Degradation of Carbofuran in Water by Solar Photocatalysis in Presence of Photosensitizers

The effect of the presence of photosensitizers, methylene blue (MB) and rose Bengal (RB), on the degradation of carbofuran (2,3-dihydro-2,2-dimethylbenzofuran-7-yl methylcarbamate) in water in a solar photocatalytic system was investigated. It was found that as compared to MB, RB generally showed a stronger effect on the decomposition of carbofuran under comparable conditions. Among the conditions studied, adding 2 × 10^?6 M of RB, that corresponding to 2% of the initial concentration of carbofuran solution in the system, rendered the most effective degradation of carbofuran. As a result, a carbofuran removal percentage of 69.9%, a mineralization efficiency of 28.0%, and a microtoxicity reduction of 65.0% could be achieved. The degradation and mineralization of carbofuran was found to follow the pseudo-first order reaction kinetics. The decomposition mechanism of carbofuran was further investigated through identification of the intermediates to elaborate the influence of dye photosensitizer on the solar photocatalysis of carbofuran in water. On the basis of the intermediates identified, including carbofuran phenol, 3-hydroxy carbofuran phenol, and substituted alcohols (3-phenoxy 1-propanol, 2-ethyl 1-hexanol, 2-butoxyl ethanol), it appears that hydrolysis and hydroxylation were the two key mechanisms for decomposing carbofuran during the process of solar photocatalysis with the aid of dye photosensitizer.     

Advanced oxidation treatment of physico-chemically pre-treated olive mill industry effluent

In this study, the applicability of physico-chemical methods was investigated for the pre-treatment of the olive mill effluents prior to the discharge into the common sewerage ending with a municipal wastewater treatment plant. The samples were taken from an olive oil industry operated as three-phase process located in Turkey. Various pre-treatment methods including acid craking, polyelectrolyte and lime additions were applied. Advanced oxidation study using Fenton's process was also investigated following pre-treatment by acid cracking and cationic polyelectrolyte. Acid cracking alone gave satisfactory treatment efficiencies and polyelectrolite additions to the acid-cracked samples enhanced treatment efficiency. Since a complete treatment plant is available at the end of the sewer system, results indicated that the effluents of the investigated industry could be discharged into the municipal sewerage in the case of total chemical oxygen demand (COD_tot), suspended solid (SS) and volatile suspended solid (VSS) concentrations according to the Turkish Water Pollution Control Regulation after pre-treatment with 5 ppm anionic polyelectrolyte following acid cracking. The minimum COD_tot, SS and VSS removals were observed when raw wastewater was pre-treated with lime and the discharge standards to the municipal sewer system could not be met. Advanced oxidation with Fenton's process was applied after acid cracking and cationic polyelectrolyte treatment in order to investigate further reduction in chemical oxygen demand (COD) concentration for minimizing the influence of this industrial discharge on the existing municipal wastewater treatment plant. Results indicated that COD_tot removal increased up to 89% from 74% after Fenton's oxidation for the acid cracked samples in which cationic polyelectrolite (10 ppm) was added.     

Leachability and leaching patterns from aluminium-based water treatment residual used as media in laboratory-scale engineered wetlands

Concept and purpose  

Virtually all water treatment facilities worldwide generate an enormous amount of water treatment residual (WTR) solids for which environmentally friendly end-use options are continually being sought as opposed to their landfilling. Aluminium-based WTR (Al-WTR) can offer huge benefits particularly for phosphorus (P) removal and biofilm attachment when used as media in engineered wetlands. However, potential environmental risks that may arise from the leaching out of its constituents must be properly evaluated before such reuse can be assured. This paper presents results of an assessment carried out to monitor and examine the leachability and leaching patterns of the constituents of an Al-WTR used as media in laboratory-scale engineered wetland systems.     

Agricultural ammonia emissions inventory and spatial distribution in the North China Plain

An agricultural ammonia (NH₃) emission inventory in the North China Plain (NCP) on a prefecture level for the year 2004, and a 5 × 5 km² resolution spatial distribution map, has been calculated for the first time. The census database from China's statistics datasets, and emission factors re-calculated by the RAINS model supported total emissions of 3071 kt NH₃-N yr⁻¹ for the NCP, accounting for 27% of the total emissions in China. NH₃ emission from mineral fertilizer application contributed 1620 kt NH₃-N yr⁻¹, 54% of the total emission, while livestock emissions accounted for the remaining 46% of the total emissions, including 7%, 27%, 7% and 5% from cattle, pigs, sheep and goats, and poultry, respectively. A high-resolution spatial NH₃ emissions map was developed based on 1 × 1 km land use database and aggregated to a 5 × 5 km grid resolution. The highest emission density value was 198 kg N ha⁻¹ yr⁻¹.     

Occurrence, bioaccumulation and potential sources of polybrominated diphenyl ethers in typical freshwater cultured fish ponds of South China

To determine the potential input sources of polybrominated diphenyl ethers (PBDEs) to fish farming environments in South China, samples of seven various environmental matrices were collected from October 2006-September 2007. Tri- to deca-BDEs were detected in all samples analyzed, with mean concentrations (±standard deviations) at 5.7 ± 3.6 ng/L in pond water, 15 ± 11 ng/g dry wt. in pond sediment, 12 ± 3.8 ng/g dry wt. in bank soil, 21 ± 20 ng/g lipid wt. in fish, and 93 ± 62 ng/g lipid wt. in fish feeds. In addition, BDE-209 was the major constituent in all samples except fish and BDE-47 was predominant in fish samples. Relatively high abundances of BDE-49 were detected in all the samples compared to those in the penta-BDE technical products. Several bioaccumulation factors were evaluated. Finally, statistical analyses suggested that fish feed, as well as pond water at a lesser degree, may have been the major source of PBDEs in freshwater farmed fish.     

