燃煤电厂烟气氮氧化物排放控制技术发展现状

在广泛查阅文献的基础上,对近年来国内外已成功应用和正在研究开发的一些主要的燃煤烟气氮氧化物控制技术进行了介绍。结合我国目前脱硝行业整体水平和国家环保政策要求,对我国脱硝行业技术研发方向提出了建议。     

高压脉冲电凝-Fenton-生化法处理制药废水

通过高压脉冲电凝-Fenton对制药废水进行预处理,出水进入UASB-AO生化处理系统.研究表明:高压脉冲电凝-Fenton氧化法的最佳工况条件为进水pH值为4.0左右,高压脉冲电凝反应时间为45 min,H2O2投加量为4mL/L,Fenton氧化时间为60min.高压脉冲电凝-Fenton对CODCr去除率为36.5%～39.2%,ρ(BOD5)/ρ(CODCr)从0.13提高到0.32-0.34,废水的可生化性大大提高,UASB厌氧反应器去除率为81.4%～82.1%,AO系统去除率为88.0%～88.5%,而整个生化处理系统对CODCr去除率为95.4%～97.9%,最终出水各项指标可达到GB 8978-1996<污水综合排放标准>中一级标准.     

好氧颗粒污泥处理青霉素废水研究

青霉素在其生产过中产生大量的废水,其COD值较高,生化性较差,成分复杂,微生物难以降解,其处理技术是世界性难题。文章采用以葡萄糖模拟废水培养的好氧颗粒污泥为接种体,经青霉素废水逐步驯化后,使其完全处理青霉素废水。实验结果表明,应用好氧颗粒污泥技术,处理青霉素废水,COD,NH3_N,TP去除率较高,具有很好的处理效果。     

有机改性膨润土在印染废水处理中的应用

膨润土是一种非常有用的非金属矿物原料,其有机改性得到的有机改性膨润土可以较好地去除印染废水中的有机污染物和色度。本文综述了有机改性膨润土的制备方法及其在印染废水处理中的应用现状。     

Debromination of decabromodiphenyl ether by organo-montmorillonite-supported nanoscale zero-valent iron：Preparation, characterization and influence factors

An organo-montmorillonite-supported nanoscale zero-valent iron material(M-NZVI) was synthesized to degrade decabromodiphenyl ether(BDE-209). The results showed that nanoscale zero-valent iron had good dispersion on organo-montmorillonite and was present as a core-shell structure with a particle size range of nanoscale iron between 30–90 nm, characterized by XRD, SEM, TEM, XRF, ICP-AES, and XPS. The results of the degradation of BDE-209 by M-NZVI showed that the efficiency of M-NZVI in removing BDE-209 was much higher than that of NZVI. The efficiency of M-NZVI in removing BDE-209 decreased as the pH and the initial dissolved oxygen content of the reaction solution increased, but increased as the proportion of water in the reaction solution increased.     

Catalytic bubble-free hydrogenation reduction of azo dye by porous membranes loaded with palladium nanoparticles

Catalytic bubble-free hydrogenation reduction of azo dye by porous membranes loaded with palladium （Pd） nanoparticles was studied for the first time. The effects of Pd loading, dye concentration and reuse repetitions of membranes were investigated. In reduction, the dye concentration decreased whereas the pH rose gradually. An optimal Pd loading was found. The catalytic membranes were able to be reused more than 3 times.     

