Evaluation of biopolymer-modified concrete systems for disposal of cathode ray tube glass

Cathode ray tubes (CRTs) from computer monitors and television sets, which contain significantly high percentage of lead (Pb) by weight, represent an enormous and growing hazardous waste problem in the United States and worldwide. As a result, new technologies are needed to cope with current CRT waste stream and increased hazard and build new markets for its recycled components, developing commercially viable concrete composites, as well as minimizing CRT disposal problems. In this study, commercially available biopolymers, such as xanthan gum, guar gum, and chitosan, were used to encapsulate CRT glass waste, reducing the Pb leachability. The biopolymers utilized contain a number of useful functional groups, such as carboxyl (xanthan), hydroxyl (guar), and amino groups (chitosan), which play important roles in binding and stabilizing Pb onto concrete structures. The use of biopolymers in concrete systems can create a stable interpenetrating cross-linking composite that will last for many years. Results from these new composites show 30% higher compressive strength than standard concrete and a sharp decrease in lead leachability from several thousand milligrams per liter initially to an amount of three-tenths milligrams per liter or lower values (much lower than the U.S. Environment Protection Agency standard for hazardous waste of 5 mg/L by the toxicity characteristic leaching procedure test), and for some of the composites leachability is below even the standard for drinking water. This efficient and cost-effective CRT-biopolymer-concrete composite is a new class of biopolymer-modified material that can potentially perform a significant role in relieving the current CRT issue.     

TiO2薄膜光催化降解双酚A的研究

采用sol-gel法制备TiO2薄膜。以该薄膜为催化剂，研究了在H2O2存在的条件下，对内分泌干扰物质双酚A的光催化降解反应。分别讨论了pH值、H2O2的加入量、双酚A的初始浓度以及光照时间对降解反应的影响。结果表明，在pH=4，30mg／L的H2O2中对初始浓度为50mg／L的双酚A溶液光照180min有较好的降解效果。     

富氧条件下选择性还原NO的复合催化剂体系

选择性催化还原法是净化稀燃汽车尾气中NOx 的最有效途径之一 ,单一催化组分或单一类型的催化剂很难满足实际需要 ,复合催化剂的研究成为必然趋势。本文介绍了复合催化体系的组合形式 ,回顾了国内外最近几年复合催化剂体系净化NOx 的研究成果 ,为将来设计新的复合催化体系提出了建议     

Gas chromatography/mass spectrometry applied for the analysis of triazine herbicides in environmental waters

The excess use of triazine herbicides in agriculture causes severe contamination to the environment especially for ground water. Gas chromatography coupled with mass spectrometry (GC/MS) was used to analyze simazine, atrazine (ATR), cyanazine, as well as the degradation products of ATR such as deethylatrazine and deisopropylatrazine in environmental water samples. These compounds were baseline separated by the established GC method. The water samples were pre-concentrated by solid-phase-extraction (SPE) and analyzed by ion trap MS at sub- to low-ppt levels. Recovery of ATR by the SPE pre-concentration using a C18 cartridge was determined as 90.5 +/- 3.5%. Detection limit of the method using selected ion monitoring technique for ATR was 1.7 ppt when one liter water was analyzed. The relative analytical error for ATR fortified water samples at 200 ppt was -12.5% (n=12) with triple analysis and the relative standard deviation was 3.2%. Trace levels of ATR at 3.9 and 9.7 ppt were determined in water samples collected from a reservoir and a river in Hong Kong.     

磷石膏的改性及其在水泥生产中的应用

研究了磷石膏的改性方法及改性磷石膏在水泥生产中的应用，结果表明，通过改性，可将磷石膏中对水泥有害的杂质转化为难溶性，并能改善磷石膏中硫酸钙的溶解性能，改性磷石膏可以替代天然石膏用于水泥生产。     

半干法烟气脱硫新技术——粉末-颗粒喷动床技术

粉末 颗粒喷动床 (powder particlespoutedbed ,PPSB)是近几年来由日本研究人员开发的一种新的半干法烟气脱硫技术。本文介绍了PPSB的基本原理、优点以及在试验条件下所得到的影响因素和适宜的运行方式。PPSB在系统结构、废物处理、操作和费用方面比湿法有所提高 ,同时又比干法和其他半干法的去除率和吸收剂的利用率高。此外 ,对吸收剂研究结果表明 ,石灰石的脱硫效率虽然不及石灰 ,但是由于PPSB中吸收剂的停留时间长 ,气、固、液三相接触好的特点以及可以对石灰石进行研磨 ,因此 ,利用石灰石作吸收剂的PPSB完全可以达到理想的脱硫效率 ,同时也可以保持较好的经济性。但是 ,目前还没有大规模的试验和应用。所以PPSB是一项十分值得进一步开发和应用的烟气脱硫新技术。     

