漆酶降解有机污染物的研究进展

文章综述了漆酶的来源及性质、催化氧化机制、催化氧化有机物的作用方式及影响其活性的因素,并分析了其在有机污物染治理方面的应用现状。综合国内外研究现状,开发新型的漆酶磁性纳米固定化材料及构建高效产漆酶基因工程菌是实现漆酶工业化应用的重要研究方向。     

机载产品盐雾试验结果评定判据分析与探讨

针对当前机载产品盐雾试验标准中缺少明确、可量化评估指标,试验结果评定判据粗略笼统且以定性评价为主,已不能满足产品发展和使用环境扩展需求等现状,在总结国内外现行盐雾试验标准的结果评定要求基础上,分析当前机载产品盐雾结果评定判据存在的问题与不足,从管理和技术两个层面提出改进试验结果评定可操作性的建议,指导机载产品盐雾试验实施与评价。     

辽东湾潜在褐潮生物时空分布及环境关联

以18S rDNA V4区作为目标基因,利用自行设计的真核浮游植物鉴定引物V4（F/R）,结合高通量测序技术,对辽东湾2014年四季海水中真核浮游植物多样性进行了检测.结果发现了8种潜在褐潮生物：抑食金球藻、金牛微球藻、微拟球藻、颗粒微拟球藻、细小微胞藻、密球藻、普通小球藻、钙质角毛藻,其中前2种生态风险较高,主要分布在辽东湾西南、东南两侧.除抑食金球藻和细小微胞藻为混合营养型外,其他6种均为自养型.细小微胞藻丰度最高（平均161445个/L）,主要分布在秋季;其次是抑食金球藻、金牛微球藻（平均13912,13717个/L）,主要分布在春季;之后为钙质角毛藻、普通小球藻（平均5498,5234个/L）,主要分布在秋季;密球藻（平均1345个/L）,主要分布在夏季;微拟球藻、颗粒微拟球藻最少（平均56,44个/L）,冬季无分布.辽东湾潜在褐潮生物丰度与水温、水深、无机氮、N/P显著相关,其群落结构演替与环境因子关联性有待于进一步研究.     

Nanoencapsulation of hexavalent chromium with nanoscale zero-valent iron: High resolution chemical mapping of the passivation layer

Solid phase reactions of Cr(Ⅵ) with Fe(0) were investigated with spherical-aberration-corrected scanning transmission electron microscopy(Cs-STEM) integrated with X-ray energy-dispersive spectroscopy(XEDS). Near-atomic resolution elemental mappings of Cr(Ⅵ)–Fe(0) reactions were acquired. Experimental results show that rate and extent of Cr(Ⅵ) encapsulation are strongly dependent on the initial concentration of Cr(Ⅵ) in solution. Low Cr loading in nZⅥ(1.0 wt%) promotes the electrochemical oxidation and continuous corrosion of n ZⅥ while high Cr loading(1.0 wt%) can quickly shut down the Cr uptake. With the progress of iron oxidation and dissolution, elements of Cr and O counter-diffuse into the nanoparticles and accumulate in the core region at low levels of Cr(Ⅵ)(e.g., 10 mg/L). Whereas the reacted n ZⅥ is quickly coated with a newly-formed layer of 2–4 nm in the presence of concentrated Cr(Ⅵ)(e.g., 100 mg/L). The passivation structure is stable over a wide range of pH unless pH is low enough to dissolve the passivation layer. X-ray photoelectron spectroscopy(XPS) depth profiling reconfirms that the composition of the newly-formed surface layer consists of Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxides with Cr(Ⅵ) adsorbed on the outside surface. The insoluble and insulating Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxide layer can completely cover the n ZⅥ surface above the critical Cr loading and shield the electron transfer. Thus, the fast passivation of nZⅥ in high Cr(Ⅵ) solution is detrimental to the performance of nZⅥ for Cr(Ⅵ) treatment and remediation.     

Effect of TiO2 nanoparticle aggregation on marine microalgae Isochrysis galbana

TiO_2 nanoparticles(NPs) could adversely impact aquatic ecosystems. However, the aggregation of these NPs could attenuate this effect. In this work, the biological effects of TiO_2 NPs on a marine microalgae Isochrysis galbana were investigated. The aggregation kinetics of TiO_2 NPs under different conditions was also investigated to determine and understand these effects. Results showed that, though TiO_2 NPs had no obvious impact on the size and reproducibility of algal cells under testing conditions, they caused a negative effect on algal chlorophyll, which led to a reduction in photosynthesis. Furthermore, fast aggregation of TiO_2 NPs occurred under all conditions, especially at the pH close to the p Hzpc. Increasing ionic strength and NP concentration also enhanced the aggregation rate.The aggregation and the following sedimentation of TiO_2 NPs reduced their adverse effects on I. galbana.     

