Importance of landscape heterogeneity to wood storks in Florida Everglades

Declines in populations of and reproductive success of wood storks and other wading birds have occurred in the Florida Everglades over the past several decades. These declines have been concurrent with major changes in the Everglades’ landscape characteristics. Among the plausible hypotheses that relate to landscape change are the following: (1) general loss of habitat; (2) heavy loss of specific habitat, namely, short-hydroperiod wetlands that provide high prey availability early in the breeding season; and (3) an increase in frequency of major drying out of the central slough areas, which can affect prey availability late in the breeding season. These three hypotheses were compared using an individual-based model of wood stork (Mycteria americana) reproduction. This model simulated the behavior and energetics of each individual wood stork in a breeding colony on 15-min time intervals. Changes in water depth and prey availability occurred on daily time steps. Simulation results showed a threshold response in reproductive success to reduction of wetland heterogeneity. Model comparisons in which (1) only short-hydroperiod wetlands were removed and (2) wetlands of both long and short hydroperiods were removed showed that, for the same loss of total area, the specific habitat removal caused a much greater reduction in wood stork reproduction, indicating hypothesis 2 may be a more likely explanation than hypothesis 1. Reduction of initial prey availability in the central slough areas (simulating frequent drying; hypothesis 3) reduced fledging success by an average of more than 90% in the model.     

National and global greenhouse gas dynamics of different forest management and wood use scenarios: a model-based assessment

An increased use of wood products and an adequate management of forests can help to mitigate climate change. However, planning horizons and response time to changes in forest management are usually long and the respective GHG effects related to the use of wood depend on the availability of harvested wood. Therefore, an integral long-term strategic approach is required to formulate the most effective forest and wood management strategies for mitigating climate change.The greenhouse gas (GHG) dynamics related to the production, use and disposal of wood products are manifold and show a complex time pattern. On the one hand, wood products can be considered as a carbon pool, as is the forest itself. On the other hand, an increased use of wood can lead to the substitution of usually more energy-intense materials and to the substitution of fossil fuels when the thermal energy of wood is recovered. Country-specific import/export flows of wood products and their alternative products as well as their processing stage have to be considered if substitution effects are assessed on a national basis.We present an integral model-based approach to evaluate the GHG impacts of various forest management and wood use scenarios. Our approach allows us to analyse the complex temporal and spatial patterns of GHG emissions and removals including trade-offs of different forest management and wood use strategies. This study shows that the contributions of the forestry and timber sector to mitigate climate change can be optimized with the following key recommendations: (1) the maximum possible, sustainable increment should be generated in the forest, taking into account biodiversity conservation as well as the long-term preservation of soil quality and growth performance; (2) this increment should be harvested continuously; (3) the harvested wood should be processed in accordance with the principle of cascade use, i.e. first be used as a material as long as possible, preferably in structural components; (4) waste wood that is not suitable for further use should be used to generate energy. Political strategies to solely increase the use of wood as a biofuel cannot be considered efficient from a climate perspective; (5) forest management strategies to enhance carbon sinks in forests via reduced harvesting are not only ineffective because of a compensatory increase in fossil fuel consumption for the production of non-wooden products and thermal energy but also because of the Kyoto-“cap” that limits the accountability of GHG removals by sinks under Article 3.3 and 3.4, at least for the first commitment period; (6) the effect of substitution through the material and energy use of wood is more significant and sustained as compared with the stock effects in wood products, which tend towards new steady-state flow equilibria with no further increase of C stocks; (7) from a global perspective, the effect of material substitution exceeds that of energy recovery from wood. In the Swiss context, however, the energy recovery from wood generates a greater substitution effect than material substitution.     

The effect of atmospheric thermal conditions and urban thermal pollution on all-cause and cardiovascular mortality in Bangladesh

This study assessed the effect of temperature and thermal atmospheric conditions on all-cause and cardiovascular mortality in Bangladesh. In particular, differences in the response to elevated temperatures between urban and rural areas were investigated. Generalized additive models (GAMs) for daily death counts, adjusted for trend, season, day of the month and age were separately fitted for urban and rural areas. Breakpoint models were applied for determining the increase in mortality above and below a threshold (equivalent) temperature. Generally, a 'V'-shaped (equivalent) temperature-mortality curve with increasing mortality at low and high temperatures was observed. Particularly, urban areas suffered from heat-related mortality with a steep increase above a specific threshold. This adverse heat effect may well increase with ongoing urbanization and the intensification of the urban heat island due to the densification of building structures. Moreover, rising temperatures due to climate change could aggravate thermal stress.     

