Investigation to meet China II emission legislation for marine diesel engine with diesel methanol compound combustion technology

In order to reduce the pollutant emission and alleviate the pressure of petroleum resources shortage and greenhouse gas emission at the same time, the use of clean and renewable alternative fuel for marine engines is a promising option. In this study, a marine diesel engine, which was modified to run in diesel methanol compound combustion (DMCC) mode, was investigated. After the diesel injection parameters were calibrated, and combined with a sample after-treatment device DOC (diesel oxidation catalyst), the engine could meet the requirements of China II legislation. The overall MSP (methanol substitute percent) reached 54.1%. The value of each pollutant emission was much lower than that in China II emission legislation, and there was almost no methanol and formaldehyde emissions. When methanol was injected into the inlet manifold, the intake air temperature decreased a lot, as well as the exhaust gas temperature, which were beneficial to increase engine thermal efficiency and improve engine room environment. Compared with the engine running in pure diesel mode, when the engine ran in diesel/methanol dual fuel mode, the combustion phase was advanced, and the combustion duration became shorter. Therefore, the engine thermal efficiency increased, and fuel consumption decreased significantly.     

改良黏土对重金属离子的吸附特性及防渗性能

为了评价污泥活性炭(SAC)改良黏土作为垃圾卫生填埋场衬垫防渗材料的可行性,该文通过吸附动力学试验、等温吸附平衡试验、柔性壁渗透试验,分别研究了掺量为0%、1%、3%、5%的SAC改良黏土对Cd(Ⅱ)、Cu(Ⅱ)的吸附特性以及渗透性能。试验结果表明,改良黏土对Cd(Ⅱ)或Cu(Ⅱ)的吸附以30 min内的颗粒表面吸附为主,吸附平衡时间分别为120 min或90 min。改良黏土对Cd(Ⅱ)或Cu(Ⅱ)的吸附符合Langmuir等温吸附模式。随SAC掺量由0%增加至5%,在S/L=120 g/L,Cd(Ⅱ)、Cu(Ⅱ)最大吸附量qm分别增加了25%、47%;当固液比增加到200 g/L,Cd(Ⅱ)、Cu(Ⅱ)最大吸附量qm分别增加了32%、48%。水、垃圾渗滤液2种渗透媒介下SAC改良黏土的渗透系数为1.8×10-9～1.2×10-8cm/s,均<1×10-7cm/s的防渗要求。因此,SAC改良黏土可以作为垃圾填埋场的衬垫防渗材料使用,可以有效阻滞渗滤液中重金属离子的迁移。     

A novel state-of-charge-based method for plug-in hybrid vehicle electric distance analysis validated with actual driving data

Mitigation and Adaptation Strategies for Global Change - Promoting&nbsp;Plug-In Hybrid Vehicles (PHEVs) is viewed as a promising strategy to mitigate the energy consumption and greenhouse gas...     

Well-to-wheels greenhouse gas and air pollutant emissions from battery electric vehicles in China

Mitigation and Adaptation Strategies for Global Change - Electric vehicles (EVs) play a crucial role in addressing climate change and urban air quality concerns. China has emerged as the global...     

