Effects of the spatial resolution of urban drainage data on nonpoint source pollution prediction

Environmental Science and Pollution Research - Detailed urban drainage data are important for urban nonpoint source (NPS) pollution prediction. However, the difficulties in collecting complete...     

环境治理中膜接触器的应用研究

膜接触器可以将膜分离与化工单元操作进行有效结合,是一种先进的高效分离器,可在不同接触的情况下实现相间传质,被广泛应用于废气治理、重金属选择吸收等环境治理中。对此,本文首先对膜接触器的分类原理及结构形式进行介绍,然后对不同膜接触器在环境治理中的应用原理进行分析,并以某废水治理项目为研究对象,对膜接触器在环境治理中的应用方式进行深入研究。     

Dibutyl phthalate adsorption characteristics using three common substrates in aqueous solutions

• DBP adsorption was tested using three kinds of substrates in constructed wetlands. • The DBP adsorption capacity followed the order: steel slag>gravel>shell sand. • High temperatures increased the DBP adsorption capacity in the substrates. • DOM consistently inhibited the DBP adsorption onto steel slag and gravel. In recent years, the presence and adverse impacts of phthalic acid esters in aquatic environments have gained increasing attention. This work investigated the adsorption behavior of a typical phthalic acid ester, dibutyl phthalate (DBP), onto steel slag, gravel, and shell sand (substrates commonly used in constructed wetlands). The influence of dissolved organic matter (DOM) on DBP adsorption was investigated using humic acid as a proxy for DOM. The results demonstrated that the adsorption of DBP to three substrates reached equilibrium within 96 h, and the adsorption kinetics were well fitted by a pseudo-second-order model. The DBP adsorption isotherms were best fitted by the Langmuir adsorption model. The DBP adsorption capacity decreased in the order of steel slag>gravel>shell sand, with values of 656 mg/kg, 598 mg/kg, and 6.62 mg/kg at 25°C, respectively. DBP adsorbed to the surface of all substrates in a monolayer via an endothermic process. The DBP adsorption capacities of steel slag and gravel decreased as the DOM content increased. The DBP adsorption mechanisms to steel slag and gravel mainly involved the surface coordination of DBP with –OH or –COOH groups and electrostatic interactions. The results of this work suggest that steel slag and gravel may be ideal substrates for use in constructed wetlands to treat wastewater polluted with DBP.     

220kV双分裂小四甲线粘连原因分析及防治措施

通过一起双回线路单回运行时双分裂导线发生粘连引起的发热和异常声响现象的分析,得出了双分裂导线粘连的原因是负荷电流突增,引起导线发热,导致双分裂子导线间距缩小,最终发生粘连。提出了粘连现象的危害以及预防和治理导线粘连的措施,为更好地处理和预防双分裂导线粘连现象提供了理论和实践参考。     

超临界锅炉吹灰调阀改造

某电厂超临界锅炉吹灰调阀在使用过程中长期存在内漏、调节线性差、卡涩以及阀座裂纹等问题,严重影响了吹灰系统的正常运行。针对吹灰调阀存在的内漏以及阀座裂纹问题,分析了产生内漏和阀座裂纹的原因,从阀门结构、阀芯结构、阀门各部件材质、执行机构等方面进行了改造。吹灰调阀改造后,解决了原有阀门存在的内漏、调节线性差、卡涩问题,吹灰系统安全可靠性大幅提升,对同类型锅炉阀门选型及改造有参考意义。     

Preparation and Properties of Thermoplastic Starch/Montmorillonite Nanocomposite Using N-(2-Hydroxyethyl)formamide as a New Additive

N-(2-Hydroxyethyl)formamide (HF) was synthesized efficiently and used as a new additive to prepare thermoplastic starch/montmorillonite nanocomposite (TPS/MMT). Here, HF acted as both plasticizer for TPS and swelling agent for MMT. The hydrogen bond interaction among HF, starch and MMT was proven by Fourier-transform infrared (FT-IR) spectroscopy. By scanning electron microscope (SEM), starch granules were completely disrupted. Atomic force microscopy demonstrated that partially exfoliated TPS/MMT nanocomposite was formed. The crystallinity of corn starch, MMT, HF-plasticized TPS (HTPS) and TPS/MMT nanocomposite was characterized by X-ray diffraction (XRD). Thermal stability of HTPS and TPS/MMT was determined by thermogravimetric analysis (TGA). The water resistance of TPS/MMT nanocomposite increased compared with that of pure HTPS. Tensile strengths of TPS/MMT nanocomposites were higher than those of HTPS, but just the reverse for elongations at break.     

