采用Zn-Se/不锈钢阴极的超声-电解法处理罗丹明B废水

采用超声-电解法考察了Zn-Se/不锈钢阴极处理罗丹明B废水的效果及影响因素。正交实验优化结果表明:在电流密度为2.4A/dm2、废水初始pH为6、超声功率为160W、通气量为10L/h、m(Zn)∶m(Se)为1∶1.5的Zn-Se/不锈钢作阴极、Ti/TiO2和铁网为双阳极的条件下,超声-电解法处理罗丹明B废水120min,废水脱色率为98.97%,COD去除率为88.11%。     

TiO_2/SiO_2@γ-Fe_2O_3光催化剂的制备及其光催化性能

以共沉淀法制备的纳米Fe3O4为核,以正硅酸乙酯为硅源,通过溶胶-凝胶法制备了SiO2@Fe3O4壳-核结构纳米颗粒,再以钛酸四丁酯为钛源,通过溶胶-凝胶法、经焙烧制得TiO2/SiO2@γ-Fe2O3磁性纳米光催化剂。采用X射线衍射仪、透射电子显微镜、比表面分析仪、振动磁强计对光催化剂的结构进行了表征,以苯酚溶液为模拟废水对光催化剂的光催化性能进行了评价。实验结果表明:经500℃焙烧的光催化剂活性相为锐钛矿型TiO2;在苯酚溶液初始浓度为0.2mmol/L、苯酚溶液pH为7的条件下,COD去除率为70.9%。     

化工园区空气中非甲烷总烃与挥发性有机物的定量关系

采用美国环保署(EPA)推荐的TO14/15方法和自动监测测定了某化工园区空气中挥发性有机物(VOC)以及非甲烷总烃,测定结果显示化工园区空气中非甲烷总烃与VOC的定量关系可以通过有效碳质量浓度建立,即非甲烷总烃有效碳质量浓度和VOC有效碳质量浓度之和相等。并藉此定义总有效碳解析度(R)以表征空气自动监测选定项目对空气有机污染的覆盖率指标,计算结果表明该空气自动监测选定的11项指标平均可表征该区域空气有机污染的71%。     

固定化白腐真菌反应器与接触氧化反应器联用处理癸二酸生产废水

采用固定化白腐真菌(WRF)反应器与接触氧化反应器联用处理癸二酸废水。在WRF反应器中,以汽曝玉米秸秆为载体,并添加铜、铁促进白腐真菌生长和产酶作用,载体的使用寿命约为45 d。在进水苯酚平均质量浓度为69.36 mg/L、平均进水COD为1 648.81 mg/L的条件下,经WRF反应器处理后,苯酚平均质量浓度降至7.59 mg/L,平均出水COD降至478.03 mg/L;再经接触氧化反应器处理后,苯酚平均质量浓度降至1.65 mg/L,平均出水COD降至297.31 mg/L。     

MBR工艺处理粮油加工废水的研究

采用MBR(Membrane Bioreactor)工艺对粮油加工废水进行处理发现,污染物的去除是活性污泥和膜截留共同作用的结果,试验中微生物的去除作用占污染物总去除率的62.9%~88.1%,起主要作用。当系统的污泥负荷和容积负荷分别在0.4~0.54 kgCOD/kgMLSS.d之间和3.8~5.0 kgCOD/m3.d之间变化时,系统对COD的去除率在92.5%以上。本试验所用膜的临界膜通量为8~10 L/(m2.h),系统污泥浓度从1~2g/L增加到10~12g/L时,临界膜通量从10~12L/(m2.h)下降到了3~4 L/(m2.h),随着膜面流速从1.0m/s上升到1.8m/s,膜的临界通量也相应的从4~6 L/(m2.h)上升到了16~18 L/(m2.h),呈正相关。     

浅析XLDM型脉冲袋式除尘器在CFB锅炉上的应用

介绍了兖矿国宏化工公司2台160 t/h CFB锅炉配套XLDM-5700型袋式除尘器的实际运行情况,从除尘效率、喷吹方式、运行能耗等方面分析了袋式除尘器的性能,并总结出XLDM型袋式除尘器最佳运行方式。     

Hawaiian Residents’ Preferences for Miconia Control Program Attributes Using Conjoint Choice Experiment and Latent Class Analysis

Invasive species control or eradication is an important issue. On the islands of Hawaii, this problem is exceedingly evident when it comes to Miconia calvescens (Miconia). Adequate funding is needed to control or eradicate this invasive plant, but with the limited amount of funding available for the fight against Miconia, it is important to make sure that the fund is being spent in a way that addresses the needs or preferences of the Hawaiian residents. Using the conjoint choice experiment method, we designed a survey that would measure the Hawaiian residents’ willingness to support Miconia control program attributes. The attributes focused on were cost, biodiversity loss, extent of spread and soil erosion. Latent class approach was used to assess the surveyed population to see the different preferences by individual classes. The results show three different classes or groups of individuals with varying preferences for a control program of which cost and erosion were the top preferred attributes among the classes. These groups were defined by their socio-demographics of income, the length of residency and exposure to farming/gardening activities. Even with a preference for lower cost, a group showed willingness to pay more ($2.40) for a program that reduces erosion from high to low. Finally, the biodiversity attribute had very low consideration from a majority of the respondents showing the need for educating the public regarding its importance in preserving the unique environment in Hawaii.     

汽车常见腐蚀问题分析及改进措施探讨

汽车是耐用消费品,服役环境较恶劣,经常会发生腐蚀问题;腐蚀不仅影响汽车美观,而且还直接影响汽车质量和使用寿命。本文主要就汽车腐蚀类型及常见腐蚀问题进行总结分析,并提出预防改进措施。     

Solid phase extraction with pyrenebutyric acid-bonded silica for analysis of polychlorinated biphenyls in sewage water by gas chromatography-mass spectrometry

A solid phase extraction (SPE) method using pyrenebutyric acid-bonded silica (PYB) as sorbent was developed to determine 23 polychlorinated biphenyls (PCBs) in sewage water by gas chromatography-mass spectrometry (GC-MS). Factors were optimized in SPE procedures including elution solvent, pH, and cartridge burden. The recoveries of 23 PCB congeners were 69.44-111.91% under optimized conditions. Comparisons were also conducted among PYB-SPE, C(18)-SPE and United States Environmental Protection Agency 608 (USEPA608) methods in the analysis of PCBs in sewage water samples. The results showed that the performance of PYB-SPE method was similar with USEPA608 method and better than C(18)-SPE method. Both PYB-SPE and USEPA608 methods were then employed to analyze PCBs in real spiked sewage water samples. The recoveries of PCB congeners determined by PYB-SPE method ranged from 70.6% to 92.4% in real spiked sewage water samples which were identified to be in accordance with USEPA608 method. Limits of detection (LOD) were in the range of 0.06-0.22ngL(-1) for PCB congeners. The optimized PYB-SPE method was successfully applied to the determination of PCBs in sewage water samples.