Arsenic accumulation and speciation in the submerged macrophyte Ceratophyllum demersum L.

Introduction

Ceratophyllum demersum L. is a widespread submerged macrophyte in aquatic environments.

Methods

Simulation experiments were conducted in the laboratory to investigate arsenic (As) accumulation, speciation, and efflux of C. demersum exposed to arsenate and arsenite solutions.

Results

Plant shoots showed a significant accumulation of As with a maximum of 862 and 963???g?As?g^?1 dry weight after 4?days of exposure to 10???M arsenate and arsenite, respectively. Regardless of whether arsenate or arsenite was supplied to the plants, arsenite was the predominant species in plant shoots. Furthermore, a dramatically higher influx rate of arsenate compared with arsenite was observed in C. demersum exposed to As solutions without the addition of phosphate (P). Arsenate uptake was considerably inhibited by P in this study, suggesting that arsenate is taken up by C. demersum via the phosphate transporters. However, arsenite uptake was unaffected by P and markedly reduced in the presence of glycerol and antimonite (Sb), indicating arsenite shares the aquaporin transport pathway. In addition, C. demersum rapidly reduces arsenate to arsenite in the shoot of the plant and extrudes most of them (>60?%) to the external solutions. The efflux of arsenite was much higher than that of arsenate; the former is supposed to be both active and passive processes, and the latter through passive leakage.

Conclusion

C. demersum is a strong As accumulator and an interesting model plant to study As uptake and metabolism due to the lack of a root-to-shoot translocation barrier.     

Enhanced mercuric chloride adsorption onto sulfur-modified activated carbons derived from waste tires

A number of activated carbons derived from waste tires were further impregnated by gaseous elemental sulfur at temperatures of 400 and 650 degrees C, with a carbon and sulfur mass ratio of 1:3. The capabilities of sulfur diffusing into the micropores of the activated carbons were significantly different between 400 and 650 degrees C, resulting in obvious dissimilarities in the sulfur content of the activated carbons. The sulfur-impregnated activated carbons were examined for the adsorptive capacity of gas-phase mercuric chloride (HgC1) by thermogravimetric analysis (TGA). The analytical precision of TGA was up to 10(-6) g at the inlet HgCl2 concentrations of 100, 300, and 500 microg/m3, for an adsorption time of 3 hr and an adsorption temperature of 150 degrees C, simulating the flue gas emitted from municipal solid waste (MSW) incinerators. Experimental results showed that sulfur modification can slightly reduce the specific surface area of activated carbons. High-surface-area activated carbons after sulfur modification had abundant mesopores and micropores, whereas low-surface-area activated carbons had abundant macropores and mesopores. Sulfur molecules were evenly distributed on the surface of the inner pores after sulfur modification, and the sulfur content of the activated carbons increased from 2-2.5% to 5-11%. After sulfur modification, the adsorptive capacity of HgCl2 for high-surface-area sulfurized activated carbons reached 1.557 mg/g (22 times higher than the virgin activated carbons). The injection of activated carbons was followed by fabric filtration, which is commonly used to remove HgCl2 from MSW incinerators. The residence time of activated carbons collected in the fabric filter is commonly about 1 hr, but the time required to achieve equilibrium is less than 10 min. Consequently, it is worthwhile to compare the adsorption rates of HgCl2 in the time intervals of < 10 and 10-60 min.     

菱镁矿尾矿制备高活性MgO的性能表征

菱镁矿尾矿经预处理后,在一定条件下制备高活性MgO。使用热重-差热分析仪,分析菱镁矿尾矿的分解温度,应用X射线衍射、SEM分析不同煅烧温度、保温时间对MgO晶体结构的影响,并根据Scherrer公式计算MgO晶粒的尺寸。通过电导率仪测定MgO水化电导率,分析不同条件下的MgO活性,探讨煅烧温度、保温时间、颗粒细度与MgO活性之间的关系。结果发现:煅烧温度在1 050℃,保温时间60 min时,菱镁尾矿完全分解,MgO活性最佳;煅烧温度越高,保温时间越长,MgO的活性越差;MgO颗粒细度越小,活性越高。     

玉米深加工废水的混凝实验

在室温条件下,分别选用聚合氯化铝(PAC)、聚合氯化铝铁(PAFC)及三氯化铁(FeCl3)对玉米深加工废水进行混凝实验。综合考虑各种混凝剂对磷、COD以及SS的去除效果,最终选取PAC作为混凝剂。采用PAC和聚丙烯酰胺(PAM)作为复合混凝剂,对其去除效果做进一步研究,并确定了最佳投加量及pH值。实验结果表明,在PAC投加量25mg/L,PAM投加量0.5 mg/L,pH为8条件下,混凝效果最佳。磷、COD、SS去除率可分别达到90.1%、53.3%和88.2%,对应的出水质量浓度分别为0.41、26.8和2 mg/L。     

