Sedimentary record of polycyclic aromatic hydrocarbons and DDTs in Dianchi Lake, an urban lake in Southwest China

Unique time trends of polycyclic aromatic hydrocarbons (PAHs) and dichlorodiphenyltrichloroethanes (DDTs) were found in a dated sediment core from Dianchi Lake (DC), an urban lake in Southwest China. The temporal trend of PAHs in DC was not only different from those in China's coastline and remote lakes of China, but also different from those in more developed countries. Identification of sources suggested that PAHs in DC originated primarily from domestic combustion of coal and biomass. However, a change of source from low- and moderate-temperature combustion to high-temperature combustion processes was observed. Different from those in China's coastline and some developed countries, the temporal trend of DDTs in DC mirrored the historical usage of DDTs in China, with erosion of soils and surface runoff from its drainage area the most likely routes of DDT introduction to the lake. Rapid urbanization and industrialization in its catchment, effective interception of point-source pollution, and changes in sources of energy during the last few decades have significantly influenced the vertical profiles of PAHs in DC.     

Arsenic stabilization by zero-valent iron,bauxite residue,and zeolite at a contaminated site planting Panax notoginseng

Panax notoginseng (Burk.) F.H. Chen, a rare traditional Chinese medicinal herb, is a widely used phytomedicine used all over the world. In recent years, the arsenic contamination of the herb and its relative products becomes a serious problem due to elevated soil As concentration. This study aimed to evaluate the effects of different types and dosages of amendments on As stabilization in soil and its uptake by P. notoginseng. Results showed that comparing to control treatment, the As concentrations of P. notoginseng declined by 49–63%, 43–61% and 52–66% in 0.25% zero-valent iron (Fe(0)), 0.5% bauxite residue, and 1% zeolite treatment, respectively; whereas the biomasses were elevated by 62–116%, 45–152% and 114–265%, respectively. The As(III) proportions of P. notoginseng increased by 8%, 9%, and 8%, and the transfer factors of As from root to shoot increased by 37%, 42% and 84% in the optimal treatments of Fe(0), bauxite residue, and zeolite. For soil As, all the three amendments could transform the non-specifically adsorbed As fraction to hydrous oxides Fe/Al fractions (by Fe(0) and red mud) or specifically adsorbed As fraction (by zeolite), therefore reduced the bioavailability of soil As. With a comprehensive consideration of stabilization efficiency, plant growth, environmental influence, and cost, Fe(0) appeared to be the best amendment, and zeolite could also be a good choice. In conclusion, this study was of significance in developing As contamination control in P. notoginseng planting areas, and even other areas for medicinal herb growing.     

Mass transfer coefficients for volatilization of polychlorinated biphenyls from the Hudson River,New York measured using micrometeorological approaches

Air–water exchange is an important process controlling the fate of many organic chemicals in the environment. Modeling this process is hampered by the lack of direct observations. Thus, the purpose of this work was to derive direct measurements of the mass transfer coefficients for air–water exchange (v_aw) of polychlorinated biphenyls (PCBs) that may be used to check the validity of values derived from tracer gas experiments. v_aw values for PCBs were determined using previously published turbulent fluxes divided by the corresponding dissolved phase concentrations. The median v_aw values for each homolog decreased with increasing molecular weight and ranged from 0.29 for hexachlorobiphenyls to 2.2 m d^?1 for monochlorobiphenyls with a propagated uncertainty of about 70%, lower than in previous studies. Due to relatively low wind speeds and possible sorption of PCBs to colloids, these numbers may be biased low. These field measurements of v_aw differ by as much as a factor of 23 from predictions based on the widely-used Whitman two-film model. Therefore a new formulation for the calculation of v_aw based on field measurements is needed. This study demonstrates that micrometeorological approaches are a viable option for the measurement of v_aw for hydrophobic organics such as PCBs and should be used to generate enough field data on the air–water exchange of hydrophobic organics to allow the development of new predictive models.     

响应面法和神经网络优化Acinetobactersp．DNS32发酵基质

为了提高阿特拉津降解菌Acinetobactersp．DNS32的产量,分别采用响应曲面法和基于人工神经网络的遗传算法对阿特拉津降解菌DNS32发酵培养基中3个重要基质成分（玉米粉、豆饼粉、K：HPO。）进行优化研究。响应曲面法确定3种成分的含量为玉米粉39．494g／L,豆饼粉25．638g／L和K。HPO。3．265g／L时,预测发酵活菌最大生物量为7．079×10^8CFU／mL,实测量为7．194×10^8CFU／mL;人工神经网络结合遗传算法优化确定3种主要成分含量为玉米粉为39．650g／L,豆饼粉为25．500g／L,K2HPO4为2．624g／L时,预测最大值为7．199×10^8CFU／mL,实测量为7．244×10。CFU／mL;最终确定培养基配方：玉米粉为39．650g／L,豆饼粉为25．500g／L,K2HPO4为2．624g／L,CaCO3为3．000g／L,MgSO4·7H2O和NaCl均为0．200g／L;优化后阿特拉津降解菌DNS32发酵生物量比优化前提高了36．6％。结果表明,在阿特拉津降解菌DNS32发酵培养基组分优化方面,响应面法和基于人工神经网络的遗传算法都是可行的,基于人工神经网络的遗传算法具有更好的拟合度和预测准确度。     

