Surface clogging process modeling of suspended solids during urban stormwater aquifer recharge

Aquifer recharge,which uses urban stormwater,is an effective technique to control the negative effects of groundwater overexploitation,while clogging problems in infiltration systems remain the key restricting factor in broadening its practice.Quantitative understanding of the clogging process is still very poor.A laboratory study was conducted to understand surface physical clogging processes,with the primary aim of developing a model for predicting suspended solid clogging processes before aquifer recharge projects start.The experiments investigated the clogging characteristics of different suspended solid sizes in recharge water by using a series of one-dimensional fine quartz sand columns.The results showed that the smaller the suspended particles in recharge water,the farther the distance of movement and the larger the scope of clogging in porous media.Clogging extents in fine sand were 1 cm,for suspended particle size ranging from 0.075 to 0.0385 mm,and 2 cm,for particles less than 0.0385 mm.In addition,clogging development occurred more rapidly for smaller suspended solid particles.It took 48,42,and 36 hr respectively,for large-,medium-,and small-sized particles to reach pre-determined clogging standards.An empirical formula and iteration model for the surface clogging evolution process were derived.The verification results obtained from stormwater recharge into fine sand demonstrated that the model could reflect the real laws of the surface clogging process.     

内配燃料垃圾焚烧飞灰烧结无害化处理实验研究

研究了一种垃圾焚烧飞灰烧结无害化处理的工艺,该工艺是将飞灰与不同比例煤粉混合并添加助熔剂进行造粒烧结。通过对试样进行热流和热重测量,分析了飞灰试样在加热过程中热重变化的规律,并利用XRD、扫描电镜、氮吸附分析仪等仪器分析手段对烧结试样的物相、微观形态和孔隙特性等物理化学性质进行了研究。最后采用电感耦合等离子体发射光谱仪对烧结试样重金属浸出性进行了分析。实验结果为飞灰烧结炉的设计和内配燃料烧结工艺运行参数的制定提供了依据。     

环氧化PVA载体固定漆酶的最佳工艺条件研究

在T=35℃,HAc-NaAc缓冲溶液pH为4的条件下,用环氧化PVA载体对漆酶进行固定化,固定后酶活为游离酶活的95%。用该固定化漆酶处理制浆造纸废水,反复使用6次后,酶活仍保持为初始酶活的45%,且每次COD去除率在40%以上,处理后的废水BOD增大了50%,废水可生化性得到很大提高。     

A laboratory study on migration of K+ in a two-layer landfill liner system.

Contaminant transport through the clay liner and the underIying secondary leachate drain layer (SLDL) in landfills was studied through a laboratory test, and analysis method on the transport of K+ in a two-layer soil system. The soils used for this study were Ariake clay and the underlying layer, Shirasu soil from the Kyushu region of Japan, representing the clay liner material and SLDL material, respectively. The effective diffusion coefficients (De) of the selected target chemical species, potassium (K+) for the Ariake clay and Shirasu soil were back-calculated using a computer program, and it was found that values of De derived from this study were consistent with those previously published. The hypothesis that the mechanical dispersion process can be negligible has been proved to be reasonable based on both the observation that the predicted values fit the experimental data and the analyses of two dimensionless parameters. Parametric analysis showed the transport of K+ through the soils is controlled by advection-diffusion rather than diffusion only, whereas at low Darcy velocity (i.e. < or = 10(-9) m s(-1)), transport of K+ would be controlled by diffusion. The test results and parametric analysis may be applied in design of landfill liners and SLDLs, particularly in coastal areas.     

湖北省湖泊水环境化学特征及其与人类活动的关系

通过对湖北省近３０个湖泊水环境化学的分析，探讨了湖北省湖泊水质状况和湖水的化学稳定性，指出远离工业区和居民生活区的湖泊水质一般较好，城区或城效型湖泊在不同程度上受到了工业废水和生活污水的影响。控制，消除湖泊污染是今后经济、社会和环境建设不可忽视的重要工作。     

Metal accumulation in intertidal litter through decomposing leaf blades, sheaths and stems of Phragmites australis

Metal contents of decomposing leaf blades, leaf sheaths and stems of common reed (Phragmites australis) were monitored by a litter bag method on the sediment of an intertidal brackish marsh in the Scheldt estuary (The Netherlands). On monthly intervals, two litter bags were retrieved from the marsh during 9 months for both leaf blades and sheaths and during 16 months for stems. All samples were dried, weighed and analysed for ash and Cd, Cu, Cr, Ni, Pb and Zn contents. Most concentrations increased considerably during the decomposition. Generally, also a very important net metal inflow into the litter bags could be observed. The inflow was highest for leaf blades. High correlations between ash contents and metal concentrations for leaf blades suggest that the increase of leaf blade metal contents can be due to physicochemical sorption of dissolved metals and an important infiltration of mud particles, which were not removed by rinsing the leaf blades with distilled water preceding the analyses. For stems, smaller amounts of inflowing ash and even outflowing ash amounts were found, which suggests that inflow of inorganic particles is not the major factor determining metal accumulation by stems on medium term. Ergosterol concentrations in stem tissue however proved to be correlated with metal contents, which suggests a significant role of fungal litter colonizers in metal accumulation. For leaf sheaths, the effects of physicochemical sorption, infiltration of mud particles and incorporation by microbial litter colonizers do not seem to be as pronounced as for stems and leaf blades.     

隧道内偏置火源顶棚近壁面温度边界层效应研究

基于隧道火灾不同横向火源位置的非对称卷吸影响,通过模拟计算分析了中心火源和偏置火源产生的烟气沿纵向最大温升变化规律,研究了顶棚下方近壁面区域内的不同温度分布,提出偏置火源纵向空间最大顶棚温升公式。结果表明:在壁面黏性作用下,沿纵向蔓延的烟气最高温度在顶棚下方呈现“温度边界层”分布;随着火源位置的偏移,下游出现偏置距离起主导作用影响温度衰减的区域,衰减速度相较于中心火源逐渐降低;火源下游近壁面最高温度位置逐渐远离顶棚后趋于稳定。研究结果对于排烟方式的设计以及空间通风效果的提升有着重要意义。     

GB/T 7702-2008《煤质颗粒活性炭试验方法》标准的研究

通过对GB/T 7702-2008《煤质颗粒活性炭试验方法》的修订,研究了国际上先进国家的ASTM、JIS、ГОСТ同类标准内容。本系列标准除等同采用部分国际先进标准外,还结合本国特点增加了部分国外标准没有的内容,同时着重对碘吸附值测定进行了深入研究,确定了国际先进的碘吸附值试验方法。     

环境模型参数识别与不确定性分析

在对水文模型实例的参数不确定性分析基础上,分别采用传统灵敏度分析方法、HSY算法、线性回归等方法对模型参数特性进行了识别与比较研究.结果表明参数优化算法与传统灵敏度分析方法不能解释模型结构复杂性特征,采用不确定性分析方法对环境模型参数进行识别提供了深入分析与理解模型系统的有效途径.