清河流域水环境质量监测与评价研究

近年来,随着全球各地城市化和工业化进程的不断加快,以及人类对河流水生态系统资源的不合理、掠夺式利用,河流水生态系统遭到严重破坏,各地河流相继出现水质恶化、水文条件改变、物种多样性退化、生境条件恶劣等诸多问题。文章对辽河主要支流清河水生态系统的水质状况进行了研究,并于2012年6月,对清河流域22个监测断面水质状况进行了实地调查,对其水质状况进行了评价,结果表明:22个监测断面中,达到Ⅲ类水质断面的有8个,Ⅳ类7个,Ⅴ类1个,劣Ⅴ类6个。其中6个劣Ⅴ类断面分别因氟化物、氨氮、总磷浓度超标而为劣Ⅴ类。     

基于综合水质标识指数法的四川西充河水质评价

四川省西充河为严重污染河流,选取溶解氧(DO)、氨氮(NH+4-N)、五日生化需氧量(BOD5)、总氮(TN)、总磷(TP)5项指标年平均值,采用综合水质标识指数法,研究了西充河近10年水质状况随时间变化趋势及水污染特征。2003年至2010年水质级别为劣V类,2011年和2012年水质级别为Ⅳ类,水质标识指数Iwq从2003年的12.459逐渐降低到2012年的4.431。西充河近10年水质状况整体呈好转趋势,但未达到国家规定的Ⅲ级水质标准,水质标识指数Iwq结果表明该好转的速度较慢,西充河水质状况有较大的上升潜力和空间。总氮(TN)和氨氮(NH+4-N)为河流主要污染物,为了达到国家Ⅲ级水质标准,西充河的治理已刻不容缓。     

五种重金属离子对黑褐新糠虾的急性毒性试验

通过Cu、Hg、Cd、Zn、Pb等5种重金属离子对黑褐新糠虾的急性毒性试验,分别得出了5种重金属离子对黑褐新糠虾的24、48、72、96 h半致死浓度及安全浓度,依次为:Cu2 0.625、0.161、0.161、0.125、0.013 mg/L;Zn2 4.028、1.083、0.917、0.583、0.058mg/L;Cd2 2.679、0.625、0.250、0.161、0.016mg/L;Pd2 13.750、13.750、9.583、1.917、0.192mg/L;Hg2 0.161、0.150、0.150、0.150、0.015 mg/L。研究结果表明:黑褐新糠虾对5种金属离子的敏感性为Cu2 >Hg2 >Cd2 >Zn2 >Pb2 ,黑褐新糠虾作为水域重金属离子的监测生物具有较明显的优势。     

呼和浩特城区冬季近地面挥发性有机物污染特征初步研究

挥发性有机物(VOCs)是环境空气监测的主要目标污染物。本文运用罐采样-三级冷阱预浓缩-中心切割-气相色谱(FID)/气质联用法对人群主要活动的近地面不同高度、不同时间段及不同区域的呼和浩特冬季大气环境中挥发性有机物进行定性定量分析。发现典型天气情况下,呼和浩特城区冬季近地面挥发性有机物组分中烷烃和芳香烃占比较高,城区西侧所监测点位挥发性有机物总量(TVOCs)浓度高于其他区域,且其浓度在高度和时段上存在明显差异。     

Metabolic uncoupler, 3,3′,4′,5-tetrachlorosalicylanilide addition for sludge reduction and fouling control in a gravity-driven membrane bioreactor

• Effects of metabolic uncoupler TCS on the performances of GDMBR were evaluated. • Sludge EPS reduced and transformed into dissolved SMP when TCS was added. • Appropriate TCS increased the permeability and reduced cake layer fouling. • High dosage aggravated fouling due to compact cake layer with low bio-activity. The gravity-driven membrane bioreactor (MBR)system is promising for decentralized sewage treatment because of its low energy consumption and maintenance requirements. However, the growing sludge not only increases membrane fouling, but also augments operational complexities (sludge discharge). We added the metabolic uncoupler 3,3′,4′,5-tetrachlorosalicylanilide (TCS) to the system to deal with the mentioned issues. Based on the results, TCS addition effectively decreased sludge ATP and sludge yield (reduced by 50%). Extracellular polymeric substances (EPS; proteins and polysaccharides) decreased with the addition of TCS and were transformed into dissolved soluble microbial products (SMPs) in the bulk solution, leading to the break of sludge flocs into small fragments. Permeability was increased by more than two times, reaching 60–70 L/m²/h bar when 10–30 mg/L TCS were added, because of the reduced suspended sludge and the formation of a thin cake layer with low EPS levels. Resistance analyses confirmed that appropriate dosages of TCS primarily decreased the cake layer and hydraulically reversible resistances. Permeability decreased at high dosage (50 mg/L) due to the release of excess sludge fragments and SMP into the supernatant, with a thin but more compact fouling layer with low bioactivity developing on the membrane surface, causing higher cake layer and pore blocking resistances. Our study provides a fundamental understanding of how a metabolic uncoupler affects the sludge and bio-fouling layers at different dosages, with practical relevance for in situ sludge reduction and membrane fouling alleviation in MBR systems.     