The effect of soil organic matter on fate of polycyclic aromatic hydrocarbons in soil: A microcosm study

A microcosm study was conducted to address the influences of air-soil partition and sequestration on the fate of polycyclic aromatic hydrocarbons (PAHs) in soil. Sterilized and unsterilized soils with soil organic carbon (SOC) content ranging from 0.23 to 7.06% were incubated in a chamber with six PAHs supplied through air. After 100 d of incubation when the system approached pseudo-steady state, the PAHs concentrations in the unsterilized soils still correlated with SOC significantly, while the association did not exist for those sterilized. The lower degradation rate in the soil with higher SOC was likely the major reason for the association between SOC and PAHs concentrations, while the decreased surface porosity likely suppressed such correlation for the sterilized samples. The results indicated that the sequestration was likely the major mechanism for the accumulation of PAHs in soils, while both of the soil porosity and PAHs properties had observed influences.     

Advances of air pollution science: From forest decline to multiple-stress effects on forest ecosystem services

Over the past 20 years, the focus of forest science on air pollution has moved from forest decline to a holistic framework of forest health, and from the effects on forest production to the ecosystem services provided by forest ecosystems. Hence, future research should focus on the interacting factorial impacts and resulting antagonistic and synergistic responses of forest trees and ecosystems. The synergistic effects of air pollution and climatic changes, in particular elevated ozone, altered nitrogen, carbon and water availability, must be key issues for research. Present evidence suggests air pollution will become increasingly harmful to forests under climate change, which requires integration amongst various stressors (abiotic and biotic factors, including competition, parasites and fire), effects on forest services (production, biodiversity protection, soil protection, sustained water balance, socio-economical relevance) and assessment approaches (research, monitoring, modeling) to be fostered.     

Experimental field estimation of organic nitrogen formation in tree canopies

The content of organic N has been shown in many studies to increase during the passage of rain water through forest canopies. The source of this organic N is unknown, but generally assumed to come from canopy processing of wet or dry-deposited inorganic N. There have been very few experimental studies in the field to address the canopy formation or loss of organic N. We report two studies: a Scots pine canopy exposed to ammonia gas, and a Sitka spruce canopy exposed to ammonium and nitrate as wet deposition. In both cases, organic N deposition in throughfall was increased, but only represented a small fraction (<10%) of the additional inorganic N supplied, suggesting a limited capacity for net organic N production, similar in both conifer canopies under Scottish summertime conditions, of less than 1.6 mmol N m⁻² mth⁻¹ (equivalent to 3 kg N ha⁻¹ y⁻¹).     

Broadband UV spectroscopy system used for monitoring of SO2 and NO emissions from thermal power plants

A gas monitoring system based on broadband absorption spectroscopic techniques in the ultraviolet region is described and tested. The system was employed in real-time continuous concentration measurements of sulfur dioxide (SO₂) and nitric oxide (NO) from a 220-ton h^?1 circulating fluidized bed (CFB) boiler in Shandong province, China. The emission coefficients (per kg of coal and per kWh of electricity) and the total emission of the two pollutant gases were evaluated. The measurement results showed that the emission concentrations of SO₂ and NO from the CFB boiler fluctuated in the range of 750–1300 mg m^?3 and 100–220 mg m^?3, respectively. Compared with the specified emission standards of air pollutants from thermal power plants in China, the values were generally higher for SO₂ and lower for NO. The relatively high emission concentrations of SO₂ were found to mainly depend on the sulfur content of the fuel and the poor desulfurization efficiency. This study indicates that the broadband UV spectroscopy system is suitable for industrial emission monitoring and pollution control.     

Development of a variable configuration cascade impactor for aerosol size distribution measurement

In atmospheric aerosol studies, it is often required to use two different impactors, namely, the normal pressure and the low-pressure impactor, to measure the mass-size distribution over a wide size range. From the perspective of rendering the system compact for such measurements, it may be more advantageous to combine the two features in a single instrument. In an effort towards exploring this option, a variable configuration cascade impactor (VCCI) comprising of 7 normal pressure and 4 low-pressure stages has been designed and developed. In configuration-1, it operates as a low-pressure impactor, with a sampling flow rate of 10 L min^?1 and classifies the particles from 0.1 to 21 μm in eleven size classes. In configuration-2, it operates as a normal pressure impactor, with a sampling flow rate of 45 L min^?1, and classifies the particles from 0.53 to 10 μm in seven size classes. As part of performance evaluation of the system, the deposit patterns and the integral performance have been studied. For integral performance, a comparative mass-size distribution measurement between VCCI and standard Andersen impactor was carried out. Its performance was also evaluated against the GRIMM Scanning Mobility Particle Sizer (SMPS) in the common size range of both these instruments and against GRIMM Optical Particle Counter (OPC). In addition to this, VCCI was evaluated for its performance in the PM_x configuration obtained by removing a few of the impactor stages sequentially and measuring corresponding size distribution for every stage removed. Changes in the distribution parameters due to spillover of the deposits of previous stage to remaining stages were within 10%. This variation is well within the generally accepted value for all environmental measurement related applications.