基于生态安全的DAT-IAT城市污水处理工艺改进研究

通过正交试验,得到了DAT-IAT工艺和A/DAT-IAT工艺处理城市污水的常规指标去除和生态毒理指标削减的最优运行条件。结果表明,在正交试验的同一工艺中,COD去除最优运行条件的出水COD值优于生态毒性削减最优运行条件的出水COD值,但前者出水的生态毒性较大。由于厌氧池的水解酸化作用,A/DAT-IAT工艺对COD和生态毒性的处理效果均优于DAT-IAT工艺,并且回流总能耗低于DAT-IAT工艺,但是出水COD仍不达标。为了降低进入工艺的COD的总量,以絮凝沉淀做为预处理工艺,并采用Al残留量最小的絮凝剂投药量以降低出水中残留Al带来的生态风险。结果表明,在COD去除最优运行条件下,具有絮凝预处理的工艺对COD的去除效果优于没有絮凝预处理的工艺。絮凝-A/DAT-IAT工艺在COD去除最优运行条件下出水COD为104.46 mg/L,满足排放标准。在毒性削减最优运行条件下,具有絮凝预处理的工艺的出水生态毒性有所上升,但是污染物的总量得到了大幅削减。絮凝-A/DAT-IAT工艺与DAT-IAT工艺相比,在污染物去除效率得到大幅增加的同时,生态毒性得到有效控制,生态安全得到了有效的保障。     

热化学洗涤－超声波分离技术处理油田含油污泥

为解决大量堆存的含油污泥所造成的环保隐患问题,长庆油田建设了含油污泥处理站。采用"热化学洗涤-超声波分离"工艺对含油污泥进行处理。含油污泥的含油率从处理前的48.9%降到处理后2.0%,除油率达到95.9%,除油效果较好。     

基于道化法(DOW)的计算机辅助软件开发

传统的评价方法费时费力,效率低下.将计算机技术与评价方法相结合是评价工作发展的趋势.介绍了为世界各国石油化工企业所广为接受的美国道化学公司(DOW)火灾、爆炸危险性指数评价法,以及根据该法的评价思路所开发的辅助软件的设计思路和功能.     

大气气溶胶酸度和酸化缓冲能力研究

为了掌握大气气溶胶与酸性降水的关系 ,分析和研究了中国北方和南方不同观测点可吸入颗粒物 (PM10 )的酸度 ,并利用微量酸碱滴定的方法测定了其酸化缓冲能力。结果表明大气气溶胶具有一定的酸度 ,同时对酸化的缓冲能力非常低 ,甚至可以促进降水的酸化 ,这种污染特征也是上述观测点发生酸性降水的重要原因之一。     

Spatial and temporal distribution of polycyclic aromatic hydrocarbons (PAHs) in sediments of the Nansi Lake, China

Polycyclic aromatic hydrocarbons (PAHs) were measured in surface sediments and dated core sediments from the Nansi Lake of China to investigate the spatial and temporal distribution characteristics. The concentrations of 16 kinds priority PAH compounds were determined by GC-MS method. And ²¹⁰Pb isotope dating method was used to determine the chronological age of the sediment as well as the deposition rate. The results indicated that the total PAHs concentration ranges in surface and core sediment samples were 160 ~32,600 and 137 ~ 693 ng/g (dry wt.), respectively. The sediment rate and the average mass sedimentation were calculated to be 0.330 cm·year^???1 and 0.237 g·cm^???2·yr^???1 and the sediment time of the collected core sample ranged from 1899 to 2000. The peak of PAH concentrations came at recent years. The source analysis showed PAHs mainly came from the contamination of low temperature pyrogenic processes, such as coal combustion. The PAHs concentrations were lower than ERL and LEL values for most collected samples. However, in several surface sediment samples especially in estuary sites, the PAHs concentrations were not only higher than ERL and LEL values, but also higher than ERM values.     

Using FeGAC/H2O2 process for landfill leachate treatment

Due to the growing concern of highly contaminated landfill leachate problems in Taiwan, an innovative advanced catalytic oxidation (FeGAC/H(2)O(2)) process was developed and employed in this research to treat the landfill leachate from central Taiwan. Experimental results indicated that the FeGAC/H(2)O(2) process could effectively remove organic compounds from landfill leachate. The presence of iron oxide coated granular activated carbon (FeGAC) greatly improved the oxidative ability of H(2)O(2) for the removal of humic acids, fulvic acids and non-humic substance from leachate. For instance, at pH 6, the removal efficiencies of FeGAC/H(2)O(2) and H(2)O(2) processes were 70% and 8%, respectively. FeGAC/H(2)O(2) combined both advantages of FeGAC and H(2)O(2) where FeGAC had good organics adsorption ability and could effectively catalyse the hydrogen peroxide oxidation reaction for organics removal.     

Development of a test method against hot alkaline chemical splashes.

High temperature alkaline chemical liquids have caused injuries and hazardous situations in Finnish pulp manufacturing mills. There are no requirements and/or test method standards concerning protection against high temperature alkaline chemical splashes. This paper describes the test method development process to test and identify materials appropriate for hot liquid chemical hazard protection. In the first phase, the liquid was spilled through a stainless steel funnel and the protection performance was evaluated using a polyvinyl chloride (PVC) film under the test material. After several tentative improvements, a graphite crucible was used for heating and spilling the chemical, and a copper-coated K-type thermometer with 4 independent measuring areas was designed to measure the temperature under the material samples. The thermometer was designed to respond quickly so that peak temperatures could be measured. The main problem was to keep the spilled amount of chemical constant, which unfortunately resulted in significant variability in data.     

北京核与辐射恐怖事件风险分析

采用风险分类-要素分析-风险排序的思路,对北京市核与辐射恐怖事件风险进行分析。根据国际上1998—2006年该类恐怖事件的实例,从事件所涉及的材料、场所角度将核与辐射恐怖事件分为6大类。结合北京市的实际情况进行涉核恐怖事件的要素分析,将北京市各类场所划分为4类敏感区并与5类涉核恐怖事件结合起来,得到北京市核与辐射恐怖事件风险构成图。通过风险分析,笔者认为北京市发生核与辐射恐怖事件风险最大的场所为核研究机构,最容易发生的核与辐射恐怖事件类型为涉及放射源的恐怖事件,结合分析结果对从阻止、探测、响应3个层次上提出了奥运核安保工作的反核恐工作建议。