Ozone pollution and ozone biomonitoring in European cities. Part I: Ozone concentrations and cumulative exposure indices at urban and suburban sites

In the frame of a European research project on air quality in urban agglomerations, data on ozone concentrations from 23 automated urban and suburban monitoring stations in 11 cities from seven countries were analysed and evaluated. Daily and summer mean and maximum concentrations were computed based on hourly mean values, and cumulative ozone exposure indices (Accumulated exposure Over a Threshold of 40 ppb (AOT40), AOT20) were calculated. The diurnal profiles showed a characteristic pattern in most city centres, with minimum values in the early morning hours, a strong rise during the morning, peak concentrations in the afternoon, and a decline during the night. The widest amplitudes between minimum and maximum values were found in central and southern European cities such as Düsseldorf, Verona, Klagenfurt, Lyon or Barcelona. In the northern European cities of Edinburgh and Copenhagen, by contrast, maximum values were lower and diurnal variation was much smaller. Based on ozone concentrations as well as on cumulative exposure indices, a clear north–south gradient in ozone pollution, with increasing levels from northern and northwestern sites to central and southern European sites, was observed. Only the Spanish cities did not fit this pattern; there, ozone levels were again lower than in central European cities, probably due to the direct influence of strong car traffic emissions. In general, ozone concentrations and cumulative exposure were significantly higher at suburban sites than at urban and traffic-exposed sites. When applying the newly established European Union (EU) Directive on ozone pollution in ambient air, it was demonstrated that the target value for the protection of human health was regularly surpassed at urban as well as suburban sites, particularly in cities in Austria, France, northern Italy and southern Germany. European target values and long-term objectives for the protection of vegetation expressed as AOT40 were also exceeded at many monitoring sites.     

Chapter three: methodology of exposure modeling

In this chapter, the concept of exposure assessment and its evolution is introduced, and evaluated by critically appraising the pertinent literature as it applies to exposures to Particulate Matter (PM). Exposure measurement or estimation methodologies and models are reviewed. Three exposure/measurement methodologies are assessed. Estimation methods focus on source evaluation and attribution, sources include those outdoors and indoors as well as in occupational and in-transit environments. Fate and transport models and their inputs are addressed to estimate concentrations outdoors and indoors; source attribution techniques help focus on the contributing sources. Activity pattern techniques are also reviewed and their use in exposure models to estimate inhalation exposure to PM is presented. Deterministic, regression and other stochastic models of exposure to PM are reviewed and evaluated. Strengths, limitations, assumptions and affirmations of the use of exposure assessment as an integral component of risk assessment and risk management are discussed in the conclusions and discussions section of this work.     

UDS-test with freon 11 (R-11)

Trichlorofluoromethane, in concentrations of 80, 400, 2 000, 10 000 and 50 000 ppm, was administered to rats of both sexes (Sprague Dawley) by inhalation exposure. 2 000 ppm in air (= 11 200 mg/m³) amount to twice the MAK value of 1 000 ppm. At exposure times of 4 hours this corresponds to the MAK value defined for an 8 hour workday. Unscheduled DNA synthesis (UDS) was measured in single-cell suspensions of hepatocytes, pulmonary epithelial cells and lymphocytes of the spleen, respectively. In the pulmonary cells concentrations of 2 000, 10 000 and 50 000 ppm of freon 11 lead to a significantly increased mean silver grain count compared to a negative control group. In spleen and liver cells increasing concentrations of R 11 tend to increase the incorporation of thymidine into the DNA of the cells. These changes of the extent of unscheduled DNA synthesis can, however, not be statistically verified.     

The SeKT joint research project: definition of reference conditions, control sediments and toxicity thresholds for limnic sediment contact tests

- In current biotest approaches, intact organisms or in vitro systems are exposed to sediments using different exposure scenarios. The most important issue in sediment toxicity testing protocols is the question which test phase (solid or liquid) should be used. Whole-sediment exposure protocols represent the most realistic scenario to simulate in situ exposure conditions in the laboratory. However, until now there is no agreement in how to acquire and to evaluate the data of the various available sediment contact assays. The SeKT joint research project was initiated with the aim to compare recently developed sediment contact assays by addressing reference conditions, control sediments and toxicity thresholds for limnic sediment contact tests.     

