Spatial PM2.5 mobile source impacts using a calibrated indicator method

Motor vehicles are major sources of fine particulate matter (PM_2.5), and the PM_2.5 from mobile vehicles is associated with adverse health effects. Traditional methods for estimating source impacts that employ receptor models are limited by the availability of observational data. To better estimate temporally and spatially resolved mobile source impacts on PM_2.5, we developed an approach based on a method that uses elemental carbon (EC), carbon monoxide (CO), and nitrogen oxide (NO_x) measurements as an indicator of mobile source impacts. We extended the original integrated mobile source indicator (IMSI) method in three aspects. First, we generated spatially resolved indicators using 24-hr average concentrations of EC, CO, and NO_x estimated at 4 km resolution by applying a method developed to fuse chemical transport model (Community Multiscale Air Quality Model [CMAQ]) simulations and observations. Second, we used spatially resolved emissions instead of county-level emissions in the IMSI formulation. Third, we spatially calibrated the unitless indicators to annually-averaged mobile source impacts estimated by the receptor model Chemical Mass Balance (CMB). Daily total mobile source impacts on PM_2.5, as well as separate gasoline and diesel vehicle impacts, were estimated at 12 km resolution from 2002 to 2008 and 4 km resolution from 2008 to 2010 for Georgia. The total mobile and separate vehicle source impacts compared well with daily CMB results, with high temporal correlation (e.g., R ranges from 0.59 to 0.88 for total mobile sources with 4 km resolution at nine locations). The total mobile source impacts had higher correlation and lower error than the separate gasoline and diesel sources when compared with observation-based CMB estimates. Overall, the enhanced approach provides spatially resolved mobile source impacts that are similar to observation-based estimates and can be used to improve assessment of health effects.

Implications: An approach is developed based on an integrated mobile source indicator method to estimate spatiotemporal PM_2.5 mobile source impacts. The approach employs three air pollutant concentration fields that are readily simulated at 4 and 12 km resolutions, and is calibrated using PM_2.5 source apportionment modeling results to generate daily mobile source impacts in the state of Georgia. The estimated source impacts can be used in investigations of traffic pollution and health.     

Effect of bound residues of metsulfuron-methyl in soil on rice growth

A pot experiment was conducted to appraise the hazards of bound residues of metsulfuron-methyl in soil at six levels (0, 0.050, 0.089, 0.158, 0.281, and 0.500 mg kg(-1)) to the growth of four rice varieties (Xiushui 63, Eryou 810, Liangyoupeijiu, and Zhenong 952). The morphological characteristics of rice roots like root number, total length, surface area of rice roots, and rice biomass were determined. The results showed that the bound residues of metsulfuron-methyl in soil impacted the growth of rice. Root number, total length of roots, surface area of roots, and biomass were restrained by bound residues of metsulfuron-methyl in soil. The inhibition rate of root growth increased from 69.46-81.32% to 85.18-95.97% with the increasing of levels of bound residues of metsulfuron-methyl from 0.05 mg kg(-1) to 0.50 mg kg(-1). The number of rice roots could be taken as a sensitive index to screen the rice varieties endurable to bound residues of metsulfuron-methyl in soil and to predict the potential hazards of bound residues of metsulfuron-methyl in soil to rice. The level of bound residues of metsulfuron-methyl in soil causing the root numbers decreased by 50% (IC50) followed the order of Xiushui 63 < Eryou 810 < Liangyoupeijiu < Zhenong 952.     

Treatment of refectory oily wastewater by electro-coagulation process

Electro-coagulation was used to treat refectory wastewater with high oil and grease contents. Different operational conditions were examined, including pH, current density, reaction time, conductivity, electrode distance and inlet concentration. The optimum current density was 10-14 A m(-2) within 30 min depending on the wastewater properties tested. Conductivity had little effect on the treatment efficiency. Although the addition of extra salts (e.g., sodium chloride) to the wastewater did not help increase the pollutant removal efficiency, it could save the power consumption significantly. The COD(Cr) and oil removal efficiency descended with increasing electrode distance. The optimal electrode distance was determined to be 10 mm for this equipment in consideration of the treatment cost and efficiency together. The pH effect on the performance of the electro-coagulation process was not very significant in the range of 3-10. The removal efficiency of oil and COD(Cr) under normal condition exceeded 95% and 75%, respectively.     

