Selective separation of deltamethrin by molecularly imprinted polymers using a β-cyclodextrin derivative as the functional monomer

A deltamethrin-imprinted polymer (MIP₁) was prepared using bis(-6-O-butanediacid monoester)-β-cyclodextrin (BBA-β-CD) as the functional monomer and toluene 2,4-diisocyanate (TDI) as the cross-linker. In comparison to the molecularly imprinted polymer where β-CD was applied as the functional monomer (MIP₂), MIP₁ showed a higher specific binding capacity (ΔC_P) and an improved imprinting factor (IF) for deltamethrin. The selective recognition experiments demonstrated that compared to MIP₂, MIP₁ could better recognize its template over other substrates that had similar chemical structures. The solid phase extraction (SPE) of deltamethrin using MIP₁ as the adsorbent was further investigated. The recoveries of the molecularly imprinted solid phase extraction (MISPE) column for deltamethrin were 83.2–93.4% with relative standard deviations (RSD) of 2.03–6.19%. The method has been successfully applied to the enrichment of trace deltamethrin from real water samples.     

生物质材料预处理餐饮废水

采用4种廉价的生物质材料（水葫芦、柚子皮、木屑、核桃壳）用于餐饮废水的预处理。通过静态烧杯实验,研究了各生物质材料预处理废水的效果及最佳处理条件。结果表明,生物质材料对废水中COD的去除率均在45％以上,油脂吸附量为4～16mg／g,最优吸附材料为水葫芦,COD去除率达65％,油脂吸附量为16mg／g;水葫芦和柚子皮的最佳处理条件为：粒径〈0．2mm,投加量为20g／L,废水pH为4,处理时间为2h,温度为20℃;木屑和核桃壳的最佳实验条件为：粒径〈0．2mm,投加量为28g／L,pH为2,处理时间为2．5h,温度为20℃。生物质对餐饮废水的预处理,为废水中大量有机物和废弃油脂的去除提供了新思路和途径。     

Modeling Traffic-Related Air Pollution in Street Canyons of Beijing

ABSTRACT

It is important to develop a general model to accurately simulate the air pollution in urban street areas. In this paper, the Operational Street Pollution Model (OSPM) initially developed in Denmark is tested with measured data from a relatively wide and open street in Beijing. Major factors influencing the dispersion, such as emission factors, stationary source emissions, and solar radiation, are analyzed. Results show that the model can reflect the basic dispersion pattern in the street but gives systematically higher concentrations. After modifications to estimate street-level wind speed in the model, performance is obviously improved.     

初始温度对废轮胎热解的影响

以管式炉热解实验和热重分析为基础,研究了初始温度对废轮胎热解产率及气相产物特性影响。结果表明,初始温度对废轮胎的热解存在重要影响。热重分析结果表明,废轮胎的热解过程存在2个主要失重过程,第一失重温度区间为200～500℃,第二失重温度区间为650～800℃;升温速率仅改变了热解的最大失重速率,并未改变废轮胎最终热解失重率;可通过提高升温速率能够缩短热解反应时间。在初始温度低于100℃时,废轮胎在800℃时热解已基本结束;当终温为800℃、初始温度在100～550℃范围内时,随着初始温度的提高,固、气两相产物产率均提高,而液相产物产率降低;其中气相中H2、CO和CH4的含量高于初始温度小于100℃时的含量;分析认为,可以通过调节热解的初始温度调节废轮胎热解在不同热解阶段的时间分配,适当提高热解初始温度有利于提高整个热解过程中的时间利用效率、改变废轮胎热解产物的分布;废轮胎热解气化的最佳温度区间为500～800℃。     

盐类对模拟胞外聚合物(EPS)膜污染的影响

实验旨在研究盐类对模拟胞外聚合物(EPS)溶液在超滤和微滤过程中膜污染影响,通过添加与无添加盐类的模拟溶液的比较,研究盐类对EPS膜过滤在死端过滤过程的影响。实验考察了不同模拟溶液的膜通量衰减情况和滤饼比阻,并利用Hermia模型对实验数据进行拟合分析验证膜污染机理。实验结果表明,在超滤过程中,Ca2+和Al3+能在一定程度上提高膜通量,降低滤饼比阻,延缓膜污染;在微滤过程中,两者的添加反而降低了初始通量,添加Ca2+后滤饼比阻值反而有所增大;Na+对超/微滤过程影响很小。通过Hermia模型拟合分析发现,在超滤过程中,添加盐和无添加的溶液均以滤饼堵塞机理为主,而在微滤过程中则是以中间堵塞和滤饼堵塞机理为主。     

TiO2纳米管催化活性再生处理技术简

采用H₂O₂、Fe₂（SO₄）₃和Fenton溶液对失活的TiO₂纳米管进行再生处理,重点考察了3种溶液的浓度和处理时间等对再生效果的影响,初步分析了经处理后TiO₂纳米管催化活性得到再生或增强的机理。结果表明,经H₂O₂溶液处理后TiO₂催化活性能得到有效再生,经Fe₂（SO₄）₃和Fenton溶液处理后其催化活性不仅得到再生,还能显著增强,这与H₂O₂和Fenton的强氧化作用,及进入TiO₂纳米管的Fe³⁺的阻止电子-空穴对再复合作用有关。     

Study on photocatalytic degradation of gaseous dichloromethane using pure and iron ion-doped TiO2 prepared by the sol-gel method

The synthesis of TiO₂ and Fe–TiO₂ by sol–gel method is demonstrated and characterized. The characterization of TiO₂ and Fe–TiO₂ is performed with instruments, including TGA/DTA, FTIR, UV–Vis, N₂ adsorption and SEM. Dichloromethane is used for the photocatalytic activity test. From the results of dichloromethane photocatalyitc degradation, the calcined temperature of TiO₂ and the presence of water vapor influence the photocatalytic activity. The optimum doping amount of iron ions is 0.005 mol%, and this can enhance the photocatalytic activity, while too great an amount will make the iron ions become recombination centers for the electron–hole pairs and reduce the photocatalytic activity. UV–Vis diffuse reflectance spectra of Fe–TiO₂ show an increase in absorbency in the visible light region with the increase in iron ions doping concentration The intermediate of dichloromethane photodegradation includes CHCl₃, CCl₄, CH₂Cl₂ and COCl₂. The presence of iron ions may reduce the adsorption of Cl element on the surface of the photocatalyst.     

电子垃圾焚烧排放的二噁英对周围大气环境的影响

为了研究电子垃圾焚烧产生的二噁英对周围环境的影响,同时在E1和E2采样点分别采集9个大气样品.E1周围分布大量的电子垃圾焚烧点,E2则位于E1南9 km处,周围无其他明显的二噁英排放源.所采样品用同位素稀释法进行分析测定,结果表明,E1和E2大气样品中二噁英的平均质量浓度分别为127.37、22.37 pg/m3,平均毒性当量浓度分别为8.777、1.305 pg I-TEQ/m3.八氯代二苯并呋喃(OCDF)、八氯代二苯并二噁英(OCDD)、七氯代二苯并呋喃(1,2,3,4,6,7,8-HpCDF)和七氯代二苯并二噁英(1,2,3,4,6,7,8-HpCDD)对2,3,7,8位氯代的二噁英的总浓度贡献较大,而五氯代二苯并呋喃(2,3,4,7,8-PeCDF)则对总毒性当量浓度贡献最大,其贡献率超过40%.在E1和E2两个采样点,二噁英在气相中的比例均随着氯原子取代数的增加而降低.两采样点相似的二噁英分布模式和气固分配,说明E2大气中二噁英主要来自于E1电子垃圾焚烧产生的二噁英.