垃圾焚烧炉炉膛温度的影响因素

垃圾焚烧过程的不稳定会导致大量有害物质的生成,为确保垃圾的清洁燃烧需要将炉膛温度控制在850℃以上,为此测试了焚烧炉运行的主要可控参数对炉膛温度的影响。结果表明,垃圾堆放位置在垃圾池深3～8 m处,并经过6 d以上发酵脱水后适合焚烧;炉膛温度随给料量、一次风率和一次风温增加而增大,随过量空气系数增加而降低,其中给料量宜控制在95%～110%之间;当过量空气系数为1.6、一次风率为90%、一次风温为260℃、给料量为100%时炉膛温度达901℃。     

纳米生态基对水产养殖污水的处理效果

采用三因子四水平的正交设计,实验研究了纳米生态基在不同温度、溶解氧和水力停留时间下对水产养殖污水的处理效果,确定了纳米生态基处理养殖污水的最佳条件。结果表明,含氨氮和亚硝氮浓度较高的模拟养殖污水用纳米生态基挂膜,所需时间约为22 d。纳米生态基对氨氮的去除效果明显,平均去除率达到93.5%。对氨氮去除率的影响程度,水力停留时间>温度>溶解氧。当温度为30℃,DO为5.43 mg/L,HRT为0.33 h时,纳米生态基对氨氮的处理能力最佳,去除率达到94.6%。纳米生态基对亚硝氮的平均去除率为69.3%。对亚硝氮去除率的影响程度,水力停留时间>溶解氧>温度。当温度为21℃,DO为6.40 mg/L,HRT为0.33 h时,纳米生态基对亚硝氮的处理能力最佳,去除率为71.5%。纳米生态基处理养殖污水的最佳条件:温度为30℃,DO为6.40 mg/L,HRT为0.33 h。     

简单芽孢杆菌产高效微生物絮凝剂

通过从绿化植物根际土壤和污水处理厂的活性污泥中分离筛选絮凝剂产生菌,得到一株稳定高效的微生物絮凝剂产生菌PS1,根据形态学特征、生理生化实验以及16S rDNA序列分析将其鉴定为简单芽孢杆菌(Bacillus simplex)。对菌株PS1产生絮凝剂的最佳培养时间、絮凝活性分布以及pH、CaCl2、絮凝剂投量对絮凝效果的影响进行了研究,并考察了其对实际废水的絮凝效果。结果表明,菌株PS1产絮凝剂的最佳培养时间为36 h,产生的絮凝活性物质全部存在于发酵液离心后的上清液中;当pH为7.0～8.5、CaC12投量为0.25～0.35 g/L、发酵液投加量的体积分数为1.5%～2.5%时,菌株PS1发酵液对4 g/L的高岭土悬浊液的絮凝效果最佳,絮凝率达到97%。菌株PS1所产絮凝剂对城市污水、啤酒废水、淀粉废水、医院废水的絮凝率可达90%以上。     

高铁酸钾预处理对活性污泥脱水性能的影响

通过投入不同剂量的高铁酸钾于剩余活性污泥中,研究其对污泥絮体性质和脱水性能的影响作用。污泥絮体性质的研究包括絮体粒径的变化以及污泥EPS含量的变化。脱水性能的研究包括过滤脱水性能(以CST表征)以及脱水程度(离心泥饼含固率)。实验结果表明,高铁酸钾的强氧化性可以破坏污泥絮体结构,提高污泥的机械脱水程度;但同时污泥EPS含量增加,对污泥过滤脱水性能有负面影响。高铁酸钾氧化分解生成的Fe(OH)3具有絮凝能力,可以使污泥颗粒重新絮凝;而其混凝作用可以破坏污泥细胞的稳定性,提高污泥的沉降性能。     

三元乙丙橡胶超细纤维复合膜的制备及其截留性能

以四氢呋喃和N,N-二甲基甲酰胺为溶剂,配制三元乙丙橡胶(EPDM)纺丝液,通过静电纺丝技术制备了EPDM超细纤维,进而以聚偏氟乙烯(PVDF)微滤膜为基膜制备了EPDM超细纤维复合膜。采用红外光谱(FTIR)和扫描电子显微镜(SEM)对EPDM超细纤维的结构和形态进行了表征。考察了复合膜对苯乙烯废水的截留效果和复合膜通量的变化情况。实验结果表明:EPDM超细纤维具有类似无纺布形式的多孔纤维网状结构,其直径在0.2~2.0μm之间;复合膜在操作压力为0.1MPa的条件下,处理质量浓度为100μg/mL的模拟苯乙烯废水,膜通量约为5.90mL/(cm2.h),苯乙烯去除率可达89.7%。     

用含固定化微生物的曝气生物滤池处理炼油厂高浓度废水

采用含固定化微生物的曝气生物滤池(G-BAF)处理炼油厂高浓度废水。当G-BAF池进水COD为298～11 278 mg/L时,出水COD为33.0～94.3 mg/L,COD平均去除率为97%;当G-BAF池进水ρ(NH_3-N)为12.1～188.0 mg/L时,出水ρ(NH_3-N)为0.9～49.4 mg/L,NH_3-N平均去除率为83%。经G-BAF处理后出水水质完全达到GB8978—1996《污水综合排放标准》第二类污染物的二级排放标准。