The effects of elevated CO2 on clonal growth and nutrient content of submerge plant Vallisneria spinulosa

An approximately four months long glasshouse experiment was conducted to examine the effects of elevated carbon dioxide (CO(2)) concentration (1,000 +/- 50 micromol mol(-1)) in the atmosphere on biomass accumulation and allocation pattern, clonal growth and nitrogen (N), phosphorus (P) accumulation by the submerged plant Vallisneria spinulosa Yan. Elevated CO(2) significantly increased V. spinulosa total fresh biomass ( approximately 130%) after 120 days, due to more biomass accumulation in all morphological organs than in those at ambient CO(2) (390 +/- 20 micromol mol(-1)). About 75% of the additional total biomass at elevated CO(2) was accounted for by leaf and rhizome (above ground) biomass and only 25% of it belonged to root and turion (below ground). However, the turions biomass exhibited a greater increase rate than that of organ above ground, which caused reduction in the above/below ground biomass ratio. The clonal growth of V. spinulosa responded positively to elevated CO(2). The number of primary ramets increased up to 1.4-folds at elevated CO(2) and induced a dense growth pattern. For nutrients absorption, concentration of N in leaf and in turion was significantly (p 相似文献   

Removal of cyanobacterial blooms in Taihu Lake using local soils. I. Equilibrium and kinetic screening on the flocculation of Microcystis aeruginosa using commercially available clays and minerals

Algal removal abilities of 26 clays/minerals were classified into three categories according to the 8-h equilibrium removal efficiency (Q8h) and removal rate at a clay loading of 0.7 g/L. Type I clays (sepiolite, talc, ferric oxide, and kaolinite) had a Q8h > 90%, a t50 (time needed to remove 50% of the algae) < 15 min, and a t80 < 2.5 h. Type II clays (6 clays) had a Q8h 50-90%, a t50 < 2.5 h, and a t80 > 2.5 h. Type III clays (14 clays) with Q8h < 50%, t50 > 8 h and t80 > 14 h had no practical value in removal of algal blooms. When the clay loading was reduced to 0.2 g/L, Q8h for all the 25 materials decreased to below 60%, except for sepiolite whose Q8h remained about 97%. The high efficiency for sepiolite to flocculate M. aeruginosa cells in freshwaters was due to the mechanism of netting and bridging effect.     

微波加热对活性炭表面基团及其对SO2吸附性能的影响

采用了微波加热技术,通过在不同微波功率和辐射时间条件下对不同粒径活性炭进行改性,研究了改性前后活性炭的表面化学基团、元素组成的变化,以及对SO2吸附性能的影响.结果表明,经过微波改性后活性炭的SO2吸附性能大为提高,微波功率是影响改性活性炭脱硫性能的主要因素.活性炭经微波热处理后,酸性基团发生分解,表面含氧量减少,碱性特征增强,是吸附性能增加的主要原因之一.     

某电厂堆灰场附近浅层地下水中Cr6+的成因及治理措施

分析了焦作某电厂堆灰场附近浅层地下水中Cr6+ 的形成原因。根据该区水文地质背景 ,提出在地下污染水羽的下游建可渗透反应墙的漏斗 -通道系统 ,用对Cr6+ 有很高去除效率的风化煤作为反应材料 ,使污染水羽流经此系统时有效去除地下水中的Cr6+ ,达到净化的目的     

Quantification of joint effect for hydrogen bond and development of QSARs for predicting mixture toxicity

A QSAR model is successfully proposed to predict the toxicity effect on Photobacterium phosphoreum by nonpolar-narcotic-chemical mixtures and/or polar-narcotic-chemical mixtures. For nonpolar-narcotic-chemical mixtures and polar-narcotic-chemical mixtures, their corresponding hydrophobicity-based QSAR models are derived from regression analysis. Comparison of these two QSAR models make us believe that it is the joint effect of hydrogen bond in polar-narcotic-chemical mixture that leads to the difference between these two models. Such joint effect of hydrogen bond can be quantified as AMH and BMH by using the different partition coefficients of mixtures in various organic phase/water systems. And the regression analysis results convinced us that the introduction of AMH does improve the quality of the QSAR model with r2=0.948, S.E.=0.166 and F=745.201 at P=0.000 for total 84 mixtures.     

