IC反应器处理MTO废水的中试研究

中试研究了内循环(IC)反应器处理甲醇制烯烃(MTO)废水的启动和运行过程,同时考察了颗粒污泥的性状及沼气产量的变化情况。试验过程运行稳定,系统抗冲击性强。以絮状污泥为接种污泥,经过131 d的启动和运行,IC反应器的COD去除负荷可达10 kg/(m~3·d)以上,COD去除率可达90%以上。IC反应器中的成熟颗粒污泥形状规则、密实、粒径大、沉降速率快。IC反应器的沼气产量符合理论预期。     

不同类型填料的三维电极/Fenton试剂法处理苯酚废水

采用不同类型填料对三维电极/Fenton试剂法处理苯酚模拟废水进行研究.结果表明.不同类型活性炭填料对苯酚去除率有很大影响,粒炭不适合做粒子电极,采用5.0 mm柱炭处理效果较好;采用石英砂与活性炭混合填料的处理效果比单一活性炭填料好,但苯酚去除率提高不明显;电解槽反应器中按比例投加涂膜活性炭和活性炭混合填料能明显提高苯酚去除率;当涂膜活性炭与活性炭体积比为1,2时,苯酚去除率最高,达96.8%.     

Studies of potential sources that contributed to atmospheric mercury in Toronto,Canada

This study identified sources of mercury (Hg) in downtown Toronto, Canada by analyzing gaseous elemental mercury (GEM), mercury associated with particles with sizes less than 2.5 microns (PHg < 2.5), and gaseous oxidized inorganic mercury (GOIM), commonly referred to as reactive gaseous mercury (RGM), and air pollutants (CO, NO_x, O₃, PM_2.5, SO₂) concentrations between Dec 2003 and Nov 2004. The data were analyzed using Positive Matrix Factorization (PMF) model, Principal Components Analysis (PCA), ratio analysis, back trajectories, and correlation analyses. The analyses suggest industrial sources (chemical production, metal production, sewage treatment), rather than coal combustion, were the major contributors to measured Hg levels. Overlap in source profiles for the Hg sources listed in the Canadian National Pollutant Release Inventory (NPRI) and lack of source profiles for urban sources were the major limitations to positively identifying sources from the PMF and PCA factors. Correlation analyses revealed direct emissions were the sources of GOIM in spring, summer, and fall, and the occurrence of GEM oxidation by ozone in the summer. Elevated Hg events are attributed to emissions from urban sources near the sampling site, regional point sources, and photochemical processes involving ozone.     

固定化啤酒废酵母对Cr(VI)的吸附

用2%海藻酸钠与1%明胶混合作为包埋剂固定啤酒废酵母,研究固定化啤酒废酵母对Cr(Ⅳ)的吸附特性.结果表明,固定化啤酒废酵母吸附Cr(Ⅵ)受吸附时间、起始pH、固定化菌体浓度、cr(Ⅵ)起始浓度及共存离子等因素的影响.确定固定化啤酒废酵母对Cr(Ⅵ)最佳吸附条件为:pH 2,Cr(Ⅵ)起始浓度100 mg/L,固定化菌体浓度2 g/L,吸附90 min.此条件下Cr(Ⅵ)的吸附率可达96.8%.Pd2+等并存离子可抑制固定化啤酒废酵母对Cr(Ⅵ)的吸附.用1 mol/L盐酸洗脱固定化啤酒废酵母所吸附的Cr(Ⅵ)3 h,解吸率为93.6%.     