钢渣掺量对泡沫混凝土砌块性能的影响

泡沫混凝土是一种环保、节能的保温隔热材料,以其优良的保温性能,受到越来越多研究者的关注。对钢渣的特性进行了分析测试,对钢渣不同掺量对泡沫混凝土砌块特性的影响进行了研究,结果表明,采用添加5％～35％钢渣所制备的钢渣泡沫混凝土砌块,其密度等级为JC／T1062—2007中的B10级,掺人5％、15％钢渣的泡沫混凝土抗压强度达到A3．5等级,掺人25％、35％钢渣的泡沫混凝土抗压强度达到A2．5等级。随着钢渣掺量的增大,抗压强度、抗折强度降低,吸水率增大。在同一钢渣掺量的情况下,泡沫混凝土砌块的抗压强度变化率增加显著,而且随着钢渣的加入量升高而增大。钢渣的加入有利于提高泡沫混凝土砌块的后期抗压强度。     

城市生活垃圾焚烧处理过程中重金属迁移规律研究

通过采集厦门2个垃圾焚烧发电厂进厂垃圾、渗滤液、飞灰、炉渣和烟气样品,分析垃圾组成成分及各组分的重金属含量,结果表明,垃圾中以厨余、橡塑类和纸类为主,共占到垃圾干基的78．08％,重金属含量大小次序为Zn〉Cu〉Pb〉Cr〉Ni〉Cd〉Hg;垃圾渗滤液中除Zn外,其他金属的含量都较低,一厂渗滤液中重金属Ni、Zn迁移量较大,分别达到24．46％和8．52％。二厂渗滤液中重金属的迁移有相同的趋势,但含量相对较高。垃圾焚烧后其重金属主要分布在飞灰和废渣中,烟气中的含量非常少,不同金属的含量均有差别,这与金属的性质有很大关系;通过浸出毒性分析,飞灰中重金属酸溶态含量多,容易浸出,属于危险废物。同时,不同烟气处理工艺产生的飞灰的重金属浸出量有很大差别。     

响应面法和神经网络优化Acinetobacter sp. DNS32发酵基质

为了提高阿特拉津降解菌Acinetobacter sp.DNS32的产量,分别采用响应曲面法和基于人工神经网络的遗传算法对阿特拉津降解菌DNS32发酵培养基中3个重要基质成分(玉米粉、豆饼粉、K2HPO4)进行优化研究。响应曲面法确定3种成分的含量为玉米粉39.494 g/L,豆饼粉25.638 g/L和K2HPO43.265 g/L时,预测发酵活菌最大生物量为7.079×108CFU/mL,实测量为7.194×108CFU/mL;人工神经网络结合遗传算法优化确定3种主要成分含量为玉米粉为39.650 g/L,豆饼粉为25.500 g/L,K2HPO4为2.624 g/L时,预测最大值为7.199×108CFU/mL,实测量为7.244×108CFU/mL;最终确定培养基配方:玉米粉为39.650 g/L,豆饼粉为25.500 g/L,K2HPO4为2.624 g/L,CaCO3为3.000 g/L,MgSO4.7H2O和NaCl均为0.200 g/L;优化后阿特拉津降解菌DNS32发酵生物量比优化前提高了36.6%。结果表明,在阿特拉津降解菌DNS32发酵培养基组分优化方面,响应面法和基于人工神经网络的遗传算法都是可行的,基于人工神经网络的遗传算法具有更好的拟合度和预测准确度。     

工业废水中多金属离子的吸附净化

以含有Si、Al、Ca、C元素的矿物材料作为基质,经特定条件处理后造粒成型加工成轻质多孔Si-Al-Ca-C结构的吸附材料。研究了该吸附材料对工业废水中多种金属离子的吸附性能,探讨了影响吸附性能的因素。研究结果表明,在一定条件下,Si-Al-Ca-C吸附材料对工业废水中Al3+、Ca2+、Mn2+、Cu2+、Fe3+、Mg2+、As3+和Zn2+的净化率分别高达99.34%、99.82%、98.26%、98.16%、97.76%、97.01%、100%和89.09%。金属离子残留浓度分别为0.152、0.07、0.012、0.02、0.119、0.311、0和0.259 mg/L,均低于国家污水综合排放标准(GB8978-1996)一级标准。     

高碱度水库水混凝过程中残留铝控制

针对高碱度水库水源的某水厂残留铝超标问题,选取碱化度(B)与Alb含量不同的3种铝盐絮凝剂,研究不同投量与pH值下混凝效果与残留铝浓度水平。结果表明,碱化度和Alb含量显著影响混凝效果。DOC和浊度的去除率随着3种絮凝剂AlCl3(B=0)、PACl-1(B=1.2)、PACl-2(B=2.2)投量增大而升高。3种絮凝剂投量在1.5～2.0 mg/L(以铝计)范围内,总铝和溶解铝含量最低。对于该水厂自制的絮凝剂PACl-2,可通过降低絮凝剂碱化度,或将水的pH值降低至7～7.5之间,以此可以提高PACl-2混凝效果,而且可以降低出厂水残留铝浓度。考虑工程应用可行性,可优先考虑调整絮凝剂生产工艺。