Effects of reductive inorganics and NOM on the formation of chlorite in the chlorine dioxide disinfection of drinking water

Chlorine dioxide (ClO₂) disinfection usually does not produce halogenated disinfection by-products, but the formation of the inorganic by-product chlorite (ClO₂^–) is a serious consideration. In this study, the ClO₂^– formation rule in the ClO₂ disinfection of drinking water was investigated in the presence of three representative reductive inorganics and four natural organic matters (NOMs), respectively. Fe²⁺ and S^2– mainly reduced ClO₂ to ClO₂^– at low concentrations. When ClO₂ was consumed, the ClO₂^– would be further reduced by Fe²⁺ and S^2–, leading to the decrease of ClO₂^–. The reaction efficiency of Mn²⁺ with ClO₂ was lower than that of Fe²⁺ and S^2–. It might be the case that MnO₂ generated by the reaction between Mn²⁺ and ClO₂ had adsorption and catalytic oxidation on Mn²⁺. However, Mn²⁺ would not reduce ClO₂^–. Among the four NOMs, humic acid and fulvic acid reacted with ClO₂ actively, followed by bovine serum albumin, while sodium alginate had almost no reaction with ClO₂. The maximum ClO₂^– yields of reductive inorganics (70%) was higher than that of NOM (around 60%). The lower the concentration of reductive substances, the more ClO₂^– could be produced by per unit concentration of reductive substances. The results of the actual water samples showed that both reductive inorganics and NOM played an important role in the formation of ClO₂^– in disinfection.     

美国路易斯安那州自然资源损害评估制度及其启示

联邦《石油污染条例》、州《溢油预防和应对法案》和《溢油预防和应对条例》共同构成了美国路易斯安那州自然资源损害评估制度体系,确立了评估活动主导者和参与者明确、程序清晰、客观公正、资金来源有保障,且融合了应急、评估、响应行动于一体的评估制度。我国正在建立的生态环境损害赔偿制度,虽然就损害评估已经形成了部分规范性文件,但多重视的是评估机构的资质管理和具体的评估技术方法,有必要借鉴域外经验,从主体构建、程序设计、多方参与、评估资金、融合评估和应急、恢复行动于一体五个方面完善评估管理制度。     

T2铜在不同海水飞溅条件下的腐蚀性能差异

目的研究T2铜在不同飞溅条件下的腐蚀行为。方法通过对T2铜在三亚热带海水飞溅区进行0.5、1、2 a三个周期的环境试验,采用扫描电子显微镜、X射线衍射仪对其腐蚀产物形貌、物相进行分析,使用电化学工作站对带锈样品进行分析。结果 T2铜在堤岸飞溅区和堤岸内飞溅区腐蚀速率随时间的延长逐渐下降。在飞溅区,不同周期T2铜的腐蚀产物为表面较薄的氧化层,且存在分层现象,主要由外层疏松的绿色Cu2(OH)3Cl和内层致密的棕色Cu_2O组成。不同试验周期,两处飞溅区试样表面的腐蚀产物都较为平整,堤岸飞溅区腐蚀产物层的平均厚度大于堤岸内飞溅区,腐蚀形貌均为均匀腐蚀。两处飞溅区锈层均由Cu_2O和Cu2(OH)3Cl相构成,堤岸飞溅区锈层主要为Cu_2O和Cu2(OH)3Cl相,堤岸内飞溅区锈层主要为Cu_2O相,存在少量Cu2(OH)3Cl相。结论在同一试验地点进行飞溅试验,由于飞溅条件不同,2a内铜的腐蚀速率、腐蚀产物等会存在差异。     

MWNTs/TiO2对典型氯苯类化合物的光催化降解研究

研究复合光催化剂MWNTs/TiO2对典型氯苯类有机化合物光催化降解动力学及主要光降解路径.结果表明,同一初始浓度和相同光催化降解实验条件下,60min时典型氯苯类有机化合物的光降解率均达到90%以上.其中六氯苯和五氯苯的光催化降解速率常数分别为0.0664h-1和0.0670h-1,其大小明显高于其它氯苯类化合物.1,二氯苯的光催化降解反应速率常数仅为0.0430h4--1,在典型氯苯类化合物中最小.三氯苯的3种同分异构体——1,3-三氯苯、24-三氯苯和1,5-三氯苯的光催化降解速率常数分别为0.0547h2,1,,3,-1、0445h0.-1和0.0439h-1.六氯苯的主要光催化降解路径为:HCB→PeCB→1,2,3,5-TeCB→1,2,4-TCB→1,4-DCB.     

