Effect of graphene oxide exposure on intestinal Wnt signaling in nematode Caenorhabditis elegans

Exposure to engineered nanomaterials(ENMs), such as graphene oxide(GO), can potentially induce the response of various molecular signaling pathways, which can mediate the protective function or the toxicity induction.Wnt signaling pathway is conserved evolutionarily in organisms.Using Caenorhabditis elegans as an in vivo assay model, we investigated the effect of GO exposure on intestinal Wnt signaling.In the intestine, GO exposure dysregulated Frizzled receptor MOM-5, Disheveled protein DSH-2, GSK-3(a component of APC complex), and two β-catenin proteins(BAR-1 and HMP-2), which mediated the induction of GO toxicity.In GO exposed nematodes, a Hox protein EGL-5 acted as a downstream target of BAR-1, and fatty acid transport ACS-22 acted as a downstream target of HMP-2.Functional analysis on HMP-2 and ACS-22 suggested that the dysregulation of these two proteins provides an important basis for the observed deficit in functional state of intestinal barrier.Our results imply the association of dysregulation in physiological and functional states of intestinal barrier with toxicity induction of GO in organisms.     

Ozone pollution characteristics and sensitivity analysis using an observation-based model in Nanjing, Yangtze River Delta Region of China

Ground-level ozone (O₃) has become a critical pollutant impeding air quality improvement in Yangtze River Delta region of China. In this study, we present O₃ pollution characteristics based on one-year online measurements during 2016 at an urban site in Nanjing, Jiangsu Province. Then, the sensitivity of O₃ to its precursors during 2 O₃ pollution episodes in August was analyzed using a box model based on observation (OBM). The relative incremental reactivity (RIR) of hydrocarbons was larger than other precursors, suggesting that hydrocarbons played the dominant role in O₃ formation. The RIR values for NO_X ranged from –0.41%/% to 0.19%/%. The O₃ sensitivity was also analyzed based on relationship of simulated O₃ production rates with reductions of VOC and NO_X derived from scenario analyses. Simulation results illustrate that O₃ formation was between VOCs-limited and transition regime. Xylenes and light alkenes were found to be key species in O₃ formation according to RIR values, and their sources were determined using the Positive Matrix Factorization (PMF) model. Paints and solvent use was the largest contributor to xylenes (54%), while petrochemical industry was the most important source to propene (82%). Discussions on VOCs and NO_X reduction schemes suggest that the 5% O₃ control goal can be achieved by reducing VOCs by 20%. To obtain 10% O₃ control goal, VOCs need to be reduced by 30% with VOCs/NO_X larger than 3:1.     

洱海北部入湖河流水质特征及其对北部湖区的影响

基于2016—2018年罗时江、弥苴河、永安江及洱海北部湖区监测数据分析,探讨洱海北部入湖河流污染变化特征及对北部湖区的影响。结果表明:1）"北三江"监测断面总磷、COD、氨氮浓度整体稳定在GB 3838—2002《地表水环境质量标准》Ⅱ—Ⅲ类标准限值内,年内污染物浓度变化表现出典型的农业面源污染特征,且受流域内产业模式等的综合影响;2）研究期间,河流首要污染物为TN,旱季次要污染物为COD,雨季为TP。雨季入湖负荷高于旱季,弥苴河污染负荷大于罗时江、永安江。"北三江"入湖TN和TP污染负荷分别占洱海允许负荷的50.1%和59.7%;3）入湖河流的磷元素输入是洱海北部湖区磷污染的重要来源。北部湖区污染物浓度对氮、磷入湖污染负荷相关性次月强于当月,响应存在延迟。筛选环境友好型种植模式,控制"北三江"氮磷入湖负荷,有利于保护洱海水环境。     

不同制备温度下污泥生物炭对Cr(Ⅵ)的吸附特性

以城市剩余污泥为原料,于300,400,500,600 ℃温度条件下制备生物炭,通过单因素静态吸附实验探讨制备温度对生物炭吸附Cr（Ⅵ）的影响。结果表明:在500 ℃以内随着温度上升制备的生物炭对Cr（Ⅵ）的吸附量增加,制备温度高于500 ℃后变化不明显;扫描电镜（SEM）、比表面积（BET）、傅里叶红外光谱（FTIR）表征结果显示,热解温度对生物炭表面形貌和官能团组成有显著影响;等温模型及动力学拟合结果表明,生物炭吸附Cr（Ⅵ）为单分子层吸附、物理-化学复合吸附。热解温度对污泥制备生物炭吸附Cr（Ⅵ）的性能有显著影响,最佳制备温度为500 ℃,在此条件制备的生物炭对Cr（Ⅵ）的理论吸附量可达7.93 mg/g。     

应用改良型水质综合指数法评价饮用水水质

应用1套改良型水质综合指数法对3种不同类型的饮用水水质进行评价。将选取的26项检测指标按照卫生学意义分为5大类,并对各分类指标赋权。选用内梅罗法和最差因子判别法与五色等级分级法结合对2017年4—8月的3种类型饮用水进行水质评价。除7月和8月的管网水水质为2级（水质综合指数>0.5,蓝色）以外,其余月份的出水水质均达到1级（绿色）评价标准。不同类型饮用水中对水质综合指数影响最大的水质分类指标均是有机污染指标。2种不同类型的净水机出水水质均优于管网末梢水,但需注意个别指标的污染。     

