Phytoremediation of the polluted Waigang River and general survey on variation of phytoplankton population

The Waigang River, a major tributary of the Qinhuai River system, has suffered from long-standing pollution because of lack of management. Restoration was commenced in April 2006 to reduce pollutants and improve water quality. Four ecological areas and ten surface carriers were constructed for the culture of plants (mainly water hyacinth (Eichhornia crassipes) and ryegrass (Lolium perenne L.)) for phytoremediation. Chemical oxygen demand (COD), total suspended solids (TSS), total phosphorus, total nitrogen (TN), ammonia?Cnitrogen (NH₃?CN), water transparency, and variations in phytoplankton population were investigated to evaluate the effects of restoration. Over 36?months, TSS, COD, TN, and NH₃?CN levels decreased by 91.1, 55.3, 91.5, and 86.5?%, respectively. Transparency increased from 25?cm in 2006 to 165?cm in 2009. Improvements in water quality significantly enhanced the diversity of phytoplankton, which were harmed by pollution stress. Our results show that the water hyacinth and ryegrass cultured in the ecological areas and the surface carriers can be used to restore other heavily polluted rivers with conditions similar to those of the Waigang River, especially in the initial stages of restoration.     

改性多壁碳纳米管对水中Cd~（2＋）的去除

为了增加多壁碳纳米管（multiwall carbon nanotubers,MWNTs）对水中Cd2＋的吸附量,使用混酸对多壁碳纳米管进行氧化处理,采用红外光谱进行结果表征,并探讨了吸附时间、pH值和MWNTs的使用量、Cd2＋的浓度及干扰离子对镉离子吸附的影响。结果表明,吸附时间为1.5 h、pH为5.3、吸附效果最佳,随MWNTs量的增加Cd2＋去除量增加,共存的阳离子会降低对Cd2＋的吸附效果,对Cd2＋的吸附符合Longmuir吸附定律。研究同时表明,pH小于2时Cd2＋能容易从碳纳米管上解吸。初步探讨了Cd2＋吸附机制。     

Mo-N-TiO_2光催化剂的制备、表征及其活性提高机制

以钼酸铵和氨水分别为钼源和氮源,采用溶胶-凝胶法制备了Mo-N-TiO2光催化剂,并对其进行了XRD、XPS和UV-visDRS表征。XRD结果表明,Mo、N共掺杂有效抑制了TiO2晶粒的生长,提高了TiO2由锐钛矿向金红石相的转变温度。UV-vis表明,Mo-N-TiO2光催化剂可见光吸收能力增强,吸收带边明显＂红移＂,且钼酸铵添加量（相对TiO2）为0.5%的样品＂红移＂程度最大,最大吸收带边为550 nm。XPS分析结果表明,Mo取代了TiO2晶格中的部分Ti4＋,以Mo6＋形式存在的,而N以Ti—N及N—Ti—O形式存在。以罗丹明B为模型污染物,重点考察了钼酸铵添加量与焙烧温度对Mo-N-TiO2光催剂性能的影响。结果表明,400℃焙烧下、钼酸铵添加量为0.5%的样品催化活性最好。模拟太阳光下光照120min对罗丹明B的降解率达到96.8%,是纯TiO2的2.42倍。     

不同粒径零价铁（ZVI）对污水污泥H_2S和CH_4释放速率的影响

考察了不同粒径零价铁（ZVI）,包括200目普通铁粉（200m-ZVI）、800目超细铁粉（800m-ZVI）和纳米铁粉（nZVI,粒径=20 nm）,对污水污泥的硫化氢和甲烷释放速率的影响。研究发现：（1）在22 d内,添加0.1%的200m-ZVI使污泥的硫化氢释放速率提高48.0%,而添加0.1%的800-ZVI和nZVI,则使污泥的硫化氢释放速率分别降低33.1%和77.1%;（2）不同粒径ZVI均可以提高污泥沼气中的甲烷浓度,且依次为nZVI〉800m-ZVI〉200m-ZVI;（3）在23 d内,添加0.1%的200m-ZVI和nZVI使污泥的甲烷累计产生量分别提高了15.5%和40.6%,而添加0.1%800m-ZVI则使甲烷产生量降低了12.5%。nZVI可以有效控制污泥的硫化氢释放,并显著提升污泥在厌氧发酵过程的产甲烷速率。     

Determination of partition and diffusion coefficients of formaldehyde in selected building materials and impact of relative humidity

The partition and effective diffusion coefficients of formaldehyde were measured for three materials (conventional gypsum wallboard, "green" gypsum wallboard, and "green" carpet) under three relative humidity (RH) conditions (20%, 50%, and 70% RH). The "green" materials contained recycled materials and were friendly to environment. A dynamic dual-chamber test method was used. Results showed that a higher relative humidity led to a larger effective diffusion coefficient for two kinds of wallboards and carpet. The carpet was also found to be very permeable resulting in an effective diffusion coefficient at the same order of magnitude with the formaldehyde diffusion coefficient in air. The partition coefficient (K(ma)) of formaldehyde in conventional wallboard was 1.52 times larger at 50% RH than at 20% RH, whereas it decreased slightly from 50% to 70% RH, presumably due to the combined effects of water solubility of formaldehyde and micro-pore blocking by condensed moisture at the high RH level. The partition coefficient of formaldehyde increased slightly with the increase of relative humidity in "green" wallboard and "green" carpet. At the same relative humidity level, the "green" wallboard had larger partition coefficient and effective diffusion coefficient than the conventional wallboard, presumably due to the micro-pore structure differences between the two materials. The data generated could be used to assess the sorption effects of formaldehyde on building materials and to evaluate its impact on the formaldehyde concentration in buildings.     

