新型氨化菌丝体吸附剂的制备及吸附典型内分泌干扰物的研究

以产黄青霉(Penicillium chrysogenum)菌丝体为原料,通过2步化学反应将含有大量氨基的聚乙烯亚胺(PEI)嫁接到菌丝体表面,优化反应条件,得到最佳的氨化菌丝体吸附剂.该氨化吸附剂的等电点为pH 10.2,是一种表面带正电荷的菌丝体吸附剂,能有效吸附水中的阴离子内分泌干扰物五氯酚钠(PCP)、2,4二氯苯氧乙酸(2,4-D)和全氟辛烷磺酸钾(PFOS).3种污染物的吸附等温线符合Langmuir方程,15℃时最大吸附量分别为342.9、234.1、1725.6 mg/g.热力学计算表明,3种污染物的吸附均是自发发生的,2,4-D和PFOS的吸附是吸热反应,而PCP是放热反应.     

广东省从化温泉热矿水水化学与同位素特征

从化温泉位于广东省从化市东北,地处广从断裂带北东段,泉点沿NW及NE向次级断裂出露,热水出露于燕山期花岗岩中。温泉为中低温、偏碱性的低矿化水。热水中的阳离子以K⁺、Na⁺、Ca²⁺为主,阴离子以HCO^-₃为主,属于HCO₃-Na及HCO₃-Na·Ca水。热水中偏硅酸、氟含量较高,同时含有锂、锶、钡、硼酸等微量组分及放射性组分镭、氡。由D和¹⁸O组分表明热水起源于大气降水。根据玉髓温标计算的热储温度为82.14~93.52℃。由镭-氡法测定热水年龄,可知热水在地下滞留时间较短,循环较快,如开采量不大且采用采停交替的方式,有助于热水的可持续利用。     

袋式除尘器节能降耗途径的探讨

阐述袋式除尘器的阻力组成,从除尘器结构,过滤速度及清灰制度三个方面分析了降低阻力的途径。     

Heavy metal pollution in intertidal sediments from Quanzhou Bay, China

The concentrations of eight heavy metals （Cu, Zn, Pb, Cd, Cr, Ni, Hg, and As） in the intertidal surface sediments from Quanzhou Bay were determined to evaluate their levels and spatial distribution due to urbanization and economic development of Quanzhou region, southeast China. The ranges of the measured concentrations in the sediments are as follows： 24.8-119.7 mg/kg for Cu, 105.5-241.9 mg/kg for Zn, 34.3-100. 9 mg/kg for Pb, 0.28-0. 89 mg/kg for Cd, 51.1-121.7 mg/kg for Cr, 16.1-45.7 mg/kg for Ni, 0.17-0.74 mg/kg for Hg, and 17.7-30.2 mg/kg for As. The overall average concentrations of above metals exceed the primary standard criteria but meet the secondary standard criteria of the Chinese National Standard of Marine Sediment Quality. Several contents of Cu and Hg exceed the secondary standard criteria at some stations. The results of geoaccumulation index （Igeo） show that Cd causes strong pollution in most of the study area. There are no significant correlations among most of these heavy metals, indicating they have different anthropogenic and natural sources. Some locations present severe pollution by heavy metals depending on the sources, of which sewage outlets, aquatic breeding, and commercial ports are the main sources of contaminants to the area.     

Adsorption of mercury on laterite from Guizhou Province, China

The adsorption behaviors of Hg(Ⅱ) on laterite from Guizhou Province,China,were studied and the adsorption mechanism was discussed.The results showed that different mineral compositons in the laterite will cause differences in the adsorption capacity of laterite to Hg(Ⅱ).Illite and non-crystalloids are the main contributors to enhancing the adsorption capacity of laterite to Hg(Ⅱ).The pH of the solution is an important factor affecting the adsorption of Hg(Ⅱ) on laterite.The alkalescent environment (pH 7-9) ...     