汽车用材料——PA66及其玻璃纤维复合材料在不同介质中的老化行为研究

在三种介质（二次水，汽油，乙二醇，50℃温度）条件下对PA66及PA66／GF进行95天左右的人工模拟材料在汽车使用环境下的加速试验，对不同老化时间的PA66及PA66／GF试样进行了宏观力学测试及吸湿性测试，并进一步利用示差扫描量热法（DSC），红外光谱及扫描电镜等手段分析老化前后试样的微观结构及组织差异。结合老化前后试样的力学性能变化，揭示了PA66及复合材料的老化规律和机理。实验表明，PA66及PA66／GF在三种介质中拉伸强度呈现下降趋势。其主要机理是介质溶液对试样渗入的结果影响，降低了分子间的相互作用力（范德华力）从而使材料机械性能下降；同时未发现化学作用对材料的力学性能有明显的变化。     

Acid Orange 7 degradation using methane as the sole carbon source and electron donor

• AO7 degradation was coupled with anaerobic methane oxidation. • Higher concentration of AO7 inhibited the degradation. • The maximum removal rate of AO7 reached 280 mg/(L·d) in HfMBR. • ANME-2d dominated the microbial community in both batch reactor and HfMBR. • ANME-2d alone or synergistic with the partner bacteria played a significant role. Azo dyes are widely applied in the textile industry but are not entirely consumed during the dyeing process and can thus be discharged to the environment in wastewater. However, azo dyes can be degraded using various electron donors, and in this paper, Acid Orange 7 (AO7) degradation performance is investigated using methane (CH₄) as the sole electron donor. Methane has multiple sources and is readily available and inexpensive. Experiments using ¹³C-labeled isotopes showed that AO7 degradation was coupled with anaerobic oxidation of methane (AOM) and, subsequently, affected by the initial concentrations of AO7. Higher concentrations of AO7 could inhibit the activity of microorganisms, which was confirmed by the long-term performance of AO7 degradation, with maximum removal rates of 8.94 mg/(L·d) in a batch reactor and 280 mg/(L·d) in a hollow fiber membrane bioreactor (HfMBR). High-throughput sequencing using 16S rRNA genes showed that Candidatus Methanoperedens, affiliated to ANME-2d, dominated the microbial community in the batch reactor and HfMBR. Additionally, the relative abundance of Proteobacteria bacteria (Phenylobacterium, Pseudomonas, and Geothermobacter) improved after AO7 degradation. This outcome suggested that ANME-2d alone, or acting synergistically with partner bacteria, played a key role in the process of AO7 degradation coupled with AOM.     

石油降解菌XD-1产表面活性剂的性能

从含油废水中筛选分离到1株原油降解菌XD-1,鉴定为假单胞菌（Pseuomonas sp.）.初步实验表明菌XD-1具有较强的产表面活性剂乳化原油的作用,对该菌的产表面活性剂性能进行了研究.实验证明,菌XD-1所产表面活性剂为脂肽类物质,菌在生长对数期产表面活性剂,表面活性剂的产生为生长相关型;充足的碳源是产表面活性剂的必需条件,菌利用原油为碳源时能持续大量地产表面活性剂;原油和尿素为产表面活性剂的最适碳源和氮源,菌XD-1产表面活性剂的最佳营养培养基组成为葡萄糖10 g,尿素4 g,磷酸二氢钾1 g,微量元素液4 mL,水1 L,pH 8.0.     

