废弃印刷线路板碘化法浸金研究

针对碘化法从废弃印刷线路板中提取金的工艺设计,分别考察了碘的质量分数、n(I₂)/n(I^-)比值、固液比、双氧水的质量分数、pH值、浸出时间和浸出温度对金浸出率的影响。结合正交设计优化实验方法,提出了从废弃印刷线路板中碘化法浸取金的最佳工艺条件：碘的质量分数为1.1％,n(I₂)∶n(I^-)=1∶10,双氧水的质量分数为1.5％,浸出时间4 h,固液比为1∶10,浸出温度为常温（25℃）,溶液pH值为中性,此时金浸出率可达97.5％。     

单块集尘板振打加速度的有限元分析

采用有限元分析软件ABAQUS,对单块集尘板振打加速度进行了分析计算。并将计算结果与解析法和实测法结果进行对比。对比结果表明,有限元计算值更接近于实测值。用有限元法对某厂实际运行的电除尘器加速度进行求解,计算结果与实际基本吻合。由于有限元法能非常方便地处理各种复杂板型、不同的悬挂方式、振打锤的大小以及振打方式,因此,有限元法对于现有极板的分析与新型极板的研究均具有重要的实际意义。     

微波无极紫外光催化-内电解协同降解活性艳红X-3B

采用微波无极紫外光源,以活性炭作为光催化剂TiO2的载体,与外加铁屑构成内电解反应,处理活性艳红X-3B模拟废水.实验结果表明,微波无极紫外光催化-内电解法对活性艳红X-3B的降解速率是微波无极紫外光催化和微波-内电解法单独作用时降解速率之和的2倍.在活性艳红X-3B模拟废水初始pH为7、空气曝气量为0.50 L/min、铁屑加入量为5 g/L、反应温度为40～45℃的最佳条件下,微波无极紫外光催化-内电解法的活性艳红X-3B模拟废水色度去除率达100%,TOC和可吸附有机卤化物的去除率分别为69.5%和81.8%.     

NaCl和KCl对厌氧污泥抑制的动力学研究

在厌氧颗粒污泥和厌氧絮状污泥系统中,进行盐质量浓度(NaCl或KCl质量浓度,下同)对厌氧污泥抑制动力学的研究,得到不同拟合的COD降解动力学方程及参数.实验结果表明:当盐质量浓度为10～30 g/L时,KCl对厌氧污泥的COD比降解速率的抑制程度大于NaCl;当盐质量浓度由0 g/L增至10 g/L时,半速率常数逐渐增加;当盐质量浓度由10 g/L增至30 g/L时,半速率常数逐渐减小;在厌氧污泥系统中,NaCl抑制作用下的盐抑制常数高于KCl,且颗粒污泥的盐抑制常数高于絮状污泥.     

混凝法深度处理印染废水中试研究

采用"高效混凝沉淀-过滤"深度处理工艺处理印染废水二级生化出水,并将混凝沉淀污泥回流.实验结果表明,混凝剂聚合氯化铝加入量为160 mg/L时,COD去除率平均可达34.6%,TP去除率平均达到87.9%,平均出水TP为0.3 mg/L.气相色谱-质谱分析和元素分析结果表明混凝沉淀工艺对有机物和TP的去除效果良好.     

Removal of Cr(VI) from simulative contaminated groundwater by iron metal

The Cr(VI) removal from simulative contaminated groundwater using zero-valent iron (Fe⁰) filings, Fe⁰ powder and nanoscale Fe⁰ in batch experimental mode was studied. Cr(VI) is a primary pollutant of some soils and groundwater. Zero-valent iron, an important natural reductant, could transform Cr(VI) to Cr(III) which is much less toxic and immobile. The Cr(VI) removal percentage was 87% at a metal to solution ratio of 6 g l⁻¹ for commercial iron powder (200 mesh) in 120 min, and 100% Cr(VI) was removed when the metal to solution ratio was 10 g l⁻¹. The results demonstrates that the Cr(VI) removal percentage was affected apparently by pH, the amount of Fe powder and the reaction temperature. The Cr(VI) removal percentage with nanoscale Fe⁰ was much higher than those with Fe⁰ filings or Fe⁰ powder at the same reaction time. Electrochemical analysis of the reaction process led to the conclusion that the Cr(VI) trended to form Cr(III) hydroxide under the reaction conditions. The kinetics analysis showed that Cr(VI) reduction by Fe⁰ could be described as a pseudo-first-order kinetics model.     