Long-term effects of sliver nanoparticles on the abundance and activity of soil microbiome

正Silver nanoparticles(Ag NPs)are among the most extensively used engineered nanomaterials because of their wellestablished antimicrobial and unique physicochemical properties(Yin et al.,2015).Applications of AgNPs have now been     

Seasonal variation and size distribution of biogenic secondary organic aerosols at urban and continental background sites of China

Size-resolved biogenic secondary organic aerosols(BSOA) derived from isoprene and monoterpene photooxidation in Qinghai Lake, Tibetan Plateau(a continental background site) and five cities of China were measured using gas chromatography/mass spectrometry(GC/MS). Concentrations of the determined BSOA are higher in the cities than in the background and are also higher in summer than in winter. Moreover, strong positive correlations(R2= 0.44–0.90) between BSOA and sulfate were found at the six sites,suggesting that anthropogenic pollution(i.e., sulfate) could enhance SOA formation,because sulfate provides a surface favorable for acid-catalyzed formation of BSOA. Size distribution measurements showed that most of the determined SOA tracers are enriched in the fine mode( 3.3 μm) except for cis-pinic and cis-pinonic acids, both presented a comparable mass in the fine and coarse( 3.3 μm) modes, respectively. Mass ratio of oxidation products derived from isoprene to those from monoterpene in the five urban regions during summer are much less than those in Qinghai Lake region. In addition, in the five urban regions relative abundances of monoterpene oxidation products to SOA are much higher than those of isoprene. Such phenomena suggest that BSOA derived from monoterpenes are more abundant than those from isoprene in Chinese urban areas.     

碳量子点掺杂氮化碳提高的光电化学阴极保护性能研究

目的研究g-C_3N_4/C-Dots-M复合材料的光电化学阴极保护性能。方法采用X射线衍射(XRD)、扫描电子显微镜(SEM)和紫外可见漫反射光谱技术对样品的晶体结构、微观形貌和光吸收性能进行表征。通过电化学测试可见光照射下g-C_3N_4/C-Dots-M复合材料光电极偶联316L不锈钢后的光电化学阴极保护电流密度和电位变化曲线,研究材料的光电化学阴极保护性能。结果可见光照射下,该偶联体系的光致混合电位下降至-0.43 V(vs. Ag/AgCl),光电化学阴极保护电流密度达到4.3μA/cm。结论得益于碳量子点优异的电子传导特性,g-C_3N_4/C-Dots-550复合材料的光电化学阴极保护性能比纯g-C_3N_4的明显增强。该复合材料在光电化学阴极保护方面展现了较大的应用潜力。     

DZ125合金HY3包覆型涂层退除研究

目的 研究化学法退除DZ125合金HY3包覆型涂层。方法 采用真空电弧镀技术（AIP）在定向凝固镍基高温合金DZ125上制备包覆型涂层HY3,利用化学方法完全退除基体上的涂层,通过失重法研究对比1#和2#退除溶液退除HY3涂层和DZ125合金的退除速率,采用扫描电镜（SEM）对退除后的HY3涂层和DZ125基体的微观组织进行观察。结果 经过100 min,2#溶液可以将20 ?m左右的HY3涂层完全退除,采用1#溶液需要超过100 min才能完全退除涂层。两种对DZ125合金的腐蚀性很小,对于同一种合金而言,1#溶液和2#溶液对合金的腐蚀速率比值为1︰13。在1#溶液中,合金与涂层腐蚀速率的比值为1︰87.65;在2#退除溶液中,合金与涂层腐蚀速率的比值为1︰6.81。结论 1#溶液更加适合退除DZ125合金上的HY3涂层。     

爆炸螺栓分离对热防护系统冲击响应分析

目的考察在爆炸螺栓分离过程中,作用在TPS(热防护系统)上的冲击响应是否会导致其破坏,从而影响航天器飞行安全,对过程进行数值仿真分析。方法提出四阶段仿真方案,基于MSC.Dytran软件,采用流固耦合方法对爆炸螺栓分离过程进行动力学仿真;根据单个爆炸螺栓地面分离试验的结构进行建模和分析,获取结构响应曲线;再根据实测的冲击响应数据,对爆炸过程中炸药及JWL方程的参数等设置进行调整,获取准确爆炸螺栓的分析模型;最后应用于对真实结构中TPS(热防护系统)在分离过程里受爆炸螺栓冲击响应的动力学分析与评估。结果通过参数调整,获得的仿真模型与爆炸螺栓地面分离试验实测结果一致,证明了仿真模型的有效性和四阶段仿真方案的可行性。结论提取的真实结构爆炸螺栓分离过程中作用在TPS(热防护结构)上的最大加速度响应曲线,可用于指导TPS(热防护系统)的设计。