试论我国风景资源的保护

风景资源是一种不可再生的资源,一旦毁损,无法弥补。随着旅游业的发展,风景资源面临着污染、破坏和衰竭的局面,针对这种现状,本文提出了保护对策。     

Modeling and source apportionment of diesel particulate matter

The fine and ultra fine sizes of diesel particulate matter (DPM) are of greatest health concern. The composition of these primary and secondary fine and ultra fine particles is principally elemental carbon (EC) with adsorbed organic compounds, sulfate, nitrate, ammonia, metals, and other trace elements. The purpose of this study was to use an advanced air quality modeling technique to predict and analyze the emissions and the primary and secondary aerosols concentrations that come from diesel-fueled sources (DFS). The National Emissions Inventory for 1999 and a severe southeast ozone episode that occurred between August and September 1999 were used as reference. Five urban areas and one rural area in the Southeastern US were selected to compare the main results. For urban emissions, results showed that DFS contributed (77.9%+/-8.0) of EC, (16.8%+/-8.2) of organic aerosols, (14.3%+/-6.2) of nitrate, and (8.3%+/-6.6) of sulfate during the selected episodes. For the rural site, these contributions were lower. The highest DFS contribution on EC emissions was allocated in Memphis, due mainly to diesel non-road sources (60.9%). For ambient concentrations, DFS contributed (69.5%+/-6.5) of EC and (10.8%+/-2.4) of primary anthropogenic organic aerosols, where the highest DFS contributions on EC were allocated in Nashville and Memphis on that episode. The DFS contributed (8.3%+/-1.2) of the total ambient PM(2.5) at the analyzed sites. The maximum primary DPM concentration occurred in Atlanta (1.44 microg/m(3)), which was 3.8 times higher than that from the rural site. Non-linearity issues were encountered and recommendations were made for further research. The results indicated significant geographic variability in the EC contribution from DFS, and the main DPM sources in the Southeastern U.S. were the non-road DFS. The results of this work will be helpful in addressing policy issues targeted at designing control strategies on DFS in the Southeastern U.S.     

A simplified 137Cs transport model for estimating erosion rates in undisturbed soil

(137)Cs is an artificial radionuclide with a half-life of 30.12 years which released into the environment as a result of atmospheric testing of thermo-nuclear weapons primarily during the period of 1950s-1970s with the maximum rate of (137)Cs fallout from atmosphere in 1963. (137)Cs fallout is strongly and rapidly adsorbed by fine particles in the surface horizons of the soil, when it falls down on the ground mostly with precipitation. Its subsequent redistribution is associated with movements of the soil or sediment particles. The (137)Cs nuclide tracing technique has been used for assessment of soil losses for both undisturbed and cultivated soils. For undisturbed soils, a simple profile-shape model was developed in 1990 to describe the (137)Cs depth distribution in profile, where the maximum (137)Cs occurs in the surface horizon and it exponentially decreases with depth. The model implied that the total (137)Cs fallout amount deposited on the earth surface in 1963 and the (137)Cs profile shape has not changed with time. The model has been widely used for assessment of soil losses on undisturbed land. However, temporal variations of (137)Cs depth distribution in undisturbed soils after its deposition on the ground due to downward transport processes are not considered in the previous simple profile-shape model. Thus, the soil losses are overestimated by the model. On the base of the erosion assessment model developed by Walling, D.E., He, Q. [1999. Improved models for estimating soil erosion rates from cesium-137 measurements. Journal of Environmental Quality 28, 611-622], we discuss the (137)Cs transport process in the eroded soil profile and make some simplification to the model, develop a method to estimate the soil erosion rate more expediently. To compare the soil erosion rates calculated by the simple profile-shape model and the simple transport model, the soil losses related to different (137)Cs loss proportions of the reference inventory at the Kaixian site of the Three Gorge Region, China are estimated by the two models. The over-estimation of the soil loss by using the previous simple profile-shape model obviously increases with the time period from the sampling year to the year of 1963 and (137)Cs loss proportion of the reference inventory. As to 20-80% of (137)Cs loss proportions of the reference inventory at the Kaixian site in 2004, the annual soil loss depths estimated by the new simplified transport process model are only 57.90-56.24% of the values estimated by the previous model.     

城中村改造与生态城市建设

城市化的加速,促进了经济社会的快速发展,但同时也带来了城市发展模式的思考和城中村改造的问题。对于目前中国多数的大中城市来说,建设生态城市和改造城中村是当前城市建设工作的两项重要内容。从这两项工作的理论研究入手,阐述了城中村改造与生态城市建设的关系,论证了城中村改造遵循生态城市建设要求的重要性,论述了城中村改造中的生态保护措施,力求促使城中村改造与生态城市建设有机衔接,加速生态城市建设进程。