Carbonyl emissions from vehicular exhausts sources in Hong Kong

Vehicular emission (VE) is one of the important anthropogenic sources for airborne carbonyls in urban area. Six types of VE-dominated samples were collected at representative locations in Hong Kong where polluted by a particular fueled type of vehicles, including (i) a gas refilling taxis station (liquefied petroleum gas [LPG] emission); (ii) a light-duty passenger car park (gasoline emission); (iii) a minibus station (diesel emission); (iv) a single-deck-bus depot (diesel emission); (v) a double-deck-bus depot (diesel emission); and (vi) a whole-food market entrance for light- and heavy-duty vehicles (diesel emission). A total of 15 carbonyls in the samples were quantified. Formaldehyde was the most abundant carbonyl among the VE-dominated samples, and its contribution to the total quantified amount on a molar basis ranged from 54.8% to 60.8%. Acetaldehyde and acetone were the next two abundant carbonyls. The carbonyls were quantified at three roadside locations in Hong Kong. The highest concentrations of formaldehyde and acetaldehyde, 22.7 +/- 8.4 and 6.0 +/- 2.8 microg/m3, respectively, were determined in the samples collected at a main transportation gate for goods between Hong Kong and Mainland China. The total quantified carbonyl concentration, 37.9 +/- 9.3 microg/m3, was the highest at an entrance of a cross-harbor tunnel in downtown area. The theoretical carbonyls compositions of the three roadside locations were estimated according to the VE-dominated sample profiles and the statistics on vehicle numbers and types during the sampling period. The measured compositions of formaldehyde were much higher than the theoretical compositions in summer, demonstrating that photochemical reactions significantly contributed to the formaldehyde production in the roadsides.     

The effects of manganese precursors on Mn-based/TiO2 catalysts for catalytic reduction of NO with NH3

Manganese acetate (MnAc) and manganese nitrate (MnN) were employed as precursors for the preparation of MnAc)/TiO2, Mn (N)/TiO2, Mn(Ac)-Ce/TiO2, and Mn(N)-Ce/TiO2 by impregnation. These complexes were used as catalysts in the low-temperature selective catalytic reduction of NO with NH3. The influence of manganese precursors on catalyst characteristics, the reduction activity, and the stability of the catalysts to poisoning by H2O and SO2 were studied. Experiments showed that Mn(N) produced MnO2 with large grain sizes in Mn(N)/TiO2 catalyst. On the contrary, Mn(Ac) led to highly dispersed and amorphous Mn2O3 in Mn (Ac)/TiO2 catalyst, which had better catalytic activity and stability to SO2 at low temperatures. The doping of cerium reduced the differences in catalytic performance between the catalysts derived from different Mn precursors.     

UV-Fenton体系预处理四氢呋喃废水实验研究

采用UV-Fenton体系预处理四氢呋喃废水,实验结果表明,pH值、反应时间、Fe2+和H2O2投加量等因素对处理效果有较大的影响。实验确定的最佳反应条件为:原水pH=5,Fe2+投加量2.5 mmol/L,H2O2投加量12 mmol/L,反应时间90 min,连续曝气,在此条件下,COD去除率可达85%左右。经UV-Fenton体系处理后,废水的B/C值由0.16增至0.47,可生化性提高,可满足后续生化处理的要求。     

超声波促进城市生活污泥缺氧/好氧消化的研究

本研究将超声波预处理引入城市生活污泥缺氧/好氧消化工艺中,自主设计了容积为30 L的生活污泥超声波-缺氧/好氧消化中试系统并用以实验研究。超声波预处理的参数为超声频率28 kHz,声能密度0.15 W/mL,超声时间10 min,超声间隔12 h,污泥超声比例30%。结果表明,引入超声预处理后,缩短了污泥的稳定时间,提高了污泥的消化效率。污泥消化10 d就已经达到了稳定标准,比未引入超声预处理时缩短了12 d,而MLVSS最大去除率提高了11%,达到了55.10%。超声波的引入,对污泥缺氧/好氧消化系统中污泥上清液溶解性COD（SCOD）的变化趋势影响比较明显,而对上清液的pH、氨氮和TP的变化趋势没有明显影响。     

植物对潜流人工湿地净化微污染水效果的影响研究

以4种湿地植物为实验对象,在野外构建中试潜流人工湿地,研究了不同植物及植物连根收割对湿地运行效果的影响。结果显示,植物明显提升了湿地的去污效果;其中美人蕉湿地的TP和NH4+-N去除率最高,达到55.6%和78%;空心菜湿地的TN去除率最高,达到80.5%;芦竹湿地的COD去除率最高,为26.6%;植物连根收割后,湿地运行效果下降;其中TN去除率降至空白水平之下,而其他污染指标下降至略高于空白的水平。