美国市政污水处理排放标准制定对中国的启示

在概述美国市政污水处理排放标准制度体系的基础上,介绍了其制定基于技术的排放限值和基于水质的排放限值的方法,阐述了其制定的科学性,并指出了中国市政污水处理排放标准中存在的相应问题。最后,根据美国制定排放标准限值的经验,对我国污水处理排放标准进行了思考,并提出了科学制定排放标准的方法和建议。     

AOX contamination status and genotoxicity of AOX-bearing pharmaceutical wastewater

Adsorbable organic halogens(AOX) are a general indicator for the total amount of compounds containing organically bonded halogens. AOX concentrations and components were investigated along the wastewater treatment process in four large-scale pharmaceutical factories of China, and genotoxicity based on the SOS/umu test was also evaluated. The results showed that AOX concentrations in wastewater of four factories ranged from 4.6 to 619.4 mg/L, which were high but greatly different owing to differences in the raw materials and products. The wastewater treatment process removed 50.0%–89.9% of AOX, leaving 1.3–302.5 mg/L AOX in the effluents. Genotoxicity levels ranged between 2.1 and 68.0 μg 4-NQO/L in the raw wastewater and decreased to 1.2–41.2 μg 4-NQO/L in the effluents of the wastewater treatment plants(WWTPs). One of the main products of factory I, ciprofloxacin, was identified as the predominant contributor to its genotoxicity. However, for the other three factories, no significant relationship was observed between genotoxicity and detected AOX compounds.     

On the effect of Fe(III) on proliferation of Microcystis aeruginosa at high nitrate and low chlorophyll condition

The impact of Fe concentrations on the growth of Microcystisaeruginosa in aquatic systems under high nitrate and low chlorophyll conditions was studied. The responses of cell density, total and cell chlorophyll-a intracellular Fe content and organic elemental composition of M. aeruginosa to different concentration gradients of Fe(III) in the solutions were analysed. The results showed that the proliferation speeds of M. aeruginosa were: (1) decelerated when the Fe(III) concentration was lower than 50 μg/L in the solutions, (2) promoted and positively related to the increase of Fe(III) concentration from 100 to 500 μg/L in the solutions over the experimental period, and (3) promoted in the early stage but decelerated in later stages by excess adsorption of Fe by cells when the Fe(III) concentration was higher than 500 μg/L in the solutions. The maximum cell density, total and cell chlorophyll-a were all observed at 500 μg Fe(III)/L concentration. The organic elemental composition of M. aeruginosa was also affected by the concentration of Fe(III) in the solutions, and the molecular formula of M. aeruginosa should be expressed as C_7–7.5H₁₄O_0.8–1.3N_3.5–5 according to the functions for different Fe(III) concentrations. Cell carbon and oxygen content appeared to increase slightly, while cell nitrogen content appeared to decrease as Fe(III) concentrations increased from 100 to 500 μg/L in the solutions. This was attributed to the competition of photosynthesis and nitrogen adsorption under varying cell Fe content.     

Bioaccumulation and the expression of hepatic cytochrome P450 genes in marine medaka (Oryzias melastigma) exposed to difenoconazole

This study was conducted to assess the effects of difenoconazole (DFZ), a triazole fungicide, on the hepatic biotransformation system and its bioaccumulation in marine medaka (Oryzias melastigma). Fish were exposed to DFZ (1, 10, 100, 1000 ng/L) for 180 days. The results showed that: (1) The mRNA levels of hepatic CYP1A1, CYP1B, CYP1C1, CYP27B and CYP3A40 were up-regulated, but those of CYP3A38 and CYP27A1 were down-regulated. (2) The activity of ethoxyresorufin-O-deethylase (EROD) and the content of reduced glutathione (GSH) in the liver were increased in the DFZ-treated groups, and glutathione S-transferase (GST) activity was increased in the 100 and 1000 ng/L groups. (3) DFZ was accumulated in the muscle and the biological concentration factors in the 10, 100, and 1000 ng/L groups were respectively 149, 81 and 25. These results suggested that long-term exposure to DFZ at low concentrations would result in a bioaccumulation of this compound and disturb the biotransformation system.     

