不同玉米品种对新鲜城市污泥处理效果的初步研究

寻求城市污泥安全农用的方法是当前城市污泥处理处置的重要研究课题之一.采用小区试验,研究了8个玉米品种对新鲜城市污泥处理效果.结果表明:所选择的8个玉米品种均可以在污泥上生长,大丰5品种对锌的累积量最低,04杂1品种对镉累积量最低,会单4品种对铜和铅累积量最低;玉米种植可显著降低城市污泥中的含水率,比不种玉米的对照处理(69.43%)水分去除率提高9.05%~17.50%,有利于城市污泥的干化及后续利用;各玉米品种植株中的总养分(氮+五氧化二磷+氧化钾)均高于有机肥标准(NY525—2012)的总养分要求,而重金属镉和铅的质量浓度除赛田3品种外其他品种均低于农用有机肥标准(NY525—2012)的限量值;玉米种植后城市污泥中的总养分和锌、镉、铜、铅4种重金属质量浓度变化很小.可见,利用玉米处理新鲜的城市污泥既可降低城市污泥中的水分,又可以产生一定量优质的有机肥原料,为城市污泥的资源化利用提供新思路.     

流化床O2/CO2气氛下添加SiO2对燃煤PM2.5的控制

采用小型流化床研究了在O2/CO2气氛下添加SiO2对PM2.5(空气动力学直径小于2.5 μm的颗粒物)的控制,试验在1123 K、O2/CO2气氛下进行,并采用荷电低压撞击器(ELPI)采集和分析燃烧后的PM2.5.结果表明,添加SiO2是燃烧过程中影响PM2.5生成的重要因素.添加SiO2后,生成PM1的质量浓度均降低,而PM1-2.5的质量浓度均略有增加;PM2.5质量粒径分布均呈双峰分布,峰值分别出现在0.2 μm和2.0μm左右.随着SiO2添加量的增加,PM2.5中的S、K、Na、Cu和Pb元素的含量呈减少的趋势;随着颗粒粒径减小,S、K、Na、Cu和Pb元素的含量有增高的趋势.     

La3+掺杂对吸附相反应制备TiO2复合催化剂的结晶过程及弱紫外光下活性的影响

利用吸附相反应技术制备弱紫外光响应的高效催化剂,并通过XRD、XPS以及HRTEM探索了不同焙烧温度下La3+掺杂量对TiO2结晶过程的影响.结合弱紫外光下甲基橙的降解反应,深入研究催化剂结晶过程的变化对弱紫外光下催化剂活性的影响.结果表明,La3+掺杂会抑制TiO2的结晶过程.当焙烧温度或者掺杂量较低时,La3+不能进入TiO2的晶格结构但会轻微地抑制TiO2的结晶过程;未进入晶格结构的La3+存在会引入光生载流子的浅能级捕获中心,在弱光体系中极大提升了催化剂的活性.当La3+的掺杂量为0.05%(原子分数)时,经过900℃焙烧后催化剂降解能力最高,其活性超过商用P25的2倍多.在较高La3+掺杂量(超过0.20%)时,900℃焙烧后一定量La3+进入TiO2的晶格结构而大大抑制了TiO2结晶;这种强烈的抑制作用使得催化剂中存在大量无定形结构TiO2,无定形TiO2甚至多于700℃焙烧后的催化剂,反而大大抑制了弱光体系中催化剂活性.     

酱糟与醋糟混合发酵产沼气研究

酱糟、醋糟是我国食品酿造行业产生的废弃物,通过厌氧发酵不仅可以解决废糟处理问题又可获取能源.因此本研究在中温(35±1)℃的条件下,根据C/N比的不同,进行了酱糟/醋糟干物质(TS)比分别为1∶0(N1)、1∶1.5(N2)、1∶3(N3)、1∶7(N4)、1∶18(N5)和0∶1(N6)的混合发酵实验.结果表明,单一酱渣的延滞期为17.46 d,混合发酵明显缩短了延滞期,为3.00-3.83 d;混合发酵组(N2～N5)累计产甲烷量的实验结果比计算结果分别提高了1％、16％、14％和10％,其中,N3组C/N比为25.7∶1,提高最为明显;各组发酵产生的沼气的甲烷体积分数在65％～ 70％之间;Gompertz模型拟合可以用于酱糟和醋糟混合发酵产甲烷的过程;酱、醋糟发酵的产酸类型以乙酸型发酵为主.     

流化床焚烧含盐苯胺废液的NOx排放特性

在流化床焚烧实验装置上进行含盐苯胺(C6H5NH2)废液的焚烧实验研究,用IMR-IMR2800P废气分析仪对焚烧尾气成分进行了在线监测,考察了焚烧工艺条件对NOx排放浓度的影响规律.结果显示:采用分级燃烧工艺和提高焚烧温度,可以降低NOx浓度;增大进料速率却导致NOx排放浓度的增加.当过剩空气系数(α)低于1.0时,NOx排放浓度随着α的增大急剧上升;大于1.1时,NOx排放浓度随α增加而减小.苯胺废液高温焚烧时添加氯化钠能降低NOx排放.     