柱生物曝气法吸附处理含铬废水

利用复合生物吸附剂FY01与活性污泥作为吸附材料，探讨了柱式生物曝气法对高浓度含铬电镀废水的生物吸附效果。研究结果表明，FY01性能稳定，耐进水pH冲击能力较强。当进水pH=2—5、流速为500mL／h时，10gFY01和5g活性污泥联合处理60．4mg／L含铬电镀废水2h后，铬的去除率达78％以上；在4℃冰箱和23—28℃实验室保存50d的FY01对铬的去除分别在78％～83％和77％-84％之间。柱式生物曝气吸附法对含铬废水的处理效果理想，运行稳定。串联处理2000mL总Cr、Cu^2＋和COD浓度分别为60．4、4．51和48．2mg／L的电镀废水2h后，去除率分别高达92．1％、99．2％和71．4％。     

微絮凝-超滤工艺处理微污染水源水的中试研究

进行了微絮凝．超滤工艺处理微污染水源水的中试研究。试验结果表明：在微絮凝-超滤工艺中，相同混凝剂投加量（相同金属摩尔浓度）下铁盐比铝盐的混凝效果好；微絮凝-超滤工艺的最佳絮凝时间为120s左右；最佳混凝剂投加量为2．2mg／L（以Fe计）。微絮凝-超滤工艺在改善出水水质和缓解膜污染方面均优于直接超滤工艺。微絮凝-超滤工艺的出水水质均符合建设部《城市供水水质标准》（CJ／T206-2005）要求。     

Status of trace elements in paddy soil and sediment in Taihu Lake region

Thirteen paddy soil profiles and river sediments which are sources of irrigation water were collected around the Taihu Lake, and the trace elements were estimated. The content of La and Ce in paddy soil and sediment were 39.3 and 68.6 mg/kg soil and 36.9 and 65.1 mg/kg soil, being within the range of background values. The values for Pb, Cu, Ni, Cr, Co, Mn, Zn, Se in paddy soil were 23.3, 27.8, 25.5, 63.5, 10.2, 386, 68.7 and 0.25 mg/kg soil respectively, all below the national permission level. There was a decline of Zn in paddy soil. Some of the river sediments were seriously polluted. The river in Yangjin site was most contaminated with 5.47 g Cu/kg and 7.4 g Zn/kg. The high concentration of Pb and Ni also was observed in this sediment. River in Weitang, Huashi, Xinzhuang and Meiyan were contaminated with Pb, Cu and Ni to some extent. Zn, Cu and Pb were the main pollutants in present experiment sites. The fast development of village/township industries have caused severe environmental pollution in the Taihu Lake region, especially irrigation river sediments. Se content in plant and seed was 0.04 and 0.03 mg/kg respectively, showed Se-deficiency in paddy soil in the Taihu Lake region.     

制浆废液降低普钙水分的应用研究

针对我国采用高临界流动水分的磷矿进行湿法生产普钙普遍存在产品水分达不到部颁标准的难题,直接采用制浆废液(利用其主要对环境有害成分之一--MNA作减水剂)进行降低普钙水分的研究和应用.实验结果表明,添加少量的减水剂MNA可显著降低国内朝阳、昆阳、浏阳和国外摩洛哥等单种磷矿以及昆阳-朝阳混矿的矿浆粘度和水分.采用国产昆阳-朝阳混矿进行工业生产试验结果表明,添加0.35%～0.4%干矿粉重量的减水剂MNA,不仅可使球磨添加水量从145 kg降至103 kg,矿浆含水量从30.5%降至27%,成品肥含水量从16.24%降至13.77%,而且可使有效磷从10.67%升至12.24%,转化率由86.57%提高到90.45%,矿浆细度由90.18%提高到93.12%.实验和工业生产试验表明,直接用造纸制浆废液降低普钙水分,既确保和改善了普钙的产品质量,又治理了环境污染,取得了较好的经济、环境和社会效益.     

错流式动态膜-生物反应器中污泥活性的研究

应用错流式动态膜-生物反应器(CDMBR)对己内酰胺废水进行了180 d的实验,实验过程中测定反应器的膜出水和上清液的水质,并对污泥进行了耗氧呼吸速率测定.结果表明,上清液COD一直保持在100mg/L以下,而膜出水的则保持在50 mg/L以下,膜对上清液的COD去除率达50%,而对氮的去除没有贡献.可溶性细胞产物(SMP)在反应器内容易积累,停留足够的时间后能被生物降解.通过投加抑制剂测定耗氧呼吸速率,发现异养菌、硝化细菌和亚硝化细菌的活性由于F/M的降低和SMP积累受到一定的抑制,但不影响系统的处理效率.跨膜压力、膜面流速越大,通量衰减得也就越快.