTPs and analyzed by both qualitative (RT-PCR/nested) and quantitative (qRT-PCR) methods. Of these, 100 (66 %) were found to be positive for HAV by the qualitative assay: 68.3 % in influents and 64.7 % in effluents. The vast majority of HAV sequences belonged to sub-genotype IA, with 11 different strains detected found to be identical to clinical strains isolated from Tunisian patients with acute hepatitis. Five unique variants were also detected, not previously reported in clinical cases. Only two IB strains were found, confirming the rarity of this sub-genotype in this country. The results of the present study indicate a wide circulation of the pathogen in the population, most probably in the form of asymptomatic infections, a finding consistent with the classification of the country as having intermediate/high endemicity. Quantitative data showed high viral loads in influents (3.5E+05 genome copies/liter, mean value) as well as effluents (2.5E+05 genome copies/liter, mean value), suggesting that contaminated water could be a critical element in transmission.     

Impact of an Alcohol-Based Hand Sanitizer Intervention on the Spread of Viruses in Homes

The objectives of this study were to determine the movement of a virus throughout a household and the impact of an alcohol-based hand sanitizer (ABHS) on reducing the movement and exposure of the virus to household members. Bacterial virus MS-2 was used as the surrogate for human enteric and respiratory viruses. Seven households with families having at least two children in the age range of 2–18 living in the home were used in this study. The hands of one adult family member were contaminated with 1 × 10⁸. MS-2 bacteriophage in each home. After 8 h, the hands of each family member (10 fingers) and 20 frequently touched fomites were sampled to determine baseline contamination without intervention. Within 8 h, MS-2 was detected on all of the family member’s hands and most of the fomites. The intervention consisted of providing the families in all selected homes with bottles of an ABHS, which were placed in the kitchen, bathrooms, and nurseries. Smaller individual bottles were provided for each family member greater than 12 years old to place in purses, pockets, backpacks, etc. The families were instructed to use the ABHS one time or three times during the day. For one and three uses, a statistically significant reduction of virus on un-inoculated and inoculated hands of ~99 % occurred within 8 h. Similar reductions occurred on fomites throughout the households (97–99 %). These results demonstrate that the use of an ABHS can significantly reduce transfer of a virus to the hands, and to the commonly touched surfaces within the household.