Bed Stability and Sedimentation Associated With Human Disturbances in Pacific Northwest Streams1

Abstract: To evaluate anthropogenic sedimentation in United States (U.S.) Pacific Northwest coastal streams, we applied an index of relative bed stability (LRBS*) to summer low flow survey data collected using the U.S. Environmental Protection Agency’s Environmental Monitoring and Assessment Program field methods in a probability sample of 101 wadeable stream reaches. LRBS* is the log of the ratio of bed surface geometric mean particle diameter (D_gm) to critical diameter (D*_cbf) at bankfull flow, based on a modified Shield’s criterion for incipient motion. We used a formulation of LRBS* that explicitly accounts for reductions in bed shear stress that result from channel form roughness due to pools and wood. LRBS* ranged from ?1.9 to +0.5 in streams within the lower quartile of human riparian and basin disturbance, and was substantially lower (?4.2 to ?1.1) in streams within the upper quartile of human disturbance. Modeling results suggest that the expected range of LRBS* in streams without human disturbances in this region might be generally between ?0.7 and +0.5 in either sedimentary or volcanic lithology. However, streams draining relatively soft, erodible sedimentary lithology showed greater reductions in LRBS* associated with disturbance than did those having harder, more resistant volcanic (basalt) lithology with similar levels of basin and riparian disturbance. At any given level of disturbance, smaller streams had lower LRBS* than those with larger drainages. In sedimentary lithology (sandstone and siltstone), high‐gradient streams had higher LRBS* than did low‐gradient streams of the same size and level of human disturbance. High gradient streams in volcanic lithology, in contrast, had lower LRBS* than low‐gradient streams of similar size and disturbance. Correlations between D_gm and land disturbance were stronger than those observed between D*_cbf and land disturbance. This pattern suggests that land use has augmented sediment supplies and increased streambed fine sediments in the most disturbed streams. However, we also show evidence that some of the apparent reductions in LRBS*, particularly in steep streams draining small volcanic drainages, may have resulted in part from anthropogenic increases in bed shear stress. The synoptic survey methods and designs we use appear adequate to evaluate regional patterns in bed stability and sedimentation and their general relationship to human disturbances. More precise field measurements of channel slope, cross‐section geometry, and bed surface particle size would be required to use LRBS* in applications requiring a higher degree of accuracy and precision, such as site‐specific assessments at individual streams.     

Finger and hand protection on circular table and panel saws

Several hundred accidents involving the use of circular saws and resulting in injury, to hands or fingers occur each year in Germany.In the presented project, new approaches for the prevention of hand injuries and for the contactless detection of fingers are being investigated for comprehensive protection on circular saws. The basic principles can be applied to other machines with manual loading and/or unloading. This paper describes several principles to distinct human skin and wood and a safety guard that prevents touching the rotating blade. In a first approach a reliable protective device with functional diversity has been developed using a passive infrared sensor in combination with a capacitive field sensor. Second the distinction between skin and wood or other material is done by dedicated kind of spectral analysis in the near infrared region. With a kind of light curtain the intrusion into the dangerous zone near the blade can be prevented.The safety guard protects the operator’s hand within 50 ms. The forces of the protective system peak at no more than 120 N. We are presenting a complete strategy for such different tasks as cutting wedges, stopped cutting and hidden cutting, which have a very high odds ratio.     

