评析中国现行环境保护投资体制

本文通过对我国近15年环保投资相关数据的分析,揭示了现行环保投资体制失灵的一个重要因素是结构上失衡,在环保投资中没有体现环保设施运营费用,直接影响了环保投资的效益,其次,一些指标的设计严重偏离了现实,影响了环保投资的有机构成,也导致环境政策的失效,在此基础上,结合实际,提出初步的改革设想。     

新型低温Fe/AC脱硫剂的研究

将活性焦担载氧化铁制得Fe/AC脱硫剂用于烟气脱硫,在最经济的烟气脱硫温度窗口(120℃～250℃)显示出高的脱硫活性.考察操作条件对其脱硫活性的影响,并借助EXAFS和TPD表征技术对其内在原因进行探讨.Fe/AC脱硫剂在排烟温度下用于脱硫,其活性明显优于活性焦和纯Fe₂O₃,且载体炭无氧化烧损.Fe/AC吸硫后形成2种含硫物质:H₂SO₄和Fe₂(SO₄)₃,H₂O和O₂的存在可增加Fe/AC对SO₂的吸附硫容.由高比表面活性焦制得的Fe/AC有更高的脱硫活性,这源于活性组分Fe₂O₃在其上良好的分散性.Fe/AC用于脱硫应在适宜空速[(800L/(kg·h)]下操作.     

甘氨酸厂废液综合治理的工艺及实验研究

对氯乙酸氨解法生产甘氨酸所排放的工业废水首先运用多效真空蒸发兼热泵技术回收氯化铵,然后对蒸发过程中产生的二次蒸汽冷凝水采用一次吹脱-催化氧化-二次吹脱的工艺进行处理,可使废水中的各种污染物有效去除。通过实验确定了冷凝水处理过程中的吹脱及氧化的最佳工艺参数。     

药厂、啤酒厂等有机废水厌氧处理试验研究

针对几种高浓度有机废水进行厌氧处理试验,取得参数,为生产性试验提供有价值的参数。     

聚异丁烯丁二酰亚胺尾气吸收系统的改进

针对聚异丁烯丁二酰亚胺生产工艺中废气排放量大、尾气吸收得到的盐酸含油量高、难以销售等问题,在分析原因的基础上,对尾气吸收系统进行了技术改进。尾气吸收系统改进后,排放的HCl和Cl2的质量浓度分别由65,42mg／m^3降至为零;产品综合收率由89．5％增加至96．0％;产品成本降低了700元/t。     

分子印迹硅纳米改性氧化石墨烯复合材料的制备及其对双酚A的吸附研究

制备了分子印迹硅纳米-氧化石墨烯复合吸附材料,并研究了复合材料对双酚A(Bisphenol A,BPA)的吸附性能.实验结果表明:复合吸附材料对BPA的吸附在35min内达到吸附平衡,Langmuir等温线模型得出最大吸附容量约为338.3mg/g;相对于BPA的结构类似物,对BPA具有良好的选择吸附性能;在溶液pH接...     

西藏浪卡子至洛扎公路沿线地质灾害与防治

浪卡子至洛朴公路是西藏山南地区环线公路的西段,全长120 km。由于公路位于高寒、新构造运动强烈的地区,特殊的地质背景、气候因素和鹅理环境,为该地区地质灾害的发育提供了良好的条件。公路沿线的地质灾害主要有泥石流、滑坡、坍岸(水毁)等,各类地质灾害影响公路总长7 248m,其中泥石流42条,滑坡l处,坍岸(水毁)12处。各类地质灾害对公路的建设和运营构成了极大的危害,针片这些地质灾害发育的特点,结合当地的环境和公路的等级要求,提出了切实有效的治理措施。     

铝材Sn-Ni混合盐电解着枪色参数研究

首先对铝片试样进行预处理,随后在恒定的电流密度和相同的氧化时间下,在铝材表面形成厚度均匀的阳极氧化膜,然后采用方波交流电,对铝试样进行电解着色处理,通过改变铝材电解着色工艺的着色时间、电流密度、正负电流比、占空比等因素来研究这些因素与铝材明度值和色差之间的关系。实验结果表明获得枪色的最佳工艺条件是:着色时间6m in左右,着色电流密度为1.40 A/dm2左右,正向电流比负向电流大7%左右,占空比55%左右。     

太阳热反射涂料的研制

根据涂料反射太阳热的原理,以丙烯酸树脂为基料,以金红石型钛白粉、云母粉及空心玻璃微珠为原料,制备了隔热性能和耐候性能均良好的太阳热反射隔热涂料,并研究了颜料、填料种类、粒径、涂层厚度对涂料隔热性能的影响。     

Metabolic uncoupler, 3,3′,4′,5-tetrachlorosalicylanilide addition for sludge reduction and fouling control in a gravity-driven membrane bioreactor

• Effects of metabolic uncoupler TCS on the performances of GDMBR were evaluated. • Sludge EPS reduced and transformed into dissolved SMP when TCS was added. • Appropriate TCS increased the permeability and reduced cake layer fouling. • High dosage aggravated fouling due to compact cake layer with low bio-activity. The gravity-driven membrane bioreactor (MBR)system is promising for decentralized sewage treatment because of its low energy consumption and maintenance requirements. However, the growing sludge not only increases membrane fouling, but also augments operational complexities (sludge discharge). We added the metabolic uncoupler 3,3′,4′,5-tetrachlorosalicylanilide (TCS) to the system to deal with the mentioned issues. Based on the results, TCS addition effectively decreased sludge ATP and sludge yield (reduced by 50%). Extracellular polymeric substances (EPS; proteins and polysaccharides) decreased with the addition of TCS and were transformed into dissolved soluble microbial products (SMPs) in the bulk solution, leading to the break of sludge flocs into small fragments. Permeability was increased by more than two times, reaching 60–70 L/m²/h bar when 10–30 mg/L TCS were added, because of the reduced suspended sludge and the formation of a thin cake layer with low EPS levels. Resistance analyses confirmed that appropriate dosages of TCS primarily decreased the cake layer and hydraulically reversible resistances. Permeability decreased at high dosage (50 mg/L) due to the release of excess sludge fragments and SMP into the supernatant, with a thin but more compact fouling layer with low bioactivity developing on the membrane surface, causing higher cake layer and pore blocking resistances. Our study provides a fundamental understanding of how a metabolic uncoupler affects the sludge and bio-fouling layers at different dosages, with practical relevance for in situ sludge reduction and membrane fouling alleviation in MBR systems.