钛白副产硫酸亚铁的综合利用研究

以钛白副产硫酸亚铁、氯化钾和氨水为原料，采用硫酸钾铵法制取硫酸钾。实验结果表明，该工艺生产的产品，其质量达到ZBG-21006-89国家标准，且此工艺流程简单、操作方便、条件易控制，无二次污染。     

水和废水中多氯联苯(PCBs)的测定方法及进展

本文引用了七十余篇近几年国内外的有关著文,对水和废水中的多氯联苯(PCBs)的测定方法进行了评述,全面系统地介绍了水样的采集、富集、净化和分析测定等操作程序,着重于样品的前处理和气相色谱分析,并提出了这一领域今后的发展趋势。     

氧化-混凝法处理碱性高砷废水的实验研究

对碱性高砷废水的处理进行了研究 ,针对常规混凝法除砷的缺点提出了氧化 混凝工艺。结果表明 ,用氧化 混凝工艺除砷效果显著 ,废水经处理后砷含量低于 0 5mg/L ,符合国家排放标准。氧化 混凝除砷的最佳工艺条件为 :pH值为 6— 7,H2 O2 用量为 2 5 % ,氧化时间为 10min ,Fe2 (SO4) 3 用量为 2 5g/L ,PAM用量为 11 2 5mg/L。     

Catalytic gasification of coal using eutectic salts: recovery,regeneration, and recycle of spent eutectic catalysts

Catalyst recovery studies were conducted for gasified chars produced from steam gasification of Illinois #6 coal catalyzed with two different catalyst systems. A ternary (43.5 mol% Li2CO3-31.5 mol% Na2COr-25 mol% K2CO3) and a binary (29 mol% Na2CO3-71 mol% K2CO3) eutectic catalyst system were used for gasifying coal. Various extraction schemes, such as water extraction, H2SO4 extraction, and acetic acid extraction, were evaluated with respect to their extraction efficiencies. Effects of major process variables, such as solvent-to-char ratio, mixing time, temperature, and concentration, on the extraction efficiency were evaluated. A process schematic for the entire catalyst recovery, regeneration, and recycle scheme was developed and the preliminary process economics were determined based on these extraction schemes. H2SO4 extraction was found to be the most desirable. It also turned out to be more attractive than a once-through throwaway system.     

移动式絮凝-气浮集成系统研制及其在城市污染河湖治理中的应用

针对北京城市河湖的污染状况,论述了传统絮凝-气浮工艺在污染治理中的应用研究及以该工艺为基础的集成系统的开发.结果表明,该系统对TP、COD去除率分别达81%和75%.该系统的研制成功为城市河湖的污染治理开辟了新途径.     

Plant uptake of aldicarb from contaminated soil and its enhanced degradation in the rhizosphere

Experiments were conducted to investigate the degradation of aldicarb, an oxime carbamate insecticide, in sterile, non-sterile and plant-grown soils, and the capability of different plant species to accumulate the pesticide. The degradation of aldicarb in soil followed first-order kinetics. Half lives (t1/2) of aldicarb in sterile and non-sterile soil were 12.0 and 2.7 days, respectively, which indicated that microorganisms played an important part in the degradation of aldicarb in soil. Aldicarb disappeared more quickly (p< or =0.05) in the soil with the presence of plants, and t1/2 of the pesticide were 1.6, 1.4 and 1.7 days in the soil grown with corn, mung bean and cowpea, respectively. Comparison of plant-promoted degradation and plant uptake showed that the enhanced removal of aldicarb in plant-grown soil was mainly due to plant-promoted degradation in the rhizosphere.     

混凝法处理废乳化液的研究

采用聚合硫酸铁（PFS）和聚合氯化铝（PAC）处理废乳化液，适宜的pH范围为pH≤8，在废乳化液CODcr为7000－35000mg/L时，PFS较佳投加量为0.46-0.56g/L,PAC较佳投加量为1.5-3.5g/L,CODcr去除率均可达94％以上。出水经分析表明，PFS和PAC混凝对废乳化液中的脂类和羧酸盐均有较好的效果，并且B／C由0.12分别提高到0.58和0.55，大大改善废乳化液的可生化性。