Estimation of economic costs of particulate air pollution from road transport in China

Valuation of health effects of air pollution is becoming a critical component of the performance of cost–benefit analysis of pollution control measures, which provides a basis for setting priorities for action. Beijing has focused on control of transport emission as vehicular emissions have recently become an important source of air pollution, particularly during Olympic games and Post-games. In this paper, we conducted an estimation of health effects and economic cost caused by road transport-related air pollution using an integrated assessment approach which utilizes air quality model, engineering, epidemiology, and economics. The results show that the total economic cost of health impacts due to air pollution contributed from transport in Beijing during 2004–2008 was 272, 297, 310, 323, 298 million US$ (mean value), respectively. The economic costs of road transport accounted for 0.52, 0.57, 0.60, 0.62, and 0.58% of annual Beijing GDP from 2004 to 2008. Average cost per vehicle and per ton of PM₁₀ emission from road transport can also be estimated as 106 US $/number and 3584 US $ t^?1, respectively. These findings illustrate that the impact of road transport contributed particulate air pollution on human health could be substantial in Beijing, whether in physical and economic terms. Therefore, some control measures to reduce transport emissions could lead to considerable economic benefit.     

Emission factors and particulate matter size distribution of polycyclic aromatic hydrocarbons from residential coal combustions in rural Northern China

Coal consumption is one important contributor to energy production, and is regarded as one of the most important sources of air pollutants that have considerable impacts on human health and climate change. Emissions of polycyclic aromatic hydrocarbons (PAHs) from coal combustion were studied in a typical stove. Emission factors (EFs) of 16 EPA priority PAHs from tested coals ranged from 6.25 ± 1.16 mg kg^?1 (anthracite) to 253 ± 170 mg kg^?1 (bituminous), with NAP and PHE dominated in gaseous and particulate phases, respectively. Size distributions of particulate phase PAHs from tested coals showed that they were mostly associated with particulate matter (PM) with size either between 0.7 and 2.1 μm or less than 0.4 μm (PM_0.4). In the latter category, not only were more PAHs present in PM_0.4, but also contained higher fractions of high molecular weight PAHs. Generally, there were more than 89% of total particulate phase PAHs associated with PM_2.5. Gas-particle partitioning of freshly emitted PAHs from residential coal combustions were thought to be mainly controlled by absorption rather than adsorption, which is similar to those from other sources. Besides, the influence of fuel properties and combustion conditions was further investigated by using stepwise regression analysis, which indicated that almost 57 ± 10% of total variations in PAH EFs can be accounted for by moisture and volatile matter content of coal in residential combustion.     

3种大型海藻对含铅废水的生物吸附研究

运用批吸附技术研究了海带、裙带菜和条斑紫菜对水溶液中Pb2+的吸附特性。结果表明:pH是影响生物吸附的重要因素,海带和裙带菜吸附Pb2+的适宜pH在3~5之间,紫菜吸附Pb2+的最佳pH为4;在20~40℃范围内,3种海藻对Pb2+的生物吸附非常快,40 min达到吸附平衡,动力学数据符合准二级动力学模型;Langmuir和Freundlich模型成功地拟合了平衡数据。热力学分析表明吸附能够自发进行。红外光谱分析表明,羧基是海带和裙带菜吸附Pb2+的主要官能团。实验结果表明,用这3种海藻吸附剂对水溶液中Pb2+具有较好的吸附性能,海带和裙带菜的吸附容量相近,优于紫菜。     

非活体生物质对水中活性艳红X-3B的吸附研究

研究了4种非活体生物质(米酒糟、花生壳、柚子皮、稻草秸秆)对模拟废水中活性艳红X-3B的吸附条件及吸附机理。结果表明,活性艳红X-3B初始浓度为100 mg/L、pH为1.0~2.0、吸附剂浓度为10 mg/L时,4种吸附剂对活性艳红X-3B的吸附率可达到80%。吸附在60 min左右达平衡后最大吸附量的顺序为:米酒糟(58.8 mg/g)花生壳(28.0mg/g)柚子皮(23.6 mg/g)稻草秸秆(19.5 mg/g)。在达最大吸附率时,米酒糟的用量可减少一半、pH范围可宽为1.0~6.0,且吸附量是另三者的2倍以上。综合比较,米酒糟具有较强的吸附废水中活性艳红X-3B的能力,可作为废水中活性染料的吸附剂使用。而花生壳、柚子皮和稻草秸秆的吸附能力相对较弱,不是理想的吸附材料。数学模型模拟表明,米酒糟和柚子皮的吸附过程更符合Freundlich方程,而花生壳和稻草秸秆更符合Langmuir方程;动力学研究表明4种吸附剂的吸附拟合更符合拟二级动力学方程。     

厌氧颗粒污泥藻酸盐对铜离子的吸附研究

从厌氧颗粒污泥中成功提取出细菌藻酸盐并制备成藻酸钙吸附剂,研究其对水中Cu~(2+)的吸附性能。实验结果表明,接触时间、Cu~(2+)初始浓度和溶液初始pH是影响Cu~(2+)吸附性能的重要因素。吸附等温线研究表明,Langmuir模型比Freundlich模型能更好地描述吸附过程。Cu~(2+)在藻酸钙上的吸附动力学过程可以很好地用Pseudo二级动力学方程来描述。以100 mmol/L HCI为解吸剂,可有效洗脱藻酸钙上95%的Cu~(2+),实现Cu~(2+)的回收。     

