矿山灾害学的研究模式、特征与方法

矿山灾害学主要研究矿山灾害成因动力学、矿山灾害运动学、矿山灾害预测学和矿山灾害防治对策学等 4个内容 ,其研究模型可分为工程技术研究、技术科学研究和基础科学研究三大层次 ,具有学科交叉与综合、生态环境、社会参与、安全教育和工程科学研究五大特征 ,研究方法须以科学的系统论思想为指导 ,采用逻辑辩证与历史唯物相统一法 ,既从微观上研究单一矿山灾种事故的防治技术与方法 ,又从宏观上以不同学科、不同层次、不同方位切入 ,对矿山灾害进行系统的通盘研究 ,与此同时 ,还必须大力开展多层次、多领域、多方位的国际协作与研究。因此 ,矿山灾害学的研究与发展 ,不但拓宽了矿山灾害科学研究的领域 ,而且对现代“灾害学”的建立和发展也具有十分重大的科学价值     

Predictive model for motorcycle accidents at three-legged priority junctions

In conjunction with a nationwide motorcycle safety program, the provision of exclusive motorcycle lanes has been implemented to overcome link-motorcycle accidents along trunk roads in Malaysia. However, not much work has been done to address accidents at junctions involving motorcycles. This article presents the development of predictive model for motorcycle accidents at three-legged major-minor priority junctions of urban roads in Malaysia. The generalized linear modeling technique was used to develop the model. The final model reveals that motorcycle accidents are proportional to the power of traffic flow. An increase in nonmotorcycle and motorcycle flows entering the junctions is associated with an increase in motorcycle accidents. Nonmotorcycle flow on major roads had the highest effect on the probability of motorcycle accidents. Approach speed, lane width, number of lanes, shoulder width, and land use were found to be significant in explaining motorcycle accidents at the three-legged major-minor priority junctions. These findings should enable traffic engineers to specifically design appropriate junction treatment criteria for nonexclusive motorcycle lane facilities.     

水库型饮用水水源地一级保护区隔离防护工程研究

依托于地理信息系统空间数据管理和空间信息分析的功能,利用高分辨率遥感影像研究隔离方案划定的技术流程。该技术流程主要包括收集水源地基础资料、解译高分辨率遥感影像、提取土地覆盖分类信息、建立空间数据库、划定物理隔离和生物隔离的区段。该种技术流程也适用于地形复杂、一级保护区面积较大的地下型水源地。     

旧烟度卡的烟度值R_b与新烟度标准烟度值S_F之间的关系

目前我国已发布实施了一些新烟度排放、测量和仪器标准,并规定烟度符号采用ＳＦ,烟度单位为ＦＳＮ。但由于尚未发布实施新的标准烟度卡,而仍然使用旧的标准烟度卡（烟度值为Ｒｂ）,因此给烟度测量造成了一定的误差。本文论述了旧标准烟度卡烟度值Ｒｂ与新标准烟度值ＳＦ之间的关系     

CeO_2/三维石墨烯催化臭氧氧化降解刚果红

采用原位氧化还原法制备了三维石墨烯负载型CeO_2催化剂(CeO_2/3D GN),采用XRD、FTIR、SEM、比表面积和零电荷点测定等方法对其进行了表征,并考察了CeO_2/3D GN非均相催化臭氧氧化降解水中刚果红染料的影响因素。表征结果显示:CeO_2/3D GN具有相互连通的三维网络结构;CeO_2纳米颗粒均匀地分散在石墨烯片层中;比表面积为190.89 m~2/g;零电荷点pH_(zpc)为7.36。实验结果表明:CeO_2/3D GN非均相催化臭氧氧化体系比单独臭氧氧化体系对刚果红溶液的脱色率提高了60.56百分点;连续5次重复利用CeO_2/3D GN,刚果红溶液脱色率为96.50%~98.00%;在臭氧流量为20 mg/min、催化剂投加量为1.5 g/L、初始溶液pH为7.00的最佳工艺条件下反应15 min,刚果红溶液脱色率可高达94.65%。     

Medium-scale gasification of oil palm empty fruit bunch for power generation

Journal of Material Cycles and Waste Management - This paper focuses on the performance of oil palm empty fruit bunch (EFB) gasification using a medium-scale downdraft gasifier for power...     