大气压纳秒负脉冲放电对水中大肠杆菌的灭活

采用自行研制的喷嘴-板-筒式反应器,研究了大气压纳秒负脉冲空气放电对水中大肠杆菌（Escherichia coli, E.coli）灭菌率的影响因素及规律。实验中空气自放电喷嘴电极进入反应器,气流带动放电生成的活性粒子流到达并作用于水中大肠杆菌。研究结果表明:本实验装置可有效实现对水中大肠杆菌的灭活,灭菌率随着放电电压和脉冲重复频率的增加、放电处理时间的延长而升高;随着鼓气速率的增大先增大后减小;随着喷嘴电极直径的增加先减小后增大。当采用1.30 mm喷嘴电极,在脉冲峰值电压为-32 kV、重复频率80 Hz,鼓气速率为80 mL/min时,连续放电处理12 min,灭菌率达到91%。     

医疗废物焚烧飞灰脱毒减害技术研究进展

医疗废物焚烧飞灰（MWIFA）富含高浓度的氯盐、碳组分、重金属和二噁英（PCDD/Fs）,已被列入我国《国家危险废物名录》,管理处置不当将对环境和人类健康造成严重危害。关于医疗废物焚烧飞灰处理处置的综合研究较少。介绍了医疗废物焚烧飞灰中重金属及二噁英等有毒有害物质的污染特征,分析了化学药剂稳定法、水泥固化技术、热处理技术、水热处理技术和浮选技术等多种飞灰处理技术的研究现状,重点阐述了上述后3种技术用于处理医疗废物焚烧飞灰中重金属和二噁英的研究进展及存在的问题,并对其应用前景进行了展望。     

圆红冬孢酵母利用生物柴油副产物粗甘油产油脂的影响因素分析

以餐饮废油制备生物柴油的副产物粗甘油为碳源,采用圆红冬孢酵母发酵生产微生物油脂。通过对发酵影响因素的优化,确定了最适发酵条件为:种子复苏时长24 h、富集时长10 h、接种量为6%、初始粗甘油浓度为60 g/L、C/N为60、有机氮占总氮比例为75%、发酵体积为100 mL、发酵温度为30 ℃、发酵时间为6 d,在此条件下,获得总产油量为10.56 g/L,油脂产率为0.229。与无机氮源硫酸铵相比,有机氮源蛋白胨的添加显著提高了油脂含量和总产油量。通过测定油脂的脂肪酸成分并利用Hoekman方程估算所得生物柴油的性能指标,表明其符合中国、美国及欧盟标准。该方法既为粗甘油的再利用提供了一条新途径,又为生物柴油的生产提供了廉价的原材料。     

UASB启动运行特征及互营丙酸氧化菌定量分析

为揭示升流式厌氧污泥床（UASB）反应器启动运行效能与互营丙酸降解菌群数量之间的关系,以稀释的玉米淀粉生产废水为底物,考察了UASB启动期的运行特征,并采用实时荧光定量PCR技术（qPCR）分析了互营丙酸降解菌群（丙酸氧化菌和产甲烷菌）的演替规律.结果表明,在进水COD 2000mg/L和水力停留时间（HRT）24h条件下,经过38d的连续运行,COD去除率达到了91.9%.当HRT分阶段缩短至8h时,比产甲烷速率达到了315LCH₄/（kg COD·d）,且形成了沉降性能良好的颗粒污泥.qPCR检测结果表明,至少有5种已鉴定的丙酸氧化菌存在于UASB反应器中.Pelotomaculum propionicum为接种污泥中的主要丙酸氧化菌,约占检测到丙酸氧化菌总数的45.7%.它的数量随着HRT缩短不断减少.而Syntrophobacter sulfatireducens和S.wolinii的数量随着HRT缩短不断增加,并在启动完成时达到最大值,分别为1.3×10³,5.5×10³个16S rRNA基因拷贝数/ng DNA,演替成为成熟颗粒污泥中的优势丙酸氧化菌群.Methanobacterium和Methanosarcina为接种污泥中的主要氢营养型产甲烷菌和乙酸营养型产甲烷菌,其数量随着HRT的缩短而逐渐减少,而Methanospirillum和Methanosaeta的数量随HRT的缩短逐渐增加,成为成熟颗粒污泥中的优势产甲烷菌群.     

重金属离子对肺表面活性物质单层膜的影响

为了探究重金属对肺表面活性物质（PS）膜的影响,利用Langmuir–Wilhelmy膜天平,研究了不同种类和浓度的重金属离子与PS单层膜的相互作用.发现Cr³⁺、Cu²⁺、Hg²⁺、Pb²⁺、Cd²⁺、Ni²⁺6种重金属离子均使PS单层的π-A等温线G-LE相变阶段外扩,而Fe³⁺可诱导单层缩合.随后,选取Cd²⁺,Cu²⁺,Hg²⁺,Fe³⁺4种离子进一步探究了重金属浓度对PS单层膜表面活性的影响规律,进行了可压缩模量分析,并结合红外光谱（FTIR）和原子力显微镜（AFM）探究其作用机理,发现Cu²⁺,Fe³⁺和Hg²⁺均会以浓度依赖的方式与PS单层的极性头部发生络合作用,形成复合物,改变膜的稳定性;而Cd²⁺的影响明显弱于其他3种金属离子,但也能使得PS单层有序性增强.