Combination of biodiesel-ethanol-diesel fuel blend and SCR catalyst assembly to reduce emissions from a heavy-duty diesel engine

In this study, the efforts to reduce NOx and particulate matter （PM） emissions from a diesel engine using both ethanol-selective catalytic reduction （SCR） of NOx over an Ag/Al2O3 catalyst and a biodiesel-ethanol-diesel fuel blend （BE-diesel） on an engine bench test are discussed. Compared with diesel fuel, use of BE-diesel increased PM emissions by 14% due to the increase in the soluble organic fraction （SOF） of PM, but it greatly reduced the Bosch smoke number by 60%-80% according to the results from 13-mode test of European Stationary Cycle （ESC） test. The SCR catalyst was effective in NOx reduction by ethanol, and the NOx conversion was approximately 73%. Total hydrocarbons （THC） and CO emissions increased significantly during the SCR of NOx process. Two diesel oxidation catalyst （DOC） assemblies were used after Ag/Al2O3 converter to remove CO and HC. Different oxidation catalyst showed opposite effect on PM emission. The PM composition analysis revealed that the net effect of oxidation catalyst on total PM was an integrative effect on SOF reduction and sulfate formation of PM. The engine bench test results indicated that the combination of BE-diesel and a SCR catalyst assembly could provide benefits for NOx and PM emissions control even without using diesel particle filters （DPFs）.     

生物质慢速热解工艺的新探讨

慢速热解作为生物质气流床气化的前处理工艺在国内为首创。慢速热解方法不仅可以脱除生物质内的氧元素提高能量密度,而且可以改变生物质的物性有效解决生物质气流床气化过程的输送问题。文章分析了不同生物质种类热解后固体产物、液体产物和气体产物的特性,并且粗略衡算了热解过程的吸热量。结果表明:在热解温度<500℃时,液体产物和气体产物的热值随着热解温度的升高而增加;为得到高固体产率和能量产率的半焦作为气化原料,热解温度不宜>500℃;从能量衡算角度分析而得,热解过程的吸热量很少。     

内循环移动床生物膜反应器的研究与应用

对传统移动床生物膜反应器进行改进,开发了内循环移动床生物膜反应器,通过处理模拟生活污水的研究,考察了反应器去除有机物和脱氮的能力。结果表明,在填料投加率为35%、进水COD为200～800mg/L、HRT为6h、有机负荷为0.8～3.2kg/(m.3d)的条件下,系统COD的去除率在89%以上;同时反应器具有良好的同步硝化反硝化脱氮能力,在DO为2.0mg/L、C/N为25、HRT为6h的条件下,NH4-N和TN的平均去除率分别可以达到98%和93%。另外,内循环移动床生物膜反应器与移动床生物膜反应器的对比实验结果表明,前者对COD和氮的去除效果都优于后者。     

城市污水除磷技术研究——化学强化一级除磷与生物除磷

文章分析了使用化学强化一级除磷技术存在的主要问题,特别指出了化学絮凝剂在生产过程中存在的消耗人类有限资源及环境污染大等缺点,认为该种除磷方法不符合可持续发展的理念。生物除磷技术因操作方便及二次污染小等特点成为近年来国内外研究的热点。文章通过介绍生物除磷技术的微生物学、除磷效率等领域的研究进展,结合本课题组取得的部分结果,认为科研工作者应重视该技术的应用基础研究并在实际生产中加以推广应用。     

河北某钢铁公司废水处理及回用可行性研究

水源短缺问题已经成为困扰河北某钢铁公司发展的主要因素,而废水的大量排放对环境造成污染,影响城市居民的饮水安全。通过澄清、过滤、除盐等处理工艺,将厂区排放的废水进行集中处理并回用于生产,即解决了水源短缺的问题,节约大量新水,又减轻了污水排放对环境的污染。该处理工程具有良好的经济效益和环境效益,是完全必要且可行的。