春季南黄海溶解有机碳的分布特征及其受控因素

依据2007年4月对南黄海调查所得的溶解有机碳(DOC)数据,初步分析了南黄海DOC的分布特征及其影响因素。结果表明,2007年春季南黄海DOC的质量浓度为0.91～2.69 mg/L,平均值为1.62 mg/L,北部近岸DOC浓度高,长江口北部海域及南黄海中部外海DOC含量较低;在垂直方向上,10 m层DOC含量略高,各水层量值相差不大。DOC的分布趋势主要受控于水文结构,某些河口海域,生物生产对DOC含量也有一定的贡献。     

清洁发展机制项目运作关键问题分析与管理对策研究

清洁发展机制（CDM）项目要想能够顺利通过一系列审查并最终获得减排量,需要特别重视项目运作流程中的关键环节。针对中国CDM项目审批数量少,通过率低,耗费时间长等问题,本文在分析CDM内涵及项目运作流程的基础上,指出了中国CDM项目运作中面临的主要问题,提出了相应的管理对策与建议,期望能够为中国推进CDM项目实施提供帮助。     

有机毒害物急性毒性与藻红外辐射变化研究

基于微生物检测毒害物质的重要性和选材困难对其检测技术发展的制约,开展了有机毒害物急性毒性与藻红外辐射变化研究。试验使用便携式红外测温仪测试一定量藻液中分别加入不同种有机药剂前后的温度变化。结果表明,8种藻对10种有机毒害物毒性可产生红外辐射变化的快速响应,平均最大温差的平均值为0.15℃,平均响应时间为4.4min;羊角月牙藻最大响应温差为0.27℃,响应相对明显,为8种藻中的毒性响应敏感藻。不同浓度有机药剂分别与敏感藻进行试验,明确敏感藻可检测出的最低药剂浓度,结果表明:同类毒害物质的响应灵敏度与发光细菌相同。     

Soil selenium concentration and Kashin-Beck disease prevalence in Tibet, China

In order to investigate the correlation between the prevalence of Kashin-Back disease (KBD) and Se concentrations, natural soil samples and cultivated soil samples were collected from southeastern Tibet, China; and the soil Se concentrations were measured by atomic fluorescent spectrophotometer. It was found that the mean Se concentrations of natural soil samples in KBD areas, from the first layer to the third layer, were 0.17 mg/kg, 0.11 mg/kg, and 0.10 mg/kg, respectively, and in nondisease areas were 0.21 mg/kg, 0.24 mg/kg, and 0.13mg/kg, respectively. The mean Se concentrations of cultivated soil samples were 0.10 mg/kg in KBD areas and 0.23 mg/kg in non-disease areas, respectively. Soil Se concentrations in KBD areas were lower than that in non-disease areas, and the mean concentrations of soil Se in Tibet were lower than the average of China (0.29 mg/kg). Therefore, there is a close relationship between soil Se concentrations and KBD in Tibet. More studies should be concentrated on the impacts of Se deficiency in soils and its relationship with Se concentrations in food-grain and the human body in Tibet areas.     

A mini-microbial fuel cell for voltage testing of exoelectrogenic bacteria

Current methods for testing the electricity generation capacity of isolates are time- and labor-consuming. This paper presents a rapid voltage testing system of exoelectrogenic bacteria called Quickscreen, which is based on a microliter microbial fuel cell (MFC). Geobacter sulfurreducens and Shewanella baltica were used as the model exoelectrogenic bacteria; Escherichia coli that cannot generate electricity was used as a negative control. It was found that the electricity generation capacity of the isolates could be determined within about five hours by using Quickscreen, and that its time was relatively rapid compared with the time needed by using larger MFCs. A parallel, stable, and low background voltage was achieved using titanium as a current collector in the blank run. The external resistance had little impact on the blank run during the initial period. The cathode with a five-hole configuration, used to hydrate the carbon cathode, gave higher cathode potential than that with a one-hole configuration. Steady discharge and current interrupt methods showed that the anode mostly contributed to the large internal resistance of the Quickscreen system. However, the addition of graphite felt decreased the resistance from 18 to 5 kΩ. This device was proved to be useful to rapidly evaluate the electricity generation capacity of different bacteria.     