黄孢原毛平革菌处理果胶废水

实验研究了菌体接种量、氮源、氮源浓度、温度和pH等不同因素条件下,黄孢原毛平革菌对果胶废水中果胶和COD去除效率的影响。结果表明,接种量为10 g/L时,黄孢原毛平革菌对果胶和COD的去除率最高,分别为96%和83%。酒石酸铵为黄孢原毛平革菌处理果胶废水的最佳氮源,其最佳浓度为0.8 g/L,在此条件下,菌体对果胶和COD的去除率分别为96%和84%。废水温度为25~35℃,废水pH值为4~5时,黄孢原毛平革菌对果胶废水中果胶和COD的去除效率分别可达95%及80%以上。黄孢原毛平革菌处理果胶废水的研究结果可为实际废水处理工程技术工艺的设计提供参考价值和指导意义。     

藻类吸附剂对六价铬的吸附特性

以浮游藻类制成的生物吸附剂为对象,研究了不同液相起始pH、吸附剂用量Cm和不同吸附时间t等因素对生物吸附剂吸附Cr(Ⅵ)的影响,并进行了热力学分析和对吸附前后藻类吸附剂进行了FTIR分析。结果表明,最佳吸附条件为:在起始pH=1.0,吸附剂用量Cm=6.0 g/L,吸附时间t=180 min,吸附温度T=30℃时吸附效率达到了92.10%;藻类吸附剂对Cr(Ⅵ)的吸附能很好地符合Langmuir模型和Freundlich模型,在实验的温度范围内,ΔG0均为负值,说明实验条件下藻类吸附剂对Cr(Ⅵ)的吸附反应能够自发进行;红外图谱显示在1 261~1 537 cm-1和1 034~1 053 cm-1区域峰发生了明显变化,说明其为细胞上的多糖、蛋白质等成分更多地参与了对Cr(Ⅵ)的吸附过程。由此可见,利用中水里生长的藻类制成生物吸附剂,吸附Cr(Ⅵ)具有可行性,吸附速率较高,吸附平衡时间较快。     

包埋氨氧化细菌处理合成氨工业废水

以聚乙烯醇与海藻酸钠为载体,包埋固定氨氧化细菌(AOB),研究温度、DO、初始游离氨(FA)、有机物等影响因素对其短程硝化稳定性的影响。结果表明,25~30℃时载体中氨氧化细菌占优势;DO宜控制在4.0~5.5 mg/L之间,既能满足细菌生长所需,又不至过度曝气,造成载体间的摩擦增大,减少其使用寿命;载体耐氨氮负荷能力强,同时可以抵御有机物对氨氧化细菌的伤害;当初始FA>6.5 mg/L时,氨氧化细菌的活性将受到抑制;富集氨氧化细菌的污泥包埋后氨氮去除率降低了7.5%;包埋载体在确保短程硝化作用的同时,在内部形成的缺氧区可实现反硝化脱氮,提高了系统氨氮的处理能力。     

Effects of bromide and iodide ions on the formation of disinfection by-products during ozonation and subsequent chlorination of water containing biological source matters

This study aims to investigate the influence of the coexistence of halogen ions (bromide/iodide) and biological source matters on the speciation and yield of trihalomethanes (THMs), haloacetic acids (HAAs), and N-nitrosodimethylamine (NDMA) during the ozonation and subsequent chlorination of water. The results show that the concentrations of brominated THMs and iodinated THMs increased with increasing bromide and iodide concentration. These results may be attributed to the higher reactivity of hypobromous acid and hypoiodous acid generated from the ozonation and subsequent chlorination in the presence of bromide or iodide ions. The presence of bromide increased the species of brominated HAAs. There was a shift from chlorinated HAAs to brominated HAAs after increasing the concentration of bromide. The effect of iodide on HAA formation was more complex than bromide. For most samples, the concentration of total HAAs (T-HAAs) increased to the maximum and then decreased with increasing iodide concentration. The components of the organic precursors also significantly influenced the formation of brominated and iodinated disinfection by-products (Br-DBPs and I-DBPs). Humic acids produced more CHBr₃ (596.60 μg/L) than other organic materials. Microcystis aeruginosa cells produced the most tribromoacetic acid (TBAA, 84.16 μg/L). Furthermore, the yield of NDMA decreased with increasing bromide concentration, indicating that the formation of NDMA was inhibited by the high concentration of bromide.