Kinetics of peanut shell pyrolysis and hydrolysis in subcritical water

Biomass is recognized as an important solution to energy and the environmental problems related to fossil fuel usage. The rational utilization of biomass waste is important not only for the prevention of environmental issues, but also for the effective utilization of natural resources. Pyrolysis and hyrolysis in subcritical water are promising processes for biomass waste conversion. This paper deals with hydrolysis and pyrolysis of peanut shells. Hydrolysis and pyrolysis kinetics of peanut shell wastes were investigated for the in-depth exploration of process mechanisms and for the control of the reactions. Hydrolysis kinetics was conducted in a temperature range of 180–240 °C. A simplified kinetic model to describe the hydrolysis of peanut shells was proposed. Hydrolysis activation energy as well as the pre-exponential factor was determined according to the model. The target products of peanut shell hydrolysis, reducing sugars, can reach up to 40.5 % (maximum yield) at 220 °C and 180 s. Pyrolysis characteristics were investigated. The results showed that three stages appeared in this thermal degradation process. Kinetic parameters in terms of apparent pyrolysis activation energy and pre-exponential factor were obtained by the Coats–Redfern method.     

响应面优化CCl4增强超声降解左旋氧氟沙星模拟废水

利用响应面优化实验设计方法对CCl₄增强超声降解左旋氧氟沙星模拟废水的影响因素进行探讨和分析,考察了溶液初始pH值、超声功率、左旋氧氟沙星初始浓度的影响。应用Box-Behnken中心组合设计得到一个二次多项式数学模型,确定了US/CCl₄降解左旋氧氟沙星的优化条件:初始pH值6.8,超声功率189 W,左旋氧氟沙星初始浓度为5 mg/L时,左旋氧氟沙星的去除率达到最大(82.99%)。经实验验证, 实际值与模型预测值吻合性良好,偏差仅为0.036%。     

电吸附对水中盐类、氨氮、COD的去除效果分析

电吸附技术作为高效、环境友好型的除盐、除氨氮技术,可应用与水的深度处理领域内。为了使污水回用达到工业用水的水质标准,对电吸附去除水中盐类、氨氮、COD的效果进行分析,结果表明,电吸附设备处理不同氨氮浓度的废水,对中低浓度的氨氮去除效果稳定,当进水氨氮浓度低于20 mg/L时,处理后出水氨氮浓度低于5 mg/L,COD浓度小于25 mg/L,达到回用标准;随着进水盐浓度的增大电吸附处理效果逐渐变差,在电导率低于2 500 μS/cm时除盐率在75%左右,氨氮去除率达到70%左右,COD去除率达到60%左右。经电吸附处理后的低氨氮浓度废水,TDS、氨氮浓度均可达到工业回用水标准。     

碱式硫酸铝溶液中SO42-的测定

建立了以铬黑T为指示剂,乙二胺四乙酸二钠反滴定过量BaCl₂的碱式硫酸铝溶液中SO₄^2-的测定方法。实验确定的操作条件为：待测试样稀释后ρ（SO_4^2-）为0.025 ~0.100 g/L,BaCl₂过量率为25%~100%,并且在加入BaCl₂前将试样煮沸,三乙醇胺加入量为0.10 L/L。该法回收率在98.90%~100.72%,相对标准偏差小于1%。测定方法准确,可靠,且操作简便、快速。     

利用钢铁盐酸酸洗废液在填料塔中制备FeCl3

以钢铁盐酸酸洗废液为原料,亚硝酸钠为催化剂,氧气为氧化剂,在填料塔中催化氧化制备三氯化铁。考察了反应温度、催化剂加入量和添加方式、循环流量等对制备三氯化铁的影响。实验结果表明,在优化的工艺条件为料液预热温度为60 ℃、催化剂加入量为钢铁盐酸酸洗废液总质量的0.30%、料液循环流量6.0 m³/h的条件下,反应80~120 min,酸洗废液中的Fe²⁺完全氧化为Fe³⁺。     

O3-H2O2氧化法处理印染废水

采用O₃-H₂O₂氧化法对印染废水进行氧化处理,比较了O₃氧化法和O₃-H₂O₂氧化法对印染废水的处理效果,考察了初始废水pH、H₂O₂加入量、O₃流量和反应时间对废水的色度去除率和COD去除率的影响。实验结果表明：O₃-H₂O₂氧化法对废水的COD和色度的去除效果比O₃氧化法更好;在初始废水pH为11、H₂O₂加入量为13mmol/L、O₃流量为6g/h、反应时间为60min的最佳工艺条件下,处理后废水COD为61.50mg/L,COD去除率为95.73%,废水色度为5倍,色度去除率为99.75%,TOC为37.84mg/L,TOC去除率为85.10%,BOD₅为22.76mg/L,BOD₅去除率为90.20%,BOD₅/COD为0.37。     

