以红薯浸泡液为碳源的生物反硝化

为选择低碳氮比污水生物脱氮中合适的碳源,以搅拌罐浸泡淀粉类物质释放碳源,在确定利用红薯浸泡液为碳源后,以浸没式生物滤池为反应器进行生物反硝化实验。实验结果表明:20 g红薯置于2 L自来水中,采用250 r/m in的搅拌速度,搅拌频率为每搅拌3 h停1 h,2 d后得到的浸泡液COD浓度平均为5 921 mg/L,最高可超过7 000 mg/L;将此红薯浸泡液和污水以1∶50的流量比例,采用分别投加的方式进入反应器,污水中总氮、硝酸盐氮、亚硝酸盐氮及氨氮的平均去除率分别为88.6%、91.6%、88.2%和54.8%,出水COD平均在30 mg/L以下;在红薯浸泡液COD浓度为5 700 mg/L左右时,进水中亚硝酸盐氮浓度与硝酸盐氮浓度比为3∶2时总氮去除率为95.3%,当该比例为2∶3时总氮去除率为88.2%。研究表明,红薯浸泡液是一种经济合适的碳源,采用红薯浸泡液作为低碳氮比污水生物处理中反硝化的碳源是可行的。     

剩余污泥减量化工艺条件优化研究

运用超声处理连续流活性污泥系统中不同种类的污泥,并将其回流至原系统中,研究其剩余污泥减量化效果。按正交实验设计并进行试验,确定最优工艺条件。结果表明:当声能密度为0.6 W/mL,作用时间为5 min,超声污泥为混合污泥,回流比为7∶120时,减量效果最佳。且在该条件下经一周期的运行,污泥减量效果达到96.24%,COD由进水的830 mg/L降至44 mg/L,NH4+-N和TN分别由进水的62.43 mg/L和103.19 mg/L,降解到2.31 mg/L和6.52 mg/L,达到《城镇污水处理厂污染物排放标准》(GB18918-2002)一级排放标准。     

A competitive indirect enzyme-linked immunoassay for lead ion measurement using mAbs against the lead-DTPA complex

Immunoassays for quantitative measurement of environmental heavy metals offer several advantages over other traditional methods. To develop an immunoassay for lead, Balb/c mice were immunized with a lead-chelate-protein conjugate to allow maximum exposure of the metal to the immune system. Three stable hybridoma cell lines were obtained through spleen cells fusion with Sp2/0 cells. One cell line, 2A11D11, produced mAbs with preferential selectivity and sensitivity for Pb-DTPA than DTPA, exhibiting an affinity constant of 3.34 ± 0.24 × 10⁹ M⁻¹. Cross reactivity (CR) with other metals were below 1%, except for Fe(III) with a CR less than 5%. This quantitative indirect ELISA for the lead ion was used to detect environmental lead content in local water sources; importantly, the results from the immunoassay were in excellent agreement with those from ICP-MS. Development of immunoassays for metal ions may thus facilitate the detection and regulation of environmental pollution.     

Impact of anthropogenic emissions and open biomass burning on regional carbonaceous aerosols in South China

Carbonaceous aerosols were studied at three background sites in south and southwest China. Hok Tsui in Hong Kong had the highest concentrations of carbonaceous aerosols (OC = 8.7 ± 4.5 μg/m³, EC = 2.5 ± 1.9 μg/m³) among the three sites, and Jianfeng Mountains in Hainan Island (OC = 5.8 ± 2.6 μg/m³, EC = 0.8 ± 0.4 μg/m³) and Tengchong mountain over the east edge of the Tibetan Plateau (OC = 4.8 ± 4.0 μg/m³, EC = 0.5 ± 0.4 μg/m³) showed similar concentration levels. Distinct seasonal patterns with higher concentrations during the winter, and lower concentrations during the summertime were observed, which may be caused by the changes of the regional emissions, and monsoon effects. The industrial and vehicular emissions in East, Southeast and South China, and the regional open biomass burning in the Indo-Myanmar region of Asia were probably the two major potential sources for carbonaceous matters in this region.     

CCS scenarios optimization by spatial multi-criteria analysis: Application to multiple source sink matching in Hebei province

A method, based on spatial analysis of the different criteria to be taken into consideration for building scenarios of CO₂ capture and storage (CCS), has been developed and applied to real case studies in the Hebei province. Totally 88 point sources (42 from power sector, 9 from iron and steel, 18 from cement, 16 from ammonia, and 3 from oil refinery) are estimated and their total emission amounts to 231.7 MtCO₂/year with power, iron and steel, cement, ammonia and oil refinery sharing 59.13%, 25.03%, 11.44%, 3.5%, and 0.91%, respectively. Storage opportunities can be found in Hebei province, characterised by a strong tectonic subsidence during the Tertiary, with several kilometres of accumulated clastic sediments. Carbon storage potential for 25 hydrocarbon fields selected from the Huabei complex is estimated as 215 MtCO₂ with optimistic assumption that all recovered hydrocarbon could be replaced by an equivalent volume of CO₂ at reservoir conditions. Storage potential for aquifers in the Miocene Guantao formation is estimated as 747 MtCO₂ if closed aquifer assumed or 371 MtCO₂ if open aquifer and single highly permeable horizon assumed. Due to poor knowledge on deep hydrogeology and to pressure increase in aquifer, injecting very high rates requested by the major CO₂ sources (>10 MtCO₂/year) is the main challenge, therefore piezometry and discharge must be carefully controlled. A source sink matching model using ArcGIS software is designed to find the least-cost pathway and to estimate transport route and cost accounting for the additional costs of pipeline construction due to landform and land use. Source sink matching results show that only 15–25% of the emissions estimated for the 88 sources can be sequestrated into the hydrocarbon fields and the aquifers if assuming sinks should be able to accommodate at least 15 years of the emissions of a given source.     

