Hazardous substances in indoor dust emitted from waste TV recycling facility

Various hazardous substances contained in waste TV sets might be released into environment via dust during recycling activities. Two brominated flame retardants (BFRs), polybrominated diphenyl ethers (PBDEs), and tetrabromobisphenol A (TBBPA), and five kinds of heavy metals (Cu, Pb, Cd, Cr, and Ni) were detected in indoor dust collected from two workshops (TV dismantling workshop and subsequent recycling workshop). PBDEs concentrations in dust from waste wires recycling line (722,000 ng/g) were the highest among the studied sites, followed by those in manual dismantling–sorting line (117,000 ng/g), whereas TBBPA concentrations were the highest in manual dismantling–sorting line (557 ng/g) and printed circuit board (PCB) recycling line (428 ng/g). For heavy metals, Cu and Pb were the most enriched metals in all dust samples. The highest concentration of Pb (22,900 mg/kg) was found in TV dismantling workshop-floor dust. Meanwhile, Cu was the predominant metal in dust from the PCB recycling line, especially in dust collected from electrostatic separation area (42,700 mg/kg). Occupational exposure assessment results showed that workers were the most exposed to BDE-209 among the four PBDE congeners (BDE-47, BDE-99, BDE-153, and BDE-209) in both workshops. The hazard quotient (HQ) indicated that noncancerous effects were unlikely for both BFRs and heavy metals (HQ?<?1), and carcinogenic risks for Cd, Cr, and Ni (risk?<?10^?6) on workers in two workshops were relatively low.     

Composting of waste algae: A review

Although composting has been successfully used at pilot scale to manage waste algae removed from eutrophied water environments and the compost product applied as a fertiliser, clear guidelines are not available for full scale algae composting. The review reports on the application of composting to stabilize waste algae, which to date has mainly been macro-algae, and identifies the peculiarities of algae as a composting feedstock, these being: relatively low carbon to nitrogen (C/N) ratio, which can result in nitrogen loss as NH₃ and even N₂O; high moisture content and low porosity, which together make aeration challenging; potentially high salinity, which can have adverse consequence for composting; and potentially have high metals and toxin content, which can affect application of the product as a fertiliser. To overcome the challenges that these peculiarities impose co-compost materials can be employed.     

甲苯对UASB反应器中溶解性微生物产物的影响

以乙酸钠为外加碳源,考察了UASB反应器内甲苯对可溶性微生物产物（SMP）的影响。实验结果表明：低质量浓度（20~70 mg/L）的甲苯对微生物有刺激作用,使得污泥增殖速率变小,SMP的质量浓度也逐渐减少,经过一段时间的驯化后,系统COD和TOC的去除率分别达到93%和94%以上,下降趋势较小;较高质量浓度（70~200 mg/L）的甲苯对微生物有抑制作用,污泥活性下降,反应器运行状况开始恶化,SMP的质量浓度也逐渐增大,经过一段时间的驯化后,系统COD和TOC的去除率分别维持在81%和83%以上;当甲苯质量浓度超过200 mg/L时,表现为污泥活性严重下降,对COD的去除效果极差。     

共代谢膜生物反应器法处理二甲基亚砜废水

采用蔗糖作为共代谢基质与一体式好氧膜生物反应器（MBR）工艺相结合处理二甲基亚砜（DMSO）废水。考察了装置的污泥驯化效果、DMSO去除率、污泥的性能、HRT和冲击负荷对DMSO去除率的影响。试验结果表明：驯化第29天,DMSO去除率达98.5%,表明MBR内的污泥已驯化成功;在MBR运行的正式期,当DMSO处于高负荷状态时,DMSO去除率较低;随蔗糖加入量的增加,DMSO去除率逐渐提高,最终恢复到DMSO高负荷冲击前的DMSO去除效果;正常运行时,装置进水ρ（DMSO）=257~1 448 mg/L（平均值为718 mg/L）、出水ρ（DMSO）=6~22 mg/L（平均值为7 mg/L）,DMSO去除率为96.4%~99.6%（平均值为98.9%）;在MBR运行的正式期,污泥体积指数小于100 mL/g,表明污泥的沉降性能较好,MLVSS/MLSS较高,表明污泥的活性高,MBR内MLSS的平均值为5.52 g/L,MLVSS的平均值为4.78 g/L;MBR适宜的HRT为12 h。     

镍基催化剂对污泥微波热解制生物气效能的影响

为实现污水污泥减量化、无害化及资源化的目标,在微波热解污水污泥基础上,进行了镍基催化剂对制取生物气效能影响的研究。采用元素分析对污泥元素进行检测,气/质联用分析(GC-MS)和气相色谱(GC)对热解生物气的组成和含量进行测定。实验结果表明,镍基催化剂的添加对微波热解污水污泥制取生物气有较大促进作用。5%添加量与800℃热解终温条件下具有最佳催化效果:生物气中H2、CO产量最大,H2产量由29 g/kg增加到35.8 g/kg,提升23.4%,CO产量由302.7 g/kg增加到383.3 g/kg,提升26.6%;同时催化剂还能提高热能利用效率,降低热解终温,即5%添加量在700℃热解终温时可达到空白800℃时的产气效果;镍基催化剂主要在500~600℃时发挥催化作用,加快了H2和CO的释放。微波热解污泥制取的生物气具有产量大、富含H2与CO等优点,可推动污水污泥的资源化进程。     

