人粪便中温好氧堆肥过程的有机物降解特性研究

利用密闭式小型堆肥反应器,以锯末作为堆肥载体,采用批量反应的操作方式,在35℃的温控条件下进行了人粪便的中温好氧堆肥实验。结果表明,在14 d的堆肥反应周期内,粪便中以COD为参数的有机物去除率可达到70%左右,且在10～12 d内基本完成有机物降解。在中温条件下,堆体容易保持适宜的含水率和pH值,维持适宜微生物繁殖生长的条件。运用磷脂法进行堆肥过程中微生物总量的分析,表明在一个堆肥周期内,微生物经历了环境适应期、稳定增殖期、生物量下降期等3个阶段,这一微生物繁衍规律与有机物的去除密切相关。与高温堆肥相比,中温堆肥能够减少设备加热的能量消耗,是缺水地区人粪便处置的可选方法之一。     

双氧水催化氧化中Cu/γ-Al_2O_3催化剂的稳定性研究

针对废水湿式双氧水催化氧化,采用浸渍法制备Cu催化剂,研究非均相Cu催化剂在常温常压湿式双氧水催化氧化中的稳定性与失活问题。研究表明,催化剂制备条件及催化氧化反应条件对催化剂中Cu2＋溶出均有影响。研究同时表明,催化剂失活与活性组分流失和活性组分被有机中间产物覆盖有关,高温焙烧可对催化剂再生。     

阶式生物接触氧化对富营养化太湖水源水中溶解有机物的去除性能研究

构建阶式生物接触氧化反应器处理富营养化太湖水源水,对其净水效能进行研究。结果表明,在优化工况条件下,阶式生物氧化反应器的三阶对太湖水源水中DOC的累积去除率分别为34．4％、40．2％和47．5％,对BDOC的总去除率为68．4％,除生物降解外,填料拦截、生物吸附絮凝等物理、化学作用对去除原水中的DOC仍有重要作用。DOC分子量分级表明,太湖源水中含量最大的是分子量〈500Da的DOC,含量最小的是分子量在5k～500Da间的DOC。阶式生物接触氧化反应器对分子量〈500 Da的DOC的去除率在60％以上,而出水中5k～500 Da区间的DOC含量相比原水增加近1倍。     

阴极氧还原产电生物可渗透反应栅的研究Ⅰ. 不锈钢毛电极模拟反应器

提出利用阴极氧还原和阳极微生物产电作用的产电生物可渗透反应栅（CORE-PRB）方法用于被有机物污染的地下水的修复,并以不锈钢毛为电极建立模拟反应装置验证了CORE-PRB的技术概念。实验中考察了分别以蔗糖＋醋酸盐和不同浓度的污泥消化液为进水时的反应电流,并研究电极距离对反应电流的影响。由于氧还原阴极阳极反应能力的限制,随着与阴极室距离加大,模拟反应装置各阳极室的电流迅速减小。有机基质的可生化性对模拟反应器的总电流也有显著影响。     

垂直流人工湿地水力学特性研究

通过示踪剂实验从停留时间分布（RTD）曲线及其统计特征值等方面对垂直流人工湿地的水力学特性进行了定性和定量的分析。研究表明水流在垂直流人工湿地中的流动是一种非理想的不均匀流动,存在一定的死区和水流的扩散;垂直流人工湿地较大的死区率与其表面布水的不均匀性有关,这也可能是其死区率大于表流人工湿地的最主要的原因。实验还表明,进水流量对垂直流人工湿地停留时间分布影响较大,随着进水流量的增加,平均停留时间减小,但标准平均停留时间增大,死区率减小;当进水流量为15L／h（水力负荷为620mm／d）时,水流在湿地中的散度最大,水流更接近全混流,不利于污染物的降解。     

提高炼油废水处理场的氨氮去除率

对炼油废水处理场现有工艺进行流程优化,将MBR装置调整在接触氧化池之后运行.优化流程后氨氮平均去除率可从近于0提高至71.70％;COD平均去除率可从50.00％提高至72.00％.通过对工艺流程的对比,分析了现有工艺氨氮质量浓度难以降低的原因,指出废水中存在的某些污染物对硝化细菌起到抑制作用,减少了反应器中硝化细菌的...     

制药废水有机污染物特性分析与处理

分析了某制药企业废水生物处理站进出水中有机污染物的相对分子质量分布和气相色谱—质谱图谱,提出了根据废水水质特性有针对性地确定制药废水处理工艺的新思路.实验结果表明:进出水中的有机污染物主要是相对分子质量小于1 000的物质,且主要来源于车间5排放的COD比重大、水量小的工段废水;采用旋转蒸馏预处理法处理车间5废水,可使...     

Enhanced arsenate removal from aqueous solution by Mn-doped MgAl-layered double hydroxides

Environmental Science and Pollution Research - In this study, Mn-doped MgAl-layered double hydroxides (LDHs) were successfully synthesized for efficient removal arsenate from aqueous solution. The...     

Preparation and Properties of a Chitosan–Hyaluronic Acid-Polypyrrole Conductive Hydrogel Catalyzed by Laccase

Electro conductive hydrogels, consisting of chitosan (CS), hyaluronic acid (HA), and polypyrrole (PPy), were prepared via an in situ enzymic polymerization of pyrrole in the CS–HA hydrogel, using laccase as the catalyst. This CS–HA–PPy composite hydrogel showed good conductivity. The chemical structure and morphology of this conductive hydrogel were studied by Fourier transform infrared spectroscopy, scanning electron microscopy, and X-ray diffraction technique. For CS–HA–PPy and CH–HA hydrogel, the temperature at which fastest decomposition occurred was 260 and 244 °C, respectively. That means the thermal stability of CS–HA–PPy is better than CS–HA hydrogel. The conductive hydrogel also showed excellent swelling and deswelling behaviors.     

Continuous measurement of peroxyacetyl nitrate (PAN) in suburban and remote areas of western China

Knowledge on atmospheric abundance of peroxyacetyl nitrate (PAN) is important in assessing the severity of photochemical pollution, and for understanding chemical transformation of reactive odd nitrogen and its impact on the budget of tropospheric ozone (O₃). In summer 2006, continuous measurements of PAN were made using an automatic GC–ECD analyzer with an on-line calibrator at a suburban site of Lanzhou (LZ) and a remote site of Mt. Waliguan (WLG) in western China, with concurrent measurements of O₃, total reactive nitrogen (NO_y) and carbon monoxide (CO). At LZ, several photochemical episodes were observed during the study, and the average mixing ratio of PAN (plus or minus standard deviation) was 0.76 (±0.89) ppbv with the maximum value of 9.13 ppbv, compared to an average value of 0.44 (±0.16) ppbv at remote WLG. The PAN mixing ratios in LZ exhibited strong diurnal variations with a maximum at noon, while enhanced concentrations of PAN were observed in the evening and a minimum in the afternoon at WLG. The daily O₃ and PAN concentration maxima showed a strong correlation (r² = 0.91) in LZ, with a regression slope (PAN/O₃) of 0.091 ppbv ppbv^?1. At WLG, six well-identified pollution plumes (lasting 2–8 h) were observed with elevated concentrations of PAN (and other trace gases), and analysis of backward particle release simulation shows that the high-PAN events at WLG were mostly associated with the transport of air masses that had passed over LZ.