Optimal range of plug-in electric vehicles in Beijing and Shanghai

Both China’s national subsidy policies for plug-in electric vehicles (PEVs) purchasers and passenger cars corporate average fuel consumption and new vehicle credit regulation (dual-credit policy) favor long-range 300+ km battery electric vehicles (BEVs) and 80+ km plug-in hybrid electric vehicles (PHEVs). However, these electric vehicles tend to have lower energy efficiency and higher purchase and operation costs. Vehicle with larger batteries can also be less equitable because the subsidies are often provided to more expensive vehicles and wealthier owners. This study takes advantage of a novel dataset of daily driving data from 39,854 conventional gasoline vehicles in Beijing and 4999 PHEVs in Shanghai to determine the optimal range of BEVs and PHEVs within their respective cities. We simulate a model to explore ranges with which PEVs emit less GHGs than that of a baseline hybrid and conventional gasoline vehicle while ensuring that all daily travel demands are met. Our findings indicate that in both cities, the optimal ranges to balance cost and travel demand for BEVs are 350 km or less and for PHEVs are 60 km or less in Beijing and 80 km or less in Shanghai. We also find that to minimize carbon dioxide (CO₂) emissions, the ranges are even lower 10 km in Beijing and 30 km in Shanghai. Our study suggests that instead of encouraging long-range PEVs, governments should subsidize PEV models with shorter ranges. Parallel efforts should also be made to both increase renewable energy over fossil fuels and expand charging facilities. Although individual mobility demand varies, the government could reduce occasional long-distance driving by subsidizing alternative transportation choices. Providing week-long driving trials to consumers before their purchases may help decrease the demand of very long range PEVs by alleviating the range anxiety through a learning process.

     

Effect of TiO2 nanoparticle aggregation on marine microalgae Isochrysis galbana

TiO_2 nanoparticles(NPs) could adversely impact aquatic ecosystems. However, the aggregation of these NPs could attenuate this effect. In this work, the biological effects of TiO_2 NPs on a marine microalgae Isochrysis galbana were investigated. The aggregation kinetics of TiO_2 NPs under different conditions was also investigated to determine and understand these effects. Results showed that, though TiO_2 NPs had no obvious impact on the size and reproducibility of algal cells under testing conditions, they caused a negative effect on algal chlorophyll, which led to a reduction in photosynthesis. Furthermore, fast aggregation of TiO_2 NPs occurred under all conditions, especially at the pH close to the p Hzpc. Increasing ionic strength and NP concentration also enhanced the aggregation rate.The aggregation and the following sedimentation of TiO_2 NPs reduced their adverse effects on I. galbana.     

Effects of Na+ on Cu/SAPO-34 for ammonia selective catalytic reduction

Copper-exchanged chabazite (Cu/CHA) catalysts have been found to be affected by alkali metal and alkaline earth ions. However, the effects of Na⁺ ions on Cu/SAPO-34 for ammonia selective catalytic reduction (NH₃-SCR) are still unclear. In order to investigate the mechanism, five samples with various Na contents were synthesized and characterized. It was observed that the introduced Na⁺ ion-exchanges with H⁺ and Cu^2 + of Cu/SAPO-34. The exchange of H⁺ is easier than that of isolated Cu^2 +. The exchanged Cu^2 + ions aggregate and form “CuAl₂O₄-like” species. The NH₃-SCR activity of Cu/SAPO-34 decreases with increasing Na content, and the loss of isolated Cu^2 + and acid sites is responsible for the activity loss.     

Seasonal variation and size distribution of biogenic secondary organic aerosols at urban and continental background sites of China

Size-resolved biogenic secondary organic aerosols(BSOA) derived from isoprene and monoterpene photooxidation in Qinghai Lake, Tibetan Plateau(a continental background site) and five cities of China were measured using gas chromatography/mass spectrometry(GC/MS). Concentrations of the determined BSOA are higher in the cities than in the background and are also higher in summer than in winter. Moreover, strong positive correlations(R2= 0.44–0.90) between BSOA and sulfate were found at the six sites,suggesting that anthropogenic pollution(i.e., sulfate) could enhance SOA formation,because sulfate provides a surface favorable for acid-catalyzed formation of BSOA. Size distribution measurements showed that most of the determined SOA tracers are enriched in the fine mode( 3.3 μm) except for cis-pinic and cis-pinonic acids, both presented a comparable mass in the fine and coarse( 3.3 μm) modes, respectively. Mass ratio of oxidation products derived from isoprene to those from monoterpene in the five urban regions during summer are much less than those in Qinghai Lake region. In addition, in the five urban regions relative abundances of monoterpene oxidation products to SOA are much higher than those of isoprene. Such phenomena suggest that BSOA derived from monoterpenes are more abundant than those from isoprene in Chinese urban areas.