壳聚糖复合絮凝剂处理造纸废水的实验研究

研究并考察了壳聚糖复合絮凝剂对造纸污水中COD和SS的絮凝效果,结果表明,当复合絮凝剂的配方和处理条件为：聚合硫酸铁（PFS）60 mg/L聚丙烯酰胺（PAM）2 mg/L壳聚糖（CTS）0.4 mg/L,pH为7.5时,其絮凝效果最佳,此时它对水中COD与SS的去除率分别达到57.4%和97.6%, 与传统絮凝剂PAC/PAM相比,COD与SS的去除率分别提高了10.1%和5.2%,药剂成本下降了21.1%,具有明显的经济效益与环境效益。     

热化学洗涤－超声波分离技术处理油田含油污泥

为解决大量堆存的含油污泥所造成的环保隐患问题,长庆油田建设了含油污泥处理站。采用"热化学洗涤-超声波分离"工艺对含油污泥进行处理。含油污泥的含油率从处理前的48.9%降到处理后2.0%,除油率达到95.9%,除油效果较好。     

TR-01稠油乳化降粘剂研究

针对河南油田井楼区块稠油,自制TR-01乳化降粘剂,通过实验研究了其降粘性能、稳定性,确定了降粘剂TR-01最佳浓度为0.3%、最佳油水比为70∶30。实验结果表明:TR-01乳化降粘剂对井楼区块油井的普遍适用性较强,具有较好的乳化降粘作用(降粘率达到99%以上),地层水对其降粘效果影响不大。其中的纳米成分能增加对污水中悬浮物的吸附能力和絮凝能力,对油田污水处理起到积极作用。     

炼化企业大检修作业的环保管理

以克拉玛依石化公司为例,对检修作业前环境危害因素进行了辨识,提出了检修前、检修期间环保管理的措施,从废气、废水、噪声、固废四个方面详细介绍了大检修期间进行污染控制的具体措施,分析了大型炼化企业在停工大检修作业期间存在的环境影响因素,提出了大检修作业期间的环保管理内容及污染控制措施。     

Evaluation of a Watershed Model for Estimating Daily Flow Using Limited Flow Measurements1

Abstract: The Soil and Water Assessment Tool (SWAT) model was evaluated for estimation of continuous daily flow based on limited flow measurements in the Upper Oyster Creek (UOC) watershed. SWAT was calibrated against limited measured flow data and then validated. The Nash‐Sutcliffe model Efficiency (NSE) and mean relative error values of daily flow estimations were 0.66 and 15% for calibration, and 0.56 and 4% for validation, respectively. Also, further evaluation of the model’s estimation of flow at multiple locations was conducted with parametric paired t‐test and nonparametric sign test at a 95% confidence level. Among the five main stem stations, four stations were statistically shown to have good agreement between predicted and measured flows. SWAT underestimated the flow of the fifth main stem station possibly because of the existence of complex flood control measures near to the station. SWAT estimated the daily flow at one tributary station well, but with relatively large errors for the other two tributaries. The spatial pattern of predicted flows matched the measured ones well. Overall, it was concluded from the graphical comparisons and statistical analyses of the model results that SWAT was capable of reproducing continuous daily flows based on limited flow data as is the case in the UOC watershed.     

废聚碳酸酯水解法制双酚A

以1,4-二氧六环为溶剂、NaOH为催化剂,采用废聚碳酸酯(PC)常压水解法制双酚A(BPA).对反应影响因素进行了研究.实验结果表明,在反应温度为100℃、反应时间为8h、m(NaOH):m(水+溶剂)=1:33、m(溶剂):m(PC)=4:1、m(水):m(PC)=1:1的最佳反应条件下,PC水解率大于98%,BPA收率大于95%.     

Methanolysis and Hydrolysis of Polycarbonate Under Moderate Conditions

Alkali-catalyzed methanolysis and hydrolysis of polycarbonate (PC) in a solvent in which PC can substantially dissolve such as N-methyl-2-pyrrolidone, 1,4-dioxane, tetrahydrofuran and so on were studied. Reaction conditions were optimized for the purpose of recycling PC in the form of bisphenol A and carbon carbonate. The results showed that both the methanolysis and hydrolysis of PC could take place under moderate conditions. Under the conditions of reaction temperature 40 °C, m(PC):m(MeOH) = 1:1, m(PC):m(NaOH) = 50:1, reaction time 35 min and using tetrahydrofuran as solvent, the methanolysis conversion of PC was almost 100% and the yield of bisphenol A was over 95%. Moreover, under the conditions of reaction temperature 100 °C, m(PC):m(H₂O) = 1:0.7, m(PC):m(NaOH) = 10:1, reaction time 8 h and using 1,4-dioxane as solvent, the hydrolysis conversion of PC was almost 100% and the yield of bisphenol A was over 94%.     

用Ames试验检测水源水和自来水中的遗传毒性

用微伤寒沙门氏菌／哺乳动物微粒体酶系的Ａｍａｅｓ试验,研究了不同季节物水源水及管网自来水中的遗传毒性,以ＸＡＤ２树脂为吸附剂,以丙酮－甲醇的混合液为洗脱液,浓率水样中的有机物,并对部分阳性水样进行有机成分的定性分析。结果发现：１３个水样中有７个样品在淡需要代谢活化系统Ｓ９的情况下,可诱导鼠伤寒沙门氏菌碱基移码型菌株的回复突变;不同水样在不同季节不同的诱导作用;同时通过ＧＣ／ＭＳ方法分析,发现阳性水     

过氯乙烯滤膜采样-酸消解-钼蓝光度法测定磷酸雾

建立了过氯乙烯滤膜采样 -酸消解 -钼蓝分光光度法测定磷化车间磷酸雾的监测方法。实验室模拟采样的捕集效率为 95 7%～ 99 1 %。单个实验室对含 5μg和 1 5μg样品进行多次测定 ,其相对标准差小于 5% ,样品加标回收率为 98 2 %～ 1 0 0 5% ,方法检测限为 0 0 0 7mg/m3。对标样测定 ,结果均在给定值范围内。用该法与等离子发射光谱法(ICP)对 5个样品进行比对测定 ,结果均令人满意。     

CN-测定中显色剂配制方法的选择与保存时间

对2种氰化物显色剂配制方法进行了对比,发现用无水乙醇配制的显色剂具有方便,经济,实用,无毒且显色剂保存期长等优势。