Photodegradation of PCDD/Fs adsorbed on spruce (Picea abies (L.) Karst.) needles under sunlight irradiation

Spruce (Picea abies (L.) Karst.) needles were exposed to exhaust gas containing polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) generated by combustion of polyvinyl chloride, wood, high-density polyethylene, and styrene. Photodegradation of PCDD/Fs adsorbed on spruce needles under sunlight irradiation was studied. The photodegradation of PCDD/Fs follows pseudo-first-order reaction kinetics, with photolysis half-lives ranging between 40 and 100 h. The photolysis rates of PCDF congeners are higher than PCDD congeners with the same chlorinated substitutions. Higher chlorinated PCDD/Fs tend to photolyze slowly. The wax components in spruce needles may act as proton donors and accelerate the photolysis rate. C-Cl cleavage through the addition of protons to PCDD/F molecules may be an important route for PCDD/Fs photodegradation.     

Nitrifying community analysis in a single submerged attached-growth bioreactor for treatment of high-ammonia waste stream.

This study investigated the nitrifying community structure in a single-stage submerged attached-growth bioreactor (SAGB) that successfully achieved stable nitrogen removal over nitrite of a high-strength ammonia wastewater. The reactor was operated with intermittent aeration and external carbon addition (methanol). With influent ammonia and total Kjeldahl nitrogen ranging from 537 to 968 mg/L and 643 to 1510 mg/L, respectively, 85% nitrogen removal was obtained, and effluent was dominated by nitrite (NO2-/NOx > 0.95). Nitrifying community analysis using fluorescence in situ hybridization (FISH), with a hierarchical set of probes targeting known ammonia-oxidizing bacteria (AOB) within beta-proteobacteria, showed that the AOB community of the biofilter consists almost entirely of members of the Nitrosomonas europaea/eutropha and the Nitrosococcus mobilis lineages. Image analysis of FISH pictures was used to quantify the identified AOB, and it was estimated that Nitrosomonas europaea/eutropha-like AOB accounted for 4.3% of the total volume of the biofilm, while Nitrosococcus mobilis-like AOB made up 1.2%; these numbers summed up to a total AOB fraction of 5.5% of the total volume on the biofilm. Nitrite-oxidizing bacteria (NOB) were not detectable in the biofilm samples with probes for either Nitrospira sp. or Nitrobacter sp., which indicated that NOB were either absent from the biofilters or present in numbers below the detection limit of FISH (< 0.1% of the total biofilm). Nitrite oxidizers were likely outcompeted from the system because of the free ammonia inhibition and the possibility that the aeration period (from intermittent aeration) was not sufficiently long for the NOB to be released from the competition for oxygen with heterotrophs and AOB. The nitrogen removal via nitrite in a SAGB reactor described in this study is applicable for high-ammonia-strength wastewater treatment, such as centrate or industrial wastes.     

Reproduction disturbances of Brachionus calyciflorus (rotifer) for the screening of environmental endocrine disrupters

Rotifers and especially the Brachionus calyciflorus species have already shown advantages (e.g. good sensitivity, simplicity, ecological relevance, short generation time) for the chronic toxicity assessment of water pollutants. In this study, the B. calyciflorus three-day test was evaluated on ethinylestradiol, nonylphenol and testosterone for the determination of endocrine disrupting (reproductive) effects. Reproduction (intrinsic rate of population increase) and sex ratio (males/females and mictic females/amictic females) were explored and discussed as suitable endpoints. B. calyciflorus has shown a fair sensitivity to detect reproductive disrupting effects after exposure to ethinylestradiol, nonylphenol and testosterone. Population growth (intrinsic rate of population increase, r) and the ratio ovigerous females/non-ovigerous females are both suitable endpoints, whereas the occurrence of males was not frequent enough to be used as endpoint.     

Identification of surrogate compounds for the emission of PCdd/F (I-TEQ value) and evaluation of their on-line real-time detectability in flue gases of waste incineration plants by REMPI-TOFMS mass spectrometry

Correlations between products of incomplete combustion (PIC), e.g., chloroaromatic compounds, can be used to characterise the emissions from combustion processes, like municipal or hazardous waste incineration. A possible application of such relationships may be the on-line real-time monitoring of a characteristic surrogate, e.g., with Resonance-Enhanced Multiphoton Ionization-Time-of-Flight Mass Spectrometry (REMPI-TOFMS). In this paper, we report the relationships of homologues and individual congeners of chlorinated benzenes (PCBz), dibenzo-p-dioxins (PCDD), dibenzofurans (PCDF) and phenols (PCPh) to the International Toxicity Equivalent (I-TEQ) of the PCDD/F (I-TEQ value) in the flue gas and stack gas of a 22 MW hazardous waste incinerator (HWI). As the REMPI detection sensitivity is decreasing with the increase of the degree of chlorination, this study focuses on the lower chlorinated species of the compounds mentioned above. Lower chlorinated species, e.g., chlorobenzene (MCBz), 1,4-dichlorobenzene, 2,4,6-trichlorodibenzofuran or 2,4-dichlorophenol, were identified as I-TEQ surrogates in the flue gas. In contrast to the higher chlorinated phenols, the lower chlorinated phenols (degree of chlorination <4) were not reliable as surrogates in the stack gas. The identified surrogates are evaluated in terms of their detectability by REMPI-TOFMS laser mass spectrometry. The outcome is that MCBz is the best suited surrogate for (indirect) on-line measuring of the I-TEQ value in the flue gas by REMPI-TOFMS. The correlation coefficient r of the MCBz concentration to the I-TEQ in the flue gas was 0.85.     