二氧化碳水合物储气特性的实验研究

利用二氧化碳水合物小型实验装置分别在恒容和恒压条件下,研究了机械搅拌对二氧化碳气体溶解的影响以及温度与水-气比对二氧化碳水合物形成和储气密度的影响。通过实验结果发现,机械搅拌对二氧化碳的溶解有非常明显的促进作用,可以在3 min内完成溶解过程,促进溶解作用好于添加剂SDS。研究还发现,反应温度越低,二氧化碳水合物的生成速率越快,总的储气量越大,而水-气比越大,储气密度越小。在实验压力3 MPa、反应温度273.55 K的条件下,1体积的水生成水合物后可储存157体积的二氧化碳。     

Emission of volatile organic sulfur compounds (VOSCs) during aerobic decomposition of food wastes

Food wastes collected from typical urban residential communities were investigated for the emission of volatile organic sulfur compounds (VOSCs) during laboratory-controlled aerobic decomposition in an incubator for a period of 41 days. Emission of VOSCs from the food wastes totaled 409.9 mg kg^?1 (dry weight), and dimethyl disulfide (DMDS), dimethyl sulfide (DMS), methyl 2-propenyl disulfide, carbonyl sulfide and methyl 1-propenyl sulfide were the five most abundant VOSCs, with shares of 75.5%, 13.5%, 4.8%, 2.2% and 1.3% in total 15 VOSCs released, respectively. The emission fluxes of major VOSCs were very low at the beginning (day 0). They peaked at days 2–4 and then decreased sharply until they leveled off after 10 days of incubation. For most VOSCs, over 95% of their emission occurred in the first 10 days. The time series of VOSC emission fluxes, as well as their significant correlation with internal food waste temperature (p < 0.05) during incubation, suggested that production of VOSC species was induced mainly by microbial activities during the aerobic decomposition instead of as inherited. Released VOSCs accounted for 5.3% of sulfur content in the food wastes, implying that during aerobic decomposition considerable portion of sulfur in food wastes would be released into the atmosphere as VOSCs, primarily as DMDS, which is very short-lived in the atmosphere and thus usually less considered in the sources and sinks of reduced sulfur gases.     

O3/BAF工艺系统中有机物生物降解数学模型

研究臭氧预氧化/曝气生物滤池（O₃/BAF）联合工艺深度处理实际城市污水二级出水过程中,后续BAF系统中有机物的生物降解数学模型。以有机底物浓度、填料层高度两个基本变量为控制条件,研究BAF的总体运行常数和填料特性常数,得出BAF有机物生物降解动力学方程为S_e/S₀=exp(－Kh/qSⁿ₀)。出水与进水COD浓度比值（S_e/S₀）的对数与反应器填料高度（h）之间可表达成一次函数关系。在不同的进水浓度（S₀）下,根据ln（S_e/S₀）~h和关系式m=K/qSⁿ₀,得到方程ln(q_m)=－nln(S₀)+lnK。BAF总体运行常数K和填料特性常数n分别为1.708和0.5063。该模型对BAF工艺有如下指导意义：可以根据设计流量、进水有机物浓度和出水浓度,初步确定BAF的尺寸（如横截面积、高度等）。     

异波折板水解酸化-A~2O一体化反应器实验研究

设计了异波折板水解酸化-A2O一体化反应器,进行生活污水处理的实验研究。10个月的实验结果表明,系统的最佳水力停留时间(HRT)为8 h时,最适COD进水浓度为240~600 mg/L,最佳混合液回流比(r)-污泥回流比(R)为250%~100%。控制反应器于以上运行参数下,25±2℃所对应的COD、TN和TP去除率分别为96.84%、67.55%和81.92%。当温度降至7℃时,其COD、TP和TN分别降至86.35%、50.25%和65.68%。基于实验分析结果,阐明了一体化反应器高效性的机理在于异波折板水解酸化段具有高效传质特性和A2O段具有复合式活性污泥-接触氧化好氧池的特点。     

壳聚糖改性粘土对高藻水中藻类的絮凝去除

对壳聚糖改性粘土用于天然高藻水中藻类的絮凝去除进行了研究。实验表明,经壳聚糖改性后的粘土对高藻水中藻细胞有较好的去除效果。粘土的种类对除藻效果有一定影响,其中以高粘凹凸棒石为最佳,其最佳投加量为66mg/L(壳聚糖6 mg/L),此时的叶绿素去除率达到95.45%。相比单独投加壳聚糖,粘土的加入增加了絮体密实度,减少了絮体体积,并使絮体分布更均匀。粘土的粒径对絮凝效果基本没有影响,粒径范围在25～74μm时,改性粘土对藻细胞的凝聚效果是一致的。经壳聚糖改性的粘土在酸性条件下絮凝效果较好,当pH值大于7时,其絮凝能力迅速下降。