5.12汶川地震后理县甘堡乡磨子沟泥石流特征分析

磨子沟泥石流位于四川省理县甘堡乡,历史上泥石流活动明显,沟口317国道和村庄都曾遭受其破坏。5.12汶川地震后,沟内出现大量松散固体物质,为泥石流的暴发提供了充足的物源。本文通过野外实地调查,对泥石流的形成条件和动力学特征进行分析。     

国内外城市可持续发展指标体系比较

文章以英国2009年发表的可持续发展指标体系和美国可持续社区指标指南为例,比较了国内外城市可持续发展评估指标体系,列举了各指标体系的大类和分项,从指标体系的选择和评价方法的确定等方面综述了国内可持续发展指标体系,以期为制定和完善中国的城市可持续发展指标体系提供参考。     

基于仿真的新建污水处理厂工艺参数调试

基于ASM2D模型建立了上海某新建污水厂倒置AAO流程的数学模型,并采用该厂进、出水设计数据对模型进行校正,其中,ASM2D各组分浓度分布参考文献值.同时,通过仿真计算研究了不同温度下进水流量、污泥回流比、混合液回流比及进水流量分配比对出水总化学需氧量（TCOD）、氨氮（SNH3）、总氮（TN）、总磷（TP）及总悬浮颗粒物（TSS）的影响.结果表明,研究获得的定性和定量两方面结果可供该厂在工艺参数调试中作参考.计算机仿真技术在新建污水厂工艺参数调试中的应用可以减少调试时间,降低调试费用,取得良好的经济效益与环境效益.     

陶瓷材料放射性衰变时间及最佳平衡周期研究

简述了有关放射性样品衰变平衡及平衡时间的基本理论,运用碘化钠γ谱仪对衰变时间介于0～27 d区间内的三组陶瓷样品进行放射性比活度测定,采取t检验法分析了同一样品在0d～7d、7d～12d、15 d、21 d等不同衰变时间条件下,放射性核素226Ra、232Th、40K比活度测试结果之间的差异程度,通过实验验证陶瓷样品衰变时间对其放射性测定结果准确性的影响.研究表明,当每组检测结果数据的显著性差异水平为5％,若兼顾科学性和经济性,则陶瓷样品的最佳放射性衰变时间应为至少21 d.     

生物接触氧化+植物一体化装置处理小城镇污水试验研究

利用“生物接触氧化+植物”一体化装置处理城镇污水,试验最终选用悬浮多面球作填料,采用射流曝气,控制进水流量为0.45 m3/h,进水浓度为COD 63～467 mg/L、NH3-N 11.21～52.7 mg/L、TN 28.6 ～63.5mg/L和TP １.1～6.42 mg/L时,COD、NH3-N、TN和TP的去除率分别达到88％、86％、70％、60％以上,出水COD≤30 mg/L,NH3-N≤5 mg/L、TN≤13 mg/L、TP≤0.5 mg/L.水质优于《城镇污水处理厂污染物排放标准》(GB 18918-2002)一级A标准,具有较好的工程应用前景.     

Kinetic study of phytotoxicity induced by foliar lead uptake for vegetables exposed to fine particles and implications for sustainable urban agriculture

At the global scale, foliar metal transfer occurs for consumed vegetables cultivated in numerous urban or industrial areas with a polluted atmosphere. However, the kinetics of metal uptake, translocation and involved phytotoxicity was never jointly studied with vegetables exposed to micronic and sub-micronic particles (PM). Different leafy vegetables (lettuces and cabbages) cultivated in RHIZOtest® devices were, therefore, exposed in a greenhouse for 5, 10 and 15 days to various PbO PM doses. The kinetics of transfer and phytotoxicity was assessed in relation to lead concentration and exposure duration. A significant Pb accumulation in leaves (up to 7392 mg/kg dry weight (DW) in lettuce) with translocation to roots was observed. Lead foliar exposure resulted in significant phytotoxicity, lipid composition change, a decrease of plant shoot growth (up to 68.2% in lettuce) and net photosynthesis (up to 58% in lettuce). The phytotoxicity results indicated plant adaptation to Pb and a higher sensitivity of lettuce in comparison with cabbage. Air quality needs, therefore, to be considered for the health and quality of vegetables grown in polluted areas, such as certain megacities (in China, Pakistan, Europe, etc.) and furthermore, to assess the health risks associated with their consumption.     

Feedforward control for nitrogen removal in a pilot-scale anaerobic-anoxic-oxic plant for municipal wastewater treatment

To improve the efficiency of nitrogen removal with lower energy consumption, the study of feedforward control was carried out on a pilot-scale anaerobic-anoxicoxic (AAO) plant for the treatment of municipal wastewater. The effluent qualities of the pilot plant under different control strategies were investigated. The results indicated that the change of external recycle was not a suitable approach to regulate the sludge concentration of plug-flow reactors; adjusting the aeration valve and dissolved oxygen set-point according to ammonia load could overcome the impact of influent fluctuation; and the denitrification potential could be estimated based on the transit time of anoxic zone and the relative content of carbon resource entering the anoxic zone. Simple feedforward control strategies for aeration and internal recycle were subsequently proposed and validated. The nitrogen removal was successfully improved in the pilot plant. The effluent total nitrogen had decreased by 29.9% and was steadily controlled below 15 mg·L⁻¹. Furthermore, approximately 38% of the energy for aeration had been saved.     

巴氏醋酸杆菌发酵处理甲醇废水合成细菌纤维素的研究

介绍了巴氏醋酸杆菌以甲醇为唯一碳源、以酵母膏或蛋白胨为氮源合成细菌纤维素,同时净化甲醇废水的方法,并对合成细菌纤维素的培养条件进行了研究。试验得出巴氏醋酸杆菌的适宜发酵条件为：发酵培养基中甲醇质量分数为3．5％左右,发酵培养基初始pH为5．0～6．0。接种量为5％,发酵培养温度为30℃,振荡器转速为100r／min。     

A pyrazine based metal-organic framework for selective removal of copper from strongly acidic solutions

● pz-UiO-66 was synthesized facilely by a solvothermal method. ● Efficient capture of copper from highly acidic solution was achieved by pz-UiO-66. ● pz-UiO-66 exhibited excellent selectivity and capacity for copper capture. ● Pyrazine-N in pz-UiO-66 was shown to be the dominant adsorption site. The selective capture of copper from strongly acidic solutions is of vital importance from the perspective of sustainable development and environmental protection. Metal organic frameworks (MOFs) have attracted the interest of many scholars for adsorption due to their fascinating physicochemical characteristics, including adjustable structure, strong stability and porosity. Herein, pz-UiO-66 containing a pyrazine structure is successfully synthesized for the efficient separation of copper from strongly acidic conditions. Selective copper removal at low pH values is accomplished by using this material that is not available in previously reported metal–organic frameworks. Furthermore, the material exhibits excellent adsorption capacity, with a theoretical maximum copper uptake of 247 mg/g. As proven by XPS and FT-IR analysis, the coordination of pyrazine nitrogen atoms with copper ions is the dominant adsorption mechanism of copper by pz-UiO-66. This work provides an opportunity for efficient and selective copper removal under strongly acidic conditions, and promises extensive application prospects for the removal of copper in the treatment for acid metallurgical wastewater.     

HSE管理体系运行常见问题分析及对策

1HSE管理体系运行的常见问题国内石油企业推行HSE管理体系已经十余年,在从上到下各级领导的高度重视下,由最初的少数企业行为,发展到现今的全面推进实施,普遍应用这一系统方法管理企业职业健康、安全和环境工作,