PCBs and PCDD/Fs in lake sediments of Grosser Arbersee, Bavarian Forest, South Germany

Despite their environmental importance, there are still relatively few historical studies of the environmental occurrence of polychlorinated biphenyls (PCBs), polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs), especially in middle Europe. Trends in PCBs and PCDD/Fs were, therefore, assessed in lake sediments of the Grosser Arbersee over the past 130 years (1860-1990). Ballschmiter-PCB concentrations (congeners # 28, 52, 101, 138, 153, 180) increased between 1946 and 1972 from 4.2 to 32.0 microg kg(-1) dry wt, but have since decreased to 25.6 microg kg(-1) dry wt. High chlorinated PCB congeners reached their maxima earlier (1968-1972) than low chlorinated congeners (1985-1991). These trends were consistent with patterns expected from the production and use of PCBs and their precursors. PCDD/F concentrations increased between 1950 from 0.6 microg kg(-1) dry wt to 2.3 microg kg(-1) dry wt in 1977, falling to 1.7 microg kg(-1) dry wt by 1993. PCDF concentrations exceeded those of PCDD until 1968, but afterwards PCDDs (especially OCDD) were predominant. These patterns suggest that domestic heating and waste combustion were the most likely sources, but pollution from local industries, such as metal smelting and glass production, might also have been involved. The data provide a valuable case study from central Europe which confirms the overall declining trends of PCB and PCDD/F contamination shown elsewhere.     

Toxic emissions during co-combustion of biomass-waste wood-lignite blends in an industrial boiler

The objectives of this work were to study the PCDD/F emissions during the co-combustion of waste wood/coal co-combustion in an industrial boiler and to determine the relation of the toxic emissions to the fuel properties. Co-combustion experiments were performed in a 13.8 MWthermal industrial moving grate combustor. The fuels which were examined in this study included Greek lignite, natural uncontaminated wood, power poles and medium density fibers (MDFs) which were by-products of the plant production process. Fuel blends were prepared by mixing single components in various concentrations. PCDD/F emissions were collected during experimental runs and were analyzed according to standard methods. Low PCDD/F emissions were obtained during the co-combustion tests, lower than the limit value of 0.1 ng TEQ/Nm3. The lowest values were observed during the combustion of fuel blends containing MDF, possibly due to the inhibitory action of some of the N-containing MDF ingredients, such as urea. No direct correlation was found between the PCDD/F and the copper emissions, while examination of the PCDD/F homologue patterns revealed the predominance of the lower chlorinated isomers over the higher ones.     

Photolysis of polycyclic aromatic hydrocarbons adsorbed on spruce [Picea abies (L) Karst] needles under sunlight irradiation

Photolysis of polycyclic aromatic hydrocarbons (PAHs) sorbed on surfaces of spruce [Picea abies (L.) Karst.] needles under sunlight irradiation was investigated. PAHs were produced by combustion of polyvinyl chloride (PVC), wood, high-density polyethylene (HDPE), and styrene in a stove. The factors of sunlight irradiation on the surfaces of spruce needles were taken into consideration when investigating the kinetic parameters. The photolysis of the 18 PAHs under study follows first-order kinetics. The photolysis half-lives range from 15 h for dibenzo(a,h)anthracene to 75 h for phenanthrene. Photolysis of some PAHs on surfaces of spruce needles may play an important role on the fate of PAHs in the environment.     

Evaluation of the respicon as a personal inhalable sampler in industrial environments

The Respicon has been introduced as a sampler for health related measurements of airborne contaminants at workplaces. The instrument is aimed at simultaneous collection of three health related aerosol fractions: (a) the coarser inhalable fraction, defining the aerosol fraction that may enter the nose and mouth during breathing; (b) the intermediate thoracic fraction, defining the fraction that may penetrate beyond the larynx and so reach the lung; and (c) the finer respirable fraction, defining the fraction that may penetrate to gas exchange region of the lung. The instrument has a number of features attractive to occupational hygienists: in addition to providing the three aerosol fractions simultaneously, it is light and compact enough to be used as a personal sampler. yet can be a tripod mounted for area sampling, it can provide samples not only for gravimetric analysis but also microscopic and chemical analyses; and it is also available in a photometric direct-reading version. The instrument has previously been evaluated as an area sampler and, in this mode of operation, has shown reasonable accuracy in collecting respirable, thoracic and inhalable particles, the latter up to particle diameters of ca. 80 microm. Except for some scattered unpublished data there exist no systematic investigations in the Respicon's performance when used as a personal sampler in the industrial environment. In this paper, we will report on a study of side by side comparison of the Respicon with the IOM inhalable sampler, regarded as a reference instrument for the inhalable fraction. The main study was performed at six different workplaces in a nickel refinery. Statistical analysis of the gravimetrically-determined concentration data reveals consistently lower aerosol exposure values for the Respicon as compared to the IOM sampler. The data for the nickel workplaces are compared with findings from other studies. The results are interpreted in the light of the overall results and the possibility of introducing a correction factor is discussed.