Congener-specific concentrations and carbon stable isotope ratios (delta13C) of two technical toxaphene products (Toxaphene and Melipax)

In this study we compared the contribution of individual congeners and the ratios of stable carbon isotopes of two technical toxaphene products. The former US-American product Toxaphene was from 1978 and the East-German product Melipax from 1979. Both technical products showed the known complexity in GC/ECD measurements. Contributions of 24 peaks to each of the technical products were determined by gas chromatography in combination high resolution electron capture negative ion mass spectrometry (GC/ECNI-HRMS). The percentages of the compounds studied in the technical mixtures ranged from approximately 0.05% to approximately 2.5% but showed some individual differences. 2,2,5,5,8,9,9,10,10-nonachlorobornane (B9-1025 or P-62) was identified as a major congener in both mixtures. 2-Endo,3-exo,5-endo,6-exo,8,8,10,10-octachlorobornane (B8-1413 or P26) and 2-endo,3-exo,5-endo,6-exo,8,8,9,10,10-nonachlorobornane (B9-1679 or P-50) were found at similar concentration in both technical products. Identical amounts of Melipax or Toxaphene were combusted to CO2 in an element analyzer and their delta13C values were determined relative to the international standard Vienna PeeDee belemnite (VPDB). The mean delta13C values of both products varied by 2.8% (determined at two different locations) which is roughly one order of magnitude more than the precision obtained in repetitive analyses of the individual products. Thus, both investigated products could be unequivocally distinguished by stable isotope ratio mass spectrometry (IRMS). IRMS analyses may thus be a suitable tool for tracing back toxaphene residues in environmental and food samples to the one or both of the products.     

Atmospheric versus biological sources of polycyclic aromatic hydrocarbons (PAHs) in a tropical rain forest environment

To distinguish between pyrogenic and biological sources of PAHs in a tropical rain forest near Manaus, Brazil, we determined the concentrations of 21 PAHs in leaves, bark, twigs, and stem wood of forest trees, dead wood, mineral topsoil, litter layer, air, and Nasutitermes termite nest compartments. Naphthalene (NAPH) was the most abundant PAH with concentrations of 35 ng m(-3) in air (>85% of the sum of 21PAHs concentration), up to 1000 microg kg(-1) in plants (>90%), 477 microg kg(-1) in litter (>90%), 32 microg kg(-1) in topsoil (>90%), and 160 microg kg(-1) (>55%) in termite nests. In plants, the concentrations of PAHs in general decreased in the order leaves > bark > twigs > stem wood. The concentrations of most low-molecular weight PAHs in leaves and bark were near equilibrium with air, but those of NAPH were up to 50 times higher. Thus, the atmosphere seemed to be the major source of all PAHs in plants except for NAPH. Additionally, phenanthrene (PHEN) had elevated concentrations in bark and twigs of Vismia cayennensis trees (12-60 microg kg(-1)), which might have produced PHEN. In the mineral soil, perylene (PERY) was more abundant than in the litter layer, probably because of in situ biological production. Nasutitermes nests had the highest concentrations of most PAHs in exterior compartments (on average 8 and 15 microg kg(-1) compared to <3 microg kg(-1) in interior parts) and high PERY concentrations in all compartments (12-86 microg kg(-1)), indicating an in situ production of PERY in the nests. Our results demonstrate that the deposition of pyrolytic PAHs from the atmosphere controls the concentrations of most PAHs. However, the occurrence of NAPH, PHEN, and PERY in plants, termite nests, and soils at elevated concentrations supports the assumption of their biological origin.     

Determination of herbicides in stemflow and throughfall of beeches (Fagus sylvatica L.) and in rainfall

The pesticide contamination of water samples collected in and nearby a beech forest in northern Germany was evaluated. For this purpose, a method for the collection of water samples from stemflow and throughfall of beeches (Fagus sylvatica L.) and rainfall was developed in response to the demands for the analysis of organic contaminants in water samples. Furthermore a sensitive and selective multiresidue method was developed to determine 18 pesticides, frequently used in Germany, in aqueous samples. The samples collected were taken from the stemflow, the crown throughfall and the rainfall between May and November 2001. Analysis based on reversed-phase liquid chromatography with a pneumatically assisted electrospray mass spectrometer followed a solid phase extraction using C-18 extraction cartridges. Isoproturon, metolachlor, prosulfocarb and terbuthylazine were found during and shortly after their application period. In rainfall metolachlor, terbuthylazine and prosulfocarb were detectable in concentrations between 5 and 65 ng l(-1) and isoproturon in concentrations between 20 and 360 ng l(-1) respectively. In most of the samples, concentrations of those four pesticides were higher and detectable for a longer time in stemflow than in rainfall. Crown throughfall samples were collected from the end of August to November. Absolute deposition of isoproturon to forest soil were up to 70 times higher in comparison to rainwater samples.