Application of improved seasonal GM(1,1) model based on HP filter for runoff prediction in Xiangjiang River

Environmental Science and Pollution Research - Runoff forecasting is essential for the reasonable use of regional water resources, flood prevention, and mitigation, as well as the development of...     

Distribution and bioavailability of ceria nanoparticles in an aquatic ecosystem model

Along with the increasing utilization of engineered nanoparticles, there is a growing concern for the potential environmental and health effects of exposure to these newly designed materials. Understanding the behavior of nanoparticles in the environment is a basic need. The present study aims to investigate the distribution and fate of ceria nanoparticles in an aquatic system model which consists of sediments, water, hornworts, fish and snails, using a radiotracer technique. Concentrations of ceria in the samples at regular time intervals were measured. Ceria nanoparticles were readily removed from the water column and partitioned between different organisms. Both snail and fish have fast absorption and clearance abilities. Hornwort has the highest bioaccumulation factors. At the end of the experiment, sediments accumulated most of the nanoparticles with a recovery of 75.7 ± 27.3% of total ceria nanoparticles, suggesting that sediments are major sinks of ceria nanoparticles.     

海水电池处理模拟海水养殖废水

随着中国海水养殖业的迅猛发展,海水养殖废水排放量与日俱增,近海水域环境严重恶化。采用海水电池处理模拟海水养殖废水,以镁为电池负极,钛为电池正极。镁负极失去电子产生Mg2+,与废水中的NH4+、PO43-结合生成磷酸铵镁（MgNH4PO4·6H2O,MAP）,将废水中的NH4+和PO43-去除。结果表明,当pH为9.5,氮磷配比为1：1.1时,氮的去除率可达85.34% ,磷的去除率可达98.46%。利用正交实验研究pH、初始氨氮浓度、氮磷比和COD4个因素对氮磷去除的影响,氨氮初始浓度、COD分别对氮、磷的去除影响最大。多个电池串联时,总输出电压是各电池电压之和。     

Effects of aeration frequency on leachate quality and waste in simulated hybrid bioreactor landfills

Research has been conducted to investigate the effects of daily aeration frequency on leachate quality and waste settlement in simulated hybrid landfill bioreactors. Four laboratory-scale reactors were constructed and operated for about 10 months to simulate different bioreactor operations, including one anaerobic bioreactor and three hybrid bioreactors with different aeration frequencies (one, two, and four times per day). Chemical oxygen demand (COD) and biochemical oxygen demand (BOD₅) reduced more than 96% of the initial concentrations in all aerated bioreactors. The differences of COD and BOD₅ reductions among tested aeration frequencies were relatively small. For ammonia nitrogen, the higher aeration frequency (two or four times per day) resulted in the quicker reduction. Overall, the concentrations of heavy metals (Cr, Co, Cu, Mn, Ni, and Zn) decreased over time except Cd and Pb. The reduction of redox-sensitive metal concentrations (Mn, Co, Ni, and Cu) was greater in aerated bioreactors than in anaerobic bioreactor. Settlement of municipal solid waste (MSW) was enhanced with higher frequency of aeration events (four times per day).

Implications: In recent years, hybird bioreactor landfill technology has gained a lot of attention. Appropriate aeration rate is crucial for hybrid bioreactor operation, but few studies have been done and different results were obtained. Research was conducted to investigate the effects of daily aeration frequency on leachate quality and waste settlement. Results indicated that aeration can effectively accelerate waste stabilization and remove organic carbon concentration and total nitrogen in the leachate.     

臭氧活性炭-后置砂滤工艺对水中农药的控制效能

选择我国饮用水水质标准中有相关规定,以及部分用量较大或虽被禁用但仍有残留的农药共25种,对黄浦江水源水以及采用臭氧活性炭-后置砂滤工艺的某水厂工艺段出水中的浓度分布进行了调查,评估了砂滤后置工艺条件下相应农药的实际处理效果。结果表明:原水中有包括莠去津、乐果、六氯苯、敌敌畏、乙草胺、丁草胺、仲丁威和p,p'-DDT的8种农药检出,且总浓度较高达到760 ng/L,其中莠去津和乙草胺含量较高,最高浓度分别达到531 ng/L和277 ng/L;从季节性分布来看,春季总农药浓度最高达760 ng/L,秋季最低为175 ng/L。从工艺去除效果来看,臭氧活性炭砂滤后置工艺对农药的总体去除率为62%~78%,与冬春季相比,夏秋季节的农药的去除率提高约10%左右,这可能与高温期微生物活性较高有关。值得关注的是,砂滤后置工艺与同期常规臭氧活性炭工艺相比农药的总去除率要低10%左右,应结合总体出水水质情况对其进一步评估。     