Diffusive gradients in thin films using molecularly imprinted polymer binding gels for in situ measurements of antibiotics in urban wastewaters

• Selective molecularly imprinted polymer (MIP) binding gel was prepared. • MIP-DGT showed excellent uptake performance for antibiotics. • In situ measurement of antibiotics in wastewaters via MIP-DGT was developed. • The MIP-DGT method was robust, reliable, and highly sensitive. Urban wastewater is one of main sources for the introduction of antibiotics into the environment. Monitoring the concentrations of antibiotics in wastewater is necessary for estimating the amount of antibiotics discharged into the environment through urban wastewater treatment systems. In this study, we report a novel diffusive gradient in thin films (DGT) method based on molecularly imprinted polymers (MIPs) for in situ measurement of two typical antibiotics, fluoroquinolones (FQs) and sulfonamides (SAs) in urban wastewater. MIPs show specific adsorption toward their templates and their structural analogs, resulting in the selective uptake of the two target antibiotics during MIP-DGT deployment. The uptake performance of the MIP-DGTs was evaluated in the laboratory and was relatively independent of solution pH (4.0–9.0), ionic strength (1–750 mmol/L), and dissolved organic matter (DOM, 0–20 mg/L). MIP-DGT samplers were tested in the effluent of an urban wastewater treatment plant for field trials, where three SA (sulfamethoxazole, sulfapyridine, and trimethoprim) and one FQ (ofloxacin) antibiotics were detected, with concentrations ranging from 25.50 to 117.58 ng/L, which are consistent with the results measured by grab sampling. The total removal efficiency of the antibiotics was 80.1% by the treatment plant. This study demonstrates that MIP-DGT is an effective tool for in situ monitoring of trace antibiotics in complex urban wastewaters.     

Determination of Steroid Estrogens in Wastewater Treatment Plant of A Controceptives Producing Factory

Steroid estrogens such as estrone (E1), 17β-estradiol (E2), estriol (E3), and 17α-ethynylestradiol (EE2) have been suspected to be the main contaminants, which can affect the endocrine system of animals. Many authors have investigated these chemicals in the domestic wastewater treatment plants (WTP). However, wastewater from industries producing steroid contraceptives has not got ample attention. From the environmental point of view, the four steroids are very significant because even very low concentrations (ng/L) can cause reproductive disturbances in human, livestock and wildlife. The main purpose of the present investigation was to develop an analytical method for the determination of the four steroid estrogens present in WTP of a pharmacy factory, mainly producing contraceptive medicine in Beijing, China. Analysis was performed by solid-phase extraction (SPE) system and liquid chromatography combined with tandem mass spectrometry (LC/MS/MS). The average recoveries from effluent samples ranged from 88% to 103% and the precision of the method ranged from 9% to 4%. Based on 0.5-L wastewater samples, the limit of quantification (LOQ) was determined at 0.7 ng/L for E1, 0.8 for E2, 0.9 ng/L for E3, and 0.5 ng/L for EE2 in influent, and 1.0 ng/L for E2 and EE2, and 2.0 ng/L for E1 and E3 in effluent. In the influent samples, average concentrations of 80, 85, 73 and 155 ng/L were determined for E1, E2, E3 and EE2, respectively, showing that they were removed in this WTP to the extent of 79, 73, 85 and 67%, respectively.     

VOCs在线监测远程质量控制可行性研究

地表水水质自动监测要求对主要监测指标具备远程质量控制功能,而对挥发性有机物（VOCs）在线监测没有明确要求。采用自行设计的标准溶液储存装置和一套吹扫捕集-气相色谱-氢火焰离子化检测器/电子捕获检测器（P＆C-GC-FID/ECD）在线监测系统对水中19种VOCs组分开展了远程标准溶液测试。结果表明,19种VOCs组分在线加标回收率为88.8%～103.8%,在线多点线性测试相关系数为0.995 9～0.999 7,连续16 d标准溶液测试的示值误差范围为-18.91%～21.91%;VOCs在线监测系统远程质量控制是可行的,可实时监控仪器性能,有效预警预报水质状况。     

ClO2三相催化氧化处理硝基苯生产废水的试验

硝基苯(NB)生产废水中含有大量NB及其衍生物,对生物具有毒性,属难生物降解物质.采用ClO2三相催化氧化工艺对NB废水进行处理.结果表明,每升废水投加280、350 mg ClO2,废水在活性炭加载含铜复合金属氧化物的催化剂床层停留56min,NB和色度的去除率均达到95%以上,COD去除率达到90%以上.吨废水处理成本约为10.5元.     

荧光法研究DNA与蒽相互作用机理

利用荧光猝灭光谱和紫外-可见吸收光谱研究了体外DNA对蒽的荧光猝灭机理.结果表明,DNA的紫外-可见光谱没有发生红移现象,通过计算分析不同温度下的荧光猝灭常数和热力学参数,结合两种光谱分析可知DNA对蒽的荧光猝灭属于动态猝灭机理.