A case study predicting environmental impacts of urban transport planning in China

Predicting environmental impacts is essential when performing an environmental assessment on urban transport planning. System dynamics (SD) is usually used to solve complex nonlinear problems. In this study, we utilized system dynamics (SD) to evaluate the environmental impacts associated with urban transport planning in Jilin City, China with respect to the local economy, society, transport, the environment and resources. To accomplish this, we generated simulation models comprising interrelated subsystems designed to utilize changes in the economy, society, road construction, changes in the number of vehicles, the capacity of the road network capacity, nitrogen oxides emission, traffic noise, land used for road construction and fuel consumption associated with traffic to estimate dynamic trends in the environmental impacts associated with Jilin's transport planning. Two simulation scenarios were then analyzed comparatively. The results of this study indicated that implementation of Jilin transport planning would improve the current urban traffic conditions and boost the local economy and development while benefiting the environment in Jilin City. In addition, comparative analysis of the two scenarios provided additional information that can be used to aid in scientific decision-making regarding which aspects of the transport planning to implement in Jilin City. This study demonstrates that our application of the SD method, which is referred to as the Strategic Environmental Assessment (SEA), is feasible for use in urban transport planning.     

Generalized models for prediction of pentachlorophenol dissipation dynamics in soils

Dissipation of pentachlorophenol (PCP) in soil was investigated and the chemical relationships with soil properties were addressed. The results indicate that the dissipation of extractable PCP residues can be described using first-order kinetics equations, with a half-dissipation time (T(1/2)) ranging from 6.5 to 173.3d. The sharply different patterns of PCP dissipation in different soils were closely related to soil properties. Correlations of stepwise regression equations obtained were significant at 0.01 probability level between soil parameters and extractable PCP residues (R(2)=0.974**) as well as T(1/2) values (R(2)=0.882**). Using pH together with organic carbon content (OC) and soil particle size distribution, the dissipation dynamics of PCP in soil could be accurately predicted.     

Filterability of oil sands tailings

In Canadian oil sands mining operations, bitumen is extracted from oil sands using the hot water extraction process, which produces tremendous amounts of tailings. Currently, these tailings are disposed of in large ponds, in which coarse particles settle out relatively quickly and fine particles remain suspended in water and settle very slowly. After years of settling, the fine particles form a stable suspension in water known as mature fine tailings (MFTs). Long-term storage of the MFT is costly and poses a major environmental liability.Oil sands companies are now actively investigating different approaches to replace or reduce the use of oil sands tailings ponds. Filtration of the tailings to produce “dry tailings” for stacking is now being investigated as an alternative by a number of companies. Fast water drainage is a critical step for the filtration process. In this paper, we use simple laboratory-scale filtration tests to evaluate the filterability of the oil sands tailings and to generate a parameter that can be used in filtration scale-up. It was found that the filterability of the original coarse oil sands tailings was relatively low. However, after the fines are flocculated with the coarse particles to form uniform flocs the filterability was improved by several orders of magnitude. The results demonstrate that filtration of the flocculated coarse tailings to produce the “dry” stackable tailings may be viable.     

城市垃圾预处理改善焚烧特性的探讨

针对目前我国城市垃圾的高水分、低热值的特性,提出了2种改善城市垃圾焚烧特性的有效措施:生物质垃圾源分类和生物干燥.在我国建立生物质垃圾源分类体系,将生物质垃圾源头分类后,剩余垃圾的热值可以提高约50%～120%,已适合直接入炉焚烧,同时分离出来的生物质垃圾也更易于好氧堆肥或厌氧消化.另外一项技术措施是在焚烧前利用生物干燥技术,降低城市垃圾的水分含量,提高入炉垃圾的热值,这种方法主要是利用生物反应热来干燥城市生活垃圾,只需要在垃圾投入焚烧炉前增加一个预处理步骤,不必改变目前的垃圾收运体系,而且进行生物干燥后的垃圾更易于分选其中的可回收物质.