蛭石吸附及解吸锌离子特性研究

用蛭石对锌离子的吸附解吸进行了实验研究,初步探讨了其对锌离子吸附解吸的机理。研究结果表明：蛭石对Zn^2＋具有较强的吸附能力,吸附在8h左右接近平衡。随着锌离子浓度的增加,蛭石的吸附量也在逐渐增加,当锌离子浓度达到400mg／L时,吸附量趋于平稳。在完成吸附实验的基础上,分别采用过滤和取上清液的方法解吸,实验证明静置平衡后,取出上清液50ml,再加入50ml解吸剂的方法解吸效果较好;解吸时间在0h到12h,蛭石的解吸量呈现递增的趋势,且达到1．070mg／g;在12h到48h内,解吸量基本没有增加,其中在24h时达到最大解吸量1．074mg／g。不同的解吸剂对蛭石解吸锌离子影响效果不同：蒸馏水不能使锌离子解吸;K^＋的影响作用相对于Na^＋更明显,随着两种阳离子浓度的增加,蛭石的解吸量逐渐增加。     

新生产空调客车内挥发性有机物浓度水平和来源分析

选取某厂家新生产的、下线时间不超过28d的53座新空调客车,在车辆处于静止状态下采用二次热解析-毛细管气相色谱/质谱联用法测量新空调车内挥发性有机物的分布特征和浓度水平.根据NIST02标准谱图进行匹配检索,结合色谱保留时间定性,共定性检出33种挥发性有机物,包括烷烃(15种、45.4%)、芳香类化合物(9种、27.3%)、醇(4种、12.1%),酮(3种、9.1%)、酯(2种、6.1%),且大多集中在C6～C10的范围内.新车内浓度最高的前5种挥发性有机物分别为癸烷(8.01 mg/m3)、3-甲基己烷(7.10mg/m3)、庚烷(5.10mg/m3)、异庚烷(4.20 ms/m3)和1-甲基,3-乙基苯(3,56 mg/3),总挥发性有机物TV012,52.5mR/m3.烷烃主要来源于空调车内部保温材料如聚氨酯(PU)发泡海绵或者聚乙烯(PE)发泡材料的释放,而车内检出的芳香族化合物主要来自汽车内饰用胶粘剂、密封胶等的释放.     

几种医疗垃圾处理技术综述

医疗废物是一类危害极大的特殊废物。自20世纪50年代起,医疗废物的处理已引起世界各国的广泛重视。目前,国内外学者对医疗废物处理技术的研究日益丰富,已经取得了一定的研究成果。在此基础上,通过综合比较焚烧处理、高压蒸汽灭菌处理、化学处理、微波处理、热解处理等几种医疗废物处理技术,综合评定了各种处理工艺的技术参数及优缺点,最后比较分析得出了高温热解法具有多方面的优点,是目前国内外首推的医疗废物处理技术。     

复合混凝剂用于夏季太湖水混凝脱浊研究

用特征粘度系列化的聚二甲基二烯丙基氯化铵(PDM)与聚合氯化铝(PAC)复合得到稳定的复合混凝剂,用于夏季高藻太湖水强化混凝脱浊处理.通过混凝烧杯实验.考察了无机/有机复合比例、PDM特征粘度对脱浊效果及絮团沉淀性能的影响.结果表明,对浊度为30-33 NTU,温度为28～30℃,藻含量为2.6×107个儿的太湖水,在与某市水厂混凝强度相近的搅拌强度下.当达到该水厂2NTU沉淀池出水的余浊标准时,PAC需7.00 mg/L的投加量.质量复合比例为5:1、10:1、20:1的PAC(以Al2O3计)/PDM复合混凝剂所需PAC投加量随PDM特征粘度0.52、1.53、2.46 dL/g的增加分别为3.00-2.83 ms/L、3.50-3.49ms/L、5.37-4.67 mg/L,相对于PAC减少投加量57.14%-59.57%、50%-50.14%、23.29%-33.29%;作为深度处理的技术准备.当沉淀出水浊度要求提高至1NTU的情况下,复合药剂依然可发挥好的作用,PAC需10 mg/L的投加量,PAC(以Al2O3计)与PDM质量复合配比为20:1、10:1、5:1的复合混凝剂需8.33-3.91 mg/L的投加量,能比PAC减少投加量16.7%～60.9%.可见,PDM明显提高了PAC的混凝脱浊效果与沉淀性能,且PAC/PDM质量复合配比越低,PDM特征粘度越高,脱浊效果与沉淀性能越好.     

高校宿舍甲醛污染健康风险评价

针对高校宿舍空间及人均面积占有量较小的特点,导致室内空气污染严重,尤其是新装修的宿舍,由装修所带来的污染不可忽视.本文以装修所带采的典型污染物甲醛为测评对象,分别测定了男女生宿舍室内甲醛含量在一天内的变化,利用SPSS软件分析得出甲醛浓度的变化规律,且女生宿舍甲醛浓度大约是男生宿舍的1.3倍,并对此给出了合理解释.利用EPA健康风险评价模型得出室内甲醛污染带来的致癌风险,最后提出了4项科学具体的预防措施,旨在提高人们对高校宿舍装修带来的污染的重视.