一种新型环境矿物材料在废水处理中的应用研究

实验研究表明 ,磷矿石作为一种新型环境矿物材料对重金属离子工业废水具有较好的处理效果 ,且自身具有显著的优点。采用分级处理的方法以及磷矿石的合适用量可以使处理后的工业废水达到排放标准甚至饮用标准 ,同时 ,由于磷矿石去除重金属离子速度快 ,在瞬间即可发生作用 ,使得利用动态法进行工业废水的连续处理成为可能 ,而且不会产生二次污染 ,具有工艺应用意义     

反硝化除磷的影响特性试验

采用SBR反应器（厌氧/缺氧/好氧工艺）,分别研究了乙酸盐及硝酸盐浓度变化对反硝化除磷的影响特性.试验结果表明,当进水COD浓度＞230 mg/L时,乙酸盐浓度的变化对释磷、除磷速率等影响并不显著.在硝酸盐浓度＜30 mg/L时,硝酸盐浓度越高,缺氧段除磷速率也就越高.在C/P＞23,C/N＞5条件下,SBR系统对磷、氮去除率在90%以上.     

秸秆固定化石油降解菌降解原油的初步研究

用秸秆做载体固定嗜碱芽孢杆菌(Bacillus alcalophilus SG)降解原油,其原油去除率为73.88%,高于单纯投加菌液或者菌液与秸秆的混合物的原油去除率.秸秆的最佳投加量(干重)为25.0 g/L,最佳固定化时间为30 h.用预处理过的秸秆固定SG,降低了固定化SG的原油去除率.在固定化培养基中添加无机盐离子,促进了固定化SG对原油的降解.不同初始pH的原油培养基在固定化SG降解原油的过程中逐渐呈中性或偏碱性.固定化SG在pH 6.0～10.0时对原油均有不错的降粘能力.     

污泥的粘度与浓度、温度三者关系式的实验推导

通过融合污泥粘度与污泥浓度关系式、污泥粘度与温度关系式,得到一个新的关系式:污泥粘度与污泥浓度、温度的关系式,并通过实验数据拟合出各项参数,拟合效果比较理想.得出的污泥粘度与污泥浓度、温度的关系式对了解污泥的粘度变化非常有帮助,同时,该关系式也将为污泥处理、处置方案的制定提供参考依据.     

强化一级处理与SBR工艺处理油脂精炼加工废水

介绍了规模为200 m^3/d的油脂精炼加工废水处理工程的设计与运行.先经强化一级处理工艺预处理,再经SBR工艺处理,出水的有关指标能达到设计的排放标准,工艺运行稳定.     

高效喷淋泡沫脱硫技术及装置的应用

SO2是产生酸雨的主要气体，其主要来源于工业燃煤锅炉。以沈阳一家电厂为例，该厂选用新型高效的喷淋泡沫脱硫除尘器对锅炉排放的SO2进行治理。进入喷淋泡沫塔前的SO2平均浓度为2780mg／m^3，经脱硫后出塔平均浓度为289．3mg／m^3，去除率为89．6％。结果表明，这种有别于传统湿法的新型高效的喷淋泡沫脱硫技术及装置具有脱硫效率高、装置占地少、运行稳定、沉淀物易于回收利用等特点，对锅炉排放的SO2进行治理是非常有效的。     

SBR法降解有机物规律的研究

本研究是以处理啤酒废水的试验为基础展开的。试验结果进一步验证了SBR法具有简易,快速、低耗等优点。除此之外,还得出以下结论:增加间歇反应时起始污泥浓度可以提高处理效率或减少反应时间;非限制曝气方式耐冲击负荷,需氧均匀,能缩短反应周期;间歇反应中微生物细胞的合成代谢占主导地位,对氮与磷的需要量大于传统的理论值。本文还指出SBR法是很适合我国国情的一种废水处理工艺,应当加强对它的研究和推广应用。     

柱生物曝气法吸附处理含铬废水

利用复合生物吸附剂FY01与活性污泥作为吸附材料，探讨了柱式生物曝气法对高浓度含铬电镀废水的生物吸附效果。研究结果表明，FY01性能稳定，耐进水pH冲击能力较强。当进水pH=2—5、流速为500mL／h时，10gFY01和5g活性污泥联合处理60．4mg／L含铬电镀废水2h后，铬的去除率达78％以上；在4℃冰箱和23—28℃实验室保存50d的FY01对铬的去除分别在78％～83％和77％-84％之间。柱式生物曝气吸附法对含铬废水的处理效果理想，运行稳定。串联处理2000mL总Cr、Cu^2＋和COD浓度分别为60．4、4．51和48．2mg／L的电镀废水2h后，去除率分别高达92．1％、99．2％和71．4％。     

Co-surfactant of ethoxylated sorbitan ester and sorbitan monooleate for enhanced flushing of tetrachloroethylene

This work evaluated the flushing efficiency of tetrachloroethylene (PCE) using the co-surfactant of non-ionic ethoxylated sorbitan ester (Tween) and oilphilic sorbitan monooleate (Span 80), which formed more hydrophobic micelles than Tween alone. The flushing efficiency was evaluated with laboratory columns filled with silica and aquifer sand. Results from column flushing were also compared to those of batch solubility experiments to study the removal mechanism by the co-surfactant solution. Compared to Tween 80 alone, the molar solubilization ratio and the affinity between the micelles and PCE increased 84% and 90%, respectively, by the co-surfactant solution of Tween 80 and Span 80 mixed at a 4:1 ratio. Flushing with 1% Tween 80 solution yielded a steady PCE recovery of 7% for both silica and aquifer sand in each pore volume (PV). Flushing with co-surfactant of 1% Tween 80 + Span 80 (4:1) further increased PCE recovery to 10% for silica sand and 13% for aquifer sand per PV. A comparison of results from column flushing and batch solubility tests indicated that the primary flushing mechanism of PCE using the co-surfactant solution of Tween 80 + Span 80 (4:1) was micellar solubilization.     

Controlled exposures of volunteers to respirable carbon and sulfuric acid aerosols.

Respirable carbon or fly ash particles are suspected to increase the respiratory toxicity of coexisting acidic air pollutants, by concentrating acid on their surfaces and so delivering it efficiently to the lower respiratory tract. To investigate this issue, we exposed 15 healthy and 15 asthmatic volunteers in a controlled-environment chamber (21 degrees C, 50 percent relative humidity) to four test atmospheres: (i) clean air; (ii) 0.5-microns H2SO4 aerosol at approximately 100 micrograms/m3, generated from water solution; (iii) 0.5-microns carbon aerosol at approximately 250 micrograms/m3, generated from highly pure carbon black with specific surface area comparable to ambient pollution particles; and (iv) carbon as in (iii) plus approximately 100 micrograms/m3 of ultrafine H2SO4 aerosol generated from fuming sulfuric acid. Electron microscopy showed that nearly all acid in (iv) became attached to carbon particle surfaces, and that most particles remained in the sub-micron size range. Exposures were performed double-blind, 1 week apart. They lasted 1 hr each, with alternate 10-min periods of heavy exercise (ventilation approximately 50 L/min) and rest. Subjects gargled citrus juice before exposure to suppress airway ammonia. Lung function and symptoms were measured pre-exposure, after initial exercise, and at end-exposure. Bronchial reactivity to methacholine was measured after exposure. Statistical analyses tested for effects of H2SO4 or carbon, separate or interactive, on health measures. Group data showed no more than small equivocal effects of any exposure on any health measure.(ABSTRACT TRUNCATED AT 250 WORDS)