Quality considerations of European PM emission inventories

This paper reviews information on emission inventories of particulate matter (PM) in Europe. A large body of scientific literature is available to cover many different aspects. Studies focus on specific sources or source sectors (road transport as well as off-road machinery, domestic heating, industry, agriculture, and natural sources), among which especially road transport emissions are clearly best established. Emission inventories comprising all sources are available for specific European regions, often pointing out regional differences, but also for the entire continent. Still these inventories often are not able to satisfy the needs. Due to PM specific circumstances such as the large number of sources, very different release pathways and differences of the individual particles in terms of chemical composition or size, it is very difficult to appropriately handle measurement conditions to arrive at adequate emission factors, especially when emission points cannot be defined clearly. Information on fugitive emissions (caused by wind shear, material transfer processes or other mechanical forces from non-point sources) is sparse, except for road traffic emissions where recent data seems to converge. The problem of data gaps concerns activities in industry (quarries), agriculture, but also natural particles like sea salt and wind-blown dust. Comparing complete inventories to independent efforts in assessing emissions, e.g. atmospheric measurements combined with source apportionment, allows to better understand and quantify the reliability of inventory data. Methodological improvements and harmonization currently under way in Europe will focus efforts and allow for more reliable PM inventories in the near future.     

Trace elements in sediments,blue spotted tilapia Oreochromis leucostictus (Trewavas, 1933) and its parasite Contracaecum multipapillatum from Lake Naivasha,Kenya, including a comprehensive health risk analysis

This study presents the distribution of 15 major and trace elements in sediments and fish and their pericardial parasites from Lake Naivasha, Kenya. The lake is one of the few freshwater lakes in the Great Rift Valley and is under strong anthropogenic pressure mainly due to agricultural activities. Its fish provide a valuable protein source for approximately 100,000 people in the area. Fish and their parasites have been acknowledged as indicators of environmental quality due to their accumulation potential for both essential and nonessential trace elements. A total of 34 specimens of the blue spotted tilapia Oreochromis leucostictus and pooled samples of their pericardial parasite, the anisakid nematode Contracaecum multipapillatum (larvae 3), were examined. Element concentrations were determined by inductively coupled plasma-optical emission spectroscopy (ICP-OES) and graphite furnace atomic absorption spectrometry (GF-AAS). The concentrations of elements in the sediments reflected the geology of the area and did not point to pollution: none of the investigated trace elements, including Pb, Cd, Cu, and Zn, showed elevated values. In contrast, concentrations in the fish muscle were elevated for Li, Sr, Cd, and Zn, with high target hazard quotients (THQ?>?0.1) indicating a potential health risk to the consumers of this fish. Fish liver showed significantly higher concentrations of the trace elements Fe, Mn, Cd, and Cu compared to the muscle and C. multipapillatum. In the parasite, Zn had the highest concentration, but the worms only minimally accumulated trace elements in relation to their fish host.     

An Evaluation of Qualitative Indexes of Physical Habitat Applied to Agricultural Streams in Ten U.S. States1

Hughes, Robert M., Alan T. Herlihy, and Philip R. Kaufmann, 2010. An Evaluation of Qualitative Indexes of Physical Habitat Applied to Agricultural Streams in Ten U.S. States. Journal of the American Water Resources Association (JAWRA) 46(4): 792-806. DOI: 10.1111/j.1752-1688.2010.00455.x Abstract: Assessment of stream physical habitat condition is important for evaluating stream quality globally. However, the diversity of metrics and methods for assessing physical habitat condition confounds comparisons among practitioners. We surveyed 51 previously sampled stream sites (0.0-6.3 m wide) located in regions of row-crop agriculture in Oregon, California, North Dakota, South Dakota, Nebraska, Iowa, Minnesota, Pennsylvania, Maryland, and West Virginia to evaluate the comparability of four indexes of physical habitat condition relative to each other. We also compared the indexes to previously calculated indexes of fish and macroinvertebrate condition. The physical habitat indexes included the Stream Visual Assessment Protocol Version 2 of the Natural Resources Conservation Service, the qualitative habitat evaluation index of the Ohio Environmental Protection Agency, the rapid bioassessment protocol of the United States Environmental Protection Agency (USEPA), and a qualitative physical habitat index based on USEPA quantitative physical habitat measurements. All four indexes were highly correlated with each other, but low-to-moderately correlated with biotic index scores for fish and macroinvertebrate assemblages. Moderately high correlations occurred between some macroinvertebrate biotic index scores and quantitative metrics. We conclude that additional research is needed to increase the predictive and diagnostic capabilities of qualitative physical habitat indexes.