Microbial community composition and electricity generation in cattle manure slurry treatment using microbial fuel cells: effects of inoculum addition

Environmental Science and Pollution Research - Microbial fuel cell (MFC) is a sustainable technology to treat cattle manure slurry (CMS) for converting chemical energy to bioelectricity. In this...     

上埋式管道穿越高填方填挖结合部位的受力状态研究

以延安新区黄土高填方工程中的上埋式排水管道为原型,开展了相似比为1:2的室内试验,试验前在模型箱底部一定位置预设沉降底板模拟实际填方的工后沉降过程,在试验土体和管道中布设压力盒、位移计和应变片,以采集试验过程中的管土接触压力、管-土相对位移和管道应变等数据。研究表明,负土拱效应对管道的上部压力影响明显,竖向压力系数最大达3.4,与沉降量的关系符合三次多项式曲线,负土拱效应对管道的影响不可忽略。开挖纵向剖面后发现管道下部土层间出现明显的脱空裂缝,是管道下部管-土接触压力减小的原因。该成果为黄土高填方场地中管周土压力的计算、管道变形控制提供参考。     

Characteristics of PM<Subscript>2.5</Subscript>, CO<Subscript>2</Subscript> and particle-number concentration in mass transit railway carriages in Hong Kong

Fine particulate matter (PM_2.5) levels, carbon dioxide (CO₂) levels and particle-number concentrations (PNC) were monitored in train carriages on seven routes of the mass transit railway in Hong Kong between March and May 2014, using real-time monitoring instruments. The 8-h average PM_2.5 levels in carriages on the seven routes ranged from 24.1 to 49.8 µg/m³, higher than levels in Finland and similar to those in New York, and in most cases exceeding the standard set by the World Health Organisation (25 µg/m³). The CO₂ concentration ranged from 714 to 1801 ppm on four of the routes, generally exceeding indoor air quality guidelines (1000 ppm over 8 h) and reaching levels as high as those in Beijing. PNC ranged from 1506 to 11,570 particles/cm³, lower than readings in Sydney and higher than readings in Taipei. Correlation analysis indicated that the number of passengers in a given carriage did not affect the PM_2.5 concentration or PNC in the carriage. However, a significant positive correlation (p < 0.001, R ² = 0.834) was observed between passenger numbers and CO₂ levels, with each passenger contributing approximately 7.7–9.8 ppm of CO₂. The real-time measurements of PM_2.5 and PNC varied considerably, rising when carriage doors opened on arrival at a station and when passengers inside the carriage were more active. This suggests that air pollutants outside the train and passenger movements may contribute to PM_2.5 levels and PNC. Assessment of the risk associated with PM_2.5 exposure revealed that children are most severely affected by PM_2.5 pollution, followed in order by juveniles, adults and the elderly. In addition, females were found to be more vulnerable to PM_2.5 pollution than males (p < 0.001), and different subway lines were associated with different levels of risk.     

不同市场结构组合下稀土最优开采路径研究

本文从价格视角将我国稀土市场结构的变化历程划分为不同阶段,分别从理论和现实视角上探讨了在国际、国内都是完全竞争市场,国际市场垄断、国内市场完全竞争,国际市场完全竞争、国内市场垄断,国际、国内都是垄断市场条件下稀土最优开采路径及最优耗竭时间,并通过设定参数判断其相对大小关系。发现在一定的假设条件下,开采前期当国内和国际市场都是完全竞争时,稀土最优开采量是最大的;当国内和国际市场都是垄断时,稀土最优开采量是最小的;其他两种市场情况下稀土最优开采量居于中间,当国际市场是稀土的主要消费地时,国际竞争-国内垄断市场情况下稀土最优开采量大于国际垄断-国内竞争市场情况下稀土最优开采量,反之,国际垄断-国内竞争市场情况下稀土最优开采量大于国际竞争-国内垄断市场情况下稀土最优开采量。     

Experimental thermal storage research of organic binary phase change materials in building environment

This paper aims to reveal the heat transfer mechanism of low-temperature phase change material (PCM) and design PCM heat storage device in building heating environment. Firstly, low-temperature binary PCMs of lauric acid and stearic acid are prepared, and their thermal properties are investigated by DSC. Then, shell and tube latent heat thermal energy storage units are conducted, and heat transfer experiments are carried out to analyze the heat transfer mechanism of PCM. The results demonstrate that natural convection plays an important role in heat transfer process, and the heat storage efficiency of PCMs can be significantly enhanced by increasing the fin width and improving the inlet heat transfer fluid (HTF) temperature. Furthermore, some proposals are put forward to guide the design of PCM storage device in building heating environment.     

