不同类型清水剂处理油田含聚污水的效果对比

考察了阳离子型CWC-14、非离子型NQS-01和阴离子型AQS-08 3类清水剂对油田含聚污水的处理效果,对比了它们的作用特点和絮体性能。实验结果表明:在清水剂加入量350 mg/L、处理温度65℃、搅拌转速300 r/min、搅拌时间5 min的条件下,CWC-14、NQS-01和AQS-08对含聚污水的除油率分别为98.8%、98.0%和99.4%;NQS-01受处理温度、搅拌条件影响较大;CWC-14受污水中聚合物质量浓度影响最大。清水剂的絮体特点与其作用机理有关,CWC-14的絮凝速率最快,起效时间最短,絮体呈黏性大块状;NQS-01的絮凝速率最慢,起效时间最长,絮体呈浮油状;AQS-08的絮凝速率和起效时间适中,絮体呈松散状、流动性好。对比结果表明,非阳离子型清水剂可有效避免油田含聚污水处理过程中的黏性油泥问题。     

Preparation of MgCr<Subscript>2</Subscript>O<Subscript>4</Subscript> from waste tannery solution and effect of sulfate,chloride, and calcium on leachability of chromium

This paper presents a study regarding the preparation of MgCr₂O₄ from waste tannery solution, and chromium leaching behavior is also investigated with varying amounts of sulfate, chloride and calcium. The phase transformation, crystallinity index and crystallite diameter were characterized using XRD, FT-IR and thermal analysis. A well-crystallized MgCr₂O₄ was successfully prepared at 1400 °C. The sintering temperature had a major impact on the formation of MgCr₂O₄ compared with sintering time. The MgCr₂O₄ phase was observed initially at 400 °C and its crystallite diameter increased with increasing temperature. The concentration of total chromium leached and Cr(VI) decreased gradually with increasing temperature. The considerable amount of Cr(VI) was found in the leachate at 300–500 °C caused by Cr(VI) intermediary products. Sulfate and chlorine could impact the transformation efficiency of chromium adversely, and chlorine has a more significant effect than sulfate. The presence of calcium disturbed the formation of MgCr₂O₄ and new chromium species (CaCrO₄) appeared, which resulted in a sharp increase in the concentration of leached Cr(VI). Incorporating Cr(III) into the MgCr₂O₄ spinel for reusable products reduced its mobility significantly. This was demonstrated to be a promising strategy for the disposal of chromium containing waste resource.     

楼板对钢筋混凝土框架结构受力性能影响

汶川8级地震震害调查发现,这次地震中现浇钢筋混凝土框架结构多发生"强梁弱柱"型破坏,这与规范中"强柱弱梁"抗震设计原则相悖。为探究其原因,采用ABAQUS软件对钢筋混凝土带楼板框架和空框架结构进行了侧向加载情况的性能分析。通过对比纵向梁端钢筋应力变化和柱端钢筋应力变化,以及分析不同侧向位移对应的楼板钢筋的应力变化情况,指出楼板对梁端抗负弯矩能力的增强有很大贡献。研究了节点类型、楼板钢筋材性、侧向位移、梁高、梁跨和板厚等因素对纵向梁端处楼板有效宽度的影响规律,提出了负弯矩作用下梁端处楼板有效宽度的取值方法。     

Pretreatment of cyanided tailings by catalytic ozonation with Mn2+/O3

The increasing amount of cyanided tailings produced as a by-product has gained significant attention in recent years because of the rapid development of the gold industry and extensive exploitation of gold mineral resources. The effective use of these secondary resources is becoming an important and urgent problem for all environmental protection staff. Manganese-catalyzed ozonation for the pre-oxidation of cyanided tailings was studied and the effects of Mn²⁺ dosage, initial sulfuric acid concentration, ozone volume flow, temperature and agitation speed on pretreatment were examined. The optimum reaction conditions were observed to be: ore pulp density 2.5%, agitation speed 700 r/min, temperature 60 ℃, Mn²⁺ dosage 40 g/L, ozone volume flow 80 L/hr, initial sulfuric acid concentration 1 mol/L, and reaction time 6 hr. Under these conditions, the leaching rate of Fe and weight loss could reach 94.85% and 48.89% respectively. The leaching process of cyanided tailings by Mn²⁺/O³ was analyzed, and it was found that the leaching of pyrite depends on synergetic oxidation by high-valent manganese and O³, in which the former played an important part.     