突变灰盖鬼伞过氧化物酶降解刚果红的响应面法优化分析简

酶法降解偶氮染料刚果红是一个复杂的过程,受温度、pH、酶量、刚果红浓度和双氧水浓度显著影响。为研究各因素及因素间交互作用对刚果红降解影响,提高刚果红的降解率,分别使用单因素法和响应面分析法对刚果红降解条件进行了优化。单因素实验结果显示灰盖鬼伞过氧化物酶降解刚果红的最适条件为：pH 5.0、32℃、酶量4.98 U、双氧水0.1 mmol/L、刚果红20 mg/L,此时刚果红最高降解率为34.84%。然后选双氧水浓度、刚果红浓度和灰盖鬼伞过氧化物酶量作为3个因素,通过中心组合设计实验,用响应面法对刚果红降解进行优化分析,最后得到一个拟合度良好的二次多项方程模型（R²=0.9900）。方差分析结果显示,刚果红浓度和酶量是影响最显著的因素,双氧水与酶以及染料与酶之间的交互作用极显著。响应面分析优化后的反应体系为：双氧水浓度0.15 mmol/L,刚果红浓度为27.21 mg/L,酶为2.0 7 U,在此条件下,刚果红降解率达58.13%。     

接种微生物与人粪便同步连续投加对好氧堆肥效果的影响简

利用新型梨形筒式好氧堆肥反应器,在通风量为3.0 L/min,搅拌频率为5 min/h的条件下,就不接种微生物、接种土著菌种、枯草芽孢杆菌与酵母菌时人粪便连续投加好氧堆肥效果进行了对比。堆制20 d即2个运行周期中各堆体的温度、含水率、COD、总氮、pH值与GI等的变化表明,接种微生物可以显著提高堆体的升温速率与堆体平均温度、COD降解率、GI（P<0.01）,堆肥可迅速达到完全腐熟。接种土著菌种效果最为明显（P<0.01）,其后相继为枯草芽孢杆菌与酵母菌。接种土著菌种可使堆体温度在50℃以上维持18 d,第8天COD降解率达到61.17%、总氮损失率为25.75%,第6天时GI达到108.22%。     

初级基质对降解菌Pseudomonas putida共代谢苯扎贝特的影响

通过对3,5-二硝基水杨酸(DNS)法测定还原糖含量各影响因素的筛选,优化确定了显色时间8 min,稳定时间10 min,最佳波长490 nm下进行吸光度测定的检测方法;分析分别以葡萄糖和麦芽糖作为外加碳源时,降解菌Pseudomonas putida B-31的生长情况和共代谢降解典型药物苯扎贝特(BZF)的过程。结果表明,降解菌只有在外加碳源的条件下才可正常生长,而且其在葡萄糖环境中生长得更好;拟合得到的葡萄糖、麦芽糖和BZF代谢动力学结果显示,葡萄糖对BZF去除的促进作用更为明显,同时从葡萄糖培养基中降解菌所提取的酶比活力要高于麦芽糖培养基,分析原因可能是葡萄糖所诱导的降解菌关键酶活力更强,而且还可能会产生不同的蛋白质点位。     

石英砂滤料表面润湿改性

采用硅烷偶联剂、钛酸酯偶联剂和铝酸酯偶联剂对石英砂进行表面改性,以制备亲油疏水性滤料。研究得出,钛酸酯偶联剂改性石英砂的最佳工艺条件为:偶联剂用量15%,反应温度90℃,搅拌时间15 min;硅烷偶联剂和铝酸酯偶联剂改性石英砂的最佳工艺条件均为:偶联剂用量15%,反应温度110℃,搅拌时间15 min。水对钛酸酯偶联剂改性石英砂滤料的润湿重量由改性前的1.5589 g降低到0.0282 g,水对硅烷偶联剂改性石英砂滤料的润湿重量降低到0.0607 g,水对铝酸酯改性石英砂滤料的润湿重量降低到0.2664 g。静态吸附实验表明,硅烷偶联剂、钛酸酯偶联剂和铝酸酯偶联剂改性石英砂滤料对油的吸附容量分别增加了33.67%、42.87%和22.30%。XPS和FT-IR分析表明,偶联剂均以化学键的方式包覆在石英砂滤料表面,结合稳定。     

重庆主城区秋冬季逆温对空气质量影响的观测分析

2013年9—11月利用RPG-HATPRO地基多通道微波辐射计对重庆主城区大气进行连续探测,统计了大气逆温情况,并对典型重污染天气下大气逆温与空气质量状况进行综合分析。结果表明,逆温出现的频率为63.3%,基本为接地逆温类型,逆温层厚度为953 m,逆温强度为0.3℃/hm;逆温的存在为气溶胶的积聚和凝聚创造了有利条件。