壳聚糖复合絮凝剂处理造纸废水的实验研究

研究并考察了壳聚糖复合絮凝剂对造纸污水中COD和SS的絮凝效果,结果表明,当复合絮凝剂的配方和处理条件为：聚合硫酸铁（PFS）60 mg/L聚丙烯酰胺（PAM）2 mg/L壳聚糖（CTS）0.4 mg/L,pH为7.5时,其絮凝效果最佳,此时它对水中COD与SS的去除率分别达到57.4%和97.6%, 与传统絮凝剂PAC/PAM相比,COD与SS的去除率分别提高了10.1%和5.2%,药剂成本下降了21.1%,具有明显的经济效益与环境效益。     

改性纤维球在油田污水处理中的应用

纤维球过滤可充分发挥出滤料深层的截污能力。介绍了改性纤维球滤料的技术要求,在使用过程中主要存在的几个问题,改性纤维球过滤器的结构及特点,在油田污水处理中的现场应用情况。试验证明,经50%互溶剂+2%表面活性剂+2%烧碱清洗后,改性纤维球滤料颜色变为灰白,纤维之间松散,不存在粘结现象,清洗较为彻底。     

Spatial character of polychlorinated biphenyls from soil and respirable particulate matter in Taiyuan, China

As one of China’s great metropolises, Taiyuan is affected by heavy chemical industry and manufacture of chemical products, and faces pollution from polychlorinated biphenyls (PCBs). Therefore, this study was conducted to determine the PCB concentrations in various environmental media in Taiyuan. We collected 15 soil samples, 34 respirable particulate matter (PM) samples (17 of PM_2.5 and 17 of PM₁₀) from urban areas of Taiyuan, and measured a total of 144 PCB congeners (including some coeluting PCB congeners). The total PCB concentrations were 51–4.7 × 10³ pg g⁻¹ in soil, 27–1.4 × 10² pg m⁻³ in PM_2.5 and 16–1.9 × 10² pg m⁻³ in PM₁₀. Of the PCB homologues, the dominant PCBs detected in the various media were all tri-CBs. Soil was relatively the most polluted media. Furthermore, principal-component analysis revealed that the major PCB source in Taiyuan may be associated with the main commercial PCB through long-range transmission. Toxic equivalency (TEQ) concentrations (based on ten dioxin-like PCBs) ranged from N.D. to 5.9 × 10⁻³ pg-WHO TEQ g⁻¹ in soil, 2.0 × 10⁻⁴–3.4 × 10⁻³ pg-WHO TEQ m⁻³ and 1.0 × 10⁻⁴–1.2 × 10⁻³ pg-WHO TEQ m⁻³ in PM_2.5 and PM₁₀, respectively. In previous studies, PCBs were not a severe component of contaminant in Taiyuan; however, this study suggested there is a potential threat of human exposure to PCBs for residents of Taiyuan.     

工业企业厂界环境噪声监测中背景噪声监测及修正探讨

针对测量结果修正的相关要求,本文对新颁布的《工业企业厂界环境噪声排放标准》（GB12348-2008）和旧标准《工业企业厂界噪声测量方法》（GB／T12349-1990）在实际工作中的运用进行了比对、分析和探讨,并根据实际工作经验,提出了在背景噪声难以测量的一些特殊情况下的几种解决途径,主要提出噪声源声值与背景声值相差小于3dB（A）时的解决方案。     

微波无极紫外光催化-内电解协同降解活性艳红X-3B

采用微波无极紫外光源,以活性炭作为光催化剂TiO2的载体,与外加铁屑构成内电解反应,处理活性艳红X-3B模拟废水.实验结果表明,微波无极紫外光催化-内电解法对活性艳红X-3B的降解速率是微波无极紫外光催化和微波-内电解法单独作用时降解速率之和的2倍.在活性艳红X-3B模拟废水初始pH为7、空气曝气量为0.50 L/min、铁屑加入量为5 g/L、反应温度为40～45℃的最佳条件下,微波无极紫外光催化-内电解法的活性艳红X-3B模拟废水色度去除率达100%,TOC和可吸附有机卤化物的去除率分别为69.5%和81.8%.     

混凝法深度处理印染废水中试研究

采用"高效混凝沉淀-过滤"深度处理工艺处理印染废水二级生化出水,并将混凝沉淀污泥回流.实验结果表明,混凝剂聚合氯化铝加入量为160 mg/L时,COD去除率平均可达34.6%,TP去除率平均达到87.9%,平均出水TP为0.3 mg/L.气相色谱-质谱分析和元素分析结果表明混凝沉淀工艺对有机物和TP的去除效果良好.