Effects of sludge retention time, carbon and initial biomass concentrations on selection process: From activated sludge to polyhydroxyalkanoate accumulating cultures

Four sequence batch reactors (SBRs) fed by fermented sugar cane wastewater were continuously operated under the aerobic dynamic feeding (ADF) mode with different configurations of sludge retention time (SRT), carbon and initial biomass concentrations to enrich polyhydroxyalkanoate (PHA) accumulating mixed microbial cultures (MMCs) from municipal activated sludge. The stability of SBRs was investigated besides the enrichment performance. The microbial community structures of the enriched MMCs were analyzed using terminal restriction fragment length polymorphism (T-RFLP). The optimum operating conditions for the enrichment process were: SRT of 5 days, carbon concentration of 2.52 g COD/L and initial biomass concentration of 3.65 g/L. The best enrichment performance in terms of both operating stability and PHA storage ability of enriched cultures (with the maximum PHA content and PHA storage yield (Y_PHA/S) of 61.26% and 0.68 mg COD/mg COD, respectively) was achieved under this condition. Effects of the SRT, carbon concentration and initial biomass concentration on the PHA accumulating MMCs selection process were discussed respectively. A new model including the segmentation of the enrichment process and the effects of SRT on each phase was proposed.     

Contribution of precursor compounds to the release of per- and polyfluoroalkyl substances (PFASs) from waste water treatment plants (WWTPs)

Per-and polyfluoroalkyl substances(PFASs) are ubiquitous in sludge and water from waste water treatment plants, as a result of their incorporation in everyday products and industrial processes. In this study, we measured several classes of persistent PFASs,precursors, transformation intermediates, and newly identified PFASs in influent and effluent sewage water and sludge from three municipal waste water treatment plants in Sweden, sampled in 2015. For sludge, samples from 2012 and 2014 were analyzed as well.Levels of precursors in sludge exceeded those of perfluoroalkyl acids and sulfonic acids(PFCAs and PFSAs), in 2015 the sum of polyfluoroalkyl phosphoric acid esters(PAPs) were 15–20 ng/g dry weight, the sum of fluorotelomer sulfonic acids(FTSAs) was 0.8–1.3 ng/g,and the sum of perfluorooctane sulfonamides and ethanols ranged from non-detected to 3.2 ng/g. Persistent PFSAs and PFCAs were detected at 1.9–3.9 ng/g and 2.4–7.3 ng/g dry weight, respectively. The influence of precursor compounds was further demonstrated by an observed substantial increase for a majority of the persistent PFCAs and PFSAs in water after waste water treatment. Perfluorohexanoic acid(PFHxA), perfluorooctanoic acid(PFOA), perfluorohexane sulfonic acid(PFHxS), and perfluorooctane sulfonic acid(PFOS)had a net mass increase in all WWTPs, with mean values of 83%, 28%, 37% and 58%,respectively. The load of precursors and intermediates in influent water and sludge combined with net mass increase support the hypothesis that degradation of precursor compounds is a significant contributor to PFAS contamination in the environment.     

Determination of 15 phthalate esters in air by gas-phase and particle-phase simultaneous sampling

Based on previous research, the sampling and analysis methods for phthalate esters (PAEs) were improved by increasing the sampling flow of indoor air from 1 to 4 L/min, shortening the sampling duration from 8 to 2 hr. Meanwhile, through the optimization of chromatographic conditions, the concentrations of 9 additional PAE pollutants in indoor air were measured. The optimized chromatographic conditions required a similar amount of time for analysis as before, but gave high responsivity, the capability of simultaneously distinguishing 15 kinds of PAEs, and a high level of discrimination between individual sample peaks, as well as stable peak generation. The recovery rate of all gas-phase and particle-phase samples of the 15 kinds of PAEs ranged from 91.26% to 109.42%, meeting the quantitative analysis requirements for indoor and outdoor air sampling and analysis. For the first time, investigation of the concentration levels as well as characteristics of 15 kinds of PAEs in the indoor air from four different traffic micro-environments (private vehicles, busses, taxis and subways) was carried out, along with validation of the optimized sampling and analytical method. The results show that all the 9 additional PAEs could be detected at relatively high pollution levels in the indoor air from the four traffic micro-environments. As none of the pollution levels of the 15 kinds of PAEs in the indoor air from the 4 traffic micro-environments should be neglected, it is of great significance to increase the types of PAEs able to be detected in indoor air.     