等离子体催化脱氮的实验研究

研究了等离子体和催化剂共同作用下氮氧化物的脱除情况 ,催化剂采用分子筛Cu ZSM 5。实验证明 ,在有催化剂存在的条件下 ,等离子体反应器的脱氮效率有了很大的提高 ,同时电源功率、烟气成分、温度、添加剂也都是影响实验结果的重要因素。     

Synthesis of novel CeO2-BiVO4/FAC composites with enhanced visible-light photocatalytic properties

To utilize visible light more effectively in photocatalytic reactions, a fly ash cenosphere （FAC）-supported CeO2-BiV04 （CeO2-BiVO4/FAC） composite photocatalyst was prepared by modified metalorganic decomposition and impregnation methods. The physical and photophysical properties of the composite have been characterized by X-ray diffraction （XRD）, scanning electron microscope （SEM） and energy dispersive X-ray spectroscopy （EDX）, X-ray photoelectron spectroscopy （XPS）, and UV-Visible diffuse reflectance spectra. The XRD patterns exhibited characteristic diffraction peaks of both BiVO4 and Ce02 crystalline phases. The XPS results showed that Ce was present as both Ce4＋ and Ce3＋ oxidation states in Ce02 and dispersed on the surface of BiV04 to constitute a p-n heterojunction composite. The absorption threshold of the CeO2-BiVO4/FAC composite shifted to a longer wavelength in the UV-Vis absorption spectrum compared to the pure Ce02 and pure BiV04. The composites exhibited enhanced photocatalytic activity for Methylene Blue （MB） degradation under visible light irradiation. It was found that the 7.5 wt.% CeO2-BiVO4/FAC composite showed the highest photocatalytic activity for MB dye wastewater treatment.     

活性污泥工艺的多目标优化分析

研究了多目标优化方法在活性污泥工艺优化中应用的可行性,以国际水协(IWA)发布的基准仿真模型BSM1的工艺流程为对象,以出水水质、过程能耗和反应池体积的指标为优化目标,以反应池池容(5个)、混合液回流量、污泥回流量、污泥排放量、反应池氧气传质系数(3个)等11个变量为决策变量,构建了基于BSM1的多目标优化模型,并利用MatLab非支配排序遗传算法NSGA-II进行求解,获得了BSM1多目标优化模型的Pareto解.研究结果表明,在Dry进水条件下,通过将体积指标增大4.1%,可以明显改善出水水质指标(降低81.5%),能耗指标也能得到一定改善(降低13.3%);在3种进水条件(Dry,Rain,Storm)下,相对于BSM1工艺参数的缺省值,利用本研究的优化解作为工艺参数,均能不同程度改善出水水质、降低能耗.研究结果显示,在活性污泥过程不同目标之间进行权衡可以通过多目标优化方法来实现.     

Cosolvent-enhanced chemical oxidation of perchloroethylene by potassium permanganate

A laboratory study was conducted to examine cosolvent-enhanced in-situ chemical oxidation (ISCO) of perchloroethylene (PCE) using potassium permanganate (KMnO4). The conceptual basis for this new technique is to enhance permanganate oxidation of dense non-aqueous phase liquids (DNAPLs) with the addition of a cosolvent, thereby increasing DNAPL solubility while avoiding mobilization. Among 17 cosolvent candidates screened, tertiary butyl alcohol (TBA) and acetone were the most stable in the presence of KMnO4, both of which increased PCE aqueous solubility significantly, and therefore are suitable to be used as cosolvent in this study. Batch experiments indicated that the second-order rate constant for PCE oxidation by potassium permanganate was 0.043+/-0.002 M(-1) s(-1) in the purely aqueous (no cosolvent) solution. In the presence of 20% cosolvent (volume fraction=fc=0.2), the rate constant decreased to 0.036+/-0.003 M(-1) s(-1) with TBA and to 0.031+/-0.002 M(-1) s(-1) with acetone. However, in the presence of free-phase PCE, chloride ion concentration from PCE oxidation in acetone/water solutions (fc=0.2) was about twice that in aqueous solutions, indicating that the increase in PCE solubility more than compensated for the decrease in reaction rate constant, such that the oxidation efficiency of PCE was increased with cosolvent. A complete chlorine mass balance was observed in the aqueous system, whereas approximately 70% was obtained in TBA/water or acetone/water (fc=0.2). In soil columns containing residual DNAPL and subjected to isocratic flushing with step-wise increases in f(c) cosolvent, TBA at fc=0.2 resulted in PCE mobilization, whereas acetone at fc相似文献   

化学清洗技术在安钢D900风机冷却系统的应用

利用化学清洗技术，对风机循环系统、油冷却系统进行杀灭微生物、除垢、去锈、管壁钝化、预膜处理，既保证了高炉的正常生产，又延长了风机的使用寿命。     

炉底渣磨细优化其品质的试验

以浙江长兴电厂所排的炉底渣为例,通过磨细将其加工成相当于国标Ⅱ级粉煤灰的产品。试验结果表明:长兴电厂炉底渣的化学成分以SiO2与Al2O3较高为特征,物相以玻璃体占绝对优势,微量元素和放射性元素含量均在国标规定的安全范围内;磨细炉底渣的45μm筛余量控制在10%左右时其品质为最优;磨细炉底渣的火山灰活性要优于磨细Ⅱ级粉煤灰的。