Atmospheric deposition of phthalate esters in a subtropical city

In Chinese cities, air pollution has become a serious and aggravating environmental problem undermining the sustainability of urban ecosystems and the quality of urban life. Bulk atmospheric deposition samples were collected two-weekly, from February 2007 to January 2008, at three representative areas, one suburban and two urbanized, in the subtropical city, Guangzhou, China, to assess the deposition fluxes and seasonal variations of phthalate esters (PAEs). Sixteen PAE congeners in bulk deposition samples were measured and the depositional fluxes of ∑₁₆PAEs ranged from 3.41 to 190 μg m^?2 day^?1, and were highly affected by local anthropogenic activities. The significant relationship between PAEs and particulate depositional fluxes (correlation coefficient R² = 0.72, P < 0.001) showed PAEs are associated primarily with particles. Temporal flux variations of PAEs were influenced by seasonal changes in meteorological parameters, and the deposition fluxes of PAEs were obviously higher in wet season than in dry season. Diisobutyl phthalate (DiBP), Di-n-butyl phthalate (DnBP), and Di(2-ethylhexyl) phthalate (DEHP) dominated the PAE pattern in bulk depositions, which is consistent with a high consumption of the plasticizer market in China. PAE profiles in bulk deposition showed similarities exhibited in both time and space, and a weak increase of high molecular weight PAE (HMW PAE) contribution in the wet season compared to those in the dry season. Average atmospheric deposition fluxes of PAEs in the present study were significantly higher than those from other studies, reflecting strong anthropogenic inputs as a consequence of rapid industrial and urban development in the region.     

饮用水消毒副产物控制工艺研究进展

通过对氯、二氧化氯、紫外线等常见消毒工艺以及去除已生成消毒副产物的深度处理工艺进行了分析,探讨了各种消毒工艺的消毒性能和对消毒副产物的控制效果以及各种深度处理工艺对消毒副产物的去除性能,为实际水处理中消毒以及深度处理工艺的选择提供了参考。     

碳纳米管电极原位产生过氧化氢及其对亚甲基蓝脱色效果简

将碳纳米管固定化制成多孔疏水性导电薄膜构建电化学阴极还原体系,实现过氧化氢在阴极的原位产生。电极特性研究表明,电极在较宽的电压范围内均具有较好的活性。考察了阴极电位、电极成分、氧气流量和电解质浓度对过氧化氢原位产生的影响,在优化条件下经过120 min后过氧化氢达到66.17 mg/L,并探讨过氧化氢原位产生的机理。在此基础上考察原位过氧化氢氧化工艺下对亚甲基蓝的脱色效果,并分析其脱色机理。     

响应面法优化甘蔗渣-污泥复合活性炭的制备工艺

为了提高污泥活性炭的吸附性能以提升其实际应用价值,提出在污泥中掺杂甘蔗渣制备复合活性炭,并采用Plackett-Burman联用响应面法对影响复合活性炭碘值的条件进行筛选优化。通过Plackett-Burman实验筛选出热解温度、热解时间和甘蔗渣与污泥干重比为主要影响因素,对这3个因素进行Box-Behnken实验,经响应面优化得到影响碘值的二次响应曲面模型,模型显示热解温度与热解时间、热解温度与干重比的交互作用显著,并确定了最佳制备条件:热解温度550℃、热解时间30 min和干重比50%,此时复合活性炭碘值为814 mg/g,优于未优化条件下制备的复合活性炭。通过比表面积、孔结构和碘值的测定以及元素和扫描电镜分析得出,甘蔗渣的掺杂提高了复合活性炭的比表面积、微孔体积、碘值及含碳量。研究结果表明,甘蔗渣掺杂和制备条件优化是提高污泥活性炭吸附性能的有效手段。     

Mn/γ-Al2O3催化剂的制备及头孢合成废水的催化臭氧氧化法深度处理

对Mn/γ-Al₂O₃催化剂的制备条件及头孢合成废水的催化臭氧氧化法深度处理工艺条件进行了优化。实验结果表明：以Mn（NO₃）₂溶液为浸渍液,Mn/γ-Al₂O₃催化剂的最优制备条件为浸渍液浓度0.10 mol/L、浸渍时间9 h、焙烧温度400 ℃、焙烧时间2 h;在反应时间为30 min、废水pH为9.0、臭氧通量为4.6 mg/min、催化剂加入量为5 g/L的条件下,当进水COD、BOD₅、ρ（氨氮）和色度分别为220~250 mg/L,8~10 mg/L,10~12 mg/L和60~70倍时,出水COD、BOD₅、ρ（氨氮）和色度的平均去除率分别为53%,30%,33%和93%,出水水质满足GB 21904—2008《化学合成类制药工业水污染物排放标准》的要求。