Quantifying public health benefits of environmental strategy of PM2.5 air quality management in Beijing–Tianjin–Hebei region, China

In 2013,China issued "Air Pollution Prevention and Control Action Plan(Action Plan)" to improve air quality.To assess the benefits of this program in Beijing-Tianjin-Hebei(BTH)region,where the density of population and emissions vary greatly,we simulated the air quality benefit based on Ben MAP to satisfy the Action Plan.In this study,we estimate PM_(2.5) concentration using Voronoi spatial interpolation method on a grid with a spatial resolution of 1 × 1 km~2.Combined with the exposure-response function between PM_(2.5) concentration and health endpoints,health effects of PM_(2.5) exposure are analyzed.The economic loss is assessed by using the willingness to pay(WTP) method and human capital(HC) method.When the PM_(2.5) concentration falls by 25% in BTH and reached 60 μg/m~3 in Beijing,the avoiding deaths will be in the range of 3175 to 14051 based on different functions each year.Of the estimated mortality attributable to all causes,3117 annual deaths were due to lung cancer,1924 – 6318 annual deaths were due to cardiovascular,and343 – 1697 annual deaths were due to respiratory.Based on WTP,the estimated monetary values for the avoided cases of all cause mortality,cardiovascular mortality,respiratory mortality and lung cancer ranged from 1110 to 29632,673 to 13325,120 to 3579,1091 to 6574 million yuan,respectively.Based on HC,the corresponding values for the avoided cases of these four mortalities were 267 to 1178,161 to 529,29 to 143 and 261 million yuan,respectively.     

Mesoporous carbon nanomaterials induced pulmonary surfactant inhibition, cytotoxicity, inflammation and lung fibrosis

Environmental exposure and health risk upon engineered nanomaterials are increasingly concerned. The family of mesoporous carbon nanomaterials(MCNs) is a rising star in nanotechnology for multidisciplinary research with versatile applications in electronics,energy and gas storage, and biomedicine. Meanwhile, there is mounting concern on their environmental health risks due to the growing production and usage of MCNs. The lung is the primary site for particle invasion under environmental exposure to nanomaterials. Here, we studied the comprehensive toxicological profile of MCNs in the lung under the scenario of moderate environmental exposure. It was found that at a low concentration of 10 μg/mL MCNs induced biophysical inhibition of natural pulmonary surfactant. Moreover, MCNs at similar concentrations reduced viability of J774 A.1 macrophages and lung epithelial A549 cells.Incubating with nature pulmonary surfactant effectively reduced the cytotoxicity of MCNs.Regarding the pro-inflammatory responses, MCNs activated macrophages in vitro, and stimulated lung inflammation in mice after inhalation exposure, associated with lung fibrosis.Moreover, we found that the size of MCNs played a significant role in regulating cytotoxicity and pro-inflammatory potential of this nanomaterial. In general, larger MCNs induced more pronounced cytotoxic and pro-inflammatory effects than their smaller counterparts. Our results provided valuable information on the toxicological profile and environmental health risks of MCNs, and suggested that fine-tuning the size of MCNs could be a practical precautionary design strategy to increase safety and biocompatibility of this nanomaterial.     

闲置厌氧氨氧化微生物的启动及微生物分析

文章以闲置12个月的厌氧氨氧化生物膜填料重新启动厌氧氨氧化反应器,并对反应器的活性恢复情况、脱氮效果和微生物菌群结构开展研究。实验结果表明:在启动的200 d逐渐将进水氨氮、亚硝态氮浓度从50 mg/L提高到70 mg/L,水力停留时间从12 h缩短到4 h,后期氨氮去除率达80%以上,亚硝酸盐去除率达95%。170~200 d的稳定期中,平均去除负荷0.71±0.15 kg/(m~3·d)。另外,通过高通量测序技术对反应器中微生物群落变化情况进行了系统分析。启动过程中填料中污泥微生物浮霉菌门Planctomyctes的相对丰度从13.7%增长到了36.0%,成为优势菌群。