Carbonyl emissions from heavy-duty diesel vehicle exhaust in China and the contribution to ozone formation potential

Fifteen heavy-duty diesel vehicles were tested on chassis dynamometer by using typical heavy duty driving cycle and fuel economy cycle. The air from the exhaust was sampled by 2,4- dinitrophenyhydrazine cartridge and 23 carbonyl compounds were analyzed by high performance liquid chromatography. The average emission factor of carbonyls was 97.2 mg/km, higher than that of light-duty diesel vehicles and gasoline-powered vehicles. Formaldehyde, acetaldehyde, acetone and propionaidehyde were the species with the highest emission factors. Main influencing factors for carbonyl emissions were vehicle type, average speed and regulated emission standard, and the impact of vehicle loading was not evident in this study. National emission of carbonyls from diesel vehicles exhaust was calculated for China, 2011, based on both vehicle miles traveled and fuel consumption. Carbonyl emission of diesel vehicle was estimated to be 45.8 Gg, and was comparable to gasolinepowered vehicles （58.4 Gg）. The emissions of formaldehyde, acetaldehyde and acetone were 12.6, 6.9, 3.8 Gg, respectively. The ozone formation potential of carbonyls from diesel vehicles exhaust was 537 mg O3/km, higher than 497 mg O3/km of none-methane hydrocarbons emitted from diesel vehicles.     

中国危险废物和医疗废物焚烧处置行业二（口恶）排放水平研究

通过调研全国危险废物和医疗废物焚烧处置设施,对包含二噁英排放水平的设施按处置对象、炉型和处理量分类,并作系统分析和研究.结果表明现有危险废物焚烧设施烟气中二噁英的浓度比医疗废物低,达标率为74.19%;危险废物选用回转窑处置效果较好,达标率为66.67%;而医疗废物选用回转窑或热解炉,要综合考虑处置规模、生产成本和二英排放总量等因素;危险废物介于10~30 t·d-1和医疗废物介于10~20 t·d-1的处置设施要尤其注意二噁英的排放问题;医疗废物焚烧飞灰中二噁英的均值浓度为危险废物6倍以上,仅有16.67%满足填埋要求.二者烟气中二英的浓度分布以1,2,3,4,6,7,8-HpCDF、2,3,7,8-TCDF和OCDD为主.     

静置/好氧/缺氧序批式反应器（SBR）脱氮除磷效果研究

以静置段代替传统厌氧段,采用后置缺氧方式,考察了静置/好氧/缺氧序批式反应器(SBR)(R1)的生物脱氮除磷(BNR)性能,并与传统厌氧/好氧/缺氧序批式反应器(SBR)(R2)进行对比.两反应器进水乙酸钠、氨氮(NH+4-N)及磷酸盐(PO3-4-P)浓度均分别为350 mg·L-1(以COD计)、40 mg·L-1及12 mg·L-1,水力停留时间(HRT)为12 h.研究结果表明,R1长期运行中磷的去除率与R2相当,分别为92.4%和92.1%,而总氮(TN)去除率则较R2高,分别为83.5%和77.0%.R1静置段省去搅拌但仍能起到厌氧段的作用,为好氧快速摄磷奠定了基础,同时R1缺氧段发生反硝化摄磷,使出水磷降至0.91 mg·L-1.好氧段内R1发生了同步硝化-反硝化(SND),贡献了18.0%的TN去除量,R2也存在SND,但脱氮贡献率较少,仅为9.8%.R1和R2后置缺氧反硝化均以糖原驱动,反硝化速率分别为0.98、0.84 mg·g-1·h-1(以每g VSS产生的N(mg)计),出水TN分别为6.62、9.21 mg·L-1.研究表明,静置段代替传统厌氧段后,可获得更好的脱氮效果,且工艺更为简化.     

大孔网状聚氨酯载体MBBR工艺处理低浓度硝基苯废水实验研究

利用大孔网状聚氨酯载体在MBBR工艺条件下,研究了系统挂膜与启动过程,同时利用挂膜成熟稳定的载体进行低浓度硝基苯废水处理实验。研究结果表明,在20℃条件下培养的活性污泥生长状况良好,挂膜速度快,生物膜厚度大,耐冲击负荷。在MBBR反应时间24 h、材料投加量为1/4、硝基苯初始浓度为2.095mg/L的条件下,处理低浓度硝基苯废水的效果最好,CODcr去除率为92.58%,硝基苯去除率为49.82%。