粉末活性污泥处理含铀废水的特性

以生活污水处理厂剩余活性污泥为原料,制备粉末活性污泥(PAS)作为生物吸附剂,考察pH值,PAS投加量,U(Ⅵ)初始浓度和吸附时间对PAS吸附U(Ⅵ)的影响,探讨了PAS吸附U(Ⅵ)的作用机理。实验结果表明,在U(Ⅵ)初始浓度为10 mg/L时,其最佳吸附pH值为3,去除率97.77%,吸附平衡时间120 min;吸附过程较好地拟合了准二级动力学模型(R2≈1)和Freundlich等温模型(R2≈1);X射线能谱和离子交换实验分析表明,离子交换为其主要吸附方式,参与交换的主要离子为Ca2+;红外光谱分析表明,PAS吸附U(Ⅵ)后自身结构未发生改变。以0.1 mol/L的HCl溶液作为解吸液,初次解吸率达92.83%,循环利用3次仍具有较好的吸附效果。     

巢湖低温高效聚磷菌的筛选及其特性

采用低温富集培养及混合平板分离技术,从巢湖底泥中分离筛选得到2株在低温下仍具有较高效能的菌株D3、D6,经过厌氧/好氧交替培养,2种菌株在低温下(8℃)的除磷率均达到80%以上。在低温下,研究了pH、微量元素对2株菌株生长及除磷率的影响,实验结果表明,2株菌都具有广泛的温度适应性,适宜其生长和除磷的pH为中性偏碱,微量元素的缺乏对2株菌株的生长和除磷效果有不同程度的不良影响。染色观察显示,厌氧培养时菌体内聚羟基丁酸(PHB)颗粒明显增多,转为好氧培养后异染颗粒增多,为典型的聚磷菌特征。经鉴定,2株菌均属假单胞菌属。     

聚硅酸钛制备及其助凝特性

采用在活化硅酸制备过程中加入适量TiCl4的方法,试制了一种新型无机高分子助凝剂—聚硅酸钛。研究了不同/条件下制备的聚硅酸钛在固定pH值的水中分散物的粒径和Zeta电位随着活化时间的变化趋势,并与活化硅酸作比较。结果表明,在Si/Ti=20,活化48 h的条件下能制备出较为稳定的聚硅酸钛。与活化硅酸相比,聚硅酸钛在水中的分散物具有较大的粒径和更高的Zeta电位。通过对比制备的活化硅酸和聚硅酸钛的红外图谱发现,聚硅酸钛中有Ti-O-Si键,证明钛离子参与了聚合反应,新生成的化学键提高了它的聚合度和稳定性。采用硫酸铝为混凝剂,聚硅酸钛为助凝剂进行混凝除浊实验。测定了絮凝体的Zeta电位和混凝沉淀后的上清液浊度,研究了硫酸铝投加量和混凝pH对聚硅酸钛助凝效果的影响。结果表明,投加适量的聚硅酸钛助凝剂,明显提高了混凝除浊效果且拓宽了有效混凝pH值的范围。     

PVC/PES-g-PEGMA共混膜的制备及其耐污染性能

首先将聚乙二醇单甲基甲醚酯(PEGMA)接枝到聚醚砜(PES)上得到PES-g-PEGMA,然后利用溶液共混的方法,将聚氯乙烯(PVC)与PES-g-PEGMA共混,通过溶剂-非溶剂扩散诱导相分离法(NIPS)制备PVC/PES-g-PEGMA共混膜。在此基础上对PVC/PES-g-PEGMA共混膜的断面和表面微观结构、水通量、 截留率、机械性能及耐污染等性能进行测试,并采用接触角,含水率(EWC),X 射线光电子能谱仪(XPS) 来表征PES-g-PEGMA 的质量百分含量对 PVC/PES-g-PEGMA 共混膜亲水性的影响。结果表明,PVC/PES-g-PEGMA共混膜水通量,亲水性较纯PVC有很大程度的提高。耐污染性实验表明,随着PES-g-PEGMA的增加,耐污染性逐渐增强。实验结果同时也表明,该共混体系最佳共混比为7:3。     

不同好氧预处理方式对餐厨垃圾产甲烷的影响

为了研究不同好氧预处理方式对餐厨垃圾厌氧消化产甲烷的影响,通过建立3个模拟厌氧生物反应器,研究了传统厌氧生物反应器C1、上层好氧预处理-厌氧生物反应器C2和底部好氧预处理-厌氧生物反应器C3 3种不同操作条件下的产甲烷过程。结果表明,挥发性有机酸的累积使C1始终处于产甲烷滞后阶段;而C2、C3的好氧预处理通过加快易水解酸化组分和过量挥发性有机酸的好氧降解,有效缓解了酸性抑制,产甲烷滞后时间明显缩短至10 d内。第32天C2停止上层曝气后,在27 d内甲烷浓度达到了50%以上,同时,产甲烷速率迅速上升,并在第81天可达到峰值773 mL/(kg·d)。C3在第11天停止底部曝气后,虽然经过22 d的时间甲烷浓度即上升至50%,但之后产甲烷速率经历回落阶段后再次逐渐上升,在实验结束时仅达到517 mL/(kg·d)。上层曝气的好氧预处理方式所需曝气时间相对较长,但其产甲烷启动快,与底部曝气相比,其后期的甲烷化过程更稳定并可达到较高的产甲烷速率。