双极膜电渗析技术处理稀土钠皂化废水回收液

采用双极膜电渗析（BMED）技术处理稀土钠皂化废水回收液,使回收液中的氯化钠转化为氢氧化钠溶液（简称碱）和盐酸（简称酸）而回用。考察了电流和初始酸碱浓度对膜对电压、回收的酸和碱的浓度、电流效率和能耗的影响。实验结果表明,随电流的增大,膜对电压升高,回收的酸和碱的浓度也明显增加,电流效率和能耗均提高;随初始酸碱浓度的增加,膜对电压、电流效率和能耗均下降,回收的酸和碱的浓度逐渐增加;综合考虑各方面因素并侧重考虑回收的酸和碱的浓度,本实验适宜的工艺条件为：电流25 A、初始酸碱浓度0.3 mol/L。在此条件下反应150 min,回收酸的浓度为1.24 mol/L,回收碱的浓度为1.55 mol/L。     

3M测试片法在膜法水处理技术中的应用

采用3M测试片法测定膜法水处理系统的细菌总数,找出双膜系统的微生物污染环节,并采用正交实验筛选出适宜的杀菌剂种类、杀菌剂加入量和杀菌时间。实验结果表明：3M测试片法的测定结果数据准确可靠,且操作简便,节省时间,可以替代常规的平皿培养法用于评价膜的微生物污染情况;某炼化公司双膜系统的反渗透膜已受到微生物的污染,确定的适宜杀菌条件为杀菌剂Trsea 380、杀菌剂加入量50 mg/L、杀菌时间2.0 h,在此条件下杀菌率可达100%。     

城市污水处理厂除臭生物滤池运行效果及影响因素研究

对山东某城市污水处理厂散发的恶臭气体进行除臭研究,考察了除臭生物滤池的运行效果、工艺影响因素和除臭生物滤池内微生物相特点。结果表明:(1)在进气量为828 m3/h、气体停留时间为30 s、硫化氢和氨进气质量浓度分别为0.5~28.4、0.9~34.3 mg/m3的条件下,稳定运行时,大部分时间硫化氢和氨去除率分别达98%和80%以上,而且除臭生物滤池对于进气负荷具有较强的抗冲击能力。(2)当填料含湿量为43.6%~63.4%时,硫化氢去除率在90%以上;氨去除受填料含湿量的影响较大,填料含湿量越高越利于氨的去除。(3)在处理低浓度含硫化氢和氨的恶臭气体时,生物除臭工程可以在低填料pH(3.0左右)下长期运行,并保持较高的恶臭气体去除率。(4)运行第60天后,当温度为10℃以上时,硫化氢和氨去除率几乎不受影响;第169天后,当温度降至10℃以下时,硫化氢和氨去除率均有一定程度的下降,最低分别为94.6%和79.8%。(5)除臭生物滤池稳定运行时,优势硫氧化菌主要为嗜酸性硫细菌。     

Degradation of rhodamine B by Fe(0)-based Fenton process with H2O2

Degradation of rhodamine B by Fe(0)-based Fenton process with H₂O₂ was investigated. The effects of H₂O₂ dose, Fe(0) dose, initial concentration of rhodamine B and initial pH value on the degradation of rhodamine B were examined. The results showed that the degradation and mineralization of rhodamine B occurred with low dose of H₂O₂ and Fe(0). The intermediates of rhodamine B were analyzed with UV-Vis spectrophotometry and ion chromatography and the mechanism of oxidative degradation of rhodamine B was also discussed. The reactive oxygen species (·OH) produced in Fe(0)-based Fenton process with H₂O₂ is the key to the degradation of rhodamine B by ways of N-de-ethylation, chromophore cleavage, ring-opening and mineralization.