短程硝化颗粒污泥的快速培养与硝化特性研究

以城市污水处理厂剩余污泥为种泥,以2 min沉淀时间为选择压,在序批式反应器(SBR)中快速培养出好氧颗粒污泥。经过60个周期(20 d),反应器内出现砂粒状颗粒,并持续稳定运行120 d。成熟的颗粒污泥平均粒径856.56μm,具有良好的硝化性能。SBR反应器以固定曝气时间方式运行,亚硝酸盐积累率达80%以上,实现了稳定短程硝化。试验结果表明:絮体污泥(即接种污泥)与颗粒污泥的硝化过程相似但略有差异。二者差别在于,氨氮氧化结束后,继续曝气120 min,絮体污泥将亚硝酸盐完全转化为硝酸盐,而颗粒污泥仅将部分亚硝酸盐转化且过程比较缓慢。     

景观用再生水氮磷条件下两种典型水华藻类的生长及竞争规律

针对再生水景观水体的藻类控制,以BG11培养基为基础,设定不同氮磷浓度,对铜绿微囊藻和小球藻进行了纯培养和共培养实验。实验结果表明:初始总氮浓度为15 mg/L、总磷浓度为0.1 mg/L时两种藻就能出现明显的生长高峰;当总氮浓度为3⁴5 mg/L,氮磷比为3045 mg/L,氮磷比为30¹50的情况下,小球藻在与铜绿微囊藻的竞争中容易成为优势藻种。     

Research on the evolvement of morphology of coking coal during the coking process

The evolvement of morphology and structure of the coal with different metamorphic degrees during coking process in the vertical furnace was investigated by infrared Image detector. Moreover, the temperature distribution in the radial direction and the crack formation were also studied in heating process. The results show that the amount of crack and the shrinkage level of char decrease with the coal rank rising. In addition, the initial temperature of crack formation for char increases with the coal rank rising.     

Interface-mediated synthesis of monodisperse ZnS nanoparticles with sulfate-reducing bacterium culture

We have created a new method of ZnS nanospheres synthesis. By interface-mediated precipitation method (IMPM), monodisperse ZnS nanoparticles was synthesized on the particle surface of sulfate-reducing bacterium nutritious agar culture. Sulfate-reducing bacterium (SRB) was used as a sulfide producer because of its dissimilatory sulfate reduction capability, meanwhile produced a variety of amino acids acting as templates for nanomaterials synthesis. Then zinc acetate was dispersed into nutritious agar plate. Subsequently agar plate was broken into particles bearing much external surface, which successfully mediated the synthesis of monodisperse ZnS nanoparticles. The morphology of monodisperse ZnS nanospheres and SRB were examined by scanning electron microscopy (SEM), and the microstructure was investigated by X-ray diffraction (XRD). The thermostability of ZnS nanoparticles was determined by thermo gravimetric-differential thermo gravimetric (TG-DTG). The maximum absorption wavelengh was analysed with an ultraviolet-visible spectrophotometer within a range of 199–700 nm. As a result, monodisperse ZnS nanoparticles were successfully synthesized, with an average diameter of 80 nm. Maximum absorption wavelengh was 228 nm, and heat decomposed temperature of monodisperse ZnS nanoparticles was 596°C.     

Interface-mediated synthesis of monodisperse ZnS nanoparticles with sulfate-reducing bacterium culture

We have created a new method of ZnS nanospheres synthesis. By interface-mediated precipitation method (IMPM), monodisperse ZnS nanoparticles was synthesized on the particle surface of sulfate-reducing bacterium nutritious agar culture. Sulfate-reducing bacterium (SRB) was used as a sulfide producer because of its dissimilatory sulfate reduction capability, meanwhile produced a variety of amino acids acting as templates for nanomaterials synthesis. Then zinc acetate was dispersed into nutritious agar plate. Subsequently agar plate was broken into particles bearing much external surface, which successfully mediated the synthesis of monodisperse ZnS nanoparticles. The morphology of monodisperse ZnS nanospheres and SRB were examined by scanning electron microscopy (SEM), and the microstructure was investigated by X-ray diffraction (XRD). The thermostability of ZnS nanoparticles was determined by thermo gravimetric-differential thermo gravimetric (TG-DTG). The maximum absorption wavelengh was analysed with an ultravioletvisible spectrophotometer within a range of 199-700 nm. As a result, monodisperse ZnS nanoparticles were successfully synthesized, with an average diameter of 80 nm. Maximum absorption wavelengh was 228 nm, and heat decomposed temperature of monodisperse ZnS nanoparticles was 596℃.