An overview on the processes and technologies for recycling cathodic active materials from spent lithium-ion batteries

This paper aims to make an overview on the current status and new tendency for recycling cathodic active materials from spent lithium-ion batteries. Firstly, it introduces several kinds of pretreatment technologies, followed by the summary of all kinds of single recycling processes mainly focusing on organic acid leaching and synergistic extraction. Then, several examples of typical combined processes and industrial recycling processes are presented in detail. Meanwhile, the advantages, disadvantages and prospect of each single process, combined process, as well as industrial recycling processes, are discussed. Finally, based on a novel acidic organic solvent, the authors briefly introduce an environmental friendly process to directly recycle and resynthesize cathodic active material LiNi_1/3Co_1/3Mn_1/3O₂ from spent lithium-ion batteries. The preliminary experimental results demonstrated the advantages of low reaction temperature, high separation efficiency and organic solvent cycling and preventing secondary pollution to the environment. This process may be used for large-scale recycling of spent lithium-ion batteries after further study.     

Kinetics study of fermentative hydrogen production from liquid swine manure supplemented with glucose under controlled pH

Kinetics of H₂ production from liquid swine manure supplemented with glucose by mixed anaerobic cultures was investigated using batch experiments under four different pH conditions (4.4, 5.0, 5.6, and uncontrolled). The temperature for the experiments was controlled at 37 ± 1°C and the length of experiments varied between 50 and 120 hours, depending upon the time needed for completion of each individual experiment. The modified Gompertz model was evaluated for its suitability for describing the H₂ production potential, H₂ production rate, and substrate consumption rate for all the experiments. The results showed that the Gompertz model could adequately fit the experimental results. The effect of pH was significant on all kinetic parameters for H₂ production including yield, production rate and lag time, and the substrate utilization rate. The optimal pH was found to be 5.0, at which a maximum H₂ production rate (0.64 L H₂/h) was obtained, and deviation from the optimal pH could result in substantial reductions in H₂ production rate (0.32 L H₂/h for pH 4.0 and 0.43 L H₂/h for pH 5.6). The results also showed that if pH was not controlled for the batch fermentation process, the substrate utilization efficiency could steeply decrease from 98.8% to 33.7%.     

Influences of adding easily degradable organic waste on the minimization and humification of organic matter during straw composting

To find a better composting process with low greenhouse gas emission and high humus production, the effect of adding kitchen waste on reduction and humification of organic matter during straw composting was studied. Three processes were compared, consisting of different ratios of straw and kitchen waste (1:2, 1:1, and 2:1). At four time points over a 62-d incubation, the reduction and humification of compost was evaluated by measuring the total mass, carbon content, and humic material content of the compost. Treatment 1 (straw/kitchen waste ratio of 1:2) reduced the total mass of compost the most. Treatment 2 (straw/kitchen waste ratio of 1:1) reduced the total carbon content the most, reflecting the highest emission of greenhouse gas. Treatment 3 produced the most humic acid material and released the lowest amount of carbon. Hence, from the point of view of reducing greenhouse gas emissions and increasing stable organic matter such as humus and humic acid during composting, treatment #3 was optimal. The three treatments resulted in significant differences in microbial biomass and enzyme activity during composting. The highest amount of active microbial biomass was associated with the largest reduction in compost mass (treatment 1). Higher proportions of straw (treatments 2 and 3), which contains more lignin, were associated with greater β-glycosidase activity, which may generate more humus that can improve soil quality. Dehydrogenase activity seemed to be the most important microbial factor in organic carbon catabolism or humification.     

Chemical oxidation of sulfadiazine by the Fenton process: Kinetics,pathways, toxicity evaluation

This paper investigated sulfadiazine oxidation by the Fenton process under various reaction conditions. The reaction conditions tested in the experiments included the initial pH value of reaction solutions, and the dosages of ferrous ions and hydrogen peroxide. Under the reaction conditions with pH 3, 0.25 mM of ferrous ion and 2 mM of hydrogen peroxide, a removal efficiency of nearly 100% was achieved for sulfadiazine. A series of intermediate products including 4-OH-sulfadiazine/or 5-OH-sulfadiazine, 2-aminopyrimidine, sulfanilamide, formic acid, and oxalic acid were identified. Based on these products, the possible oxidation pathway of sulfadiazine by Fenton's reagent was proposed. The toxicity evaluation of reaction solutions showed increased antimicrobial effects following the Fenton oxidation process. The results from this study suggest that the Fenton oxidation process could remove sulfadiazine, but also increase solution toxicity due to the presence of more toxic products.