Assessment of popular techniques for co-processing municipal solid waste in Chinese cement kilns

• Municipal solid waste (MSW) was fermented, screened, gasified, then co-processed. • Co-processing MSW in cement kilns could cause excessive pollutant emissions. • Bypass flue gas can be disposed of through the main flue system. • Popular MSW co-processing methods do not affect cement quality. Cement kiln co-processing techniques have been developed in the past 20 years in China, and more than 60 factories now use fermentation, screening, and gasification pre-treatment techniques to co-process municipal solid waste (MSW). There three complete MSW pre-treatment techniques, co-processing procedures, and environmental risk assessments have been described in few publications. In this study, we assessed the effectiveness of each technique. The results suggested that the pollutant content released by each pre-treatment technology was lower than the emission standard. To reveal the mechanisms of pollutant migration and enrichment, the substances in the kiln and kiln products are investigated. The input of co-processing materials (Co-M) produced by fermentation caused formation of polychlorinated dibenzo-p-dioxins and dibenzofuran (PCDD/Fs) in the bypass flue gas (By-gas) in excess of the regulatory standard. The Co-M input produced by the screening and gasifier technologies caused the total organic carbon (TOC) concentration to exceed the standard. In addition, the NO_x, TOC, and PCDD/Fs in the By-gas exceeded the regulatory standard. Raw meal was the primary chlorine and heavy metals input stream, and clinker (CK) and cement kiln dust (CKD) accounted for>90% of the total chlorine output stream. Flue gas and CKD were the primary volatile heavy metal (Hg) output streams. Greater than 70% of the semi-volatile heavy metals (Cd, Pb, Tl and Se) distributed in hot raw meal and bypass cement kiln dust. The low-volatility heavy metals were concentrated in the CK. These results indicated that co-processing techniques used in China still require improvement.     

Study on dust–gas coupling pollution law and selection of optimal purification distance of air duct during tunneling process

During the excavation of high gas mine, gas and dust often exist at the same time. In order to ensure that the gas concentration remains within a safe range and minimize the risk of workers’ pneumoconiosis, we simulated the interaction mechanism of airflow, gas, and dust, explored the pollution law of gas and dust, and obtained the optimal purification distance (L_p) by the CFD method. The reliability of the numerical simulation was verified by field measurements. Firstly, the properties of the gas and dust affected the structure of the airflow field. At the same time, the change in the airflow field affected the concentration distributions of the gas and dust. During the diffusion process, some high-risk regions in which the gas or dust concentrations exceeded 0.80% or 200 mg/m³, respectively, were discovered. Moreover, we have found that the airflow velocity in the top region of the tunnel and at the intersection corner between the cutting face and tunnel wall was the main factor affecting the purification effects. When L_p = 5–8 m, the gas concentration remained below 0.50%. When L_p = 6 m, the dust concentration reached a minimum of 287.5 mg/m³. Therefore, the optimal purification distance was determined to be 6 m; in which case, the gas and dust concentrations decreased by 32.84% and 47.02%, respectively.

     

内陆输送过程中沙尘单颗粒类型及其非均相反应

采用单颗粒分析方法对2004 年2~3 月发生在北京的3 次沙尘暴的样品中沙尘颗粒物的化学成分进行了测定.3 次沙尘暴的反向轨迹图显示,它们主要来自于中国北部、西北部和蒙古的戈壁沙漠地区,且这些沙尘颗粒主要通过高空长距离输送到下游区域.使用带能谱的扫描电镜对481 个沙尘颗粒进行分析,并根据成分特征,把这些沙尘颗粒划分为8 种类型,主要类型有“富Si”、“富Ca”、“富S”、“富Fe”.将北京样品分析结果与呼和浩特、塔克拉玛干和敦煌的结果进行对比,结果显示,长距离输送的沙尘颗粒表面发生了SO₂ 的非均相化学反应,导致部分颗粒局部的表面发生化学修改作用,且“富Ca”的碱性矿物为非均相化学反应提供了更有利的反应界面.