絮团粘性分维数的概念及其分析模型

水处理中的絮团具有复杂的形态结构,分维数是描述这种结构的有力工具。通过分析固液体系的粘度与絮团分维数之间的关系,提出了絮团粘性分维数的新概念及粘性分维数测定的数学物理模型,并进行了实验验证。与常用的质量分维数、边界分维数、面积分维数、体积分维数、表面积分维数等相比,絮团的粘性分维数及其测定模型具有易于测量、可同时表征不同类型絮团、可定量分析絮凝产品组成等特点,从而为絮团形态结构的定性及定量研究开辟了新的途径。     

气浮技术在膜生物反应器剩余污泥浓缩过程中的应用

污泥浓缩作为污泥处理的关键环节之一,开发高效的污泥浓缩工艺对于降低污泥含水率、提高脱水设备的运行效率、降低脱水能耗具有十分重要的意义。针对MBR污泥浓度高、污泥粒径小、污泥沉降性能较差等特点,故采用传统的重力浓缩和机械浓缩技术很难有效实现污泥浓缩。因此,尝试采用气浮浓缩技术降低污泥含水率的可行性。从气浮浓缩的中试结果来看,较适宜运行参数为:固体负荷为15 kg/(m2·h),水力负荷为1.5 m3/(m2·h),回流比为1,PAM投配率2‰(w/w干固体),溶气压力为0.4 MPa,气固比为0.03。经过中试设备进行气浮浓缩后,污泥含水率降低至96%左右。此外,还研究了采用气液多相泵系统对剩余污泥的浓缩效率,结果显示,该设备的使用相对于传统溶气气浮工艺,其优点表现在占地小、工程造价低以及运行成本低等方面。     

KOH活化花生壳生物质炭对亚甲基蓝吸附性能研究

以花生壳生物质炭(P-BC)为原料,KOH为活化剂,采用化学活化法制得活化生物质炭(K-BC),通过考察对亚甲基蓝的吸附性能,研究了花生壳生物质炭的最佳活化条件,并利用N2吸附-脱附实验、SEM等对最佳活化条件下的生物质炭进行表征。结果表明,K-BC活化的最佳条件为碱炭比为1.5∶1,活化温度为800℃,活化时间为90 min,此时K-BC的比表面积达到597.93 m2/g,总孔容达到0.76 cm3/g。并考察了亚甲基蓝初始浓度、pH等对K-BC吸附亚甲基蓝的影响,随着初始浓度的增加,吸附平衡时间显著延长,亚甲基蓝去除率显著降低;当pH=6时,K-BC对亚甲基蓝的吸附量最大;K-BC对亚甲基蓝的吸附动力学曲线符合伪二阶动力学模型,吸附平衡时K-BC对亚甲基蓝的吸附能力为80~149.95 mg/g。     

CdIn2S4/复合材料的制备及光降解罗丹明B

利用高压静电纺丝技术,制得含有羧基的导电聚合物纤维(聚偏氟乙烯/苯乙烯-马来酸酐共聚物/纳米石墨),高温水热条件下在纤维表面制备CdIn2S4颗粒,得到CdIn2S4/导电聚合物纤维复合材料。运用扫描电子显微镜(SEM)、X射线衍射仪(XRD)、紫外-可见吸收光谱仪(UV-Vis)和热失重分析仪(TGA)对复合材料的结构进行表征。并利用350 W氙灯模拟太阳光进行光催化降解罗丹明B。结果发现,CdIn2S4/导电聚合物纤维复合材料的降解效率高于CdIn2S4粉体和Degussa P25 TiO2粉体,光催化降解3 h,罗丹明B的降解率为96.2%。